• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.375-380
• /
• 2001

MF is a half shaft blast furnace which has been developed at Mitsui Miike Smelter in the 1960’s to treat vertical retort residue. The MF has also been tested for treatment of various recycling materials and wastes. Now various secondaries and wastes (EAF dust, zinc leaching residue, Cu sludge, etc ) are mainly treated. Powder materials are briquetted with reductant before being fed to the furnace. Products are crude zinc oxide, matte, non-hazardous slag and steam. Zinc and lead are recovered in oxide dust, and copper and silver are recovered in matte. The MF can be widely applied to many kinds of materials which contain such non-ferrous metal-valuables. In addition, the improvement in operation and technology has effectively made the unit capacity much larger. The MF now has many advantages for these treatment processes.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.10a
• /
• pp.475-479
• /
• 2011

Leak problem with large pressure drop occurrs non-periodic shock pulsation due to the deterioration of a isolation valve in feed-water recirculation piping system. This paper discusses on the shock vibration and noise occurred due to the effect of acoustical shock pulsations by degradation of the isolation valve in a power site.

• Korean Journal of Pharmacognosy
• /
• v.17 no.3
• /
• pp.189-194
• /
• 1986

The single acute treatment of mice with the steam distillate, non-volatile ether extract and methanol extract from mace, arils of Myristica fragrans(Myristicaceae) caused a significant prolongation of hexobarbital-induced narcosis, an increase in strychnine toxicity as well as a significant decrease in hepatic microsomal drug metabolizing enzyme activities. On seven daily consecutive administrations, however, the duration of narcosis was markedly shortened and significant increases in the hepatic enzyme activities were shown. From the non-volatile ether fraction, macelignan, a new lignan, mp $70{\sim}72^{\circ}$ was isolated as an active principle.

• Journal of Electrical Engineering and information Science
• /
• v.2 no.4
• /
• pp.59-65
• /
• 1997

In this paper, a general fuzzy syntactic method for recognition of flaw patterns and for the measurement of flaw characteristic parameters for a non-destructive inspections signal, called eddy-current, is presented. Solutions are given to the subtasks of primitive pattern selection, signal to symbol transformation, pattern grammar formulation, and event-synchronous flaw pattern extraction based on the grammars. Fuzzy attribute grammars are used as the model for the pattern grammar because of their descriptive power in the face of uncertain constraints caused by nose or distortion in the signal waveform, due to their ability to handle syntactic as well as semantic information. This approach has been implemented and the performance of eh resultant system has been evaluated using a library of law patterns obtained from steam generator tubes in nuclear power plants by an eddy current-based non-destructive inspection method.

• Elastomers and Composites
• /
• v.33 no.2
• /
• pp.103-109
• /
• 1998

The determination method of successful operation conditions to control the temperature and pressure in autoclave after non-taping vulcanization process was represented. Heat and mass balances were constructed to predict the mass flow rates of air, steam, and condensed water into or from autoclave when the temperature and pressure in the autoclave were to be controlled in the desired profiles. The balance equations were solved by appropriate mathematics, and the solution was applied to an autoclave system where the temperature and pressure were linearly decreased. The resulting solutions were illustrated in graphs.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.23 no.2
• /
• pp.238-243
• /
• 1994

Changes of lipid components in modified oleoresin during cooking at high temperature were investigated. In preparation of the modified oleoresin, dried red pepper was milled to 100 mesh of size particle and extracted oily compounds by reduced pressure steam distillation . The rest part was reextracted and concentrated and concentrated. The extracts were combined. The same volume of water and 4% of polyglycerol condensed ricinoleate (PGDR) were added to the combined extract, and emulsified to make oleresin red pepper. Non-polar lipid components were quantified 3 times higher in the oleoresin than polar lipid components . The components of non-polar lipd was mainly triglyceride comprising 75.8%. The level of phosphatidyl choline and phosphatidyl ethanolamine were 38.6and 26.1%, respectively. linoleic acid was distinctively abundant (63.1%) and followed by palmitic acid, oleic acid, linolenic acid and stearic acid in the oleoresin. Oxidation of lipid at high temperature was principally affected by temperature rather than oxygen existence . With the result of oxidation , palmitic acid and myristic acid increased, however, oleic acid, linoleic acid, and linolenic acid decreased.

