• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.5-8
• /
• 1999

In this paper, we present narrowband interference (NBI) cancelling algorithm applied to wideband spread spectrum system. We introduce multi-carrier transmission technique to overcome hardware inplementation difficulty of wideband spreading above 40MHz and to enhance NBI performance. A direct-sequence spread spectrum receiver using both decision-feedback and two sided LMS filters for combating narrowband interference is applied. We show that performance of this receiver outperforms conventional NBI rejection systems in tone jamming, partial band jamming, and impulsive channel through the bit error ratio evaluation. In addition, we propose a new technique to improve the performance of time domain NBI rejection algorithm sensitive to impulsive channel.

• Proceedings of the IEEK Conference
• /
• 2003.07a
• /
• pp.35-38
• /
• 2003

We propose a switched beamforming to improve the reception performance of VSB system in severe Rayleigh fading channel. The VSB system has only about 3% of known training signal for the receiver in a data field and the reception performance of VSB receiver is degraded significantly when there are near-0 dB ghosts in receiving signal. The switched beamforming forms several beams in different directions and selects only one beam among them. For the selection of a beam with best channel condition for VSB equalizer, we extracted the channel profiles in time domain for all the beams by correlating the PN511 sequence in VSB field sync and selected optimal beam by comparing the channel profiles. The simulation results show that the proposed method improves the reception performance of VSB system in severe Rayleigh channel.

• The Journal of the Acoustical Society of Korea
• /
• v.22 no.6
• /
• pp.482-488
• /
• 2003

Line may receiver contains an ambiguity on conjugate bearings, because of lacking aperture in transverse direction. To solve the left/right bearing ambiguity of line-array receiver we used line-array with cardioid beam. In addition, the synthetic aperture method adopts coherent processing of sub-aperture signals at successive time intervals in the beam domain. We presented performances about division of left/right bearing ambiguity according to array synthetic number of times in this paper.

• Information and Communications Magazine
• /
• v.24 no.3
• /
• pp.76-86
• /
• 2007

This paper describes the RF performance issues of UE RF Transceiver for W-CDMA system based on 3GPP specifications. the parameters of transmitter and receiver are derived from the viewpoint of RF performance. In order for UE to achieve high performance, the transceiver performance requirements such as ACIR, EVM, Peak Code Domain Error, spectrum emission mask, frequency error stability and TX power control dynamic range for transmitter and reference sensitivity level, blocking characteristics, noise figure, ACS, linearity, AGC dynamic range for receiver are considered. On the basis of the required parameters, the UE RF transceiver is designed and then implemented. The evaluation of RF performance is accomplished through practical test scenarios.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.25 no.6
• /
• pp.477-483
• /
• 2020

This study proposes a DQ synchronous reference frame model of a series-parallel tuned inductive power transfer (SP-IPT) system. The wireless power transmission system experiences control difficulty because the transmitter-side controller cannot directly measure the receiver-side load voltages and currents. Therefore, a control-oriented circuit model that shows the dynamics of the IPT system is required to achieve a well-behaved controller. In this study, an equivalent circuit model of the SP-IPT system in a synchronously rotating reference frame is proposed using the single-phase DQ transformation technique. The proposed circuit model is helpful in modeling the dynamics of the voltages and currents of the transmitter- and receiver-side resonant tanks and loads. The proposed circuit model is evaluated using frequency- and time-domain simulation results.

• Geophysics and Geophysical Exploration
• /
• v.16 no.3
• /
• pp.139-144
• /
• 2013

A computer program has been developed to estimate time-domain electromagnetic (EM) responses for a onedimensional model with multiple source and receiver dipoles that are finite in length. The time-domain solution can be obtained by applying an inverse fast Fourier transform (FFT) to frequency-domain fields for efficiency. Frequency-domain responses are first obtained for 10 logarithmically equidistant frequencies per decade, and then cubic spline interpolated to get the FFT input. In the case of phases, the phase curve must be made to be continuous prior to the spline interpolation. The spline interpolated data are convolved with a source current waveform prior to FFT. In this paper, only a step-off waveform is considered. This time-domain code is verified with an analytic solution and EM responses for a marine hydrocarbon reservoir model. Through these comparisons, we can confirm that the accuracy of the developed program is fairly high.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.11C
• /
• pp.641-648
• /
• 2011

Frequency domain equalization is the most promising technology that has relatively low complexity in multipath channel. A frame of single carrier system with frequency domain equalization (SC-FDE) has cyclic prefix to mitigate effect of delay spread. After synchronization and equalization procedure on the SC-FDE system, common phase offset (CPO) that can introduce performance degradation caused by phase mismatch between transmitter and receiver oscillators is remained. In this paper, common phase offset tracking in frequency domain is proposed. To track CPO, constant amplitude zero autocorrelation code sequence as training sequence is adopted. By using numerical results, performance of mean square error is evaluated. The results show that MSE of CPO has similar performance compare to the time-domain estimation and there is no need of domain conversion.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.8
• /
• pp.981-987
• /
• 2019

In this paper, we propose a new SC-FDE (single carrier frequency domain equalization) structure to cope with narrow band interference signals or jammers and reduce pilot overhead. The conventional SC-FDE structure has a problem that the receiver performance degrades severely due to difficulty in time-domain channel estimation when narrow band jammers exist. In addition, the spectral efficiency is lowered by transmitting pilot at every SC-FDE block to estimate channel response. In order to overcome those problems, the proposed structure is devised to estimate frequency domain channel directly without time domain channel estimation. To reduce the pilot overhead, several data blocks are transmitted between two pilots. The channel estimate of each data block is found through linear interpolation of two channel estimates at two pilots. By performing frequency domain channel equalization using this channel estimate, the distortion by the channel is well compensated when narrow band jammers exist. The performance of the proposed structure is confirmed by computer simulation.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.12
• /
• pp.2394-2402
• /
• 2017

The frequency selective fading by multipaths determines a performance of underwater acoustic communication system in shallow littoral ocean. In this study, a characteristics of underwater acoustic channel and performance of multi-carrier system is evaluated in littoral ocean with a 50m deep water, an effective wave height of 0.5m and sandy mud bottom near Busan city. A multipath delay spread and time and frequency domain are presented as a function of a transmitter-to-receiver range. A bit-error-rate of a 5 channel 4FSK(Frequency Shift Keying) with a transmission rate of 1kbps, is examined and RS(Reed-Solomon) code is also adopted to remove a burst error due to time domain fading. A number of multipath are less than four and a bit-error-rate is decreased as an increase of a transmitter-to-receiver range which gives a congestion of multi-paths resulting in a decrease of time and frequency domain fading. The measured bit-error-rate is about 10-4 at greater than 600m of transmitter-to-receiver range.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.11
• /
• pp.73-79
• /
• 2004

While CDMA systems are proven to be excellent solutions for cellular communications, they suffer from severe multi-path interferences and are unable to support high-data-rate transmissions over frequency-selective fading channels. This paper introduces a novel downlink transmission method for next generation mobile communication systems. The proposed method allows frequency-domain equalization at the receiver while maintaining the compatibility with the 3rdgeneration CDMA systems.