• Journal of the Korean Chemical Society
• /
• v.56 no.4
• /
• pp.431-439
• /
• 2012

Dissipative particle dynamics (DPD) was carried out to study the nucleation and crystal growth process of $CeO_2$ nanoparticles in different alcohol aqueous solutions. The results showed that the nucleation and crystal growth process of $CeO_2$ can be classified into three stages: nuclei growth, crystal stabilization and crystal aggregation except the initial induction stage, which could be reproduced by collecting simulation results after different simulation time. Properly selecting the sizes of $CeO_2$ and water bead was crucial in the simulation system. The influence of alcohol type and content in solutions, and precipitation temperature on the particle dimension were investigated in detail and compared with the experimental results. The consistency between simulation results and experimental data verify that the simulation can reproduce the macroscopic particle aggregation process. The effect of solvent on the nucleation and crystal growth of $CeO_2$ nanoparticles are different at three stages and can not be simply described by Derjaguin-Landau-Verwey-Overbeek (DLVO) theory or nucleation thermodynamics theory. Our work demonstrated that DPD methods can be applied to study nanoparticle forming process.

• Journal of Environmental Science International
• /
• v.24 no.2
• /
• pp.237-244
• /
• 2015

This objectives of research are to figure out combustion characteristics with increasing temperature with petrochemical sludge by adding wasted organic matters which are waste electric wire, anthracite coal and sawdust, and to exam heating value and ignition temperature for using refused derived fuels(RDFs). After analyzing TGA/DTG, petrochemical sludge shows a rapid weight reduction by vaporing of inner moisture after $170^{\circ}C$. Gross weight reduction rate, ignition temperature and combustion rates represent 68.6%, $221.9^{\circ}C$ and 54.1%, respectively. In order to assess the validity of the RDFs, the petrochemical sludge by adding wasted organic matters which are waste electric wire, anthracite coal and waste sawdust. The materials are mixed with 7:3(petrochemical sludge : organic matters)(wt%), and it analyzes after below 10% of moisture content. The ignition temperatures and combustion rates of the waste electric wire, anthracite coal and waste sawdust are $410.6^{\circ}C$, $596.1^{\circ}C$ and $284.1^{\circ}C$, and 85.6%, 30.7% and 88.8% respectively. In heating values, petrochemical sludge is 3,600 kcal/kg. And the heating values of mixed sludge (adding 30% of the waste electric wire, anthracite coal and waste sawdust) each increase up to 4,600 kcal/kg, 4,100 kcal/kg and 4,300 kcal/kg. It improves the ignition temperatures and combustion rates by mixing petrochemical sludge and organic matters. It is considered that the production of RDFs is sufficiently possible by using of petrochemical sludge by mixing wasted organic matters.

• Nano
• /
• v.13 no.11
• /
• pp.1850130.1-1850130.12
• /
• 2018

A novel strontium titanate/binary metal sulfide ($SrTiO_3/SnCoS_4$) heterostructure was synthesized by a simple two-step hydrothermal method. The visible-light-driven photocatalytic performance of $SrTiO_3/SnCoS_4$ composites was evaluated in the degradation of methyl orange (MO) under visible light irradiation. The photocatalytic performance of $SrTiO_3/SnCoS_4-5%$ is much higher than that of pure $SrTiO_3$, $SnCoS_4$, $SrTiO_3/SnS_2$ and $SrTiO_3/CoS_2$. The $SrTiO_3/SnCoS_4$ composite material with 5 wt.% of $SnCoS_4$ showed the highest photocatalytic efficiency for MO degradation, and the degradation rate could reach 95% after 140 min irradiation time. The enhanced photocatalytic activity was ascribed to not only the improvement of visible light absorption efficiency, but also the construction of a heterostructure which make it possible to effectively separate photoexcited electrons and holes in the two-phase interface.

• Carbon letters
• /
• v.23
• /
• pp.9-16
• /
• 2017

This paper introduces a nitrogen-doped ordered mesoporous carbon (NOMC) derived from glucosamine with hybrid capacitive behaviors, achieved by successfully combining electrical double-layer capacitance with pseudo-capacitance behaviors. The nitrogen doping content of the fabricated NOMC reached 7.4 at% while its specific surface area ($S_{BET}$) and total pore volume reached $778m^2g^{-1}$ and $1.17cm^3g^{-1}$, respectively. A dual mesoporous structure with small mesopores centered at 3.6 nm and large mesopores centered at 9.9 nm was observed. The specific capacitance of the reported materials reached up to $328Fg^{-1}$, which was 2.1 times higher than that of pristine CMK-3. The capacitance retention rate was found to be higher than 87.9% after 1000 charge/discharge cycles. The supplementary pseudocapacitance as well as the enhanced wettability and conductivity due to the incorporation of nitrogen heteroatoms within the carbon matrixes were found to be responsible for the excellent capacitive performance of the reported NOMC materials.

• Proceedings of the Polymer Society of Korea Conference
• /
• 2006.10a
• /
• pp.141-141
• /
• 2006

Petrochemicals contain a wide variety of monomers and their derivatives which are used in the production of plastics, fibers and synthetic rubber. Until now, petrochemicals have had a dramatic impact on our food, clothing, shelter and leisure because they are the least expensive, most readily available, and can be processed most easily into the end use products. Petrochemical industry, which is known as one of the typical cycle profitability businesses, is now moving downward. In order to overcome the anticipated loss of profit, petrochemical companies are making an effort to offer a value-added upgrading to conventional products. This lecture will discuss a few of issues on the current status and prospect of petrochemical industry.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2002.08a
• /
• pp.924-929
• /
• 2002

We have developed the novel liquid crystal materials with a difluoromethyleneoxy (CF2O) moiety as a linkage group in order to satisfy the diversified various requirements for AM-LCDs. These novel CF2O LC materials have excellent physical properties that are high dielectric anisotropy, low viscosity and wide nematic temperature ranges. Physical properties measurement results that mixtures containing CF2O LC materials have suitable for characteristics for AM-LCDs. The CF2O LC materials are excellent compound for quick response and low driving voltage application.

• Proceedings of the Korean Society of Plant Pathology Conference
• /
• 1999.10a
• /
• pp.42.2-42
• /
• 1999

• Proceedings of the Korean Society of Plant Pathology Conference
• /
• 1999.10a
• /
• pp.43.2-43
• /
• 1999

• Proceedings of the Korean Society of Plant Pathology Conference
• /
• 1999.10a
• /
• pp.43.1-43
• /
• 1999

• Proceedings of the Botanical Society of Korea Conference
• /
• 2001.04a
• /
• pp.15-15
• /
• 2001