• Toxicological Research
• /
• v.29 no.3
• /
• pp.203-209
• /
• 2013

A simple and rapid liquid chromatography-tandem mass spectrometry (LC-MS/MS) method was developed and validated for the quantification of ${\varepsilon}$-acetamidocaproic acid (AACA), the primary metabolite of zinc acexamate (ZAC), in rat plasma by using normetanephrine as an internal standard. Sample preparation involved protein precipitation using methanol. Separation was achieved on a Gemini-NX $C_{18}$ column ($150mm{\times}2.0mm$, i.d., 3 ${\mu}m$ particle size) using a mixture of 0.1% formic acid-water : acetonitrile (80 : 20, v/v) as the mobile phase at a flow rate of 200 ${\mu}l/min$. Quantification was performed on a triple quadrupole mass spectrometer employing electrospray ionization and operating in multiple reaction monitoring (MRM) and positive ion mode. The total chromatographic run time was 4.0 min, and the calibration curves of AACA were linear over the concentration range of 20~5000 ng/ml in rat plasma. The coefficient of variation and relative error at four QC levels were ranged from 1.0% to 5.8% and from -8.4% to 6.6%, respectively. The present method was successfully applied for estimating the pharmacokinetic parameters of AACA following intravenous or oral administration of ZAC to rats.

• BMB Reports
• /
• v.39 no.3
• /
• pp.247-252
• /
• 2006

A rapid method for the detection of Hepatitis E Virus (HEV) was developed by utilizing nano-gold labeled oligonucleotide probes, silver stain enhancement and the microarray technique. The 5'-end -$NH_2$ modified oligonucleotide probes were immobilized on the surface of the chip base as the capture probe. The detection probe was made of the 3'-end -SH modified oligonucleotide probe and nano-gold colloid. The optimal concentrations of these two probes were determined. To test the detection sensitivity and specificity of this technique, a conservative fragment of the virus RNA was amplified by the RT-PCR/PCR one step amplification. The cDNA was hybridized with the capture probes and the detection probes on microarray. The detection signal was amplified by silver stain enhancement and could be identified by naked eyes. 100 fM of amplicon could be detected out on the microarray. As the results, preparation of nano-gold was improved and faster. Development time also was shortened to 2 min. Thus, considering high efficiency, low cost, good specificity and high sensitivity, this technique is alternative for the detection of HEV.

• Journal of Pharmaceutical Investigation
• /
• v.22 no.2
• /
• pp.133-137
• /
• 1992

A novel oral controlled release tablet which may offer more uniform drug level in the body than simple zero-order was developed. The tablet is composed of three layers; outer film layer, middle part compression-coated hydroxypropylmethylcellulose (HPMC) matrix layer, and inner core layer. Each layer contains nicardipine HCl as a model drug. In vitro dissolution test showed that the tablet released the drug in clear three steps; a rapid initial release, followed by a constant rate of release, and then a second phase of fast release of drug. The dissolution characteristics could be modified easily by changing the grade of HPMC, thickness of matrix layer, content of methylcellulose in matrix layer, content of active ingredient in each layer. The pH of dissolution medium did not affect the release profile. This three-step release system is expected to raise the blood concentration rapidly to effective level and to maintain effective blood level longer than simple slow-release systems.

• Journal of Environmental Science International
• /
• v.23 no.5
• /
• pp.887-893
• /
• 2014

In order to remove fluoride ions from aqueous solution, PVC-$Al(OH)_3$ beads were prepared by immobilizing $Al(OH)_3$ with polyvinyl chloride (PVC). The prepared PVC-$Al(OH)_3$ bead was characterized by using SEM, EDS and Zeta potential. Dependences of pH, contact time and initial fluoride concentration on the adsorption of fluoride ions were studied. The optimal pH was in the range of 4~10. The adsorption was rapid during the initial 12 hr, and equilibrium was attained within 72 hr. The adsorption rate of fluoride ions by PVC-$Al(OH)_3$ beads obeyed the pseudo-second-order kinetic model. The maximum adsorption capacity obtained from Langmuir isotherm model was found to be 62.68 mg/g.

• Journal of Microbiology and Biotechnology
• /
• v.17 no.1
• /
• pp.116-122
• /
• 2007

An efficient enzyme system for the synthesis of L-tyrosine was developed using a fed-batch reactor with continuous feeding of phenol, pyruvate, and ammonia. A thermo- and chemostable tyrosine phenol-lyase from Symbiobacterium toebii was employed as the biocatalyst in this work. The enzyme was produced using a constitutive expression system in Escherichia coli BL21, and prepared as a soluble extract by rapid clarification, involving treatment with 40% methanol in the presence of excess ammonium chloride. The stability of the enzyme was maintained for at least 18 h under the synthesis conditions, including 75 mM phenol at pH 8.5 and $40^{\circ}C$. The fed-batch system (working volume, 0.51) containing 1.0 kU of the enzyme preparation was continuously fed with two substrate preparations: one containing 2.2 M phenol and 2.4 M sodium pyruvate, and the other containing 0.4 mM pyridoxal-5-phosphate and 4M ammonium chloride (pH 8.5). The system produced 130g/I of L-tyrosine within 30h, mostly as precipitated particles, upon continuous feeding of the substrates for 22 h. The maximum conversion yield of L-tyrosine was 94% on the basis of the supplied phenol.

