• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.4A
• /
• pp.369-379
• /
• 2011

During the routing process between nodes on the CR(Cognitive Radio) network conducting for efficient use of limited frequency resources, spectrum handover process due to the appearance of the PU occupies most of the routing latency, and also decreases the reliability of the path. In this paper, a cooperative routing protocol in a multi-channel environment is proposed. The source node broadcasts a message with available channel lists and probability of PU appearance during its route guidance. The intermediate nodes re-transmit the message, received from the source node, and update and maintain the information, status table of the path. The destination node determines the optimal path and sends a reply message to the selected path after it receives the messages from the intermediate nodes. The average probability of the PU appearance and the average time of the PU appearance are updated while transferring data. During data transmission the channel with the lowest probability of appearance of the PU is selected dynamically and if a PU appears on the current channel partial repairment is performed. It is examined that reliability of the selected path considerably is improved and the routing cost is reduced significantly compared to traditional routing methods.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.6C
• /
• pp.495-505
• /
• 2010

In this paper, the effect of Near-Far Problem (NFP) among distributed nodes in OFDMA-based Wireless Mesh Networks (WMNs) is analyzed by investigating statistical characteristics of Time Difference of Arrival (TDoA) and Desired-to-Undesired power Ratio (DUR). In order to overcome the effects of Inter-Symbol Interference (ISI), Inter-Carrier Interference (ICI), and Inter Link Interference (ILI), caused by TDoA in WMNs, we derive effective SINR for each subcarrier, and then, propose the optimal starting point of FFT window which can minimize BER for each subcarrier. In addition, we propose a subcarrier-based Zero Forcing - 2 Dimensional Ordered Successive Interference Cancellation (ZF-2DOSIC) technique for signal detection in WMNs with TDoA. It is verified by simulation that the effective SINR and uncoded BER performances of the proposed signal detection technique for OFDMA-based WMNs are significantly improved, compared with those of conventional technique.

• Korean Journal of Weed Science
• /
• v.17 no.4
• /
• pp.390-399
• /
• 1997

This experiment was conducted to introduce PAT (phosphinothricin acetyltransferase, non-selective herbicide bialaphos resistant gene) gene into potato (Solanum tuberosum. cv. Desiree). Optimal shoot regeneration from leaf discs and stem segments was obtained in MS medium supplemented with 0.1 mg/L IBA and 0.5 mg/L BA, and the frequency of shoot regeneration was 54% in left discs and 46% in stem segments. In this condition, leaf discs and stem segments of potato were co-cultivated with A. tumefaciens MP90 which contained binary vector with GUS: :NPTII gene and PAT gene. Transgenic shoots were regenerated from leaf and stem-derived calli on selection medium with 100mg/L kanamycin. The 100${\mu}M$ acetosyringone treatment during the co-cultivation highly enhanced(4 times than the control) the shoot regeneration on selection medium. When the putative transgenic plants were transferred to medium with 10mg/L basta, all of them were survived. After PCR. GUS test, and Southern blot analysis of the survived plant, we confirmed that the gene was stably integrated into the potato genome and expressed. After the transgenic plants were transplanted in soil, and the transgenic plants were sprayed with the herbicide basta (300ml/10a), the transgenic plants remained green but control plants were died.

• Korean Journal of Microbiology
• /
• v.39 no.3
• /
• pp.128-134
• /
• 2003

Transformation-associated recombination (TAR) cloning is based on co-penetration into yeast spheroplasts of genomic DNA along with TAR vector DNA that contains 5'- and 3'-sequences (hooks) specific for a gene of interest, followed by recombination between the vector and the human genomic DNA to establish a circular YAC. Typically, the frequency of recombinant insert capture is 0.01-1% for single-copy genes by TAR cloning. To further refine the TAR cloning technology, we determined the effect of GC content on target hooks required for gene isolation utilizing the $Tg\cdot\AC$ mouse transgene as the targeted region. For this purpose, a set of vectors containing a B1 repeated hook and Tg AC-specific hooks of variable GC content (from 18 to 45%) was constructed and checked for efficiency of transgene isolation by radial TAR cloning. Efficiency of cloning decreased approximately 2-fold when the TAR vector contained a hook with a GC content ～${\leq}23$% versus ～40%. Thus, the optimal GC content of hook sequences required for gene isolation by TAR is approximately 40%. We also analyzed how the distribution of high GC content (65%) within the hook affects gene capture, but no dramatic differences for gene capturing were observed.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.8
• /
• pp.1107-1113
• /
• 2018

