• Bulletin of the Korean Chemical Society
• /
• v.27 no.12
• /
• pp.2058-2060
• /
• 2006

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.6 no.2
• /
• pp.209-221
• /
• 1996

The purpose of this study was to find a suitable cosolvent to $CS_2$ so that desorption efficiency can be improved for both polar and non-polar organic solvent mixtures collected on an activated charcoal tube. Cosolvents added to $CS_2$ include: DMF(N,N-dimethylformamide): $CS_2$ (v/v 1:99), DMF:$CS_2$(v/v 3:97), BC (butyl carbitol, 2-(2-butoxy ethoxy) ethanol):$CS_2$(v/v 1:99), and BC:$CS_2$(v/v 3:97)). The results obtained were as follows : 1. Comparing the desorption efficiency of $CS_2$ with those of $CS_2$ with 1, 3, 5 % DMF and 1, 3 % BC cosolvents for two different groups of charcoal tubes each containing 8 different polar and non-polar organic solvents with 3 different concentration levels, the desorption efficiencies of the cosolvent-added $CS_2$ increased significantly for all polar organic solvents regardless of concentration levels tested. For non-polar organic solvents, no noticeable improvement was detected except xylene and trichloroethylene. The desorption efficiency of xylene increased significantly while that of trichloroethylene increased significantly at the lowest concentration level tested. 2. Either 5 % DMF or 3 % BC was the most suitable cosolvent because the desorption efficiency for non-polar organic solvent mixtures was similar or slightly improved compared with that of $CS_2$, while those of for polar organic solvent mixtures were above 75 % except for cyclohexanone. 3. The smallest variations in desorption efficiency represented by the ratio calculated from the maximum to minimum desorption efficiency for all concentration levels tested were found when 3 % BC was used as a cosolvent. The above results indicate that the desorption efficiency of $CS_2$ particularly for polar organic solvent mixtures collected on a charcoal tube can be significantly improved by the use of cosolvents such as 5 % DMF or 3 % BC. A caution, however, is in order for selecting a cosolvent whenever the cosolvent itself is being used in the workplace or the impurities contained in the cosolvent may interfere with the analytical results. In addition, to improve desorption efficiencies for such organic solvents as cyclohexanone or ketones, it is recommended to use suitable collection and desorption media other than the traditional method of charcoal tube collection/$CS_2$ desorption.

• Journal of Life Science
• /
• v.21 no.5
• /
• pp.700-705
• /
• 2011

Using enrichment procedures, we isolated organic solvent-tolerant Bacillus sp. BCNU 5005 from waste water and soil in the Ulsan industrial plant region. BCNU 5005 had a maximum similarity of 98% with B. subtilis and was designated as B. subtilis based on phylogenetic analyses using 16S rDNA sequences. Generally, most bacteria and their enzymes are destroyed or inactivated in the presence of high concentrations of organic solvents. However, the lipase activity of B. subtilis BCNU 5005 was very stable in the presence of various kinds of solvents (25%, v/v) except chloroform, ethylbenzene and decane. Furthermore, BCNU 5005 was determined to have a degradative ability towards organic solvents. This organic solvent tolerant Bacillus sp. BCNU 5005 could be used as a new potential resource for biotransformation and bioremediation.

• Journal of Preventive Medicine and Public Health
• /
• v.30 no.1 s.56
• /
• pp.61-67
• /
• 1997

This study was performed to evaluate the effects on hearing of video tape manufacturing workers exposed to organic solvents. The experimental groups included solvents exposed group 51 and unexposed group 57 workers. All workers was examined air and bone conduction sensitivity by pure tone audiometer. The mean age of solvents exposed group was 34.1 and nonexposed group was 35.8. The mean duration of solvents exposed group was 7.3years. High frequency hearing loss prevalence of both groups was 23.5% in the group exposed to organic solvents and 17.5% in nonexposed group. There is no statistical significants in the prevalence of high frequency hearing loss. According to comparison of mean auditory threshold value by frequencies, on the air conduction test, right was statistically significant in the 250, 500, 1000, 2000, 4000Hz, except 8000Hz. Left 250, 500, 1000Hz was statistically significant. On the bone conduction test, left 250, both 500, 1000, 2000, 4000Hz, except right 250Hz, was statistically significant difference. Generally, auditory sensitivity threshold of the exposed group was higher than the nonexposed group.

• Korean Journal of Clinical Laboratory Science
• /
• v.40 no.2
• /
• pp.147-152
• /
• 2008

Due to the development and expansion of industries and medical standards, the number of workers who handle organic solvents within hospitals is increasing. The authors in this study intended to investigate the actual conditions of the handling of the solvents and to encourage the recognition that the exposure to such solvents may be possible because of insensitivity to safety. In order to investigate the actual conditions of exposure of workers within hospitals, the experimental group included the three sections (Pathology department, Central Supply Room, and Operating Room), which handle organic solvents most frequently. Meanwhile, university interns were selected to be the control group. This study was conducted between May 1 to May 30, 2007, and urine was taken as samples. Hippuric acid, mandelic acid, methylhippuric acid, and phenylglyoxylic acid were analyzed through gas chromatography, and a total of 52 subjects of the experimental and the control groups were performed of the analysis. As for the results of the analysis of the experimental group, the exposure to benzene was $42.27{\pm}3.70mg/g$ creatinine, that of xylene was $1.30{\pm}0.18g/g$ creatinine, and that of toluene was $2.36{\pm}0.24g/g$ creatinine. Meanwhile, the results of the analysis of the control group showed that the exposure to benzene was $15.54{\pm}2.85mg/g$ creatinine, that of xylene was $0.52{\pm}0.02g/g$ creatinine, and that of toluene was $0.85{\pm}0.20g/g$ creatinine. The amount of exposure to benzene, xylene, and toluene was shown to be under the maximum permitted level, but as for Pathology department, it was required to educate on working conditions, to educate workers on prevention management about their health, and to install fume hood and exhaust system to improve the environments.

