• 한국윤활학회:학술대회논문집
• /
• 한국윤활학회 2001년도 제33회 춘계학술대회 개최
• /
• pp.15-21
• /
• 2001

This study assesses the wear process of particle impingement erosion which is a major source of erosion among fluid power components. First, Bitter's theory was modified to simplify engineering calculations. Second, actual experiments were conducted to validate the modified equation. And the effect of concentration and size distribution of impinging particles was tested. Little deviation from the prediction of the modified equation was observed. To develop an analytical approach to the erosion mechanism, further experimental data are required to establish a correlation with other engineering parameters.

• 전기의세계
• /
• 제29권8호
• /
• pp.524-531
• /
• 1980

In order to investigate the effect of inorganic dielectric fine particle mixed in Low Density Polyethylene on the deterioration by treeing, a comparative study for initiation and development of the tree has been carried out between the pure thin film specimen and the same geometrical specimen mixed with a constant weight percent by a defiend particle size of $Al_{2}$O$_{3}$ and SiO$_{2}$, having larger dielectric constants than that of the base material. According to the results, it has been observed that as increasing dielectric constant, the initiation of tree is expedited, however, the development of the tree reached at the surface of filler particles shows the suppressive trends. From these facts, a reasonable interpretation may be possible by considering the effect of intensified electrical field around the tip in the presence of filler particles, that the initiation and the development of tree are a mechanical break down process caused by Maxwell stress due to the concentration of electrical field at the tip. This suppressive effect is specifically suggestive for the reason that a discharge route must be constructed around the particle surface because of the intensified field strength near filler, which, in turn, reduces the geometrical curvature of the tip so that the local intensity of electrical field can be relaxed. Further more an experimental evidence for this assumption was able to observe in this investigation.

• 임산에너지
• /
• 제20권1호
• /
• pp.1-5
• /
• 2001

국내 주요 간벌목과 목질재료 탄화물 중 성능면과 자원면을 고려하여 선정한 수 토양개량시험을 실시하여, 이들 목질폐잔재 탄화물들이 토양개량제로서의 효과와 토양개량과 관련하여 입자크기에 따른 효과에 관하여 조사한 결과는 다음과 같다. 서양측백 파종실험에서 토양에 목탄을 처리한 것이 무처리구보다 좋은 성장을 나타냈으며 그 중 흡착성이 좋은 잣나무탄이 가장 좋은 처리효과를 나타냈다. 칠엽수 이식실험에서도 무처리보다 목탄을 처리한 것이 좋은 길이성장을 보였다. 또한 파종 및 이식실험에서 입자의 크기에 따른 성장량의 차이는 없는 것으로 나타났다. 사과나무 문우병에 의한 뿌리썩음 때문에 쇠약해진 사과나무에 목탄을 시용하여 수세회복의 효과를 얻었다.

• 한국환경과학회지
• /
• 제4권2호
• /
• pp.181-194
• /
• 1995

여러가지 다양한 상수처리 실험조건에서 응집제로 Ferric Nitrate를 사용하여 수증의 카오린 점토입자를 응결하는 과정중의 응집동력학을 조사하기 위하여 본 영구는 수행되었다. 응집동력학을 측정하기 위한 방법으로서 AIA 시스템으로 부터 없어진 입자크기분포와 Rlowing suspension에서의 PDA에 의한 탁도증가 정도의 측정이 사용되었다. 결론으로서, 저온에서의 응집은 그 효율이 상당히 저하 되는것으로 발견 되었으며 저온에서의 응집을 향상시키기 위아여 수중의 pH보다는 pOH를 일정하게 유지하는 것이 부분적으로 응집효율향상에 도움이 되는 것으로 나타났다.

• Carbon letters
• /
• 제13권2호
• /
• pp.130-132
• /
• 2012

In this study, cobalt oxide ($Co_3O_4$)/graphene composites were synthesized through a simple chemical method at various calcination temperatures. We controlled the crystallinity, particle size and morphology of cobalt oxide on graphene materials by changing the annealing temperatures (200, 300, $400^{\circ}C$). The nanostructured $Co_3O_4$/graphene hybrid materials were studied to measure the electrochemical performance through cyclic voltammetry. The $Co_3O_4$/graphene sample obtained at $200^{\circ}C$ showed the highest capacitance of 396 $Fg^{-1}$ at 5 $mVs^{-1}$. The morphological structures of composites were also examined by scanning electron microscopy and transmission electron microscopy (TEM). Annealing $Co_3O_4$/graphene samples in air at different temperatures significantly changed the morphology of the composites. The flower-like cobalt oxides with higher crystallinity and larger particle size were generated on graphene according to the increase of calcination temperature. A TEM analysis of the composites at $200^{\circ}C$ revealed that nanoscale $Co_3O_4$ (~7 nm) particles were deposited on the surface of the graphene. The improved electrochemical performance was attributed to a combination effect of graphene and pseudocapacitive effect of $Co_3O_4$.

