• Proceedings of the KSRS Conference
• /
• 2002.10a
• /
• pp.297-302
• /
• 2002

The subsystems of two channel correlation radiometer such as RF front-end, IF and LF unit, LO unit, software based I/Q demodulator and complex correlator are characterized and their performance is analyzed in this paper. The limited hardware calibration method and receiver design consideration are discussed. The receiver architecture of 37GHz correlation radiometer is integrated. The designed radiometer employs a single-sideband superheterodyne receiver. The center frequency of the radiometer is 37 GHz and IF center frequency is 1.95 GHz with the equivalent noise bandwidth of 79.6 MHz. The receiver has less than 4.2 dB noise figure which is calculated by the Y-factor method and its gain can be adjusted from 60 dB to 80 dB.

• Proceedings of the KSRS Conference
• /
• 2002.10a
• /
• pp.604-609
• /
• 2002

The passive microwave remote sensing has progressed considerably in recent years. Important earth surface parameters are detected and monitored by airborne and space born radiometers. However the spatial resolution of real aperture measurements is constrained by the antenna aperture size available on orbiting platforms and on the ground. The inverse problem technique is researched in order to improve the spatial resolution of microwave scanning radiometer. We solve a two-dimensional (surface) temperature-imaging problem with a major intention to develop high-resolution methods. In this paper, the scenario for estimation of both radiometer point spread function (PSF) and target configuration is explained. The PSF of the radiometer is assumed to be unknown and estimated from the observations. The configuration and brightness temperature of targets are also estimated. To do this, we deal with the parametric modeling of observation scenario. The performance of developed algorithms is illustrated on two-dimensional experimental data obtained by the water vapor radiometer.

• Proceedings of the KSRS Conference
• /
• v.1
• /
• pp.386-389
• /
• 2006

The sea surface wind speed (SSWS) derived by microwave radiometer can be contaminated by change of microwave brightness temperature owing to the angle between the sensor azimuth and the wind direction (Relative Wind Direction). We attempt to correct the contamination to the SSWS derived by Advanced Microwave Scanning Radiometer (AMSR) on Advanced Earth Observing Satellite II (ADEOS-II), by applying the method proposed by Konda and Shibata (2004). The improvement of accuracy of the SSWS estimation amounts to roughly 60% of the error caused by the RWD effect.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.6
• /
• pp.1133-1138
• /
• 2010

We have developed an imaging radiometer system at W-band. The system consists of lens, reflector, 30-ch receiver array, scanner, and signal processor. One receiver consists of a dielectric rod antenna, a balun, LNA(low noise amplifier) and a detector. The system configuration requirements are described. Finally, we represent radiometer images to obtain through clouds, smoke, dust, and other obstructions which render visible and IR systems ineffective.

• Journal of Industrial Technology
• /
• v.25 no.B
• /
• pp.135-140
• /
• 2005

Voltage of radiometer is measured experimentally using the radiation apparatus in each case of iron- and copper-plates as specimen heating device. The length between radiometer and conical shield and the temperature of specimen heating device are considered as variables. The length between radiometer and conical shield controls the amount of radiation from the specimen heating device. Emissivity for both iron-and copper-plates are calculated by using Stefan-Boltzmann equation. One of results shows that emissivity for both materials increases as the length between radiometer and conical shield increases.

• Journal of Advanced Navigation Technology
• /
• v.2 no.1
• /
• pp.11-21
• /
• 1998

There have been active research efforts in the development of a dual-use millimeter-wave radiometer as an aircraft landing aid in low visibility conditions. In this paper, we constructed a radiometer operating at the Ka-band where it is relatively easy to build RF components. The radiometer is used to collect radiometric signatures of some vehicles and land surfaces. Measured signatures suggest that vehicles with metallic surfaces yield signatures markedly different from nearby land surfaces so that they can easily be detected by a simple radiometer.

