• 대한전기학회논문지:전력기술부문A
• /
• 제49권6호
• /
• pp.272-279
• /
• 2000

This paper describes a controller design and dynamic performance analysis of UPFC based on 3-level inverters. Major attention is focused on the controller design for both shunt and series inverters, including regulator design for the dc link voltage sharing across the dc capacitors. An energy-based approach was investigated for effectively designing the controller. A detailed UPFC model has been developed with EMTP using 24-pulse 3-level inverters to verify this approach. Simulation results about dynamic performance of UPFC confirm effects for increasing transmission capacity and damping low-frequency oscillation. The developed simulation model would be very effective to analyze the dynamic performance of UPFC.

• 대한전기학회논문지:전력기술부문A
• /
• 제51권10호
• /
• pp.483-494
• /
• 2002

In this thesis an optimal design technique of fuzzy logic controller using the real variable elitist genetic algorithm(RVEGA) as a supplementary control to Static Var Compensator(SVC) in order to damp oscillation in an AC-DC Dower system was proposed. Fuzzy logic controller is designed self-tuning shape of fuzzy rule and fuzzy variable using genetic algorithm based on natural selection and natural genetics. To verify the robustness of the proposed method, considered dynamic response of system by applying a load fluctuation.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 추계학술대회 논문집 학회본부 A
• /
• pp.157-159
• /
• 1999

This paper presented design of an $H_{\infty}$ controller for TCSC to enhance the damping of an inter-area oscillation in KEPCO power system. TCSC location is selected by using eigne sensitivity and frequency response. Nonliner time simulation and eigenvalue analysis show that the proposed TCSC $H_{\infty}$ controller can suppress the inter-area oscillations efficiently with induced reduction model correctly.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 추계학술대회 논문집 학회본부 A
• /
• pp.193-196
• /
• 1999

This paper presents a new systematic contingency selection and screening method for transient stability. The variation of modal synchronizing torque coefficient(MSTC) is computed using eigen-sensitivity analysis of the electromechanical oscillation modes in small signal stability model and contingencies are ranked in decreasing order of the sensitivities of the MSTC(SMSTC). The relevant clusters are identified using the eigenvector or participating factor. The proposed algorithm is tested on the KEPCO system. Ranking obtained by the SMSTC is consistent with the time simulation results by PSS/E.

• Tribology and Lubricants
• /
• 제11권5호
• /
• pp.87-92
• /
• 1995

Lip seals, important components in many hydraulic devices, dissipate energy through friction, resulting in power loss. This study contributes to an understanding of lip seal friction by further exploring the connections between friction behavior, viscoelastic properties of robber and viscous properties of the lubricant. Experiments haven been conducted for short stroke oscillations, where these connections are quite strong. Sliding friction experiments at a variety of pressures, temperatures and oscillation rates (for different seal materials, surface roughnesses and lubricant viscosities) are examined. Speculative explanations are suggested for conditions under which friction maxima and frictional vibrations occur.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2006년도 춘계학술대회논문집
• /
• pp.1034-1039
• /
• 2006

Large-amplitude, combustion-induced oscillations are observed in most systems involving continuous flow, such as aeroengine afterburners, gas boilers and rocket motors. Strong furnace vibration is typically characterized by the presence of well developed standing waves in the furnace, generating high pressure pulsation and causing structural vibration of the furnace walls. 320MW NG boilers have been experienced high vibration frequently since reconstruction works. Excessive furnace vibration was encountered when a burner air rate is suddenly reduced during load zone changed from 270MW to 300MW. An investigation showed that the primary cause of the vibration was induced by combustion low air flow rate. This paper describes phenomenon examination on strong furnace vibration due to the change of boiler operating conditions.

• 천문학회보
• /
• 제36권2호
• /
• pp.149.2-149.2
• /
• 2011

We performed the cross-correlation analysis on energy-dependent light curves of the Z-type source GX 5-1. We observed X-ray delays of a few hundred seconds between hard (16-30 keV) and soft (2-5 keV) X-ray light curves. During these phenomena, the centroid frequency of horizontal branch oscillation (HBO) was found to shift to lower or higher frequency indicating towards the dynamical movement of a Compton cloud or an inner disk front. Both eastern and western approaches were used to unfold the X-ray continuum and systematic changes were observed in soft and hard X-ray spectral components. Simultaneous energy spectral and power density spectral study shows that the production of HBOs is closely related to the Comptonizing region rather than the accretion disk. We discuss the results in the context of re-condensation of coronal material in the inner accretion disk region.

• Journal of Electrical Engineering and information Science
• /
• 제2권4호
• /
• pp.53-58
• /
• 1997

In this paper, the power system stabilizer(PSS) using the sliding mode observer-model following(SMO-MF) with closed-loop feedback (CLF) for single machine system is extended to multimachine system. This a multimachine SMO-MF PSS for unmeasureable plant state variable is obtained by combining the sliding mode-model following(SM-MF) including closed-loop feedback(CLF) with the full-order observer(FOO). And the estimated control input for unmeasurable plant sate variables is derived by Lyapunov's second method to determine a control input that keeps the system stable. Time domain simulation results for the torque angle and for the angular velocity show that the proposed multimachine SMO-MF PSS including CLF for unmeasurable plant sate variables is able to damp out the low frequency oscillation and to achieve asymptotic tracking error between the reference model state at different initial conditions and at step input.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 D
• /
• pp.838-840
• /
• 1997

This presents a design method for fuzzy logic controllers of TCSC using genetic algorithm. Fuzzy logic controllers are applied to damp the dynamic disturbances sum as sudden changes of AC system loads. The dynamic performances of fuzzy logic controllers are compared with those of PI controllers. The simulation results show that dynamic performances of fuzzy controllers have better response than those of PI controllers when the AC system load changes.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2003년도 제14회 정기총회 및 03년 동계학술발표회
• /
• pp.228-229
• /
• 2003

The quasi-phase matching (QPM) technique has dramatically changed the guidelines in developing nonlinear optical materials, which doesn't require birefringence and off-diagonal components for efficient wavelength conversion. Minimum requirement for QPM is the modulation of nonlinearity and ferroelectric materials with low coercive field has become fascinating in periodical poling. Stoichiometric lithium tantalate (SLT) has attractive advantages of low coercive field (∼l .5 KV/mm), high nonlinearity, high optical damage resistance and low thermo-optic coefficients, leading to a large aperture QPM devices for high power operation. (omitted)