• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1999년도 전력전자학술대회 논문집
• /
• pp.346-349
• /
• 1999

This paper proposes a new series-connected diode rectifier which draws sinusoidal input currents. The proposed rectifier system is configured by adding an auxiliary circuit to the conventional 12-pulse series-connected diode rectifier and employing a current injection technique. A low kVA (0.02Po (PU) ) active current source injects a triangular current results in near sinusoidal input current from the utility with less than 1% THD. The resulting system is suitable for high voltage and high power applications. Experimental results is provided from a 220VA rectifier system.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 F
• /
• pp.1969-1972
• /
• 1998

Harmonic analysis is important for PWM rectifiers with high powerfactor. This paper describes the harmonic analysis of input current in high powerfactor boost-type rectifier. The magnitudes of the harmonics are obtained through the current wave from analysis and the effect of source reactance is also analyzed.

• Journal of Electrical Engineering and information Science
• /
• 제3권3호
• /
• pp.366-372
• /
• 1998

A high efficiency interleaved active clamp forward converter with self driven synchronous rectifiers for a modular power processor is presented. To simplify the gate drive circuits, N-P MOSFETs coupled active clamp method is used. An efficiency about 90% for the load range of 50-100% is achieved. The details of design for the power stage and current mode control circuit are provided, and also some experimental results are given.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 전력전자학술대회 논문집
• /
• pp.514-519
• /
• 2001

Most of inverters adopt a diode rectifier as an input stage, which has very simple and rugged structure and therefore low cost. In order to properly design the 3-phase diode rectifier with an output smoothing capacitor and input inductors, it is necessary to fully simulate the system due to its nonlinear characteristics. Therefore this paper describes the operating behaviors including the current commutation in detail by using the proposed equivalent circuit, and also proposes the Simulink-based model of the system. The simulation results show the validity of the proposed model in all operating conditions.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1993년도 하계학술대회 논문집 B
• /
• pp.818-820
• /
• 1993

In the three phase full-wave thyristor rectifier, heat radiation concentrated at a few thyristor(s), while equipment's output is normal. That is very important on the predictive maintenance or checking including replacement of parts(or modules). Therefore, this report explains the method of effective diagnosis and the reason that firing control modules have to be adjusted accuratly on each phase.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2019년도 전력전자학술대회
• /
• pp.269-270
• /
• 2019

Vienna rectifier is used for telecom power applications because of its simple structure, high efficiency and high power density. This rectifier is also suitable to obtain a high voltage DC output. This paper describes the analysis and design of a single-phase module of a Vienna rectifier to obtain 750VDC output. The simulation and experimental results are provided to verify the theoretic analysis and design.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1998년도 Proceedings ICPE 98 1998 International Conference on Power Electronics
• /
• pp.206-211
• /
• 1998

In audio techniques calculation of digital filters is accelerated considerably by use of wave variables instead of voltages and currents. The suitability of wave variables for digital simulation of power converters was investigated and the results are reported in this paper. The original method is described briefly, modelling of switches and diode rectifiers is presented, examples are given and the features of the method are discussed.

• 전력전자학회논문지
• /
• 제21권4호
• /
• pp.335-342
• /
• 2016

This paper proposes an energy storage-assisted, series-connected module-integrated power conversion system that integrates a photovoltaic power conditioner and a charge balancing circuit. In conventional methods, a photovoltaic power conditioner and a cell-balancing circuit are needed for photovoltaic systems with energy storage devices, but they cause a complex configuration and high cost. Moreover, an imbalanced output voltage of the module-integrated converter for PV panels can be a result of partial shading. Partial shading can lead to the fault condition of the boost converter in shaded modules and high voltage stresses on the devices in other modules. To overcome these problems, a bidirectional buck-boost converter with an integrated magnetic device operating for a charge-balancing circuit is proposed. The proposed circuit has multiple secondary rectifiers with inductors sharing a single magnetic core, which works as an inductor for the main bidirectional charger/discharger of the energy storage. The secondary rectifiers operate as a cell-balancing circuit for both energy storage and the series-connected multiple outputs of the module-integrated converter. The operating principle of the cell-balancing power conversion circuit and the power stage design are presented and validated by PSIM simulation for analysis. A hardware prototype with equivalent photovoltaic modules is implemented for verification. The results verify that the modularized photovoltaic power conversion system in the output series with an energy storage successfully works with the proposed low-cost bidirectional buck-boost converter comprising a single magnetic device.

• 해양환경안전학회지
• /
• 제18권4호
• /
• pp.360-364
• /
• 2012

전기추진시스템 분야에서 AC/DC 컨버터는 상대적으로 간단한 다이오드 소자를 이용하는 정류기가 가장 널리 사용되고 있으며 이 정류기는 입력 전류에 큰 고조파를 포함하고 있어서 고조파 저감을 위한 많은 연구가 진행되고 있다. 본 연구에서 제안된 방식은 다이오드 정류기의 출력 전류를 정류기와 추진전동기 입력측에 주입하여 정류기와 추진전동기 입력 전류에 포함되는 고조파 성분을 줄이고 또한, 와이-델타 변압기를 정류기 및 추진전동기 입력회로에 설치되는 전류주입장치의 분배회로에 사용하여 주입전류와 전원 및 부하를 서로 절연함으로써 전류파형 개선과 전기적 안전성을 확보하였다. 제안한 방법을 현재 사용 중인 전기추진선박에서 적용하여 시뮬레이션 하였으며 기존의 전력변환장치와 비교하여 그 타당성을 입증하였다.

• 한국철도학회논문집
• /
• 제10권6호
• /
• pp.717-722
• /
• 2007

본 논문에서는 직류 1500V 지하철 변전소의 가선전압과 피더별 전류량을 측정한 결과를 분석한다. 선릉과 양동시장 변전소들의 피더별 소비 및 회생전력을 측정하고, 피더별로 발생된 회생전력이 타 피더로 전달되는 전력량을 계산하였다. 전철변전소에서 회생전력이 교류될 수 있는 거리를 타 변전소와의 중간지점으로 가정하고, 전동차 1편성의 회생전력량을 기초로 변전소에서 발생되는 총 회생전력량을 근사식으로 계산하였다. 이렇게 얻어진 값과 측정된 피더간 교류된 회생전력량을 사용하여 변전소의 회생전력 실효전력량을 계산하고 회생인버터가 설치된 후 재활용할 수 있는 회생전력량을 근사적으로 얻었다.