• The Korean Journal of Pesticide Science
• /
• v.20 no.2
• /
• pp.128-132
• /
• 2016

Volatile organic solvents are used to extract the bioactive materials from raw materials for environmentally-friendly farming materials (EFFM), but the solvent should not remain in EFFM for the safety reasons. Thus qualitative and quantitative analysis method for the solvents using Headspace-GC were evaluated. Water content depleted the detection ratio of hydrophilic solvents and disturbing the hydrophilic interaction with solvents by DMSO might be helped to increase the detection ratio (up to 715%). Surfactant concentration affected to the detection ratio (68.5-179.1%) while surfactant type was not deeply involved the solvent detection. On the other hand, matrix-matched calibration method was accepted the minimum requirements for the quantitative analysis of the solvents in EFFM.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.05a
• /
• pp.300-303
• /
• 1999

For the fast dry of the aqueous tape, the process which water was replaced by organic solvent was proposed. So-called, it was the solvent washing dry, Three organic solvents (methanol, ethanol, and acetone) were selected for the washing solvent. The weight loss of the washed tapes was measured to evaluate the dry rate of the tapes and dried tapes were examined the generation of the cracks with the variations of the organic solvent and the washing time. Methanol, ethanol, and acetone were all available organic solvents for this method. The tapes washed in methanol, ethanol, and acetone were dried rapidly for twenty minutes. After thirty minutes, the weight losses were not any more. The solvent of the lower surface tension can decreases the crack of dried tape. If solvent substitutes water completely, though it was fast dried, crack can be eliminated. The tape casting system was designed for the solvent washing dry and prepared. An homogeneous tape was established by continuous tape casting process.

• Journal of Preventive Medicine and Public Health
• /
• v.28 no.2 s.50
• /
• pp.386-397
• /
• 1995

A cross sectional study was performed to evaluate the neurobehavioral effects of chronic exposure of complex organic solvents, using NCTB(Neurobehavioral Core Test Battery) recommended by WHO(World Health Organization). Forty female shoe factory workers and twenty-two controls matched with age were participated. The tests were performed in the morning before start of work, to exclude the effects of acute exposure. Workers were exposed mainly to toluene, methyl ethyl ketone, n-hexane, cyclo-hexane, dichloroethylene, trichloroethylene, benzene, xylenes etc. The ranges of present solvent exposure of hygienic effect were $0.46\sim0.71$ in the process using adhesives indirectly, and $1.83\sim2.39$ in the process using it directly. We reclassified the subjects, according to cumulative exposure. It showed significantly poorer performances in high exposed group on Santa Ana Dexterity and Benton Visual Retention, compared with control group. After controlling confounder, the significances were still remained. But, further cohort studies, having the information of personal exposure dose from entering a factory, are required to clarify the effects of chronic exposure of complex organic solvents in relation to dose and duration of exposure.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.7 no.2
• /
• pp.279-288
• /
• 1997

The penetrating speeds of organic solvents into the nude mouse skin were measured by in vitro methods(diffusion cell methods) and in vivo methods(measuring internal residues of the organic solvents). The results were as follows: 1. The penetrating speeds of toluene, m-xylene, MEK, MIBK, ethanol, IPA and 2-bromopropane into the skin were $0.4832mg/cm^2/h$, $0.1738mg/cm^2/h$, $1.124mg/cm^2/h$, $0.6627mg/cm^2/h$, $1.747mg/cm^2/h$, $1.359mg/cm^2/h$, and 2-bromopropane $4.165mg/cm^2/h$ respectively. 2. The penetrating speeds of the mixtures of two, toluene and m-xylene, the mixture of three, IPA, ethyl acetate, and MIBK, the mixture of five, toluene, m-xylene, IPA, ethyl acetate, and MIBK were $0.172mg/cm^2/h$, $1.431mg/cm^2/h$, and $2.983mg/cm^2/h$ respectively. 3. The absorption speeds of 2-bromopropane and styrene which were measured by in vivo processes were $3.12mg/cm^2/h$ and $1.44mg/cm^2/h$ respectively. The absorption speed of 2-bromopropane mesured in vivo was 74.9% of that measured by in vitro methods, $4.165mg/cm^2/h$.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.15 no.1
• /
• pp.27-35
• /
• 2005

This study was carried out to evaluate the characteristics of petroleum refinery workers' exposure to organic solvents. Exposure assessment was conducted by full shift-based long term personal sampling(TWA-P) and task-based short term personal sampling(STEL-P) strategy. Major organic solvents that workers can be exposed are various, varying from C3~C12, and this study focused on 11 kinds including benzene, considering toxicity and concentration level. In comparison with two sampling results, STEL-P shows a significant(p<0.001) excess of exposure level rather than TWA-P. As the potential risk index for benzene is calculated as 16, benzene should be set the highest priority for control in petroleum refinery industry. The tasks with the highest benzene exposure level were de-watering(AM;99.8 ppm), draining(AM;19.6ppm), sampling(AM;16.2ppm), and manual gauging(AM;15.02ppm). Petroleum refinery workers' exposure pattern to organic solvents differs by tasks performed, and some task has a high risk of temporary extreme exposure. Therefore, traditional 8-hour TWA sampling strategy have possibility of underestimation of exposure level of workers in petroleum refinery.