• Journal of the Korean Society for Railway
• /
• v.15 no.6
• /
• pp.558-565
• /
• 2012

Abnormal climate or weather is more frequently reported nowadays due to the global climate change. Especially, extremely low temperature in winter season may cause bad thermal discomfort of passengers. In this study, the effect of car heating modes on cabin temperature change and distribution was studied by using a real-scale environmental chamber for passenger cabin. It was found that the cabin temperature rose quickly at the initial stage of heating system operation, but it stopped increasing after certain point. And, temperature was higher when the height from the floor was higher. Based on the obtained result, the way to minimize the decrease of passengers' thermal comfort was suggested.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.4
• /
• pp.219-225
• /
• 2014

The New efficient Mux-based scan latch cell design and scan test of LOS/LOC modes are proposed for detection of delay faults in digital logic circuits. The proposed scan cell design can support LOS(Launch-off-Shift) and LOC(Launch-off-Capture) tests with high fault coverage and low scan power and it can alleviate the problem of the slow selector enable signal and hold signal by supporting the logic capable of switching at the operational clock speeds. Also, it efficiently controls the power dissipation of the scan cell design during scan testing. Functional operation and timing simulation waveform for proposed scan hold cell design shows improvement in at-speed test timing in both test modes.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.6D
• /
• pp.539-547
• /
• 2012

Increasing the mode transfer volume between public transportation modes has known to be necessary for efficiency improvement of public transportation system operation and it is also found to be important to have relevant transfer point selection with reflection of current travel pattern. This study is in regards to providing a selection guideline for the location of transfer point between public transport modes. This case study has been carried out for Daegu Metropolitan City especially for public transportation users behaviour by analysis of daily usage of transportation card to identify the transfer travel pattern. A cluster analysis was applied to categorize the pattern of transfer stop which induces many users and a discriminant analysis also utilized for grouping the stops by number of transfer trip. This research produces the estimation result of transfer volume for urban railway system no.3 in Daegu City which is currently under construction. In addition, the locations of transfer center has also been proposed.

• Journal of Energy Engineering
• /
• v.12 no.4
• /
• pp.309-319
• /
• 2003

The main purpose of this paper is to present a simulation model for assessing the impacts of a variable speed wind turbine (VSWT) on the distribution network and perform a simulation analysis of volt-age profiles and harmonics along the wind turbine installed feeder using the presented model. The modeled wind energy conversion system consists of a fixed pitch wind turbine and a permanent-magnet synchronous generator, in which a controllable power electronics inverter performs variable speed operation and reactive power output control. Impact analysis on voltage profiles and harmonics of a VSWT-installed distribution feeder is addressed and simulated in terms of steady state and dynamic behaviors. Various capacities and different modes of variable speed wind turbines are simulated and investigated. Case studies demonstrate how feeder voltages are influenced by capacity and control modes of wind turbines and changes in wind speed under various network conditions, and show harmonic impacts on the feeder. Modeling and simulation analysis is based on PSCAD/EMTDC a software package.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.2
• /
• pp.162-168
• /
• 2008

In this paper, the RCF(Resistive Companion Form) analysis method is applied to analyze small signal stability of power systems including thyristor controlled FACTS(Flexible AC Transmission System) equipments such as TCSC(Thyristor Controlled Series Capacitor). The eigenvalue sensitivity analysis algorithm in discrete systems based on the RCF analysis method is presented and applied to the power system including TCSC. As a result of simulation, the RCF analysis method is very useful to precisely calculate the variations of eigenvalues or newly generated unstable oscillation modes after periodic switching operations of TCSC. Also the eigenvalue sensitivity analysis method based on the RCF analysis method enabled to precisely calculate eigenvalue sensitivity coefficients of controller parameters about the dominant oscillation mode after periodic switching operations in discrete systems. These simulation results are different from those of the conventional continuous system analysis method such as the state space equation and showed that the RCF analysis method is very useful to analyze the discrete power systems including periodically operated switching equipments such as TCSC.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.11 no.3
• /
• pp.127-135
• /
• 2008

Intermodal or transfer facilities is always necessary wherever different modes meet at one place and exchanges of passengers among the modes take place. Design of intermodal or transfer facilities requires a careful consideration of numerous legal and technical factors. This study intends to suggest the fundamental principles needed for design the intermodal facilities to enhance the level-of-service for transfer passengers as well as the efficiency of operation. Previous studies and relevant legal documentation are reviewed and examined. Steps in the design procedures are suggested, and data necessary for designing the facility is suggested. The above principles are applied to the real design of Busan KTX station in order to identify the problems.

