• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 하계학술대회 논문집
• /
• pp.894-896
• /
• 2001

The Polypropylene films which are made by refinement of its pellet and formed as crystals are exposed to Radiation. As the results, degradation effects were observed in non-crystalline regions. It is thus considered that the effects occur by destroying of lattice binding force by Radiation. The distribution of degradation was increased with irradiation quantities of Radiation and dielectric constant of Polypropylene sheets irradiated Radiation was rapidly increased from above 10 MHz.

• 한국음향학회지
• /
• 제38권4호
• /
• pp.467-475
• /
• 2019

고출력의 초음파는 매질을 진행하면 음향 흐름과 음향 방사힘을 만들어낸다. 공기를 매질로 하는 3차원 공간상에 음향 방사힘을 발생시키면 입체적인 촉감을 형성할 수 있으므로 공간적인 정보를 직접 피부에 촉각으로 전달할 수 있다. 본 논문은 40 kHz의 작은 초음파 송신자 154개를 묶어 오목한 형태로 배열시켜서 초음파를 송신하여 집속초점에서 음향 방사힘을 발생시켰다. 초음파 음장의 초점의 근처에서 음향 방사힘에 의한 촉각을 확인하였다. 촉각 감도를 올리기 위하여 송신 초음파를 60 Hz의 구형파로 진폭 변조를 하였다. 초음파 촉각의 응용으로 음향 방사힘이 형성되는 허공에 촉각이 감지되는 영역을 형성시켜서, 손의 위치를 지정하는 지시자로 사용하였다. 촉각이 감지되는 초점위치에 있는 손의 모양을 영상 입력으로 받아서 손가락의 개수를 기계에 피드백하는 시스템을 구현함으로써 초음파를 이용한 촉각의 유용성을 확인하였다.

• 한국의학물리학회지:의학물리
• /
• 제32권4호
• /
• pp.153-158
• /
• 2021

Purpose: This study evaluated the features of a pressure mapping system for patient motion monitoring in radiation therapy. Methods: The pressure mapping system includes an MS 9802 force sensing resistor (FSR) sensor with 2,304 force sensing nodes using 48 columns and 48 rows, controller, and control PC (personal computer). Radiation beam attenuation caused by pressure mapping sensor and signal perturbation by 6 and 10 mega voltage (MV) photon beam was evaluated. The maximum relative pressure value (mRPV), average relative pressure value (aRPV), the center of pressure (COP), and area of pressure distribution were obtained with/without radiation using the upper body of an anthropomorphic phantom for 30 minutes with 15 MV. Results: It was confirmed that the differences in attenuation induced by the FSR sensor for 6 and 10 MV photon beams were small. The differences in mRPV, aRPV, area of pressure distribution with/without radiation are about 0.6%, 1.2%, and 0.5%, respectively. The COP values with/without radiation were also similar. Conclusions: The characteristics of a pressure mapping system during radiation treatment were evaluated on the basis of attenuation and signal perturbation using radiation. The pressure distribution measured using the FSR sensor with little attenuation and signal perturbation by the MV photon beam would be helpful for patient motion monitoring.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2014년도 춘계학술대회 논문집
• /
• pp.644-649
• /
• 2014

Analytical model is derived for the far-field acoustic radiation from machinery installed inside cylindrical shell. The analytical model includes the effect of fluid loading and interactions between periodic ring supports. Transmitted force from machine to a shell can be different by the impedance of shell. In this paper the transmitted force from machinery to a infinite shell through vibration isolator is considered by the impedance of shell. The effect of the shell impedance for acoustic radiation is investigated.

• 한국소음진동공학회논문집
• /
• 제21권9호
• /
• pp.834-841
• /
• 2011

Obtaining the real exciting force is important for the analysis of structural vibration or sound radiation to represent the actual condition. But in most cases, it is so difficult to get the actual force signals by direct measurement using sensors due to complex geometry. This paper suggests advanced source identification method which can be applied to the prediction of radiated noise considering correlations between measured signals. This method was implemented to the identification of the fan force in the refrigerator. The analysis of structural vibration and radiated noise caused by the fan force was also performed. The comparison between predicted SPL and measured SPL of the radiated noise by the refrigerator fan showed good agreement.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2002년도 하계학술발표회
• /
• pp.108-109
• /
• 2002

