• 한국결정성장학회지
• /
• 제9권5호
• /
• pp.521-526
• /
• 1999

산화막 트랩은 스트레스 바이어스 전압에 의해 산화막 계면과 산화막 안에 생성됨을 조사하였다. 이러한 실험은 게이트 면적 1$10^{-3}\textrm{cm}^2$를 갖는 산화막 두께 범위가 113.4$\AA$에서 814$\AA$까지의 산화막 안에서 상대적 트랩 위치를 결정하였다. 트랩은 캐소우드 부근에 음전하, 애노우드 부근에 양전하로 충전되어 있다. 트랩의 전하상태는 스트레스 고전압 인가 후 낮은 전압인가에 의해 쉽게 변화되었다. 고전압 스트레스에 의해 발생된 트랩의 산화막 전하상태는 양 또는 음전하를 포함한다.

• Bulletin of the Korean Chemical Society
• /
• 제30권4호
• /
• pp.817-820
• /
• 2009

To meet the high current load requirement from the high energy density realized by metal oxide and high power density graphite, we propose a novel hybrid supercapacitor consisting of Nb2O5 and KS6 graphite in 1.0 M LiPF6-EC:DEC (1:2). This new system exhibits a sloping voltage profile from 2.7 to 3.5 V during charging and presents a high operating voltage plateau between 1.5 and 3.5 V during discharging. The cell was tested at a current density of 100 mA/g with a cut-off voltage between 3.0 and 1.0 V. This novel energy storage system delivers the highest initial discharge capacity of 55 mAh/g and exhibits a good cycle performance.

• 한국세라믹학회지
• /
• 제52권5호
• /
• pp.325-330
• /
• 2015

Performance of solid oxide fuel cells (SOFCs), in comparison with that under hydrogen fuel, were investigated under direct internal reforming conditions. Anode supported cells were fabricated with an Ni+YSZ anode, YSZ electrolyte, and LSM+YSZ cathode for the present work. Measurements of I-V curves and impedance were conducted with S/C (steam to carbon) ratio of ~ 2 at $800^{\circ}C$. The outlet gas was analyzed using gas chromatography under open circuit condition; the methane conversion rate was calculated and found to be ~ 90% in the case of low flow rate of methane and steam. Power density values were comparable for both cases (hydrogen fuel and internal steam reforming of methane), and in the latter case the cell performance was improved, with a decrease in the flow rate of methane with steam, because of the higher conversion rate. The present work indicates that the short-term performance of SOFCs with conventional Ni+YSZ anodes, in comparison with that under hydrogen fuel, is acceptable under internal reforming condition with the optimized fuel flow rate and S/C ratio.

• 한국세라믹학회지
• /
• 제53권5호
• /
• pp.483-488
• /
• 2016

Anode supported solid oxide fuel cells (SOFCs), consisting of Ni+YSZ anode, YSZ electrolyte, and LSM+YSZ cathode, were fabricated and constant current tested with direct internal reforming of methane (steam to carbon ratio ~ 2) as well as hydrogen fuel at $800^{\circ}C$. The cell, operated under direct internal reforming conditions, showed relatively rapid degradation (~ 1.6 % voltage drop) for 95 h; the cells with hydrogen fuel operated stably for 170 h. Power density and impedance spectra were also measured before and after the tests, and post-test analyses were conducted on the anode parts using SEM / EDS. The results indicate that the performance degradation of the cell operated with internal reforming can be attributed to carbon depositions on the anode, which increase the resistance against anode gas transport and deactivate the Ni catalyst. Thus, the present study shows that direct internal reforming SOFCs cannot be stably operated even under the condition of S/C ratio of ~ 2, probably due to non-uniform mixture (methane and steam) gas flow.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 추계학술대회 논문집
• /
• pp.159-162
• /
• 1999

All solid state thin film micro-batteries consisting of lithium metal anode, an amorphous LiPON electrolyte and cathode of vanadium oxide have been fabricated and characterized, which were fabricated with cell structure of Li/LiPON/V$_2$O$\sub$5/Pt. The vanadium oxide thin films were formed by d.c. reactive sputtering on Pt current collector. After deposition of vanadium oxide films, in-situ growths of lithium phosphorus oxynitride film were conducted by r.f. sputtering of Li$_3$PO$_4$ target in mixture gas of N$_2$ and O$_2$. The pure metal lithium film was deposited by thermal evaporation on thin film LiPON electrolyte. The cell capacity was about 45${\mu}$Ah/$\textrm{cm}^2$ $\mu\textrm{m}$ after 200 cycle. No appreciable degradation of the cell capacity could be observed after 50 cycles .

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 하계학술대회 논문집 Vol.6
• /
• pp.334-335
• /
• 2005

Ternary tellurite glassy systems ($Li_2O-V_2O_5-P_2O_5$) have been synthesised using Vanadium oxide as a network former and Lithium oxide as network modifier. The addition of a metal? oxide makes them electric or mixed electric-ionic conductors, which are of potential interest as cathode' materials for solid-state batteries. This glass-ceramics crystallized from the $Li_2O-V_2O_5-P_2O_5$ system are particularly interesting, because they exhibit high conductivity (up to $5.95\times10^{-4}$ S/cm) at room temperature. the glass samples were prepared by quenching the melt on the copper plate and the glass-ceramics were heat-treated at crystallizing temperature determined from differential thermal analysis (DTA). The electric D.C conductivity result have been analyzed in terms of a small polaron-hopping model.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 하계학술대회 논문집 Vol.5 No.2
• /
• pp.842-844
• /
• 2004

Ternary tellurite glassy systems $(CuO-V_2O_5-TeO_2)$ have been synthesised using tellurium oxide as a network former and copper oxide as network modifier. The addition of a transition-matal oxide makes them electric or mixed electric-ionic conductors, which are of potential interest as cathode materials for solid-state batteries. This glass-ceramics crystallized from the $CuO-V_2O_5-TeO_2$ system are particularly interesting, because they exhibit high conductivity ( up to $6.03{\times}10^{-3}S/cm$) at room temperature. the glass samples were prepared by quenching the melt on the copper plate and the glass-ceramics were heat-treated at crystallizing temperature determined from differential thermal analysis (DTA). The electric D.C conductivity result have been analyzed in terms of a small polaron-hopping model.

