• 한국생물공학회:학술대회논문집
• /
• 2003.04a
• /
• pp.382-385
• /
• 2003

Organic solvent tolerant bacterium, designated as strain BCNU 106 is a gram negative, rod-shaped aerobe and grows on benzene, toluene, ethylbenzene, and xylenes (BTEX) as a sole carbon source. According to 16S rDNA analysis and fatty acid analysis, strain BCNU 106 showed highest similarity to Pseudomonas syringae var. savastanoi (Pseudomonas savastanoi). Strain BCNU 106 was able to utilize toluene, ethylbenzene, both o-, m-, p-xylene , m-cresol and o-cresol. The degradation of o-, m-, p-xylene by strain BCNU 106 is particularly important, since o-xylene is a compound of considerable environmental interest, owing to its recalcitrance; and very few microorganism have been reported to utilize both o-, m-, p-xylene as a sole carbon source.

• Journal of the Korean Society of Safety
• /
• v.21 no.4 s.76
• /
• pp.66-72
• /
• 2006

An accurate knowledge of the AITs(autoignition temperatures) is important in developing appropriate prevention and control measures in industrial fire protection. The measurement of AITs are dependent upon many factors, namely initial temperature, pressure, vessel size, fuel/air stoichiometry, catalyst, concentration of vapor, ignition delay time. The values of the AITs used process safety are normally the lowest reported, to provide the greatest margin of sefety. This study measured the AITs of o-xylene+n-pentanol system from ignition delay time by using ASTM E659-78 apparatus. The experimental AITs of o-xylene and n-pentanol were $480^{\circ}C\;and\;285^{\circ}C$, respectively. The experiment AITs of o-xylene+n-pentanol system were a good agreement with the calculated AITs by the proposed equations with a few A.A.D.(average absolute deviation).

• Journal of the Korean Society of Safety
• /
• v.22 no.3 s.81
• /
• pp.22-27
• /
• 2007

The knowledge of the flash point of the various liquid substances is required because of process safety and control in industrial fire protection. The epoxy resin is one of versatile resins that has wide selection of using curing agents and additives to achieve various applications such as coatings, adhesives, interior materials, reinforced plastics and electrical insulation. In this study, the lower flash points for p-xylene+epoxy resin, o-xylene+epoxy resin and n-butanol+epoxy resin systems were measured by using Pensky-Martens closed cup tester. The lower flash points for p-xylene+epoxy resin, o-xylene+epoxy resin and n-butanol+epoxy resin systems rapidly increased 80wt%, 90wt% and 95wt% of epoxy resin concentration, respectively. This results serve as a guide to estimate flash point of any epoxy resin solution.

• Journal of Sensor Science and Technology
• /
• v.30 no.4
• /
• pp.191-195
• /
• 2021

Pure ZnFe₂O₄ and Fe₂O₃-ZnFe₂O₄ hetero-composite spheres were prepared by ultrasonic spray pyrolysis of a solution containing Zn- and Fe-nitrates. Additionally, the sensing characteristics of these spheres in the presence of 5 ppm ethanol, benzene, p-xylene, toluene, and CO (within the temperature range of 275-350 ℃) were investigated. The Fe₂O₃-ZnFe₂O₄ hetero-composite sensor with a cation ratio of [Zn]:[Fe]=1:3 exhibited a high response (resistance ratio = 140.2) and selectivity (response to p-xylene/response to ethanol = 3.4) to 5 ppm p-xylene at 300 ℃, whereas the pure ZnFe₂O₄ sensor showed a comparatively lower gas response and selectivity. The reasons for the superior response and selectivity to p-xylene in Fe₂O₃-ZnFe₂O₄ hetero-composite sensor were discussed in relation to the electronic sensitization due to charge transfer at Fe₂O₃-ZnFe₂O₄ interface and Fe₂O₃-induced catalytic promotion of gas sensing reaction. The sensor can be used to monitor harmful volatile organic compounds and indoor air pollutants.

• KSBB Journal
• /
• v.16 no.1
• /
• pp.61-65
• /
• 2001

In this study, a BTX degrading microbial consortium was obtained from the activated sludges of a BTX releasing sewage water and city sewage water treatment plant. The MY microbial consortium was developed for benzene and toluene degradation, whereas the MA microbial consortium was developed for xylene isomers. The major microorganism of the MA consortium was identified as Rhodococcus ruber DSM 43338T, whereas that of the MY consortium was Rhodococcus sp. In terms of the degradation of a single component, the removal rate of benzene was fastest and decreased in order; toluene, o-xylene, p-xylene and m-xylene. For degradation of mixed BTX, most BTX were degraded within 108 hours and the degradation rate showed either stimulatory or inhibitory effects depending on the composition. MA and MY microbial consortium obtained in this study may be used effectively to remove BTX biologically.