• Journal of Radiation Protection and Research
• /
• v.24 no.4
• /
• pp.215-223
• /
• 1999

Characteristics of radiation field in the steam generator(S/G) water chamber of a PWR were investigated and the anticipated effective dose rates to the worker in the S/G chamber were evaluated by Monte Carlo simulation. The results of crud analysis in the S/G of the Kori nuclear power plant unit 1 were adopted for the source term. The MCNP4A code was used with the MIRD type anthropomorphic sex-specific mathematical phantoms for the calculation of effective doses. The radiation field intensity is dominated by downward rays, from the U-tube region, having approximate cosine distribution with respect to the polar angle. The effective dose rates to adults of nominal body size and of small body size(The phantom for a 15 year-old person was applied for this purpose) appeared to be 36.22 and 37.06 $mSvh^{-1}$) respectively, which implies that the body size effect is negligible. Meanwhile, the equivalent dose rates at three representative positions corresponding to head, chest and lower abdomen of the phantom, calculated using the estimated exposure rates, the energy spectrum and the conversion coefficients given in ICRU47, were 118, 71 and 57 $mSvh^{-1}$, respectively. This implies that the deep dose equivalent or the effective dose obtained from the personal dosimeter reading would be the over-estimate the effective dose by about two times. This justifies, with possible under- or over- response of the dosimeters to radiation of slant incidence, necessity of very careful planning and interpretation for the dosimetry of workers exposed to a non-regular radiation field of high intensity.

• Proceedings of the KSMRM Conference
• /
• 2001.11a
• /
• pp.135-135
• /
• 2001

Purpose： To know the differences of the proton MR spectroscopic features of the liver between th patients with graft-versus-host disease (GVHD) and without GVHD (non-GVHD) after to marrow transplantation (BMT), and to evaluate the possibility to discriminate GVHD fro non-GVHD by analysis of the in vivo proton MR spectra. Method： We evaluated the in vivo proton MR spectra from the livers of 37 patients wh underwent BMT. Our series included 14 cases with GVHD and 23 without GVHD in the liver. Nineteen men and 18 women were included in our series. All cases of GVHD and 2 o non-GVHD were confirmed by liver biopsy and remaining of non-GVHD by evaluation clinical follow up. Proton MR spectroscopy (1H-MRS) was performed at 1.5T GE Sign Horizon (GE Medical System, Milwaukee, USA) system using localized proton STEAM sequence and body coil in all cases with subjects were located in supine position. N respiratory interruption was required during the spectroscopic signal acquisition. Paramete using in MRS were： TR = over 3000ms, TE = 30ms, number of scans = 128, voxel size = ($2{\times}2{\times}2$)$cm^3$, and one NEX. We evaluated the spectra with an attention to the differences o patterns of the peaks between GVHD and non-GVHD groups. The ratio of peak area of peaks at 1.6-4.1ppm to lipid (0.9-1.6ppm) [P(1.6-4.1ppm)/P(0.9-1.6ppm)] was calculated in GVHD and non-GVHD group, and compared the results between these groups. We als evaluated the sensitivity and specificity for discriminating GVHD from non-GVHD by anal of 1H-MRS.

• Journal of the Korea Institute of Building Construction
• /
• v.23 no.4
• /
• pp.359-367
• /
• 2023

This experimental study investigates the replacement of conventional Portland cement and sand with non-sintered cement and ferro-nickel slag to formulate eco-friendly cement mortar. The examination aimed to understand the strength properties of non-sintered cement mortar using ferro-nickel slag as fine aggregate by classifying mortar production types, fine aggregates, and curing methodologies. From flexural and compressive strength tests, it was observed that non-sintered cement mortars, incorporating ferro-nickel slag as fine aggregate, exhibited superior strength when compared to both plain mortar and steam-cured non-sintered mortar. This increased strength is attributed to the influence of the particle size, density, and absorption capabilities of the ferro-nickel slag. Furthermore, X-ray Diffraction(XRD) analyses of the mortars verified the presence of MgO, a component of ferro-nickel slag, in the form of a composite oxide. This finding substantiates the consistent strength manifestation of non-sintered cement mortars utilizing ferro-nickel slag as a fine aggregate.

• Nuclear Engineering and Technology
• /
• v.37 no.5
• /
• pp.457-468
• /
• 2005

An experimental study on post-CHF heat transfer has been performed with a $3\times3$ rod bundle using a vertical steam-water two-phase flow at low flow conditions. The effects of various parameters on the post-CHF heat transfer are investigated and the reasons for the parametric effects are discussed. As the heat transfer regime changes from CHF to post-CHF, the radial wall temperature distribution is changed depending on the pressure and the mass flux conditions. The superheat of the fluid increases considerably with an increase of the wall temperature (or heat flux) and with a decrease of the mass flux. This implies, indirectly, a strong thermal non-equilibrium at high wall temperature and low mass flux conditions. In order to improve the prediction accuracy of the existing post-CHF correlations, it is necessary to perform more experiments, particularly direct measurement of the vapor superheat, and to modify the correlation by considering a strong thermal non-equilibrium at low flow and low pressure conditions.