• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2001.10a
• /
• pp.351-354
• /
• 2001

Undrained cyclic triaxial compression tests were performed on Saemangeum dredged sand to evaluate factors affecting liquefaction strength and liquefaction behaviour characteristics. The results of these tests show that cyclic liquefaction can occur not only very loose sand(Relative density is 30%) but also dense sand(Relative density is 70%). To evaluate effect of the over consolidation ratio on the liquefaction strength, a series of undrained cyclic triaxial compression test was peformed, and the result of this test showed that the liquefaction of this test showed that the liquefaction strength of Saemangeum dredged sand approximately increased to square root of over consolidation ratio in the range of O.C.R value of 1.0 to 4.0. In the anisotropically consolidated sample tests, the liquefaction strength is increased by increasing the effective consolidation ratio.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.3
• /
• pp.33-38
• /
• 2003

Marine sediment capping is a technique where clean sand is placed over contaminated sediment to reduce the migration of contaminants to the environment. The design of in-situ caps placed over marine sediment must take into consideration the self-weight consolidation of the cap and the consolidation of the sediment as a result of adding the cap layer. Centrifuge tests were adopted to simulate the effects of consolidation settlement of capped marine sediment caused by the placement of a clean sand layer. The modeling of models technique was utilized to verify the correct modeling procedures used in this study. Two centrifuge tests were conducted with the same boundary conditions at different gravitational accelerations of 100 g and 50 g. There was good agreement between these tests. It can be concluded that the centrifuge experiment is able to model consolidation settlement of capped marine sediment.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.4
• /
• pp.77-87
• /
• 2011

To investigate the effect of drainage spacing and smear on the rate of consolidation and the efficiency of vertical drain method, a series of consolidation tests with a large consolidation chamber and special equipment for inserting mandrels were conducted. As the smeared region increases, total settlement in over-consolidated clay increases whereas apparent change in settlement does not appear in normally consolidated clay. Vertical drain generally accelerates the rate of consolidation, while it could also deteriorate the efficiency of vertical drain method even for the decreasing drainage length and spacing ratio.

• The Journal of Engineering Geology
• /
• v.12 no.4
• /
• pp.459-469
• /
• 2002

We have remolded marine clay sample collected along the vertical and horizontal directions and investigated the characteristics of the consolidation constants by SCT and CRSC methods. We have studied also on consolidation chracteristics and application for weathered granite soil using SCT and CRSC methods for undisturbed and disturbed samples. As the result, values of pre-consolidation stress, compression index, excessive pore pressure, pore water pressure ratio of the marine-clay were different due to different test methods(SCT and CRSC) and sampling directions(vortical and horizontal directions). Disturbed and undisturbed samples of the weathered granite soil have showed similar change aspect like marine clay during over-consolidatied and normally consolidatied stages.

• Journal of Navigation and Port Research
• /
• v.36 no.3
• /
• pp.181-187
• /
• 2012

Highly plastic clays in their normally consolidated states are not always linear but are concave downwards. Thus their compression index deceases with the increase of consolidation pressure. The $e-{\log}{\sigma}_{\upsilon}{\prime}$ curves of plastic or non-plastic silty clays are not linear but are convex upwards. In this paper, consolidation tests were conducted with several undisturbed field soils of Korea south coast and their $e-{\log}{\sigma}_{\upsilon}{\prime}$ plots are not always linear. In case of using Butterfield's method(liquid limit 50~100%), ${\ln}{\upsilon}-{\ln}{\sigma}_{\upsilon}{\prime}$ plots are linear. But some undisturbed samples which have void ratio over 2.24, liquid limit over 100% and plasticity index over 60% are not linear. In results of consolidation tests with remolded samples which contain silt(fly ash) contents of 90% has compression index increasing with the increase in consolidation pressure.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.5
• /
• pp.89-98
• /
• 2003

A 5∼12m thick tideland has been created in front of a new sea-dyke due to the rapid sedimentation occurring for 22 years. It is confirmed from theoretical analysis and soil tests that the deposit is in under-consolidation state. An analysis shows that when the average sedimentation rate is over 1-5cm/year for a soil with $c_v$=0.0005-0.001$cm^2$/s, excess pore water pressure exists in the deposit. It is known that the lower sedimentation rate than average in the initial deposition stage results in lower dissipation of excess pore pressure and vice versa. It is emphasized that under-consolidation behavior should be taken account in settlement analysis because structures founded on such deposits give higher settlements.