• Laser Solutions
• /
• v.7 no.3
• /
• pp.37-46
• /
• 2004

The shape and size variations of the nanopatterns produced on a polymer film using a near-field scanning optical microscope(NSOM) are investigated with respect to the process variables. A cantilever type nanoprobe having a 100nm aperture at the apex of the pyramidal tip is used with the NSOM and a He-Cd laser at a wavelength of 442nm as the illumination source. Patterning characteristics are examined for different laser beam power at the entrance side of the aperture($P_{in}$), scan speed of the piezo stage(V), repeated scanning over the same pattern, and operation modes of the NSOM(DC and AC modes). The pattern size remained almost the same for equal linear energy density. Pattern size decreased for lower laser beam power and greater scan speed, leading to a minimum pattern width of around 50nm at $P_{in}=1.2{\mu}W\;and\;V=12{\mu}m/s$. Direct writing of an arbitrary pattern with a line width of about 150nm was demonstrated to verify the feasibility of this technique for nanomask fabrication. Application on high-density data storage is discussed.

• Membrane and Water Treatment
• /
• v.8 no.5
• /
• pp.449-462
• /
• 2017

Direct treatment of municipal wastewater by forward osmosis (FO) process was evaluated in terms of water flux decline, reverse salt diffusion, pollutants rejection and concentration efficiency by using synthetic seawater as the draw solution. It was found that when operating in PRO mode (active layer facing the draw solution), although the FO membrane exhibited higher osmotic water flux, more severe flux decline and reverse salt diffusion was also observed due to the more severe fouling of pollutants in the membrane support layer and accompanied fouling enhanced concentration polarization. In addition, although the water flux decline was shown to be lower for the FO mode (active layer facing the feed solution), irreversible membrane fouling was identified in both PRO and FO modes as the water flux cannot be restored to the initial value by physical flushing, highlighting the necessity of chemical cleaning in long-term operation. During the 7 cycles of filtration conducted in the experiments, the FO membrane exhibited considerably high rejection for TOC, COD, TP and $NH_4{^+}-N$ present in the wastewater. By optimizing the volume ratio of seawater draw solution/wastewater feed solution, a concentration factor of 3.1 and 3.7 was obtained for the FO and PRO modes, respectively. The results demonstrated the validity of the FO process for direct treatment of municipal wastewater by using seawater as the draw solution, while facilitating the subsequent utilization of concentrated wastewater for bioenergy production, which may have special implications for the coastline areas.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.42 no.9
• /
• pp.779-788
• /
• 2014

The satellite should generate electric power efficiently to perform the mission successfully within limited power. For this reason, the electrical power system of LEO satellites usually regulates the power which is generated from the solar cells using MPPT (Maximum Power Point Tracking) method. This paper proposes advanced MPPT algorithm based on the fuzzy logic applied to small CubeSat satellite. The simulation has been performed to confirm the validity of the proposed method by interlocking between MATLAB/Simulink and STK (Systems Tool Kit). The EBA(Energy Balance Analysis) has also been performed at two different pointing modes of KAUSAT-5 for solar irradiation according to the satellite orbit and attitude, and load capacity varied with operation modes by Simulink and STK. The performance of fuzzy logic-based MPPT algorithm was verified through the EBA. The validity of the proposed MPPT algorithm based on the fuzzy logic was also confirmed by comparing with P&O (Perturbation & Observation) algorithm that is general in the MPPT.

• Proceedings of the KSR Conference
• /
• 2009.05a
• /
• pp.284-290
• /
• 2009

As the increased importance is placed on the new transit systems owing to the environmental pollution caused by the road traffic congestion, the policy for the introduction of the new transit systems as an alternative solution to ease the heavy burden of the construction expenses is being actively established. Since the explicit recognition of such transit systems and the review on the method of its adoption have been a pressing matter in the light of reducing the pending traffic congestion, the development of the rolling stock systems in modes of new transportation has been made in various ways taking into consideration the regional circumstances to alleviate traffic congestion, and offer a more efficient service with the application of their intrinsic characteristics. Such systems also have been developed as a mix of punctuality for railway systems operating on the runway and flexibility for buses. This paper, therefore, deals in more detail with 3 modes of systems such as low-floor articulated buses, GRT(Guided Rapid Transit) and tram cars, and studies the overseas cases of the operation of those systems involving both negative and positive aspects.