• Journal of the Earthquake Engineering Society of Korea
• /
• v.12 no.5
• /
• pp.47-56
• /
• 2008

This study was performed to evaluate the effect of Response modification factors (R-factor) in 3-, 9- and 20- story steel Moment Resisting Frame (MRF) buildings. Each structure was designed using a R-factor of 8, as tabulated in the 2000 International Building Code provision (IBC 2000) and Korea Building Code (KBC) 2008. In order to evaluate the maximum and minimum performance expected for such structures, an upper bound and lower bound design were adopted for each model. Next, each analytical model was designed using different R-factors (8, 9, 10, 11, 12) and four different structural periods with the original fundamental period. For a detailed case study, a total of 150 analytical models were subjected to 20 ground motions representing a hazard level with a 2% probability of being exceeded in 50 years. In order to evaluate the performance of the structures, static push-over and non-linear time history analysis (NTHA) were performed, and displacement ductility demand was investigated to consider the ductility capacity of the structures. The results show that the dynamic behaviors for the 3- and 9-story buildings are relatively stable and conservative, while the 20-story buildings show a large displacement ductility demand due to dynamic instability factors. (e.g. P-delta effect and high mode effect)

• Tunnel and Underground Space
• /
• v.20 no.6
• /
• pp.475-490
• /
• 2010

The analysis of slope stability was performed from seven sites among total eleven sites of waste rock which are divided into two objects (mullock-pile and rock mass) according to the location of dumping-dropping point in L limestone Mine. The analysis of circular failure using Bishop's simplified method and the finite element method for mullock-pile slopes were adopted. For rock mass slopes, identification of failure modes on stereonet projection was determined, thereby limit equilibrium analysis was applied to obtain the safety factor of slopes and the finite element method was used to understand overall behavior of slope. Phi-c reduction method was used to calculate the safety factor of slopes through the finite element method. In mullock-pile slope of zone D and rock slopes of zone F and G, the assurance of slope stability was difficult, and the plans to assure the stability of slopes were proposed on the basis of the analysis of slopes at disposal sites of waste rock. Therefore, the method of piling with waste rock by dozer pushing after dumping for mullock-pile slope of zone D is required, and the method of piling after moving to the place which has no fault zone for rock slope of zone F and G is recommended.

• Culinary science and hospitality research
• /
• v.19 no.4
• /
• pp.193-210
• /
• 2013

The purpose of this study is to understand the influence of entrepreneurial motivation upon entrepreneurial intentions of college students majoring in foodservice through the pull and push factors of the motivation theory, analyzing the moderating effects by gender. Based on total 317 college students, this study was conducted with exploring factor analysis, reliability analysis, correlation analysis, regression analysis, and hierarchical moderated regression. The results showed that, among the pull factors, need for achievement (p<0.001) and self-actualization (p<0.01) had a significant positive influence on entrepreneurial intentions. It appears that entrepreneurial intentions of college students majoring in foodservice were developed by positive entrepreneurial motivation. The moderating effects by gender were not significant. Through the study results with theoretical suggestions, this study proposed a policy to encourage entrepreneurial activation and desires in college students. Limitations and further research directions are also discussed.

• Journal of Broadcast Engineering
• /
• v.17 no.5
• /
• pp.789-807
• /
• 2012

The purpose of this paper is to find various disparity factors in conjunction with situations and contexts of the contents that cause viewer's discomfort, which is to make a content production guideline for viewer's safety, eventually. As a methodology, we extract the experimental data by letting various viewers push a pre-defined key as long as they feel discomfort during watching stereo 3D contents. For each contents, we extract the disparities and disparity changes for the focal point, vicinity of the focal point (ROI, region of interest), and the whole image. For each contents, each point or part of contents is analyzed to find the factors causing discomfort with the two prepared data with watching the contents in 3D. Then, all the analyzed data are re-analyzed to find the strength of each factor. The results from the analyses are explained from the factors having relatively high strength first. It includes the factors that are not known as well as the ones that we can already guess.

• Journal of International Academy of Physical Therapy Research
• /
• v.2 no.1
• /
• pp.214-221
• /
• 2011

The purpose of this study is to investigate and reveal the effects that the complex exercise training consisting of aerobic exercise and strength training(sit up, push up) that everyone can easily practice regardless of a time and a place in order to manage practically the physical strength of the aged affects the difference on their body composition and the change of physical fitness level. Looking into the change of body composition of an experimental group, the weight of 2.5kg was reduced after applying complex training for 12 weeks and the body fat mass of 2.65kg was reduced. Also, the abdominal fat of 0.13% was decreased and the muscle mass of 1.56kg was increased. For the change factors of physical fitness, cardiovascular endurance, muscular strength, muscular endurance, balance and flexibility excluding agility showed significant improvement after applying complex exercise training. The improvement of health fitness of the aged under this study was significantly effective to improve specified body functions which had been lowered by aging and insufficient physical activities. So, it is regarded that their health fitness is the important factor to improve the activity competence required for daily life and to lead healthy living by the improved activity competence. Henceforth, it needs to study more the complex composition of several sports, exercise intensity and the frequency based on the previous researches and studies. In addition, it needs to develop the complex exercise training in accordance with various characteristics such as a sex of the aged, an age, a physical fitness level, environment, a disease and the program in consideration of the efficacy and safety during training.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.6 no.3
• /
• pp.1-10
• /
• 2002

A series of unreinforced masonry(URM) walls were analytically investigated by FEM for a limited version of seismic in-plane performance. For this, URM walls were assumed to be continum and modeled as isotropic plane stress elements, within which the nature of cracking was propogated. Accordingly, behavioral mode of cracking in URM was modeled by smeared-crack approach. Total of 70 cases were considered for various parameters such as axial load ratio, aspect ratio and effective section area ratio due to the existence of opening, etc. The analysis results indicate that these parameters significantly and interactively influence over the ultimate strength of URM walls. Finally, it is suggested that the response modification factor for URM adopted in the current Korean Standard should be validated considering various forms of brittleness and probable failure modes in URM.