• Journal of the Korean Geotechnical Society
• /
• v.16 no.2
• /
• pp.115-123
• /
• 2000

Piezocone Penetration Test has been performed in the soft ground over the site preparation area at Inchon International Airport(IIA). With the pore pressure dissipation test results, the changes in the permeability and the coefficient of consolidation in clayey soil were checked and the differences of the undrained shear stength verified the soft ground improvement effect from vane test and piezocone test both before and after the improvement. From the results, thin sand seam was found and this caused a big difference in the coefficient of permeability and consolidation. The coefficient of consolidation was high in the upper marine deposit and relatively low in lower marine deposit. It was found that the reduction of void ratio by preloading resulted in the reduction of coefficient of consolidation after the ground improvement. In addition, there were some variations of undrained shear strength when the number of 15 or 18 was used as the coefficient of piezocone(Nkt). However, when the average value of undrained shear strength calculated using Nkt=10 was applied, the result indicated the similar average value with the result of vane test and the increasing rate of strength( Δsu/Δ$\sigma$≒0.38) also showed the similar distribution.

• Geomechanics and Engineering
• /
• v.25 no.2
• /
• pp.159-170
• /
• 2021

Particle size of tailings in different areas of dams varies due to sedimentation and separation. Saturated hydraulic conductivity of high-stacked talings materials are seriously affected by void ratio and particle breakage. Conjoined consolidation permeability tests were carried out using a self-developed high-stress permeability and consolidation apparatus. The hydraulic conductivity decreases nonlinearly with the increase of consolidation pressure. The seepage pattern of coarse-particle tailings is channel flow, and the seepage pattern of fine-particle tailings is scattered flow. The change rate of hydraulic conductivity of tailings with different particle sizes under high consolidation pressure tends to be identical. A hydraulic conductivity hysteresis is found in coarse-particle tailings. The hydraulic conductivity hysteresis is more obvious when the water head is lower. A new hydraulic conductivity-void ratio equation was derived by introducing the concept of effective void ratio and breakage index. The equation integrated the hydraulic conductivity equation with different particle sizes over a wide range of consolidation pressures.

• Geotechnical Engineering
• /
• v.13 no.4
• /
• pp.95-108
• /
• 1997

For normally consolidated clay, several researchers have developed a number of theoretical time factors to determine the coefficient of consolidation However, depending on the assumptions and analytical techniques, it could considerably vary even for a specific degree of consolidation. In this paper, a method is proposed to determine a consistent coefficient of consolidation over all ranges of degree of consolidation by applying the concept of the Optimum Design Technique. The initial excess pore pressure distribution is assumed to be obtainable by the successive spherical cavity expansion theory. The dissipation of pore pressure is simulated by means of two dimensional linear-uncoupled axisymmetric consolidation analysis. The minimization of the differences between the measured and the predicted excess pore pressures was carried by BFGS unconstrained optimum design algorithm with one dimensional golden section search technique. By analyzing numerical and real field examples, it can be found that the adopted optimum technique gives a consistent and convergent results.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2007.09a
• /
• pp.363-372
• /
• 2007

The residual settlement due to difference between predicted and observed settlement is one of the social problems during reclaiming construction in the soft ground having a deep depth such as Busan and Gwangyang province. Prediction error for the secondary compression settlement makes the construction much harder. To examine characteristics of the secondary compression settlement, the secondary compression index is the most important factor. In this study, various empirical methods for determining the secondary compression index are evaluated. And errors applied to the design case practically are also explained. The pre loading method is the only way to reduce the secondary compression settlement and reduction ratio of the secondary compression should be investigated correctly. Hence, research results on the reduction ratio of the secondary compression are analyzed in this paper. Moreover, decrement of the secondary compression index due to over consolidation ratio is examined closely by laboratory consolidation test using clay in the Gwangyang area.