• 한국세라믹학회지
• /
• 제25권4호
• /
• pp.364-372
• /
• 1988

The mechanical properties and microstructure of ceramics of the system Al2O3-ZrO2-Y2O3 sintered at 1$650^{\circ}C$ for 2h after powder preparation by the precipitation method from Al2(SO4)3.18H2O, ZrOCl2.8H2O and YCl3.6H2O were investigated. The Al2O3-ZrO2-Y2O3 ceramics sintered at 1$650^{\circ}C$ for 2h after mixing alpha-Al2O3 and ZrO2-Y2O3 powders, both were separately precipitated and calcined, were found to have the relative density higher than 97.5% so that the strengthening and toughening mechanisms could be explained mainly as the stress-induced phase transformation. On the other hand, the sintered bodies prepared by co-precipitating the three starting materials were measured to have the relative density lower than 85% so that the degradation of strength were observed above 15 vol% ZrO2 contents due to the high porosity by which the effect of stress-induced phase transformation was assumed to be depressed.

• Bulletin of the Korean Chemical Society
• /
• 제16권12호
• /
• pp.1148-1152
• /
• 1995

Oxidative dimerization of methane to C2-hydrocarbons was performed over lead aluminate spinel catalysts. These spinel catalysts were prepared by co-precipitation, aerogel, and sol-gel methods. The active phase of lead aluminate oxides was found to be PbAl2O4 spinel. The activities of the catalysts were strongly dependent on the preparation method as well as the composition of PbAl2O4 phase. The proper oxygen mobility of PbAl2O4 spinel oxides appeared to be important to get high catalytic activity and selectivity for C2-hydrocarbon formation.

• 자원리싸이클링
• /
• 제2권2호
• /
• pp.1-8
• /
• 1993

부선법에 의하여 폐수속에 함유되어 있는 철이온을 제거하기 위한 몇가지 효과적인 포수제와 최적 조건들을 알아본 실험의 결과를 요약하면 다음과 같다. 음이온 포수제인 sodium lauryl sulfate에 의해서 2가와 3가 철은 각각 pH 7과 6에서 효과적으로 제거되었다. 음이온 호수제인 aeropromotor 845에 의해서 2가와 3가철은 모두 pH pH 10~11영역에서, 3가철은 pH4~10영역에서 효과적으로 제거되었따. 따라서, 2가와 3가철은 2가와 3가 철이온침전점 이상으로 단순히 용액의 pH값을 조절하여 수산화철 침전으로 만든 다음 부선법에 의하여 효과적으로 제거된다고 할 수 있다. 그때의 효과적은 pH 조절제는 NaOH와 $Na_2CO_3$였고, 효과적인 포수제는 aeropromotor 845와 trimetyl dodecyl ammomum chloride 이었다.

• Nuclear Engineering and Technology
• /
• 제34권1호
• /
• pp.1-8
• /
• 2002

After kaolin clay was artificially contaminated with Co$^{2+}$ ion, the remediation characteristics were analyzed by the electrokinetic method. Ethanoic buffer was injected in the soil column and $CH_3$COOH was continuously inputted to the cathode reservoir to restrain the pH increase. Since the pH of the cathode side of the soil column was 4.0 initially and increased to only 6.5 after remediation for 43.6 hours, precipitate, Co(OH)$_2$, was not formed in the column. The effluent rate increased with the passage of time and Co$^{2+}$ removal in the column at the initial time were mainly controlled by ion migration. 13.1% of the total amount of Co$^{2+}$ in the soil column was removed in 10 hours, 46.8% of the total Co$^{2+}$ in 20.8 hours, 71.7% of the total Co$^{2+}$ in 30.1 hours, and 94.6% of the total Co$^{2+}$ in 43.6 hours. Meanwhile, residual concentrations in the column calculated by the developed model were similar to those by experiment. experiment.

• 한국결정성장학회지
• /
• 제33권5호
• /
• pp.167-173
• /
• 2023

출발원료인 바나듐 산화물을 이용한 Li₃V₂(PO₄)₃를 제조하기 위해 N₂H₄·H₂O를 환원제로 사용하였고 낮은 전기 전도성을 개선하기 위하여 알긴산을 탄소원으로 사용하여 직접 공침법을 통해 단사정계 Li₃V₂(PO₄)₃/C 복합체의 양극 활물질을 합성하여 전기화학 특성을 비교하였다. 구형에 가까운 형상으로 대략 1~2 ㎛의 균일한 입자 크기와 좁은 입도분포를 가지는 Li₃V₂(PO₄)₃을 얻을 수 있었다. 또한 제조한 Li₃V₂(PO₄)₃/C 복합체의 양극 활물질은 Li₃V₂(PO₄)₃ 보다 초기 방전용량의 개선과 안정적으로 용량을 유지하는 사이클 특성이 우수하여 탄소 복합체 형성으로 인해 양극 활물질의 전기화학적 성능이 향상하는 것을 알 수 있었다.

