• IE interfaces
• /
• v.21 no.2
• /
• pp.189-197
• /
• 2008

This study shows achievable capacity gain from the MMR system. Relay stations are placed along the cell boundary in tiers. We can have as many tiers of relays and as many relays in each tier as we want. A model is developed, which can estimate the system capacity varying the number of relays in each tier and the bandwidths allocated to the BS and the RS. It is shown that maximum capacity increases are 21.5% and 18.9% when we have relays in the first tier only and in the first and the second tiers, respectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37B no.12
• /
• pp.1138-1147
• /
• 2012

IEEE standard 802.16, often referred to as WiMAX, is considered a "last mile" broadband wireless access alternative to conventional DSL and Cable Internet. One extension that is recently receiving great attention is the IEEE 802.16j Mobile Multihop Relay (MMR) amendment. The focus of this amendment is the development of simple and lower cost relay stations (RSs) that can enhance network coverage and capacity. We use our proposed simple scheduling scheme for serving the SSs in a fair manner and evaluate the performance of WiMAX networks with relays, especially we analyze the impact of interference between RSs on cell throughput Through simulations and numerical analysis, we make several fundamental observations about interference aware cost effective coverage extension in such networks.

• ETRI Journal
• /
• v.33 no.4
• /
• pp.558-568
• /
• 2011

In this paper, we propose an efficient macrodiversity handover (MDHO) technique for time-division-based interference-limited IEEE 802.16j multihop wireless relay networks. In the proposed MDHO, when the diversity set members of the mobile station (MS) are a base station (BS) and relay station (RS), the MS receives the signal transmitted by the BS in the first phase. During the second phase, it also receives the simultaneous transmissions of the BS and RS. Furthermore, when the diversity set members are two RSs or two BSs, the MS receives only the simultaneous transmissions of the diversity set members. The superiority of the proposed MDHO is validated using analytical and simulation results. The performance analysis metrics are the average downlink (DL) carrier to interference and noise ratio (CINR), the average DL spectral efficiency, and the average service outage probability. Evaluation results show that the proposed MDHO significantly outperforms the conventional MDHO. The CINR gain achieved using the proposed MDHO is 4.71 dB compared to the conventional MDHO.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.11B
• /
• pp.1030-1037
• /
• 2008

This paper presents an algorithm for the path-finding problem in unknown environments with cooperative and commutative multi-robots. To verify the algorithm, we investigate the problem of escaping through the exit of a randomly generated maze by muti-robots. For the purpose, we adopt the so called frontier cells and cell utility functions, which were used in the exploration problem for the multi-robots. For the wireless communications among the mobile robots, we modify and utilize the so called the random basket routing, a kind of hop-by-hop opportunistic routing. A mobile robot, once it finds the exit, will choose its next action, either escape immediately or stay-and-relay the exit information for the others, where the robot takes one action based on a given probability. We investigate the optimal probability that minimizes the average escaping time (out of the maze to the exit) of a mobile robot.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.11
• /
• pp.5264-5281
• /
• 2017

Multihop relay-based cellular networks are attracting much interest because of their throughput enhancement, coverage extension, and low infrastructure cost. In these networks, relay stations (RSs) between a base station (BS) and mobile stations (MSs) drastically increase the overall spectral efficiency, with improved channel quality for MSs located at the cell edge or in shadow areas, and enhanced throughput of MSs in hot spots. These relay-based networks require an advanced radio resource management scheme because the optimal amount of radio resource for a BS-to-RS link should be allocated according to the MS channel quality and distribution, considering the interference among RSs and neighbor BSs. In this paper, we propose optimal resource planning algorithms that maximize the overall utility of relay-based networks under a proportional fair scheduling policy. In the first phase, we determine an optimal scheduling policy for distributing BS-to-RS link resources to RSs. In the second phase, we determine the optimal amount of the BS-to-RS link resources using the results of the first phase. The proposed algorithms efficiently calculate the optimal amount of resource without exhaustive searches, and their accuracy is verified by comparison with simulation results, in which the algorithms show a perfect match with simulations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.12A
• /
• pp.1198-1206
• /
• 2010

Recently smart phone and tablet PC are regarded as the most valuable mobile devices, so the demand of customers for multimedia supporting has been greatly increased. The network operators are now considering the deployment of relay stations ensuring low installation costs for its service cell to improve the cell capacity. Enhancing the relay stations, however, increases intra-cell interference, which is affecting the quality of service and outage ratio. In this paper, we present MPFR(Multihop Partial Frequency reuse) as the new frequency reuse scheme to increase cell throughput while maintaining low outage ratio for the OFDMA cellular multihop networks. Dynamic power control is also introduced to improve cell capacity. Overall cell throughput and outage ratio are observed by the simulation, and comparison between MPFR and conventional multihop frequency reuse schemes is convincing the performance enhancement.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.1
• /
• pp.43-51
• /
• 2015

