• ETRI Journal
• /
• 제45권2호
• /
• pp.226-239
• /
• 2023

Challenges in cognitive radio and tactical communications include recognizing anonymously received signals and estimating parameters in a blind or semi-blind manner. In this paper, we examine this issue for orthogonal frequency division multiplexing (OFDM) signaling. There are several parameters in OFDM signaling, and the blind receiver must extract and consider the synchronization issue. We assume that the blind receiver is aware of modulation type, OFDM, and not aware of chip duration and the length of cyclic prefix. First, we present new criteria based on kurtosis to estimate these parameters and compare their performance at different levels of additive white Gaussian noise with methods based on correlation, kurtosis, maximum likelihood, and matched filter. Then, we perform synchronization and estimate the start time based on these criteria and several new criteria in two steps: fine and coarse synchronization. Finally, in a more practical setup, we present the idea of jointly estimating the mentioned parameters and the signal start time as coarse synchronization. We compare different criteria and show that one of the proposed criteria has the highest efficiency.

• 한국음향학회:학술대회논문집
• /
• 한국음향학회 2004년도 추계학술발표대회논문집 제23권 2호
• /
• pp.429-432
• /
• 2004

Nonlinear acoustic responses of water-saturated sediments are very important to understand nonlinear phenomena of gassy ocean sediments. Especially, the second harmonic, the sum and the difference frequency acoustic waves in water-saturated sediments can provide practical criteria to estimate the nonlinear parameter of gassy sediments. In this paper, the difference frequency acoustic wave in water-saturated sandy sediment was observed in a water tank experiment with a pulse transmission technique. Its pressure level was 12 dB higher than the background noise level at a maximum undistorted driving pressure of source acoustic transducer. The experimental results were compared with a theoretical estimation of the parametric acoustic array. The nonlinear parameter of water-saturated sandy sediment was also estimated as 73 with their comparison. This value can be utilized as the background information to estimate gas void fraction in the water-saturated gassy sandy sediment.

• 전기전자학회논문지
• /
• 제22권3호
• /
• pp.558-564
• /
• 2018

In distributed estimation where each node can collect only partial information on the parameter of interest without communication between nodes and quantize it before transmission to a fusion node which conducts estimation of the parameter, we consider a novel quantization technique employed at local nodes. It should be noted that the performance can be greatly improved if each node can transmit its measurement to one designated node (namely, head node) which can quantize its estimate using the total rate available in the system. For this case, the best strategy at the head node would be simply to partition the parameter space using the generalized Lloyd algorithm, producing the global codewords, one of which is closest to the estimate is transmitted to a fusion node. In this paper, we propose an iterative design algorithm that seeks to efficiently assign the codewords into each of quantization partitions at nodes so as to achieve the performance close to that of the system with the head node. We show through extensive experiments that the proposed algorithm offers a performance improvement in rate-distortion perspective as compared with previous novel techniques.

• 한국지반공학회지:지반
• /
• 제12권2호
• /
• pp.43-58
• /
• 1996

지하구조물에 대한 설계 및 시공기술의 많은 발전에도 불구하고 아직도 상당부분 그간의 경험에 의존하며, 또한 많은 불확정성 요소들을 내포하고 있다. 그 중 가장 대표되는 것이 지반계수로서, 이를 설계단계에서 정확히 산정하는 데는 많은 어려움이 따른다. 본 논문의 주된 목적은 지하공간의 설계와 시공을 유기적으로 연결할 수 있는 지반공학적 접근의 일환으로 최적의 지반계수를 산정하는 데 있다. 이를 위하여 초기예측치와 계측치로부터 예측된 간을 합리적으로 조합할 수 있는 Extended Bayesian Method(EBM)을 적용하였으며, 이를 유한요소해석으로부터 구할 수 있도록 하였다. 또한 부산 지하철 현장과 캐나다의 Darlington취수터널에 대한 예제해석을 수행하여 제안된 방법의 효용성을 검증하였다.

• 대한전자공학회논문지TE
• /
• 제37권1호
• /
• pp.79-88
• /
• 2000

유발뇌파의 감성지수파라미터를 뇌파의 지속시간과 크기로 설정하고 감성지표화하려는 뇌파에 Prony모델을 적용하여 감성의 지속시간과 크기를 추정하였다. Prony모델을 적용하여 유발뇌파를 실험분석한 결과 대역별특성을 분석할 수 있었고, 감성평가지수 파라미터인 감성지속시간과 크기를 추정함으로써 안타까움, 분노 및 공포의 감성을 감성평가지수로 분류할 수 있었으며, 추정된 파라미터가 감성평가지수로서 적합함을 확인하였다.