Ultrasonography and photodynamic therapy have been proposed as useful tools as a treatment for inducing necrosis of cells using reactive oxygen species. Apoptosis is an internal mechanism necessary for cells regardless of damage. Ultrasound has the effect of inducing the apoptosis of these cells, and the frequency of 1 MHz is the most applicable area for medical use. The laser which is generally used in photodynamic therapy has a heat reaction and the treatment is limited. However, as a small light emitting diode is developed, it shows possibility to minimize the equipment and reduce heat reaction. On the other hand, there are relatively few researches on direct effects of light compared with studies using photosensitizers, and the area is also limited. Therefore, in this paper, we have developed a cancer cell proliferation control module using ultrasonic and light emitting diodes, which have relatively few side effects, and quantitatively analyze the effect of the module to propose an optimal suppression technique.

• Food Science and Preservation
• /
• v.10 no.4
• /
• pp.454-458
• /
• 2003

This study was conducted to enhance the quality and peach (Yumyung) by ozone treatment. The ozone concentration and treatment time in soaking of peach were 0.1, 0.3 and 0.5 ppm and 30 min respectively. Fruit brix degree, titratable acidity, hardness, colors values, and rotten rate were determined in ripening grade Yumyung peach and when fruits were placed at ambient temperuture(25$^{\circ}C$) during 20 days. No great difference occured between control group and all ozone treatment samples in the changes of brix degree, titratable acidity, hardness and color values at my sampling period. However, the rotten rate of ozone-treated peach stored at 25$^{\circ}C$ was lower than that of control sample. The orders of rotten rate in peaches stored for 15 days at 25$^{\circ}C$ were control products > 0.1ppm ozone-treated > 0.3ppm ozone-treated) 0.5ppm ozone-treated. Therefore, optimal renditions of Yumyung peach stored by ozone treatment at ambient temperature during 20 days were ozone concentration of 0.5ppm, treatment time of 30min, and ozone treatment frequency of four times.

• Journal of the Korean Magnetics Society
• /
• v.9 no.2
• /
• pp.111-120
• /
• 1999

The effects of annealing in rotating magnetic field after deposition on electromagnetic properties of $Co_{82}Zr_6Mo_{12}$ thin (200~1200 $\AA$) films prepared by RF-magnetron sputtering were investigated in terms of microstructure and surface morphology. The coercivity decreases, but $4{\pi}M_5$ does not change with increasing the film thickness. The coercivity of the films was decreased below 300 $^{\circ}C$ due to stress relief and decreasing the surface roughness, while increased at 400 $^{\circ}C$ due to partial grain growth. And then, $4{\rho}M_5$ was almost independent of annealing temperatures below 200 $^{\circ}C$, but increased from 7.4 kG to 8.0 kG at 300 $^{\circ}C$ and at 400 $^{\circ}C$, which was caused by precipitation and growth of fine Co particles in the films. The electrical resistivity of films was decreased with increasing annealing temperatures and the magnetoresistance was a negative value of nearly 0 $\mu$$\Omega$cm. After annealing at 300 $^{\circ}C$, maximum effective permeability was 1200 to the hard axis of the thin films according to high frequency change. Considering the practical application of biasing layers of the films for magnetoresistive heads, optimal annealing conditions was obtained after one hour annealing at 300 $^{\circ}C$ in 400 Oe rotating magnetic field.