• International Journal of Precision Engineering and Manufacturing-Green Technology
• /
• 제5권5호
• /
• pp.637-642
• /
• 2018

The impact of the sintering process, especially in terms of sintering temperature and sintering aid concentration, on the ohmic transport and electrode performance of $(La_{0.80}Sr_{0.20})_{0.95}CoO_{3-{\delta}}$-gadolinia-doped ceria (LSCF-GDC) cathodes is studied. The ohmic and charge-transfer kinetics exhibit a highly coupled $Co_3O_4$ concentration dependency, showing the best performances at an optimum range of 4-5 wt%. This is ascribed to small grain sizes and improved connection between particles. The addition of $Co_3O_4$ was also found to have a dominant impact on charge-transfer kinetics in the LSCF-GDC composite layer and a moderate impact on the electronic transport in the current-collecting LSCF layer. Care should be taken to avoid a formation of excessive thermal stresses between layers when adding $Co_3O_4$.

• 전기화학회지
• /
• 제1권1호
• /
• pp.1-7
• /
• 1998

중간온도$(700\~800^{\circ}C)$형 고체산화물 연료전지(solid oxide filet cells)의 양극재료로 이용을 목표로 $Gd_{0.8}Ca_{0.2}Co_{1-x}Fe_xO_3,\;(x=0.0\~0.5)$ 분말을 합성하고 이의 열적 안정성, 전도특성을 조사하였다. 또한 이를 CGO(Cerium-Gadolinium Oxide) 전해질 디스크에 부착하여 양극특성을 조사하였다. 양극재료를 구연산 법에 의하여 $800^{\circ}C$에서 하소하여 분말을 합성하였을 때, Fe의 함량에 상관없이 모두 페롭스카이트 단일상을 얻을 수 있었다. 합성분말의 열적 안정성을 측정하였는데, Fe의 함량이 적을수록 열적 안정성이 열악하여 x=0.0인 시료는 $1300^{\circ}C$에서 분해되었다 그러나 Fe이 치환된 재료의 경우에는 $1400^{\circ}C$까지 분해현상은 없었으나 $1300^{\circ}C$ 근처에서 용응되는 현상이 관찰되어 양극층의 접착온도를 $1300^{\circ}C$ 이하로 설정해야 함을 알았다. $Gd_{0.8}Ca_{0.2}Co_{1-x}Fe_xO_3,\;(x=0.0\~0.5)$로 반쪽전지를 제작하여 $800^{\circ}C$ 공기중에서 전지를 가동하며 양극의 산소환원 반응에 대한 활성을 조사한 결과 조성에 상관없이 $La_{0.9}Sr_{0.1}MnO_3$보다 우수한 활성을 가졌고, $x=0.0\~0.5$인 전극중에서는 x=0.2일 때 가장 좋은 양극특성을 보였다. 이와 같이 x=0.2인 경우에 가장 우수한 활성을 갖는 이유를, Fe의 함량이 많은 경우는 열적 안정성이 우수하나산소환원 반응에 대한 활성은 감소하므로 x=0.2에서 열적 안정성과 활성 사이에 최적의 trade-off가 나타남으로 설명하였다. x=0.2인 시료의 전기 전도도를 직류 4단자법에 의하여 측정하였을 때 $800^{\circ}C$에서 51 S/cm의 값을 나타내었고, 교류 2단자법으로 측정한 이온 전도도는$800^{\circ}C$에서 $6.0\times10^{-4}S/cm$의 값을 나타내었다. 즉 이 물질은 혼합 전도체로서 전극의 전 표면이 반응의 활성점으로 작용할 가능성이 있고, 이로부터 이들이 $La_{0.9}Sr_{0.1}MnO_3$보다 우수한 양극활성을 갖는 이유를 설명할 수 있었다.

• 전기화학회지
• /
• 제4권4호
• /
• pp.139-145
• /
• 2001

본 연구에서는 리튬전지내 양극 재료로서 리튬철계 산화물을 제조하여 전극재료의 다양한 조성에 따른 전기화학적 특성을 고찰하고자 하였다 출발 물질인 $FeCl_3-6H_2O,\; NaOH,\;LiOH$를 혼합하여 저온으로 가열하여 층상의 $LiFeO_2$를 합성하였으며 출발 물질의 조성비를 바꾸어 그 영향을 조사하였다. 그 결과 NaOH의 첨가량이 증가할수록 전극의 용량은 감소하나 효율 및 용량의 감소율은 작아짐을 알 수 있었다. $NaOH/FeCl_3/LiOH$의 중량비를 2/1/7로 조성하여 합성하였을 때 가장 큰 용량을 보였으나 효율은 30회 순환 후 급격히 감소하였다. 층상의 $LiFeO_2$ 양극을 사용한 리튬 전지의 충방전 실험을 수행한 결과 이 셀은 1.5-4.5V의 범위에서 가역적임을 알 수 있었다 CPR방법을 사용하여 1M $LiPF_6/EC/DEC$ 전해질에서 확산계수를 측정하였다. 확산계수는 0.5$10^{-11}cm^2/s$임을 알 수 있었다.