• Proceedings of the KSME Conference
• /
• 2001.06e
• /
• pp.45-50
• /
• 2001

This experimental study concerns the characteristics of a transitional flow in a concentric annulus with a diameter ratio of 0.52, whose outer cylinder is stationary and inner one rotating. The pressure losses and skin-friction coefficients have been measured for the fully developed flow of a 0.2 % aqueous solution of sodium carbomethyl cellulose (CMC) at a inner cylinder rotational speed of $0{\sim}600$ rpm. The transitional flow has been examined by the measurement of pressure losses, to reveal the relation of the Reynolds numbers with the skin-friction coefficients, in the laminar and transitional flow regimes. The occurrence of transition has been checked by the gradient change of pressure losses and skin-friction coefficient with respect to the Reynolds numbers. The increasing rate of skin-friction coefficient due to the rotation is uniform for laminar flow regime, whereas it is suddenly reduced for transitional flow regime and, then, it is gradually declined for turbulent flow regime. Consequently, the critical(axial-flow) Reynolds number decrease as the rotational speed increases. Thus, the rotation of inner cylinder promotes the early occurrence of transition due to the onset of taylor vortices.

• Food Science of Animal Resources
• /
• v.18 no.1
• /
• pp.35-41
• /
• 1998

The objective of this study was to examine the changes of physical properties by additions of different kinds of stabilizers milk proteins concentration, when stored at 4$^{\circ}C$ or 20$^{\circ}C$ for yoghurt. the results were summarized as follows: 1. Addition of 2% carboxyl methyl cellulose and carrageenan, gelation 0.4%, pectin and starch 0.6%, and carrageenan & pectin 0.8% in the manufacture of yoghurt increased the viscosity, water-holding capacity and protein hydration of yoghurt. 2. Addition of 3% skim milk powder, Ca-caseinate or Na-caseinate 0.6% increased the viscosity, water-holding capacity and protein hydration of yoghurt. 3. Twenty five percent of evaporation of milk promoted to build up the optimal structure of the micelles of yoghurt and improved viscosity, water-holding capacity and protein hydration of yoghurt. 4. Addition of stabilizers to yoghurt showed an increase of viscosity, water-holding capacity and protein hydration when compared with non-addition of stabilizers to yoghurt at 4$^{\circ}C$, 20$^{\circ}C$ storage for 12hrs, 96hrs followed by the decrease of it.

• Journal of Pharmaceutical Investigation
• /
• v.41 no.1
• /
• pp.45-50
• /
• 2011

Nonclassical pathway of crystallization has been utilized to modify the properties and morphologies of inorganic and organic/inorganic materials. In here, the polymer-directed crystallization method has been applied to the pharmaceutical active ingredient to assess the applicability for as a particle engineering tool. The polymer-directed crystallization was successful to modifying the crystal size, habit and morphology, but it was not effective to discover the novel polymorphs of Sibutramine (SB). SB was selected as a model drug and polyacrylic acid (PAA), polyethylene imine (PEI) and chitosan (CHI) were added as a crystallization pathway modifier. SB was crystallized via drowning crystallization using methanol or ethanol as a solvent and water as a non-solvent. The significant interactions between polymer and the drug were confirmed by measuring the solubility of the drug in presence of polymer during the crystallization. The crystal forms of SB are characterized by X-ray diffraction (XRD), scanning electron microscope (SEM) and optical microscope (OM). The polymer-directed crystallization seems to be able to modify the crystal properties of pharmaceutical active ingredient, which is critical in determining the bioavailability, processability, and stability.

• Textile Coloration and Finishing
• /
• v.4 no.3
• /
• pp.82-90
• /
• 1992

To optimize the foam dyeing procedures for polyester and polyester/nylon blended non-woven fabrics, the effects of organic solvents and surfactants were investigated by measuring the foam heights and surface tensions of the foam dyeing solution. The results of the experiments can be summarized as follows: 1) Organic solvents and surfactants (sodium lauryl sulphate: SLS) solution lower the surface tension (ST) of the water, but ST lowering rate of SLS solution is greater than that of solvents. For a 0.25% SLS solution, the minimum surface tension was 30.3 dyne/cm, which is nearly the same value for organic solvents. 2) For 0.25% SLS solutions, additional adding of a 4.0% organic solvent makes the foam height (FH) be its maximum. 3) At 0.6 g/ι dye concentration, incorporation of 0.4% SLS makes the surface tension of the foam solution be its minimum. The foam height did not show any trend due to the dye type. 4) The effect of foam stabilizers (sodium alginate (Alg-Na) and hydroxy ethyl cellulose (HEC)) were also investigated. The foam height of the foaming solution with HEC was greater than that with Alg-Na. The foam stability of the foaming solution with Alg-Na was better than that with HEC.

• Journal of Microbiology and Biotechnology
• /
• v.19 no.8
• /
• pp.836-844
• /
• 2009

A denitrification bacterium was isolated from riverbed soil and identified as Ochrobactrum sp., whose specific enzymes for denitrification metabolism were biochemically assayed or confirmed with specific coding genes. The denitrification activity of strain G3-1 was proportional to glucose/nitrate balance, which was consistent with the theoretical balance (0.5). The modified graphite felt cathode with neutral red, which functions as a solid electron mediator, enhanced the electron transfer from electrode to bacterial cell. The porous carbon anode was coated with a ceramic membrane and cellulose acetate film in order to permit the penetration of water molecules from the catholyte to the outside through anode, which functions as an air anode. A non-compartmented electrochemical bioreactor (NCEB) comprised of a solid electron mediator and an air anode was employed for cultivation of G3-1 cells. The intact G3-1 cells were immobilized in the solid electron mediator, by which denitrification activity was greatly increased at the lower glucose/nitrate balance than the theoretical balance (0.5). Metabolic stability of the intact G3-1 cells immobilized in the solid electron mediator was extended to 20 days, even at a glucose/nitrate balance of 0.1.

