• Journal of Photoscience
• /
• v.1 no.1
• /
• pp.31-37
• /
• 1994

Photoirradiation at > 300 nm onto a suspension of platinized TiO$_2$ (TiO$_2$-Pt) particles in an aqueous solution. of N$_{\varepsilon}$-carbamyI-L-lysine (Lys(CONH)$_2$) induced the selective N-cyclization of Lys(CONH$_2$) into almost optically pure L-pipecolinic acid (PCA) under argon atmosphere at ambient temperature. Among various TiO$_2$-Pt catalysts, a P-25 (Degussa) powder platinized via impregnation from chloroplatinic acid followed by hydrogen reduction at 753 K exhibited the highest photocatalytic activity for Lys(CONH$_2$) consumption and L-PCA production. GC-MS analyses of L-PCA obtained photocatalytically from $^{15}$N$\alpha$-Lys(CONH$_2$) revealed the selective formation $^{15}$N-substituted L-PCA. This implies that the mechanism for L-PCA production contains selective cleavage of C$_{\varepsilon}$-N bond and intramolecular alkylation at $\alpha$-amino group. Effect of pH on the rate of this photocatalytic reaction was investigated in detail and compared with the pH-dependent charge distribution in Lys(CONH$_2$) molecule. It is clarified that protonation-deprotonation of $\alpha$-amino group gives marked influence on the rate and selectivity of the photocatalytic reaction. On the basis of these results, it is concluded that the selective production of optically pure L-PCA, especially in an acidic suspension of TiO$_2$-Pt, was attributed to the enhanced protonation of $\alpha$-amino group to prevent undesirable oxidation by photogenerated positive holes and blocking of $\varepsilon$-amino group to yield racemic Schiff base intermediate.

• Analytical Science and Technology
• /
• v.14 no.1
• /
• pp.15-20
• /
• 2001

Photocatalytic $TiO_2$ films were prepared by anodic oxidation at 180 V and their structural difference caused by oxidation conditions was studies. The microstructure of $TiO_2$ films in $H_2SO_4$ and $H_2SO_4/H_2O_2$ solution was mixed type of rutile and anatase. However, the $TiO_2$ layer formed in $H_2SO_4/H_3PO_4$ and $H_2SO_4/H_3PO_4/H_2O_2$ mixture was mostly anatase type. All $TiO_2$ films prepared by anodic oxidation exhibited photocatalytic properties. The photocatalytic degradation of aniline blue was first order reaction with similar rate constants at all oxidative conditions examined in this work.

• Korean Journal of Materials Research
• /
• v.11 no.1
• /
• pp.61-66
• /
• 2001

$TiO_2$films for photocatalytic reaction were synthesized by anodizing process. The photocatalytic efficiencies of anodized $TiO_2$were evaluated by the rate of decomposition of aniline blue. The properties of photocatalysis on anodic $TiO_2$films have been observed, but the efficiencies of photocatalytic reaction depended on the conditions of films formation. The microstructure of the anodic film formed in $H_2SO_4$ solution differed from that of $TiO_2$films formed in $H_2SO_4+H_3PO_4$ solution. It has been shown that the appropriate applied-voltage for anodizing of titanium for photocatalysis was 180V in both aqueous solutions.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2014.11a
• /
• pp.264-265
• /
• 2014

This Paper reports the photocatalytic activity of $g-C_3N_4/NaTaO_3$ hybrid composite photocatalysts synthesized by ball-mill method. The $g-C_3N_4$ and $NaTaO_3$ were individually prepared by Solid state reaction and microwave hydrothermal process, respectively. The $g-C_3N_4/NaTaO_3$ composite showed the enhanced photocatalytic activity for degradation of rhodamine B dye (Rh. B) under simulated solar light irradiation. The results revealed that the band-gap energy absorption edge of hybrid composite samples was shifted to a longer wavelength as compared to $NaTaO_3$ and the 50 wt% $g-C_3N_4/NaTaO_3$ hybrid composite exhibited the highest percentage (99.6 %) of degradation of Rh. B and the highest reaction rate constant ($0.013min^{-1}$) in 4 h which could be attributed to the enhanced absorption of the hybrid composite photocatalyst in the UV-Vis region. Hence, these results suggest that the $g-C_3N_4/NaTaO_3$ hybrid composite exhibits enhanced photocatalytic activity for the degradation of rhodamine B under simulated solar light irradiation in comparison to the commercial $NaTaO_3$.

• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.2896-2900
• /
• 2007

A numerical analysis was carried out to investigate the degradation of Volatile Organic Compounds (VOC) in photocatalytic microreactors with different inner geometries. Two different cases of microreactor were considered, namely, one microreactor has bump on the channel and the other has no bump on the channel. The removal efficiency of VOC has been calculated by the Langmuir-Hinshelwood reaction rate equation that was obtained from the experimental results. From the numerical calculations, it was observed that the conversion ratio of VOC for the microchannel with bump is about 4.5% greater than the microchannel without bump. And the mass transfer characteristics in the microreactor are also shown in numerical results. These results can be used effectively for the photocatalytic numerical analysis.

• Journal of Environmental Science International
• /
• v.12 no.12
• /
• pp.1277-1284
• /
• 2003

The photocatalytic oxidation of Rhodamine B (RhB) was studied using immobilized TiO$_2$ and fluidized bed reactor. Immobilized TiO$_2$ onto GF/C was employed as the photocatalyst and a 30 W germicidal lamp was used as the light source and the reactor volume was 4.8 L. The effects of parameters such as the amounts of photocatalyst, initial concentration, initial pH, air flow rate and anion additives (NO$_3$$\^$-/, SO$_4$$\^$2-/, Cl$\^$-/, CO$_3$$\^$2-/) competing for reaction. The results showed that the optimum dosage of the immobilized TiO$_2$ was 40.0 g/L. Initial removal rate of immobilized TiO$_2$ was expressed Langmuir - Hinshelwood equation.

• Journal of Environmental Science International
• /
• v.17 no.2
• /
• pp.171-176
• /
• 2008

The VOCs have a direct influence on indoor air pollution, and stimulate respiratory organs and eyes in human body. Also, most of VOCs are a carcinogenic substances and causes to SBS (sickness building syndrome). Therefore, this study was progressed in photocatalysis of VOCs using UV/$TiO_2$ which was a benign process environmentally. The experiments were performed to know photodegradation characteristics as crystalline structure of $TiO_2$ which had anatase, rutile and P-25 (anatase : rutile = 70 : 30). The main purpose of this study was to identify photocatalytic characteristics as inlet concentration of reactants, $H_2O$, and residence time.

• Journal of Korean Society for Atmospheric Environment
• /
• v.19 no.1
• /
• pp.85-92
• /
• 2003

A new type of catalytic filers has been developed in this work. A porous photocatalytic filter was prepared by coating the titania (anatase phase) powder onto the woven metal mesh. The coating sol was prepared with unique cera-mic binder, and would assist drying condition and enhance the mechanical strength of the final ceramic filers. As a result of the test for acetone decomposition, it was found to be quite effective for the photocatalytic reaction as good at conventional glass reactors which were coated inside. The present filter type reactor is expected as one of plausible devices for the simultaneous treatment of gas - particulate materials.

• Journal of the Korean Solar Energy Society
• /
• v.21 no.2
• /
• pp.55-67
• /
• 2001

This study contains the photocatalytic degradation of methyl-tert-butyl ether(MTBE), one of water-contaminating substances, into $CO_2$. Herein was investigated factors, kinetics, and reaction pathways related with MTBE degradation. This works is possible to be applied in the field of environmental remediation such as undergroundwater purification with optimized system configuration in the near future.

• Journal of Electrochemical Science and Technology
• /
• v.7 no.1
• /
• pp.1-12
• /
• 2016

The production of oxygen and hydrogen from solar water splitting has been considered to be an ultimate solution for energy and environmental issues, and over the past few years, nano-sized semiconducting metal oxides alone and with graphene have been shown to have great promise for use in photocatalytic water splitting. It is challenging to find ideal materials for photoelectrochemical water splitting, and these have limited commercial applicability due to critical factors, including their physico-chemical properties, the rate of charge-carrier recombination and limited light absorption. This review article discusses these main features, and recent research progress and major factors affect the performance of the water splitting reaction. The mechanism behind these interactions in transition metal oxides and graphene based nano-structured semiconductors upon illumination has been discussed in detail, and such characteristics are relevant to the design of materials with a superior photocatalytic response towards UV and visible light.