• Research in Community and Public Health Nursing
• /
• v.6 no.2
• /
• pp.319-334
• /
• 1995

To investigate the risk factors of low back pain, an epidemiological study was carried out among male workers aged 20-55 employed in an automobile industry in Korea during the time period from February 1993 to October 1995. Workers participated to this study were divided into low back pain group(LBP) and control group, according to the self-reports by written questionnaires. General characteristics, medical history, work related factors, fatigue, and MMPI were compared between two groups. To clarify the relationship between job related low back pain and radiologic features of lumbar spine, radiographic study was carried out. The resultant data were processed for $x^2-test$, t-test, and stepwise logistic regression to confirm the adjusted odds ratios. The results were as follows: 1. History of back disease, lifting and carrying work, excessive physical fatigue, and weakend back strength of individual workers were directly associated with low back pain. Odd ratios of these 4 risk factors of low back pain were 5.07, 3.34, 1.49, and 1.22 respectively. 2. The frequency of low back pain history was significantly higher in LBP group. 3. Back muscle strength of lumbar spine of LBP group were significantly lower than control group. 4. The workers in LBP group revealed high fatigue symptoms. 5. In MMPI test LBP group showed higher scales in hypochondriasis, depression, hysteria, psychopathic deviate, paranoia, psychasthenia, schizophrenia, and hypomania. 6. LBP group were more frequently involved in lifting and carrying, working in awkward position, bending, twisting and using lower extremities. 7. LBP group were exposed more to vibration during working. 8. In the Analysis of radiographs of lumbar spine, Jacob's line not crossing fourth lumhar disc space, transitional vertebrae and lumbar displacement more than 4.4mm in standing lateral view were more frequently observed in LBP group than control group. Through these results, it is concluded that identification of previous history of back problem, change of work or working environment for workers with previous back problem and measures to relieve both physical and psychological fatigue of the workers are required for optimal management of work-related back problems among workers. In the present study, several results were different from the previous reports: Jacob's line not corssing fourth lumbar disc space, lumbarization, and vertebral slipping (spondylolisthesis) more than 4.4mm are related to backache. Meticulous studies are required to elucidate the difference.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.12
• /
• pp.1327-1336
• /
• 2012

In this paper, the dual-faced monopole antenna, which is arranged by numerous rectangular ring patches in sequence for the multi-bands is proposed. The ring type structure of the patch can be increased the bandwidth. Therefore the bandwidth and beam width are improved by using multiple arrayed patches. When the ring type patches are inserted serially, the resonance frequencies are occurred by the current flow from the first ring patch. It is possible because the gap between the patches is very narrow. In addition, if the patches are composed on the same plane as the feed-line, fabrication could be very difficult because the gap between the patches is extremely narrow. The thickness and permittivity of the antenna, moreover, are very important parameters because both sides of the substrate are used. We finally found the optimal thickness and permittivity to generate the coupling effect by simulation. All patches are consisted of 4-steps which the patch size was decreased 85 % by each step. In conclusion, the resonant frequency bands are 1.75~2.6 GHz(850 MHz), 3.24~3.46 GHz(220 MHz), 3.8~4.0 GHz(200 MHz), and 4.4~4.9 GHz(500 MHz).

• Journal of the Korean Institute of Intelligent Systems
• /
• v.20 no.2
• /
• pp.165-172
• /
• 2010

In clinical data minig, choosing the optimal subset of features is such important, not only to reduce the computational complexity but also to improve the usefulness of the model constructed from the given data. Moreover the threshold values (i.e., cut-off points) of selected features are used in a clinical decision criteria of experts for differential diagnosis of diseases. In this paper, we propose a fuzzy discretization approach, which is evaluated by measuring the degree of separation of redundant attribute values in overlapping region, based on spatial distribution of data with continuous attributes. The weighted average of the redundant attribute values is then used to determine the threshold value for each feature and rough set theory is utilized to select a subset of relevant features from the overall features. To verify the validity of the proposed method, we compared experimental results, which applied to classification problem using 668 patients with a chief complaint of dyspnea, based on three discretization methods (i.e., equal-width, equal-frequency, and entropy-based) and proposed discretization method. From the experimental results, we confirm that the discretization methods with fuzzy partition give better results in two evaluation measures, average classification accuracy and G-mean, than those with hard partition.