• 국제학술발표논문집
• /
• The 5th International Conference on Construction Engineering and Project Management
• /
• pp.475-478
• /
• 2013

To carry out a one-off construction project successfully, effective and accurate early cost estimation is crucial, especially during the conceptual stage where very limited minimum information of construction project is given. As the level of accuracy of the early cost estimation has huge impacts on precise budgeting and cost management of a project, in other words, reducing the risk of a project, cost must be managed with special awareness. In an effort to improve the estimate accuracy of cost during the conceptual stage, this research introduces a Parameter Impact (PI) which can quantify weights of parameters and rank them; and PI development derived from the principle of impulse in physics is explicated. For a case study, 76 public apartment building cases in Korea are analyzed. To examine the validity of the proposed PI, a validation in terms of CBR applicability test and estimate accuracy comparisons using 10-nearest neighbor cases are carried out. The validation results support that the suggested PI can be applied in quantifying the weights of the parameters and CBR method for early cost estimation.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 D
• /
• pp.2216-2218
• /
• 2002

A system identification is to measure the output in the presence of a adequate input for the controlled system and to estimate the mathematical model in the basic of input output data. In the system identification, it is possible to estimate the true parameter values by the adjusted least squares method in the input-output case of no observed noise, and it is possible to estimate the true parameter values by the total least squares method in the input-output case with the observed noise. In recent the adjusted least squares method is suggested as a consistent estimation method in the system identification not with the observed noise input but with the observed noise output. In this paper we have developed the adjusted least squares method from the least squares method and have made certain of the efficiency in comparing the estimating results with the generating data by the computer simulations.

• KIEE International Transaction on Electrical Machinery and Energy Conversion Systems
• /
• 제4B권4호
• /
• pp.206-210
• /
• 2004

This paper deals with a parameter estimation of the DC-DC converter system for its diagnosis. Especially, we present the results of parameter estimation for the DC-DC converter model by the system identification method. The parameter estimation for the DC-DC converter system aims at the diagnosis of its operating status. For the operating status diagnosis of the DC-DC converter system, we assume that the DC-DC converter system is an equivalent model of the Buck converter and estimate the main parameter for on-line diagnosis. In addition, for verification of an estimated parameter, we compare a bode plot of the estimated system transfer function and measurement results of the HP4194 instrument. It is a control system analyzer for system transfer function measurement. Our results confirm that the main parameter for diagnosis of the DC-DC converter system can be estimated by the system identification method and that the aging status of the system can be predicted by these results on operating status.

• 한국건설관리학회논문집
• /
• 제9권6호
• /
• pp.175-184
• /
• 2008

건설 프로젝트의 수익성 및 타당성을 판단하기 위한 기준으로 설계초기단계에 활용되는 개산견적은 설계의사결정 업무와 밀접한 연계성을 가지고 수행되어야 할 뿐만 아니라, 정확하고 신뢰성 있는 견적결과를 도출해야 한다. 설계초기단계에서 설계자의 의사결정 지원과 설계변경에 대한 즉각적인 대처를 위해 프로토타입기반 개산견적 시스템이 개발되었지만, 파라미터에 의해 산정되는 공사항목 및 사용자에 의한 추가공사에 대한 공사비 고려가 미흡하였다. 따라서 본 연구에서는 견적의 정확도를 향상시키기 위해 실제 고층 오피스 빌딩 프로젝트의 실적자료 분석을 통해 기본설계단계에서 오브젝트-파라미터기반 건축마감공사비 산정 모델(Object & Parameter based Schematic Estimation Model, OPSEM)을 개발하였다. 모델 개발을 위해 공사비 내역서, 도면으로부터 얻은 작업항목에 대한 정보를 분석 및 분류하고, 각 작업항목 속성에 맞는 공사비 산정 방식을 제안하였다. 본 연구의 실무 효용성 검증을 위해 유사 사례 프로젝트를 바탕으로 기존의 견적방식과 제시된 모델을 활용한 견적방식의 오차율을 분석하여 정확도 비교를 실시하였다.

• 멤브레인
• /
• 제26권3호
• /
• pp.187-196
• /
• 2016

최근 정삼투(FO) 공정의 성능향상을 위해 유입수에 낮은 수압을 가하는 가압형 정삼투(PAFO) 공정이 관심을 받고 있다. Structure parameter는 FO 및 PAFO 공정 운전시 유도용질의 확산 저항성(Solute resistivity)을 결정하며, 이는 Solution-diffusion model (S-D model)을 통한 수투과 및 염투과 성능 예측을 지배하는 인자 중에 하나이다. 본 연구는 S-D model을 이용하여 가압형 정삼투시 유입수 측에 가해지는 압력에 따른 Structure parameter 변화 양상을 예측하고자 하였다.