Optical tweezers는 광압(radiation pressure)을 사용하여 입자들을 포획하거나 조절할 수 있다는 점에서 마이크로스케일의 유전체구뿐만 아니라 세포에서도 널리 사용되고 있다. 일반적으로 빛이라는 것은 광자들의 집합체로서 광자의 입자성으로 인하여 외부의 물체와 충돌시 운동량을 전달하게 되고 이것을 광압(radiation pressure)이라고 하며 optical tweezers [1]는 이 광압을 이용한 방법중 하나이다. 레이저빔을 입자에 집속 시켜 주게 되면 입자는 광압에 의해서 gradient force와 scattering force의 힘을 받게 된다. (중략)

• 한국광학회지
• /
• 제11권4호
• /
• pp.221-226
• /
• 2000

MOT에 포획된 원자 구름의 분포가 포획광의 편광, 어긋난 정렬에 따라 구형, 막대형, 고리형, 가운데 구를 포함한 고리형, 구-구형, 구-고리형 등으로 다양하게 변하는 것을 관측하였다. 이는 포획광의 어긋난 정렬 등에 의한 좌표의존 비대칭 광압(Coordinate-dependent asymmetry radiation force ; CDARF)으로 설명할 수 있었다. 루비듐-87 원자의 S1/2(F=2), P3/2(F=3)준위에 축퇴된 제만 부준위에 대하여 제만 주파수 이동, 자기장과 포획광 방향에 따른 전이 확률, 편광에 따른 전이 확률, 레이저광의 편광, 레이저 광의 공간 분포 등을 고려하여 가능한 정확한 운동방정식을 세우고, 이를 풀어 다양한 형태의 원자구름 분포를 설명하였다.

• 한국가시화정보학회지
• /
• 제20권3호
• /
• pp.19-26
• /
• 2022

In droplet microfluidics, precise droplet manipulation is required in numerous applications. This study presents ultrasonic surface acoustic wave (USAW)-based microfluidic device for label-free droplet separation based on size. The proposed device is composed of a slanted-finger interdigital transducer on a piezoelectric substrate and a polydimethylsiloxane microchannel placed on the substrate. The microchannel is aligned in the cross-type configuration where the USAWs propagate in a perpendicular direction to the flow in the microchannel. When droplets are exposed to an acoustic field, they experience the USAW-induced acoustic radiation force (ARF), whose magnitude varies depending on the droplet size. We modeled the USAW-induced ARF based on ray acoustics and conducted a series of experiments to separate different-sized droplets. We found that the experimental results were in good agreement with the theoretical estimation. We believe that the proposed method will serve as a promising tool for size-based droplet separation in a label-free manner.

• 한국가시화정보학회지
• /
• 제21권3호
• /
• pp.93-100
• /
• 2023

The yeast Saccharomyces cerevisiae (S. cerevisiae) is considered an ideal eukaryotic model and has long been recognized for its pivotal role in numerous industrial production processes. Depending on the cell cycle phases, microenvironment, and species, S. cerevisiae varies in shape and has different sizes of each shape such as singlets, doublets, and clusters. Obtaining high-purity populations of uniformly shaped S. cerevisiae cells is crucial in fundamental biological research and industrial operations. In this study, we propose an acoustofluidic method for separating S. cerevisiae cells based on their size using surface acoustic wave (SAW)-induced acoustic radiation force (ARF). The SAW-induced ARF increased with cell diameter, which enabled a successful size-based separation of S. cerevisiae cells using an acoustofluidics device. We anticipate that the proposed acoustofluidics approach for yeast cell separation will provide new opportunities in industrial applications.

• 해양환경안전학회:학술대회논문집
• /
• 해양환경안전학회 2003년도 추계학술발표회
• /
• pp.149-153
• /
• 2003

The hydrodynamic forces acting on the submerged plate are composed of diffraction and radiation forces. Thus we have carried out the extensive experiments and numerical simulations to make clear the characteristics of the diffraction and radiation forces on the submerged plate. These experimental results are compared with the numerical ones, and we discuss the effect of nonlinear on the hydrodynamic forces acting on the submerged plate. As a result, we get the conclusion that the submerged plate is useful for reducing the wave exciting forces on the structure behind the submerged plate.