• Journal of Environmental Science International
• /
• v.6 no.5
• /
• pp.521-529
• /
• 1997

In the study, we Investigated the behavior and removal efficiency of organics, nitrogen. phosphorus with operating conditions in SBRs. Substrate used was synthetic wastewater in which the ratio of $COD_{cr}$. : N : P was 100 : 12 : 2. The cycling the in SBRs was adjusted at 6 hours and 8 hours, and then certainly Included anaerobic and aerobic conditions. Also, for each cycling time. we performed 2 series of experiment simultaneously which was set up 10 days and 20 days as SRT. The removal efficiency of $COD_{cr}$. was over 97% in all operating conditions. In the 6 hours cycling time, the removal efficiency of $PO_4^{3-}-P$ reached almost 100% in steady state. And then we could observe a typical phonemena of phosphorus release and uptake, and the removal efficiency of N was 67%, Residual N source was almost TKN and most of the rest remained as $NO_2-N$. Also the difference in both SRTs was not observed practically. In the 8 hours cycling time, dissolution of sludge appeared. and, $PO_4^{3-}-P was not nearly removed but nitrogen was removed up to 75%, And the residual nitrogen was accumulated as $NO_2^--N$.

• Korean Journal of Organic Agriculture
• /
• v.19 no.4
• /
• pp.463-474
• /
• 2011

The objectives of this study were to establish of resource cycling agricultural system focused on farmer's organization. Case is selected as the farming corporation for the regional agriculture considering the amount of sowing by-products and livestock by-products generated. As a result, generation of fertilizer ingredient depend on feces and urine of Korean native cattle is estimated nitrogen 7.7 ton, phosphoric acid 2.9 ton, and potassium 4.9 ton. On the other hand, generation of fertilizer ingredient demand in cultivated acreage is estimated nitrogen 42.4 ton, phosphoric acid 14.3 ton, and potassium 17.0 ton. Therefore, optimum livestock numbers is estimated 1,867 cattle and it means 1,468 cattle can be raise additionally. In order to complete the resource cycling agricultural system, it should be establish nutrient management system at all of organization level and achieve improvements in regional resource supply. Both economic value of organic fertilizer and the resource cycling system linked market system is considered to develop resource cycling level.

• Proceedings of the Korean Society For Composite Materials Conference
• /
• 2002.10a
• /
• pp.38-42
• /
• 2002

An apparatus was developed to repetitively apply a $-196^{\circ}C$ thermal load to coupon-sized mechanical test specimens. Using this device, IM7/5250-4 (carbon / bismaleimide) cross-ply and quasi-isotropic laminates were submerged in liquid nitrogen ($LN_2$) 400 times. Ply-by-ply micro-crack density, laminate modulus, and laminate strength were measured as a function of thermal cycles. Quasi-isotropic samples of IM7/977-3 (carbon / epoxy) composite were also manually cycled between liquid nitrogen and an oven set at $120^{\circ}C$ for 130 cycles to determine whether including elevated temperature in the thermal cycle significantly altered the degree or location of micro-cracking. In response to thermal cycling, both materials micro-cracked extensively in the surface plies fellowed by sparse cracking of the inner plies. The tensile modulus of the IM7/5250-4 specimens was unaffected by thermal cycling, but the tensile strength of two of the lay-ups decreased by as much as 8.5%.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2003.05a
• /
• pp.151-155
• /
• 2003

An apparatus was developed to repetitively apply a -196 $^{\circ}C$ thermal load to coupon-sized mechanical test specimens. Using this device, IM7/5250-4 (carbon / bismaleimide) cross-ply and quasi-isotropic laminates were submerged in liquid nitrogen (L$N_2$) 400 times. Ply-by-Ply micro-crack density, laminate modulus, and laminate strength were measured as a function of thermal cycles. Quasi-isotropic samples of IM7/977-3 (carbon / epoxy) composite were also manually cycled between liquid nitrogen and an oven set at 120 $^{\circ}C$ for 130 cycles to determine whether including elevated temperature in the thermal cycle significantly altered the degree or location of micro-cracking. In response to thermal cycling, both materials micro-cracked extensively in the surface plies followed by sparse cracking of the inner plies. The tensile modulus of the IM7/5250-4 specimens was unaffected by thermal cycling, but the tensile strength of two of the lay-ups decreased by as much as 8.5 %.

• Journal of Environmental Science International
• /
• v.6 no.6
• /
• pp.697-709
• /
• 1997

Sequencing Batch Reactor(SBR) experiments for organics and nutrients removal have been conducted to find an optimum anaerobic/anoxic/aerobic cycling time and evaluate the applicability of oxidation-reduction potential(ORP) as a process control parameter. In this study, a 61 bench-scale plant was used and fed with night-soil wastewater in K city which contained TCODcr : 10, 680 mg/l, TBm : 6, 893 mg/l, $NH_4^+-N$ : 1, 609 mg/l, $PO_4^{3-}-P$ : 602 mg/l on average. The cycling time In SBRs was adjusted at 12 hours and 24 hours, and then certainly included anaerobic, aerobic and inoxic conditions. Also, for each cycling time, we performed 3 series of experiment simultaneously which was set up 10 days, 20 days and 30 days as SRT From the experimental results, the optimum cycling time for biological nutrient removal with nlght-soil wastewater was respctively 3hrs, 5hrs, 3hrs(anaerobic-aerobic-anoxic), Nitrogen removal efficiency was 77.9%, 77.9%, 81.7% for each SRT, respectively. When external carbon source was fed in the anoxic phase, ORP-bending point indicating nitrate break point appeared clearly and nitrogen removal efficiency increased as 96.5%, 97.1%, 98.9%. Phosphate removal efficiency was 59.8%, 64.571, 68.6% for each SRT. Also, we finded the applicability of ORP as a process control parameter in SBRs.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.56 no.1
• /
• pp.99-108
• /
• 2023