• Food Science and Biotechnology
• /
• v.16 no.5
• /
• pp.832-835
• /
• 2007

Moisture content of normal, waxy, and high amylose com starches was adjusted to 10-35%, and irradiated in a microwave oven. The effect of microwave irradiation on the crystalline structure of starch was measured by using a differential scanning calorimetry (DSC), and X-ray diffractometry. Pasting viscosity profile was also determined by using a rapid viscoanalyzer (RVA). For all the 3 types of starches tested, the rate of temperature increase by the microwave irradiation was faster and more rapidly reached the maximum temperature of the pressure bomb ($120^{\circ}C$) when the moisture content was higher. X-ray diffraction and DSC data revealed that the microwave irradiated starch underwent partial disruption of crystalline structure. RVA studies showed that the irradiation caused significant reductions in maximal viscosity and breakdown, whereas pasting temperature was increased. Overall trends revealed that the microwave irradiation on the starch containing limited moisture content (less than 35%) provided the effects similar to the heat moisture treatment. These effects became more significant when the moisture content was higher. Compared to waxy com starch, normal, and high amylose com starches appeared to be more susceptible to the microwave irradiation.

• Journal of Microbiology and Biotechnology
• /
• v.20 no.7
• /
• pp.1114-1120
• /
• 2010

A chitosan-degrading fungus, BSF114, was isolated from soil. The culture preparation showed strong chitosanolytic enzyme activity at an optimum pH of 4.0 and optimum temperature of $60^{\circ}C$ after 36-40 h fermentation. The rapid decrease in the viscosity of the chitosan solution early in the reaction suggested an endo-type cleavage of the polymeric chitosan chains. To identify the isolated fungus, molecular biological and morphological methods were used. The fungal internal transcribed spacer (ITS) region 1 was amplified, sequenced, and then compared with related sequences in the GenBank database using BLAST. The phylogenetic relationships were then analyzed, and the results showed that the fungus belongs to Aspergillus fumigatus. Morphological observations were also used to confirm the above conclusion. The chitooligosaccharides (COS) obtained through hydrolyzing the colloidal chitosan showed that A. fumigatus BSF114 is suitable for degrading chitosan and producing chitooligosaccharides on a large scale. High concentrations of the COS (1,000 and 500 ${\mu}g/ml$) significantly proliferated mice marrow cells.

• Journal of Information Technology Services
• /
• v.8 no.4
• /
• pp.17-40
• /
• 2009

This study is to guide to estimate service quality on ITSM operation based on ITIL(IT Infrastructure Library). ITIL v2 and v3 provide how to integrate framework of IT service and business process. It is widely used as ITSM operation base. As a latest IT trend, ITSM covers Hardware, Software, SaaS, Network, Call center, Helpdesk, ASP portal and IT operation. Servicedesk is selected as target area where valid sampling is addressable and service change is rapid. Traditional Helpdesk was focusing on technical support to solve internal IT issues passively. But it was evolved into Service Desk which focus in process and provide integrated service from customer's business view point preventively and proactively. Accordingly outsourcing types business are normally performed by group of professional capability. Service quality is measured under the SLA(Service Level Agreement). This study utilized SERVQUAL model as service quality measuring tool developed by Parasuraman, Zeitaml and Berry to find critical factors to satisfy customer. And test was processed regarding effectiveness of IT organization and customer view point thru sampling. Though valid parameters can be changed by ITSM areas under the SERVQUAL models, they naturally can be accepted as a index of service quality measurement after sampling test with acceptable significance. And I recommend to follow this study as a preparation before official SLA.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.41 no.6
• /
• pp.409-413
• /
• 2008

A simple method for the purification of porphyran from laver Porphyra yezoensis was developed to obtain information for the development of food materials with biological functionality. Crude porphyran (CP) was extracted from dried laver in boiling water for 3 h, and then fractionated using cetylpyridinium chloride into an acidic fraction (CP-F1) and a neutral fraction (CP-F2). CP-F1 was fractionated further by fractional ethanol precipitation. Fraction CP-F1-70, precipitated at an ethanol concentration of 61-70% was the major fraction containing 68.1% of the yield from the initial fraction CP-F1. The CP-F1-70 fraction displayed a single band on Sepharose CL-4B with a molecular mass of 550 kDa, indicating a homogeneous polysaccharide. The molar ratio of galactose, 3,6-anhydro-L-galactose, 6-0-methyl-D-galactose and ester sulfate of CP-F1-70 was 1:0.32:0.07:0.53. This method is very useful for rapid and large-scale preparation of purified porphyran because it is compatible with mass production.

• YAKHAK HOEJI
• /
• v.49 no.4
• /
• pp.260-267
• /
• 2005

[ $PGE_1$ ] is an endogenous substance of potent vasodialator as well as inhibitor of platelet aggregation. It has been used therapeutically in peripheral arterial occlusive disease and impotence. Intracavernous injection of $PGE_1$ for erectile dysfunction has been established for several years as a treatment option for erectile dysfunction of diverse etiologies, but this mode of administration is limited by penile discomfort, pain at the injection site, inconvenience and noncompliance. As the matter of worse, the $\beta-hydroxy$ moiety of $PGE_1$ is extremely susceptible to dehydration in solution to give inactive $PGA_1$ and $PGB_1$. For the improvement of stability, rapid absorption at action site and the convenience of application, $PGE_1$ was formulated as urethral suppositories of three types of formulations, such as PEG, witepsol, and the mixture of PEG and witepsol. The stability test of $PGE_1$ and the release test in urinary suppositories were performed. Futhermore, the effect of enhancers and vehicle composition on the penetration of $PGE_1$ through excised rat skin was evaluated by permeability coefficient and enhancement ratio.