• 환경위생공학
• /
• 제9권2호
• /
• pp.1-7
• /
• 1994

Rainwater was collected in Seoul area from January 1991 to December 1993 (over 3years) and by the analysis of the chemical components contained in rainwater, investigated the components that effect on rainwater pH Through the above studies the following conclusions were obtained. 1) Method for Averaging pH Volume weighted method is considered to be acceptable providing that precipitation is measured at the same time when the samples are taken, without precipitation data a simple averaging method should be the next choice. 2) Annual average rainwater pH was 4.98 in 1991, 4.80 in 1992, 4.67 in 1993, measurement range was 3.6-8.1. 3) In the relationship between rainwater pH and rainfall amounts rainwater pH for light rain(<15mm rainfall) was existent in the wide range(pH 4-7), but for heavy rain was corresponded to the annual average values. 4) Annual frequency of pH was Birrndat the frequency($\gamma $) between the density of the [$H^{+}$] and pH in the rainwater(over 3years ), $NO_{3}^{-}$ was excellent and the obtained results was 0.62 in 1992. Also In the correlation coefficient($\gamma $) according to the pH range $SO_{4}^{2-}, NO_{3}^{-}$, were 0.85 ,0.68 at 3.6 $Cl^-$ was 0.99(1993). At 4.1$NO_{3}^{-}(\gamma=0.48)$ in 1992, SO_4^{2-}($\gamma$=0.54), $NO_{3}^{-}(\gamma$=0.72), $Cl^- (\gamma$=0.49) in 1993. 6) pH values gradually increased with increase in $Ca^{2+}/SO_{4}^{2-}$.

• 한국세라믹학회지
• /
• 제27권4호
• /
• pp.465-472
• /
• 1990

The effects of Al2O3 and Cr2O3 addition on the mechanical properties and microstructures of Y-TZP ceramics obtained by co-precipitation method of ZrO2＋3m/o Y2O3, following pressureless sintering at 150$0^{\circ}C$ for 2h were investigated. The addition of Al2O3 and Cr2O3 improved the Y-TZP sinterability and the Al2O3 addition showed the better effect on Y-TZP sintering than that of the Cr2O3 addition. The density and microstructure had the better effect on the bending strength of specimen more than stressinduced phase transformation (SIPT) of ZrO2 from tetragonal to monoclinic phase. The hardness of the specimens was found to be depend on the relative density and the fracture toughness of Y-TZP was found to rely on the amount of SIPT. The grian size of Cr2O3-doped Y-TZP was observed to be relatively smaller and had a narrower distribution than that of Al2O3-doped Y-TZP. If decomposition reaction of Cr2O3 can be controlled at high temperatures, it is anticipated that the mechanical properties of Y-TZP can be much improved by the Cr2O3 addition.

• 대한화학회지
• /
• 제25권5호
• /
• pp.318-324
• /
• 1981

일차입자의 크기와 응집상태가 다른 두 종류의 $Fe_2O_3$를 부분침전법과 ball-mill 혼합법으로 BaCO$_3$와 혼합한 $BaCO_3-Fe_2O_3$계의 고체반응에 있어 $Fe_2O_3$분체의 영향을 조사하였다. TG, XRD, SEM 등을 측정에 사용하였으며, X-선 회절분석결과 Ba-ferrite의 생성과정은 다음과 같은 연속적인 2단계로 이루어진다는 것을 알았다. $BaCO_3 + 6Fe_2O_3\;{\longrightarrow}\;BaFe_2O_3 + 5Fe_2O_3 + CO_2{\uparrow}\;BaFe_2O_4 + 5Fe_2O_3 \;{\longrightarrow}\;BaFe_{12}O_{19}$ 또 $Fe_2O_3$원료분체의 응집상태와 혼합방법은 고체반응에 현저한 영향을 미친다는 것을 확인했다.

• 자원리싸이클링
• /
• 제30권6호
• /
• pp.36-42
• /
• 2021

폐리튬이온배터리에 함유된 유가금속을 회수하기 위해 고온에서 용융환원처리한다. 용융환원된 금속상을 염산용액으로 침출한 다음 용매추출과 침전으로 유가금속을 분리한 여과액에는 니켈(II)과 미량의 규소(IV)가 함유되어 있다. 여액으로부터 고순도 니켈화합물을 회수하기 위해 흡착법에 의한 규소(IV)의 분리와 니켈(II)의 선택적 침전에 대해 조사했다. Polyacrylamide는 규소(IV)를 선택적으로 흡착했으나 용액의 점도 역시 증가하여 여과가 어렵다. 침전제로 탄산나트륨을 첨가하면 니켈(II)과 미량의 규소(IV)가 공침되었다. 반면 옥살산나트륨은 상온에서 니켈(II)만을 선택적으로 침전시켜 순도 99.99% 이상의 니켈옥살산염 결정상을 회수할 수 있었다.

• 한국수소및신에너지학회논문집
• /
• 제27권5호
• /
• pp.471-477
• /
• 2016

In this research, the Ir supported $TiO_2$ (P25) catalyst was prepared by precipitation method for oxygen evolution reaction. The $Ir/TiO_2$ catalyst was synthesised by reduction reaction using reducing agent. Physiochemical characterizations of synthesized $Ir/TiO_2$ catalyst was studied by means of SEM, EDS mapping, TEM and XRD. The Electrochemical characterizations were tested by using the technique of CV and LSV by RDE and Potentiostat. Physicochemical properties were characterized with XRD where Iridium metal morphology and Ir(111) and Ir(222) peaks were founded. $Ir0.2Ru0.8O_2$ exhibited higher OER activity than $Ir0.5Ru0.5O_2$ followed by $Ir/TiO_2$ and $IrO_2$.