• Wind and Structures
• /
• v.22 no.6
• /
• pp.663-684
• /
• 2016

Conical vortices generated at the corner regions of large-span flat roofs have been investigated by using the Particle Image Velocimetry (PIV) technique. Mean and instantaneous vector fields for velocity, vorticity, and streamlines were measured at three visual planes and for two different flow angles of $15^{\circ}$. The results indicated that conical vortices occur when the wind is not perpendicular to the front edge. The location of the leading edge corresponding to the negative peak vorticity and maximum turbulent kinetic energy was found at the center of the conical vortex. The wind pressure reaches the maximum near the leading edge roof corner, and a triangle of severe suctions zone appears downstream. The mean pressure in uniform flow is greater than that under turbulent flow condition, while a significant increase in the fluctuating wind pressure occurs in turbulent streams. From its emergence to stability, the shape of the vortex cross-section is nearly elliptical, with increasing area. The angle that forms between the vortex axis and the leading edge is much smaller in turbulent streams. The detailed flow structures and characteristics obtained through FLUENT simulation are in agreement with the experimental results. The three dimensional (3-D) structure of the conical vortices is clearly observed from the comprehensive arrangement of several visual planes, and the inner link was established between the vortex evolution process, vortex core position and pressure distribution.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.12 no.1
• /
• pp.114-121
• /
• 2004

Frictional heating in brakes causes thermoelastic distortion of the contacting bodies and hence affects the contact pressure distribution. The resulting thermo-mechanical coupling can cause thermoelastic instability (TEI) if the sliding speed is sufficiently high, leading to non-uniform heating called hot spots and low frequency vibration known as hot judder. The vibration of brakes to the known phenomenon of frictionally-excited thermoelastic instability is estimated studying the interface temperature and pressure evolution with time. A simple model has been considered where a layer with half-thickness$\alpha$slides with speed V between two half-planes which are rigid and non-conducting. The advantage of this properlysimple model permits us to deduce analytically the critical conditions for the onset of instability, which is the relation between the critical speed and the growth rate of the interface temperature and pressure. Symmetrical component of pressure and temperature distribution at the layer interfaces can be more unstable than antisymmetrical component. As the thickness $\alpha$ reduces, the system becomes more apt to thermoelastic instability. For perturbations with wave number smaller than the critical$m_{cr}$ the temperature increases with m vice versa for perturbations with wave number larges than $m_{cr}$ , the temperature decreases with m.

• The Bulletin of The Korean Astronomical Society
• /
• v.43 no.2
• /
• pp.33.1-33.1
• /
• 2018

Ram pressure stripping by intracluster medium (ICM) can play a crucial role in galaxy evolution in the high-density environment as seen by many examples of cluster galaxies. Although much progress has been made by direct numerical simulations of galaxies (or a galaxy) as a whole in a cluster environment, the interstellar medium (ISM) in galactic disks is not well resolved to understand responses of the ISM in details. In order to overcome this, we utilize the TIGRESS simulation suite that focuses on a local region of galactic disks and resolves key physical processes in the ISM with uniformly high resolution. In this talk, we present the results from the solar neighborhood TIGRESS model facing the ICM winds with a range of ram pressures. When ram pressure is weaker than and comparable to the ISM weight, the ICM winds simply reshape the ISM to the one-sided disk, but star formation rates remain unchanged. Although there exist low-density channels in the multiphase ISM that allow the ICM winds to penetrate through, the ISM turbulence quickly closes the channels and prevents efficient stripping. When ram pressure is stronger than the ISM weight, a significant amount of the ISM can be stripped away rapidly, and star formation is quickly quenched. While the low-density gas is stripped rapidly, star formation still occurs in the extraplanar dense ISM (1-2kpc away from the stellar disk). Finally, we quantify the momentum transfer from the ICM to the ISM using the mass-and momentum-weighted velocity distribution functions of each gas phase.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.1515-1518
• /
• 2009

Hydrophobic treatments were conducted for different kinds of substrates, glass substrate, silicon wafer and plastic substrate. Ar-$CH_4$ gas mixture was used as a discharge gas for the hydrophobic treatment. The change of the contact angle before and after treatment was measured and compared. Time evolution of the contact angle change after hydrophobic treatment was investigated.

• Applied Biological Chemistry
• /
• v.19 no.4
• /
• pp.202-218
• /
• 1976

In this experiment American Summer Pairman apple was selected as test fruit in order to study the effect of sub-atmospheric pressure storage in the apple. keeping a certain pressure condition, a new sub-atmospheric pressure system was designed and constructed in which fruits were stored at $25^{\circ}C$ under two different atmospheric pressure conditions such as Normal Atmospheric Pressure (NAP) and Sub-Atmospheric Pressure (SAP). Moreover, they were divided into plots of 5% and 0% of $CO_2$, on the basis of gas composition. Under these conditions, the amount of respiration and ethylene evolution, and the changes of intercellular gas composition and organic components were investigated throughout the storage. The results obtained are as follows: (1) The intercellular gas was exhausted so rapidly by the SAP treatment that the gas equilibrium in the tissues reached within 5 minutes. (2) The amount of respiration was found to be higher in plots of NAP than SAP, and under the conditions, controlling $CO_2$ content, plots of $CO_2$ 5% were lower in the amount of respiration than $CO_2$ 0%. The climateric rise was revealed more slowly in plots of the SAP than NAP. These results indicate that the SAP treatment was an efficient method for controlling the respiration of fruits. Furthermore, these results were also realized with the results of the respiratory quotient (R.Q) and intercellular gas composition. (3) Evolution of ethylene, the ripening hormone in plant, was shown the similar tendency to the climacteric pattern of respiration; at the stage of climacteric maximum, the maximun amount of ethylene was found earlier in plots of NAP than SAP, and post climacteric stage was prolonged in the plots of the SAP compared to those of the NAP. The ethylene concentration in tissue appeared lower in plots of the SAP than NAP, which might suggest that the SAP treatment was caused to restriction of ethylene evolution. (4) Effects of the SAP treatment mentioned hitherto were proved also with the test of the external appearance such as changes of color and freshness, firmness, rotting and weight loss. (5) In the investigation of organic components, vitamin C and organic acids varied less in plots of SAP than NAP. Specially, it was remarkable that the loss of malic acid was least decreased by the SAP treatment. These effects of the SAP treatment were distinctive in the changes of the ratios of malic and citric acid to total acid, and the ratios of free sugar to free acid.