• Clean Technology
• /
• v.29 no.4
• /
• pp.279-287
• /
• 2023

Fine dust emitted from coal combustion is classified into filterable particulate matter (FPM) and condensable particulate matter (CPM). CPM is difficult to control with existing air pollution control devices, so research is being conducted to understand the characteristics of CPM. Components constituting condensable particulate matter (CPM) are divided into inorganic and organic components. There are many quantitative analysis results for the ionic components, which account for a significant proportion of the CPM inorganic components, but little is known about the organic components. Thus, there is a need for a quantitative analysis of CPM organic components. In this study, aromatic hydrocarbons (toluene, ethyl benzene, m,p-xylene, and o-xylene) and n-alkanes with 10 to 30 carbon atoms were quantitatively analyzed to understand the organic components of CPM emitted from a lab-scale coal combustor. Of the aromatic hydrocarbons, toluene accounted for 1.03% of the CPM organic components. On the other hand, the contents of ethyl benzene, m,p-xylene, and o-xylene showed low values of 0.11%, 0.18%, and 0.51% on average, respectively. Among the n-alkanes, triacontane (C₃₀) showed a high content of 2.64% and decane (C₁₀) showed a content of 2.05%. The next highest contents were shown with dodecane (C₁₂), tetradecane (C₁₄), and heptacosane (C₂₇), all of which were higher than that of toluene. The n-alkane substances that had detectable concentrations showed higher contents than ethyl benzene, m,p-xylene, and o-xylene except for tetracosane (C₂₄).

• Journal of the Korean Chemical Society
• /
• v.22 no.6
• /
• pp.380-385
• /
• 1978

Adsorption isotherms of o-xylene on Spheron 6, a graphitized carbon black, are obtained at various temperatures using a quartz beam microbalance. BET plots are made to estimate the molecular area of o-xylene from these isotherms. On Spheron 6, the molecular area of o-xylene (m.p $-25^{\circ}C$) remains constant until the temperature is increased up to $-15^{\circ}C$, but increases abruptly between $-15^{\circ}C$ and $-14^{\circ}C$, and then again remains constant thereafter. These results are interpreted as implying that the adsorbed o-xylene molecules are flatly localized on Spheron 6 with compact packing below $-15^{\circ}C$ while they gain a rotational degree of freedom around the benzene ring at the higher temperature.

• Biomedical Science Letters
• /
• v.16 no.2
• /
• pp.123-126
• /
• 2010

Volatile organic compounds are commonly off gassed from various building materials and can induce sick building syndrome. Volatile organic compounds such as formaldehyde, xylene and toluene are known as toxic agents in immune cells. Human leukocytes, particularly, neutrophils and eosinophils play important roles in the regulation of immune responses. In this study, we investigated the toxic effects of formaldehyde, ortho-xylene (o-xylene), para-xylene (p-xylene) and toluene on the apoptosis of neutrophils and eosinophils isolated from the blood of healthy donors. Formaldehyde increased the constitutive apoptosis of neutrophils and eosinophils. o-xylene, p-xylene and toluene increased the spontaneous apoptosis of eosinophils, but not that of neutrophils. Formaldehyde increased the protein level of IL-8 in neutrophils and eosinophils, and suppressed the MCP-1 expression in neutrophils. The release of IL-6 from neutrophils was diminished by volatile organic compounds used in this study. In conclusion, formaldehyde, xylene and toluene elevate the apoptosis of neutrophils and eosinophils, and regulate the release of cytokine and chemokine in neutrophils and eosinophils. These results indicate that formaldehyde, xylene and toluene have a cytotoxicity in human neutrophils and eosinophils and may damage the modulation of immune responses.

• Journal of Microbiology and Biotechnology
• /
• v.17 no.11
• /
• pp.1772-1781
• /
• 2007

Activated sludge was sequentially adapted to benzene, toluene, and o-xylene (BTX) to study the effects on the change of microbial community. Sludge adapted to BTX separately degraded each by various rates in the following order; toluene>o-xylene>benzene. Degradation rates were increased after exposure to repeated spikes of substrates. Eleven different kinds of sludge were prepared by the combination of BTX sequential adaptations. Clustering analyses (Jaccard, Dice, Pearson, and cosine product coefficient and dimensional analysis of MDS and PCA for DGGE patterns) revealed that acclimated sludge had different features from nonacclimated sludge and could be grouped together according to their prior treatment. Benzene- and xylene-adapted sludge communities showed similar profiles. The sludge profile was affected from the point of the final adaptation substrate regardless of the adaptation sequence followed. In the sludge adapted to 50 ppm toluene, Nitrosomonas sp. and bacterium were dominant, but these bands were not dominant in benzene and benzene after toluene adaptations. Instead, Flexibacter sp. was dominant in these cultures. Dechloromonas sp. was dominant in the culture adapted to 50 ppm benzene. Thauera sp. was the main band in the sludge adapted to 50 ppm xylene, but became vaguer as the xylene concentration was increased. Rather, Flexibacter sp. dominated in the sludge adapted to 100 ppm xylene, although not in the culture adapted to 250 ppm xylene. Two bacterial species dominated in the sludge adapted to 250 ppm xylene, and they also existed in the sludge adapted to 250 ppm xylene after toluene and benzene.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.2
• /
• pp.375-383
• /
• 2000

A mixed culture isolated from petroleum-contaminated soil was enriched on toluene as a sole carbon and energy source, and degradation characteristics of BTEX(Benzene, Toluene, Ethylbenzene, Xylenes) was observed. In the single-substrate experiments, all the BTEX compounds were degraded, and it was degraded as following orders; toluene, benzene, ethylbenzene, and p-xylene. In the degradation experiments of BTEX mixtures, the degradation rate was decreased compared to that in the single substrate experiment and ethylbenzene was degraded faster than benzene. In the experiments of binary-mixtures, various substrate interactions such as inhibition, stimulation, and non-interaction were observed, and ethylbenzene was shown to be most potent inhibitor of BTEX degradation. In the degradation characteristic studies of xylene isomers, m-xylene and p-xylene were degraded as carbon sources, and it was stimulated in the presence of either benzene or toluene. However, degradation of o-xylene was enhanced only in the presence of benzene.