• Journal of Microbiology and Biotechnology
• /
• v.21 no.12
• /
• pp.1287-1293
• /
• 2011

The extracellular polysaccharide (EPS) was isolated from mycelial cultures of Laetiporus sulphureus var. miniatus and purified by DEAE cellulose and Sephadex G-50 column chromatography. The purified EPS (EPS-2-1) was composed of only glucose units and its molecular mass was 6.95 kDa. The chemical structure of EPS-2-1 consisted of a main chain containing ($1{\rightarrow}4$)-Glcp units with branches at the C-6 position of the chain carrying-Glcp-($1{\rightarrow}4$)-linked residues. The effect of purified EPS on immunomodulatory genes and proteins of the Bcl-2 family was observed using cultured U937 human leukemia cells. Of note, the levels of Bax and Bad proteins treated with the EPS (4 mg/ml) were approximately 23- and 18-times higher than those in non-treated cells, respectively. These results may suggest that the EPS purified from the mushroom L. sulphureus is associated with the activation of immunomodulatory mediators, Bax and Bad proteins.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.17 no.1
• /
• pp.8-15
• /
• 2005

This study concerns the characteristics of helical flow in a concentric and eccentric annulus with a diameter ratio of 0.52 and 0.9, whose outer cylinders are stationary and inner ones are rotating. Pressure losses and skin friction coefficients have been measured for fully developed flows of water and $0.2\%$ aqueous of sodium carboxymethyl cellulose(CMC), respectively, when the inner cylinder rotates at the speed of $0\~500$ rpm. The effect of rotation on the skin friction coefficient is significantly dependent on the flow regime. In all flow regimes, the skin friction coefficient is increased by the inner cylinder rotation. This study shows the change of skin friction coefficient and wall shear stress corresponding to the variation of rotating speed of the inner cylinder, radius ratio, eccentricity, and working fluids.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2007.11a
• /
• pp.93-102
• /
• 2007

Biocomposite was organized with biodegradable polymer and natural fiber that has potential to be used as replacement for glass fiber reinforced polymer composite with the benefits of low cost, low density, acceptable specific strength, biodegradability, etc. Until now, non-wood fibers have been used as reinforcements of biocomposite which are all plant-based fibers. The present study focused on investigating the fabrication and characterization of biocomposite reinforced with red algae fiber. The bleached red algae fiber(BRAF) showed very similar crystallinity to the cellulose. It has high stability against thermal degradation (maximum thermal decomposition temperature of 359.3$^{\circ}C$) and thermal expansion. Biocomposites reinforced with BRAF have been fabricated by a compression molding method and their mechanical and thermal properties have been studied. The storage modulus and the thermomechanical stability of PBS matrix are markedly improved with reinforcing the BRAF. These results support that the red algae fiber can be used as an excellent reinforcement of biocomposites as "green-composite" or "eco-composite".

• Journal of the Korean Wood Science and Technology
• /
• v.25 no.1
• /
• pp.65-70
• /
• 1997

The effects on the enzymatic hydrolysis of waste paper treated with physical or chemical treatment were investigated. To gain the higher saccharification rate, physical or chemical treatment are necessary in enzymatic conversion process of waste paper. The major deterrents to the effective utilization of waste paper for enzymatic conversion process are phenolic compounds, cellulose crystallinity and coating materials. In the enzymatic hydrolysis of waste paper, the deterrents through enzymatic conversion process can be eliminated by the physical or chemical treatment. This study was performed to obtain the optimal condition for enzymatic conversion process of non-treated waste paper and to review effects on enzymatic conversion process of waste paper treated with physical or chemical methods. In the aspect of saccharification rate, waste paper treated with 1.5% sodium hypochlorite was the most effective and in physical treatment methods, multi-stage treatment(autohydrolysis+refining treatment) was more effective than the other physical treatment.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.28 no.7
• /
• pp.873-881
• /
• 2004

This research was aimed to investigate the effect of enzyme and the addition of chelators on rotting of the Kenaf bast. Enzyme rotting was effective only when the chelators were added with the enzyme. EDTA was a more effective chelator than oxalic acid under 1% concentration. There was no difference in the rotting effect under different enzyme concentration levels, and under different treatment time and temperature. Therefore, it was found that enzyme rotting can be carried out with low enzyme concentration(0.125%) at room temperature. Retting time can be shortened when higher enzyme concentration and higher temperature are applied. Cellulose I structure of kenaf fiber did not change after enzyme rotting, and different enzyme concentration did not affect the crytallinity structure. Non-cellulosic matters such as hemicellulose, lignin, and pectin were present in the descending order in the enzyme rotted kenaf fiber, and there were no differences in their amounts due to enzyme concentration levels. There was no difference in the dyeabilities of kenaf fiber rotted with different enzyme concentration levels. Enzyme rotted kenaf fiber showed better cyeability when pectin, lignin, and hemicellulose were removed.