• Geomechanics and Engineering
• /
• v.7 no.5
• /
• pp.569-587
• /
• 2014

Triaxial compression creep tests were performed on salt rock samples using cyclic confining pressure with a static axial pressure. The test results show that, up to a certain time, changes in the confining pressure have little influence on creep properties of salt rock, and the axial creep curve is smooth. After this point, the axial creep curve clearly fluctuates with the confining pressure, and is approximately a straight line both when the confining pressure decreases and when it increases within one cycle period. The slope of these lines differs: it is greater when the confining pressure decreases than when it increases. In accordance with rheology model theory, axial creep equations were deduced for Maxwell and Kelvin models under cyclic loading. These were combined to establish an axial creep equation for the Burgers model. We supposed that damage evolution follows an exponential law during creep process and replaced the apparent stress in creep equation for the Burgers model with the effective stress, the axial creep damage equation for the Burgers model was obtained. The model suitability was verified using creep test results for salt rock. The fitting curves are in excellent agreement with the test curves, so the proposed model can well reflect the creep behavior of salt rock under low-frequency cyclic loading. In particular, it reflects the fluctuations in creep deformation and creep rate as the confining pressure increasing and decreasing under different cycle periods.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.9 no.6
• /
• pp.500-505
• /
• 2004

The present study was to investigate the purification of a fermentation broth by an electromicrofiltration membrane. Microfiltration runs with a crude and a centrifuged broth, with solution of particles recovered from centrifugation and with permeates from microfiltration experiments were thus compared. Microfiltration performances were governed by colloids and small particles that induced sharp initial flux declines. For these results, the evolution of the overall membrane resistance was increased by $80\%$ in comparison with the electromicrofiltration membrane. The main focus of this study was set on the enhancement of the filtrate flux by an electric field. This pressure electrofiltration leads to a drastic improvement of the filtration by $100\%$ and the filtration time was thereby reduced. Pressure electrofiltration serves as an inter­esting alternative to the cross-flow filtration and it effectively separates advantageous constitu­ents such as amino acids and biopolymers from a fermentation broth. They were equally main­tained during the microelectrofiltration, although they were significantly reduced by $45\%$ by the microfiltration without the application of an electric field. Accordingly, since the electrofiltration membrane was provided more permeability, this study experimentally demonstrates that the permeability inside a membrane can be controlled using an electric field.

• Journal of Photoscience
• /
• v.9 no.2
• /
• pp.82-85
• /
• 2002

33kDa extrinsic protein, an important protein in oxygenic photosynthesis, was known to have no fixed configuration in solution. At 20$\^{C}$ and pH 6, 33kDa extrinsic protein showed changes of free energy of -14.6 kJ/mor$\^$-1/ and of standard volume of -120mL/mol, respectively, with increase of hydrostatic pressure, comparatively lower than for most proteins. NBS modification of Trp241 in 33kDa extrinsic protein dramatically changes the secondary protein structure, its affinity to photosystem II as well as photosynthetic oxygen evolution. The relationship between structural change and transport of oxygen, water and proton is deserved a further study.

• Korean Journal of Mathematics
• /
• v.21 no.2
• /
• pp.125-150
• /
• 2013

The stabilized Gauge-Uzawa method (SGUM), which is a second order projection type algorithm to solve the time-dependent Navier-Stokes equations, has been newly constructed in 2013 Pyo's paper. The accuracy of SGUM has been proved only for time discrete scheme in the same paper, but it is crucial to study for fully discrete scheme, because the numerical errors depend on discretizations for both space and time, and because discrete spaces between velocity and pressure can not be chosen arbitrary. In this paper, we find out properties of the fully discrete SGUM and estimate its errors and stability to solve the evolution Navier-Stokes equations. The main difficulty in this estimation arises from losing some cancellation laws due to failing divergence free condition of the discrete velocity function. This result will be extended to Boussinesq equations in the continuous research (part II) and is essential in the study of part II.

• Wind and Structures
• /
• v.13 no.2
• /
• pp.191-206
• /
• 2010

Windborne debris is a major cause of structural damage during severe windstorms and hurricanes owing to its direct impact on building envelopes as well as to the 'chain reaction' failure mechanism it induces by interacting with wind pressure damage. Estimation of debris risk is an important component in evaluating wind damage risk to residential developments. A debris risk model developed by the authors enables one to analytically aggregate damage threats to a building from different types of debris originating from neighboring buildings. This model is extended herein to a general debris risk analysis methodology that is then incorporated into a vulnerability model accounting for the temporal evolution of the interaction between pressure damage and debris damage during storm passage. The current paper (Part I) introduces the debris risk analysis methodology, establishing the mathematical modeling framework. Stochastic models are proposed to estimate the probability distributions of debris trajectory parameters used in the method. It is shown that model statistics can be estimated from available information from wind-tunnel experiments and post-damage surveys. The incorporation of the methodology into vulnerability modeling is described in Part II.