In this study, changes in biofloc-related and pathogenic bacteria in both low and high concentration biofloc breeding water planted with the halophyte (Triglochin maritimum were investigated). In the low-concentration biofloc breeding water, the ratio of bacteria related to the nitrogen cycle was initially 59.57% and, it decreased to 26.57% at the end of the experiment while other bacteria (excluding nitrogen-cycling bacteria and vibrios) increased from 38.75% to 73.43%. However, the planted experimental group maintained a relatively high ratio of nitrogen cycling bacteria at 58%. In the high-concentration experimental group, bacteria related to the initial nitrogen cycle, non-pathogenic vibrios, and pathogenic vibrios were 11.60, 36.28, and 20.14%, respectively. Finally, nitrogen-cycling bacteria were 36.47% in the control group and 37.55% in the planted group. The total number of vibrios decreased by 46.54% in the planted group and 48.01% in the control group, indicating a significant decrease in both experimental groups. However, the residual rate of pathogenic vibrios was 4.48% in the control group and 0.54% in the planted group. Overall, the planted group showed decreasing harmful bacteria and increasing useful bacteria.

• Corrosion Science and Technology
• /
• v.19 no.1
• /
• pp.31-36
• /
• 2020

An efficient wet process approach to modifying natural graphite (NG) electrodes for Li-ion batteries is introduced in this paper. With homogeneous mixing and thermal decomposition of NG with diammonium phosphate ((NH₄)₂HPO₄), phosphorus and nitrogen were successfully incorporated into the surface layer of NG particles. Electron microscopy and X-ray photoelectron spectroscopy analyses demonstrated that the surface was well modified by this process. As a result, the treated NG electrodes exhibited much improved electrochemical performance over pristine NG at two different temperatures: 25 ℃ and 50 ℃. Excellent capacity retention of 95.6% was obtained after 100 cycles at 50 ℃. These enhanced properties were confirmed in a morphology analysis on the cross-sections of the NG electrodes after galvanostatic cycling. The improved cycle and thermal stabilities can be attributed to the surface treatment with phosphorus and nitrogen; the treatment formed a stable solid electrolyte interphase layer that performed well when undergoing Li insertion and extraction cycling.

• Journal of Forest and Environmental Science
• /
• v.29 no.2
• /
• pp.116-124
• /
• 2013

Differences in rates and patterns of nitrogen cycling have been correlated with nitrogen stable isotope measurements in forest ecosystems of tropical and temperate regions, but limited similar work has been conducted in sub-tropical forests. This study investigated patterns in stable N isotopic composition in a subtropical forest in Taiwan by sampling three soil profiles and overstory and understory foliage. Soil ${\delta}^{15}N$ in the forest floor ranged from -1.8 to -1.8‰. Mineral soils had higher ${\delta}^{15}N$ (4.1 to 6.0‰). Foliage ${\delta}^{15}N$ in overstory trees ranged from -6.6 to -2.0‰, and understory foliage ${\delta}^{15}N$ ranged from -5.0 to -1.2‰. There was a weak correlation between foliar % N and ${\delta}^{15}N$ ($r^2=0.214$). Compared to results from similar surveys in tropical and temperate forests, foliar ${\delta}^{15}N$ values were generally lower. These results help highlight the need for improved knowledge regarding the relationships between patterns in N stable isotopes and processes affecting rates of N cycling, especially as related to wider scale patterns in forest ecosystems within the east-Asia region.

• Journal of Plant Biology
• /
• v.20 no.3
• /
• pp.109-118
• /
• 1977

Seasonal distribution of N, P and K contents and their cycling were studied in Korean oak (Quercus acutissima) and Korean alder (Alnus sibirica) stands in central part of Korean peninsula. The amounts of three minerals were high in young leaves but gradually decreased with the process of leaf development in both stands. The amounts of minerals in the branches, trunks and roots were decreased in summer, however, they increased again in autumn. Seansonal changes of these minerals were not significant in the two stands. The amounts of phosphorus and potassium in plant and soil were higher in the oak stand than the alder one, but those of nitrogen were reversed. The amounts of minerals absorbed during one year were greater in the oak stand than in the alder one, but those returned into soil through mineralization of litter were less in the former than in the latter. The nutrient requirements of the oak stand were greater than the alders, but the cycling rate, the ratio of the amount of minerals absorbed to returned, was opposite.

• Journal of Crop Science and Biotechnology
• /
• v.10 no.2
• /
• pp.57-63
• /
• 2007

Due to the strong influence of nitrogen(N) on plant productivity, a vast amount of N fertilizers is used to maximize crop yield. Over-use of N fertilizers leads to severe pollution of the environment, especially the aquatic ecosystem, as well as reducing farmer's income. Growing of N-efficient cultivars is an important prerequisite for integrated nutrient management strategies in both low- and high-input agriculture. Taking maize as a sample crop, this paper reviews the response of plants to low N stress, the physiological processes which may control N-use efficiency in low-N input conditions, and the genetic and molecular biological aspects of N-use efficiency. Since the harvest index(HI) of modern cultivars is quite high, further improvement of these cultivars to adapt to low N soils should aim to increase their capacity to accumulate N at low N levels. To achieve this goal, establishment and maintenance of a large root system during the growth period may be essential. To reduce the cost of N and carbon for root growth, a strong response of lateral root growth to nitrate-rich patches may be desired. Furthermore, a large proportion of N accumulated in roots at early growth stages should be remobilized for grain growth in the late filling stage to increase N-utilization efficiency. Some QTLs and genes related to maize yield as well as root traits have been identified. However, their significance in improving maize NUE at low N inputs in the field need to be elucidated.