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.365-368
• /
• 2007

Millimeter-wave (MMW) imaging radiometer systems have an attractive advantage to obtain an image through low visibility weather conditions such as fog, clouds and light rain compared with visible and infrared imaging systems. Many countries have developed a various kinds of MMW imaging radiometers for the aim of low cost and high performance. In Korea, Millimeter-wave Imaging RAdiometer Equipment (MIRAE) has been developed since the end of 2006. Recently the development of some modules was finished for the test model. This paper describes the design and development of the MIRAE. In addition, the test results of its manufactured modules are presented.

• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.526-529
• /
• 2005

Dual-channel Radiometers for Earth and Atmosphere Monitoring (DREAM) is the Korean first spaceborne microwave radiometer which is the main payload of Science and Technology SATellite-2 (STSAT-2). STSAT-2 will be launched by Korea Space Launch Vehicle-l (KSL V-I) at NARO Space Center in Korea in 2007. DREAM is a two-channel, total power microwave radiometer with the center frequencies of 23.8 GHz and 37 GHz. The spaceborne radiometer is composed of an antenna unit, a receiver unit, and a data acquisition/processing unit. The bandwidths of radiometer are 600 MHz at 23.8 GHz and 1000 MHz at 37 GHz. The integration time of two channels is 200 rns. The sensitivity of DREAM is less than 0.5 K. This paper presents the required performance and system design of DREAM in detail.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.9
• /
• pp.858-867
• /
• 2011

In this paper, we propose a microwave radiometer for remote sensing of oil spills on the water surface. In order to achieve the development aim of the measurement accuracy within 0.2 mm for oil slicks of 0~4 mm thickness, the requirements of the microwave radiometer and the specifications of its receiver are drawn. From these requirements and specifications, the receiver with high gain, high sensitivity is designed and implemented. The receiver has the bandwidth of 58 MHz, the system gain of 47.3 dB and the sensitivity of 0.46 K at 10.65 GHz. The processes of design and implementation of the receiver are described in this paper. The effectiveness of the proposed microwave radiometer in the measurement of oil slicks is demonstrated experimentally. The results show the microwave radiometer can detect the oil slicks for 0~5 mm thickness within the accuracy of 0.13 mm successfully.

• Current Optics and Photonics
• /
• v.1 no.3
• /
• pp.175-185
• /
• 2017

The aerosol optical properties such as depolarization ratio (${\delta}$) and aerosol extinction-to-backscatter ratios (S, LIDAR ratio) and ${\AA}ngstr{\ddot{o}m$ exponent (${\AA}$) derived from measurement with AERONET sun/sky radiometer at Gangneung-Wonju National University (GWNU), Gangneung, Korea ($37.77^{\circ}N$, $128.87^{\circ}E$) during a winter season (December 2014 - February 2015) are presented. The PM concentration measurements are conducted simultaneously and used to identify the high-PM events. The observation period was divided into three cases according to the PM concentrations. We analysed the ${\delta}$, S, and ${\AA}$ during these high PM-events. These aerosol optical properties are calculated by the sun/sky radiometer data and used to classify a type of aerosols (e.g., dust, anthropogenic pollution). The higher values of ${\delta}$ with lower values of S and ${\AA}$ were measured for the dust particles. The mean values of ${\delta}$, S, and ${\AA}$ at 440-870 nm wavelength pair (${\AA}_{440-870}$) for the Asia dust were 0.19-0.24, 36-56 sr, and 0.48, respectively. The anthropogenic aerosol plumes are distinguished with the lower values of ${\delta}$ and higher values of ${\AA}$. The mean values of spectral ${\delta}$ and ${\AA}_{440-870}$ for this case varied 0.06-0.16 and 1.33-1.39, respectively. We found that aerosol columnar optical properties obtained from the sun/sky radiometer measurement are useful to identify the aerosol type. Moreover, the columnar aerosol optical properties calculated based on sun/sky radiometer measurements such as ${\delta}$, S, and ${\AA}$ will be further used for the validation of aerosol parameters obtained from LIDAR observation as well as for quantification of the air quality.