• Journal of ILASS-Korea
• /
• v.8 no.1
• /
• pp.9-15
• /
• 2003

The liquid phase LPG injection (LPLI) system is considered as one of the next generation fuel supply systems for LPG, vehicles, since it can accomplish the higher power, higher efficiency, and lower emission characteristics than the existing mixer type fuel supply system. However, during the injection of liquid LPG fuel into the inlet duct of an engine, a large quantity of heat is extracted due to evaporation of fuel. A problem is that the moisture in the air freezes around the outlet of a nozzle, which is called icing Phenomenon. It may cause damage to the outlet nozzle of an injector. The frozen ice deposit detached from the nozzle also may cause a considerable damage to the inlet valve or valve seat. In this work, the experimental investigation of the icing phenomenon was carried out. The results showed that the icing phenomenon and process were mainly affected by humidity of inlet air instead of the air temperature in the inlet duct. Also, it was observed that the icing occurs first in the inlet of a nozzle, and grows considerably at the upper part of the nozzle inlet and the opposite side of the nozzle entrance. An LPG fuel, mainly consisting of butane, has lower latent heat of vaporization than that of propane, which is an advantage in controlling the icing phenomenon.

• Journal of Institute of Control, Robotics and Systems
• /
• v.15 no.7
• /
• pp.675-682
• /
• 2009

Instead of direct driving like BLDC, the induction principle is adopted as a driving one for planar stage. The stage composed of four linear induction motors put in square type is activated by two-axial forces; low-frequency attractive force and thrust force of the linear induction motors. Here, the modified vector control whose new inputs are q-axis current and dc current biased to three phase current instead of d-axis current or flux current is applied extensively to overall motion of the stage. For the developed system, the precision step test and the constant velocity test are tried to guarantee its feasibility for TFT-LCD pattern inspection. However, to exclude a discontinuity due to phase shift and minimize a force ripple synchronized with the command frequency, the initial system is revised to the antagonistic structure over the full degree of freedom. Concretely describing, the porous air bearings guide an air-gapping of the stage up and down and a pair of liner induction motors instead of single motor are activated in the opposite direction each other. The performances of the above systems are compared from trapezoid tracking test and sinusoidal test.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.9
• /
• pp.1291-1294
• /
• 2002

Various racemic N-protected ${\alpha}-amino$ acids such as N-t-BOC-(tert-butoxycarbonyl), N-CBZ-(benzyloxycarbonyl) and N-FMOC-(9-fluorenylmethyloxycarbonyl) ${\alpha}-amino$ acids were resolved as their anilide and 3,5-dimethylanilde derivatives on an HPLC chira l stationary phase (CSP) developed by modifying a commercial (S)-leucine CSP. The chromatographic resolution results were compared to those on the commercial (S)-leucine CSP. The resolutions were greater on the modified CSP than those on the commercial CSP with only one exception, the resolution of N-t-BOC-phenylglycine anilide. In addition, the chromatographic resolution behaviors were quite consistent except for the resolution of N-protected phenylglycine derivatives, the (S)-enantiomers being retained longer. Based on the chromatographic resolution behaviors and with the aid of CPK molecular model studies, we proposed a chiral recognition mechanism for the resolution of N-protected ${\alpha}-amino$ acid derivatives. However, for the resolution of N-protected phenylglycine derivatives, a second chiral recognition mechanism, which competes in the opposite sense with the first chiral recognition mechanism, was proposed. The two competing chiral recognition mechanisms were successfully used in the rationalization of the chromatographic behaviors for the resolution of N-protected phenylglycine derivatives.

• Journal of the Korean Wood Science and Technology
• /
• v.43 no.5
• /
• pp.539-547
• /
• 2015

To investigate dimensional responses of wood under dynamic temperature condition, poplar (populous euramericana Cv.) specimens, 20 mm in radial (R) and tangential (T) directions with two thicknesses of 4 and 10 mm along the grain, were exposed to cyclic temperature changes in square wave between $25^{\circ}C$ and $40^{\circ}C$ at 60% relative humidity (RH) for three different cycling periods of 6 h, 12 h and 24 h. R and T dimensional changes measured during the cycling gave the following results: 1) Transverse dimensional changes of the specimens were generally square but at an opposite phase and lagged behind the imposed temperature changes. The phase lag was inversely correlated with cycling period, but positively related to specimen thickness, while the response amplitude was directly proportional to cycling period, but in a negative correlation with specimen thickness. 2) The specimens showed swelling hysteresis behavior. The heat shrinkage coefficient (HSC) became greater as cycling period increased or specimen thickness decreased. 3) Dimensional changes of the specimens produced deformation accumulation during repeated adsorption and desorption. The deformation accumulating ratio decreased with an increase in cycling period and specimen thickness. 4) Wood suffered 1.5 times as many dimensional changes per unit temperature variation as per unit humidity variation, and this deformation behaved even more seriously under static condition.