• 한국세라믹학회지
• /
• 제37권2호
• /
• pp.152-157
• /
• 2000

Si3N4/SiC nanocomposite ceramics containing 5 wt%dispersed SiC particles were prepared by gas-pressure-sintering at 200$0^{\circ}C$ under nitrogen atmosphere. SiC particles with average sizes of 0.2 and 0.5${\mu}{\textrm}{m}$ were used, and the effect of the SiC particle size on the microstructure was investigated. The addition of SiC particles effectively suppressed the growth of the Si3N4 matrix grains. The effect of grain growth inhibition was higher in the nanocomposites dispersed with fine SiC. SiC particles were dispersed uniformly inside Si3N4 matrix grains and on grain boundaries. When the fine SiC particles were added, large fraction of the SiC particles was trapped inside the grains. On the other hand, when the large SiC particles were added, most of the SiC particles were located on grain boundaries. Typically, the fraction of SiC particles located at grain boundaries was higher in the specimen prepared from $\beta$-Si3N4 than in the specimen prepared from $\alpha$-Si3N4.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2001년도 추계학술대회 논문집
• /
• pp.213-219
• /
• 2001

In this paper, particle velocity of slurry flow, a kind of solid-particle two phase flow, was measured by using a particle tracking velocimetry. Particles are modeled by sphere-shaped glass whose diameters are 3mm, 5mm, and 7mm At first, a particle which is falling in the water is captured and analyzed to give their free falling velocity. The falling velocity was very high up to about 4m/sec in the air, which needs special algorithm for the accurate measurement. For the upwelling slurry flow in the straight duct, there are some noises caused by cavity. However, the effect was so small that it does not affect the measurement of large particles. From the preliminary study of applying the PTV to measurement of particle movement in slurry flow, we could find out the optimum value of parameters: threshold value., searching area radius and correlation area size.

• 한국응용과학기술학회지
• /
• 제21권2호
• /
• pp.132-139
• /
• 2004

Film forming behavior of monodispersed model composite latexes with particle size of 190 nm, which consist of n-butyl acrylate as a soft phase monomer and methyl methacrylate as a hard phase monomer with different morphology was examined. Five different types of model latexes were used in this study such as random copolymer particle, soft-core/hard-shell particle, hard-core/soft-shell particle, gradient type particle, and mixed type particle. The film forming behavior was evaluated using pseudo on-line measurements of the cumulative weight loss, the UV transmittance, and the tensile fracture energy. Each stages of film formation I, II were not sensitive to the morphology of model latexes, but stage-ill was largely dependent on the morphology of model latexes. The chain mobility of polymer which composed the shell component was found to dominantly determine the behavior of film forming stage-III.

• 대기
• /
• 제22권2호
• /
• pp.175-186
• /
• 2012

In this study, we investigate the effects of elliptical shape of Asian dust particles on the estimation of aerosol optical depth by implementing T-matrix method into WRF/Chem Dust Model. The phase function calculated by assuming elliptical particle shape near $110{\sim}160^{\circ}$ of scattering angle showed about 20 times larger than that calculated by assuming spherical particle shape. Significant difference of extinction efficiency was found with an increase of size parameter and aspect ratio. From the simulations of two Asian dust events occurred on 1 April 2007 and 16 March 2010, we found that the difference of extinction efficiency between elliptical and spherical particle shape was about 5~8%. The aerosol optical depth calculated by assuming elliptical particle shape with 1.6, 1.4 and 1.2 of aspect ratio was about $4.0{\pm}0.5%$, $2.0{\pm}0.2%$, and $1.0{\pm}0.1%$ larger than those estimated by assuming spherical particle shape.

• 생물환경조절학회지
• /
• 제12권2호
• /
• pp.77-82
• /
• 2003

본 실험은 토마토 양액재배에서 펄라이트 배지를 순환식 재배방법에 적용하고자 수행되었다. 펄라이트 배지의 입자를 소립(ø1∼2mm 미만), 중립(ø2∼3mm), 대립(ø4∼5 mm)으로 분리하여 양액공급량에 따른 토마토의 생육을 검토한 결과는 아래와 같다. 제 3화방 개화(초기생육)시 초장은 중립과 대립에서는 양액공급량이 많을수록 길었으나 소립에서는 양액공급량에 관계없이 길어 초기에 생육관리는 대립일수록 1일 양액공급량이 많아야 할 것으로 생각되었다. 그러나 제 3화방 개화기 이후는 소립에서는 주당 1일 공급량을 1.5L로, 그리고 중립과 대립에서는 주당 1일 3.0L로 관리하는 것이 착과수가 많고 수량이 높았다 기형과율은 펄라이트 입자의 크기에 관계없이 양액공급량이 많을수록 적었다. 근활력은 정식 후 50일까지는 입자크기 및 양액공급량에 관계없이 증가하였으나, 50일 이후부터는 감소하기 시작하여 정식 후 100일에는 소립에서는 양액공급량이 많을수록, 그리고 중립과 대립에서는 양액공급량이 적을수록 감소하는 경향이 컸다. 소립에서는 앙액공급량이 증가할수록 모든 무기성분함량이 감소하는 경향이었으나 중립과 대립에서는 증가하는 경향이었다 N. K. Ca및 Mg의 함량은 소립에서는 양액공급량이 1일 3.0L/주 처리구에서 가장 적었으나 대립과 중립에서는 1일 3.0L/주 처리구에서 가장 많았다. 이상의 결과에서 토마토 순환식 양액재배시 펄라이트 입자는 중립과 대립의 사용이 유리하고 양액공급량은 주당 1일 3.0L 관리하는 것이 유리하였다.