Upcoming cellular networks such as LTE-advanced and IEEE 802.16m are enhanced by relay stations to support high data rate multimedia services and minimize the shadow zone with low cost. Enhancing the relay stations, however, divides the multihop cellular network into smaller microcells and the distance between microcells is closer, which intends large intra-cell and inter-cell interference. Especially the access link on downlink in the OFDMA cellular network is the throughput bottleneck due to the severe interference caused by base stations and relay stations transmitting large data to mobile stations simultaneously. In this paper, we present interference aware channel allocation algorithm to avoid severe interference on multihop cellular networks with random topology. Proposed algorithm increases SINR(signal to interference plus noise ratio) and decreases number of required control messages for channel allocation, so that increases overall throughput on the networks.

• ETRI Journal
• /
• v.32 no.2
• /
• pp.230-240
• /
• 2010

The IEEE802.16j standard uses non-transparent relay stations to extend coverage. There are two types of non-transparent relay modes, that is, the time-division transmit and receive (TTR) relay mode which can operate with one of two types of frame structures, a single-frame and multiframe structure, and the simultaneous transmit and receive (STR) relay mode. In this paper, we analyze the relay performance of TTR and STR relay modes in IEEE 802.16j MMR system. We also propose a fair resource allocation scheme for the downlink relay frame. Numerical results show that relay performance of the TTR with a single-frame or a multiframe structure and that of the STR relay modes are almost the same in a two-hop system. However, in a three-hop system, the TTR mode with a single-frame structure outperforms other relay modes.

• ETRI Journal
• /
• v.35 no.2
• /
• pp.234-244
• /
• 2013

Internet protocol television (IPTV) service depends on the network quality of service (QoS) and bandwidth of the broadband service provider. IEEE 802.16j mobile multihop relay Worldwide Interoperability for Microwave Access networks have the opportunity to offer high bandwidth capacity by introducing relay stations. However, to actually satisfy QoS requirements for offering IPTV services (HDTV, SDTV, Web TV, and mobile TV) for heterogeneous users' requests, providers must use a video server for each IPTV service type, which increases the network load, especially bandwidth consumption and forwarding time. In this paper, we present a solution for forwarding IPTV video streaming to diverse subscribers via an 802.16j broadband wireless access network. In particular, we propose a new multicast tree construction and aggregation mechanism based on the unique property of prime numbers. Performance evaluation results show that the proposed scheme reduces both bandwidth consumption and forwarding time.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.2
• /
• pp.618-633
• /
• 2014

Relay technology is becoming more important for mobile communications and wireless internet of things (IoT) networking because of the extended access network coverage range and reliable quality of service (QoS) it can provide at low power consumption levels. Existing mobile multihop relay (MMR) technology uses fixed-point stationary relay stations (RSs) and a divided time-frame (or frequency-band) to support the relay operation. This approach has limitations when a local fixed-point stationary RS does not exist. In addition, since the time-frame (or frequency-band) channel resources are pre-divided for the relay operation, there is no way to achieve high channel utilization using intelligent opportunistic techniques. In this paper, a different approach is considered, where the use of mobile/IoT devices as RSs is considered. In applications that use mobile/IoT devices as relay systems, due to the very limited battery energy of a mobile/IoT device and unequal channel conditions to and from the RS, both minimum energy consumption and QoS support must be considered simultaneously in the selection and configuration of RSs. Therefore, in this paper, a mobile RS is selected and configured with the objective of minimizing power consumption while satisfying end-to-end data rate and bit error rate (BER) requirements. For the RS, both downlink (DL) to the destination system (DS) (i.e., IoT device or user equipment (UE)) and uplink (UL) to the base station (BS) need to be adaptively configured (using adaptive modulation and power control) to minimize power consumption while satisfying the end-to-end QoS constraints. This paper proposes a minimum transmission power consuming RS selection and configuration (MPRSC) scheme, where the RS uses cognitive radio (CR) sub-channels when communicating with the DS, and therefore the scheme is named MPRSC-CR. The proposed MPRSC-CR scheme is activated when a DS moves out of the BS's QoS supportive coverage range. In this case, data transmissions between the RS and BS use the assigned primary channel that the DS had been using, and data transmissions between the RS and DS use CR sub-channels. The simulation results demonstrate that the proposed MPRSC-CR scheme extends the coverage range of the BS and minimizes the power consumption of the RS through optimal selection and configuration of a RS.