• Physical Therapy Korea
• /
• v.9 no.3
• /
• pp.39-46
• /
• 2002

In this study, vertical acceleration of center of mass was observed along normal gait phases in 9 healthy male volunteers (aged $25.7{\pm}2.18$). The developed wireless accelerometric device was attached on the intervertebral space between L3 and L4 using a semi-elastic waist belt. A three-dimensional motion analysis system, synchronized with the accelerometry, was used for detecting gait phases. There was no significant correlation between the body weight and the acceleration. The first peak curve covered loading response phase. The second downward peak point was matched accurately with the opposite toe-off. In mid-stance and terminal stance, the acceleration curve highly resembled the vertical ground reaction force curve. There was no significant difference in timing between the final upward peak point and the initial contact. Therefore, the developed accelerometry system would be helpful in determining determine temporal gait pattems in patients with gait disorders.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.1
• /
• pp.113-118
• /
• 2015

In this paper, a cancellation technique for electromagnetic waves is realized based on a retrodirective antenna array system. The system re-transmits a signal to the direction of the incoming signal, with the same frequency and opposite phase. For the experimental verification, a $2{\times}2$ retrodirective array system is designed and fabricated. Experimental results for a metallic cylinder show as much as 26-dB reduction in reflection.

• Korean Journal of Applied Biomechanics
• /
• v.16 no.2
• /
• pp.9-19
• /
• 2006

The purpose of this study was to analyze the kinematic variables of the lower limbs joints and the muscle activity for lower limbs during the level and downhill running. The subjects were 6 males of twenties and required to run on the level and downhill which was -7% grade treadmill at 8.3km/h. The running performances were filmed by high speed video camera and EMG signal was gained by ME3000P8 Measurement Unit. Rectus femoris(RF), Vastus lateralis(VL), Gluteus medius(GLU), Biceps femoris(BF), gastrocnemius medial head(GM), gastrocnemius lateral head(GL), Soleus(SO), Tibialis anterior(TA) were selected. The result of this study were as follows: 1. Ankle, knee, hip joint in downhill running showed less movement than the level running but, no significant difference. 2. VL and BF during the support phase in downhill running showed Iess muscle activity than the level running. but RF showed the opposite result. 3. GM, GL, SO adn TA during the supports phase in downhill running showed less muscle activity than the level running.

• Proceedings of the KIEE Conference
• /
• 2005.07b
• /
• pp.1515-1517
• /
• 2005

In this paper, we represent both occurrence reason of Surge-voltage and Leakage-current of AC drive system which is operated by Voltage-type PWM Inverter. It generates a compensating voltage which has the same amplitude as, but the opposite phase to, the common-mode voltage produced by the PWM inverter. The compensating voltage is superimposed on the inverter output by a common-mode transformer. As a result, the common-mode voltage applied to the load is canceled completely. The design method of the active common-mode noise canceler is also presented in detail. Therefore, we try to describe the method controling both of them and all of the proprieties are proved by our experiment.

• Nuclear Engineering and Technology
• /
• v.47 no.7
• /
• pp.804-813
• /
• 2015

The electrical-impedance method has been widely used for void-fraction measurement in two-phase flow due to its many favorable features. In the impedance method, the response characteristics of the electrical signal heavily depend upon flow pattern, as well as phasic volume. Thus, information on the flow pattern should be given for reliable void-fraction measurement. This study proposes an improved electrical-conductance sensor composed of a three-electrode set of adjacent and opposite electrodes. In the proposed sensor, conductance readings are directly converted into the flow pattern through a specified criterion and are consecutively used to estimate the corresponding void fraction. Since the flow pattern and the void fraction are evaluated by reading conductance measurements, complexity of data processing can be significantly reduced and real-time information provided. Before actual applications, several numerical calculations are performed to optimize electrode and insulator sizes, and optimal design is verified by static experiments. Finally, the proposed sensor is applied for air-water two-phase flow in a horizontal loop with a 40-mm inner diameter and a 5-m length, and its measurement results are compared with those of a wire-mesh sensor.

• Journal of Astronomy and Space Sciences
• /
• v.36 no.3
• /
• pp.133-147
• /
• 2019

Challenging Minisatellite Payload (CHAMP) satellite magnetic data are used to investigate the latitudinal variation of the storm-time meso-scale field-aligned currents by defining a new metric called the FAC range. Three major geomagnetic storm events are considered. Alongside SymH, the possible contributions from solar wind dynamic pressure and interplanetary magnetic field (IMF) $B_Z$ are also investigated. The results show that the new metric predicts the latitudinal variation of FACs better than previous studies. As expected, the equatorward expansion and poleward retreat are observed during the storm main phase and recovery phase respectively. The equatorward shift is prominent on the northern duskside, at ${\sim}58^{\circ}$ coinciding with the minimum SymH and dayside at ${\sim}59^{\circ}$ compared to dawnside and nightside respectively. The latitudinal shift of FAC range is better correlated to IMF $B_Z$ in northern hemisphere dusk-dawn magnetic local time (MLT) sectors than in southern hemisphere. The FAC range latitudinal shifts responds better to dynamic pressure in the duskside northern hemisphere and dawnside southern hemisphere than in southern hemisphere dusk sector and northern hemisphere dawn sector respectively. FAC range exhibits a good correlation with dynamic pressure in the dayside (nightside) southern (northern) hemispheres depicting possible electrodynamic similarity at day-night MLT sectors in the opposite hemispheres.