• Proceedings of the Korean Society for Emotion and Sensibility Conference
• /
• 2000.11a
• /
• pp.91-97
• /
• 2000

The conventional model did not take momentum conservation into consideration when the electron absorbs and emits the photons. II-ray provides momentum conservations on any directions of the entering photons, and also the electrons have radial momentum conservations and fully elastic bouncing between two atoms, in the new atom model. Conventional atom model must be criticized on the following four points. (1) Natural motions between positive and negative entities are not circular motions but linear going and returning ones, for examples sexual motion, tidal motion, day and night etc. Because the radius of hydrogen atom's electron orbit is the order of 10$^{-11}$ m and the radia of the nucleons in the nucleus are the order of 10$^{-l4}$m and then the converging n-gamma rays to the nucleus have so great circular momentum, the electron can not have a circular motion. We can say without doubt that any elementary mass particle can have only linear motion because of the n-rays' hindrances, near the nucleus. (2) Potential energy generation was neglected when electron changes its orbit from outer one to inner one. The h v is the kinetic energy of the photo-electron. The total energy difference between orbits comprises kinetic and potential energies. (3) The structure of the space must be taken into consideration because the properties of the electron do not change during the transition from outer orbit to inner one even though it produces photon. (4) Total energy conservation law applies to the energy flow between mind and matter because we daily experiences a interconnection between mind and body. An understanding of the mechanisms responsible for the control of normal proliferation and differentiation of the various cell types which make up the human body will undoubtedly allow a greater insight into the abnormal growth of cells, A large body of biochemical evidence was eventually used to generate a receptor model with an external ligand binding domain linked through a single trans-membrane domain to the cytoplasmic tyrosine kinase and autophosphory-lation domains. The ligand induced conformational change in the external domain generates either a push-pull or rotational signal which is transduced from the outside to the inside of cell.l.ell.

• Journal of IKEEE
• /
• v.24 no.1
• /
• pp.260-268
• /
• 2020

This paper presents the high frequency resonant inverter of class D SEPP(Single-Ended Push Pull) type using LS-ZVS-LSTC, which can reduce the switching losses during the turn-on and turn-off switching time. The analysis of high frequency resonant inverter using LS-ZVS-LSTC(Low-loss Turn-off Snubber Capacitor) proposed in this paper is described in general by adopting the normalized parameters. The operating characteristics of the proposed high frequency resonant inverter were also evaluated by using the control parameters such as the normalized control frequency(μ), the normalized load time constant(τ), the coupling factor(κ) and so on. Based on the characteristic values through the characteristics of evaluation, an example of the design method of the 1.8[kW] class D SEPP type high frequency inverter is suggested, and the validity of the theoretical analysis is verified using the experimental data.

• Journal of Korean Society of Rural Planning
• /
• v.26 no.2
• /
• pp.39-49
• /
• 2020

This study was attempted to grasp the push-pull factors of urban to rural migrants in relation to services and infrastructure of rural welfare and culture. Online and offline survey were conducted for urban residents who were willing to return to the rural area and those who were already returning to the rural area. In the fields of health care, social welfare, and education, it was found that the satisfaction level of urban-to-rural migrants was relatively higher than those of latent urban-to-rural migrants. In the field of culture, leisure and sports, the level of satisfaction and concern were similar, so it was found that the expectations for the field were relatively high before returning rural area. As for the agreement degree to expand support, the demand for emergency medical facilities and dementia care program was the highest, and the demand for health care was found to be relatively high. The results of the survey on the top priority items indicate that latent urban-to-rural migrants require support of facility and space item and expansion of program item, and urban-to-rural migrants have high demand for expansion of program item in all field except healthcare field. The results of this study are expected to provide useful information for establishing the direction of the rural area development project in connection with the revitalization of policy of people return to rural area.

• Journal of Drive and Control
• /
• v.14 no.4
• /
• pp.1-8
• /
• 2017

The Down-the-Hole hammer is one of the pneumatic drill equipment used for grinding, drilling, and mining. One the advantages of which is that a reduction work efficiency at deep site are relatively small compared to other drilling methods. Due to the large vibration in the underground area, it is difficult to measure the performance of the hammer, and hammer testing requires substantial production cost and operating expenses so research on the development of the hammer is insufficient. Therefore, this study has developed a dynamic simulation model that apprehends the operating principles of an 8-inch DTH hammer and calculates performance data such as performance impact force, piston speed, and BPM. By using the simulation model, design factors related to strike force and BPM were selected, and the influence of each design factors on performance was analyzed through ANOVA analysis. As a result, be the most important for BPM and the strike force are position of upper port that push the piston in the direction of the bit and in BPM, the size of the empty space between the bits and the piston is the second most important design factor.