• Journal of the Korean Home Economics Association
• /
• v.20 no.2
• /
• pp.73-84
• /
• 1982

The purpose of this study was to develop a basic bodice pattern and establish standards regrading to the size and grading of Korean misses' measurements in order to provide modern data for the ready-to-wear garment industry. 222 girls, aged from 18 to 27, were measured on 19 items of their structure. Mean, standard deviation, coefficient of variance, maximum, minimum, range and correlation coefficient between each items were analized. The analysis revealed the following significant results. The fundamental difference data of the bodice pattern and grading measurements between the year of 1975 and 1981 were as follow. (1) The measurements of bust and center back were used as a foundation to establish a standard size and grading. (2) Ranges of the bust circumference measurements were increased. Thus the sizes ere classfied into 5 groups. (3) The ease of bust circumference was increased due to the increasement of shoulder width. (4) The increase of the upper arm resulted to lower the bust line. (5) The shoulder slopes were higher than 1975. Therefore, the basic measurements of the shoulder slopes were reduced. (6) In spite of the front neck measurements were not changed, the back measurements were requied to increase. (7) the center front length became much shorter in the contrast with the increase of the center back length.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.24 no.2
• /
• pp.155-163
• /
• 2012

The aim of this study is to evaluate the performance of the GHP system with 150 energy piles for a commercial building. In order to demonstrate the feasibility of a sustainable performance of the system, simulations were conducted over 1-year and 20-year periods, respectively. The 1-year simulation results showed that the maximum and minimum temperatures of brine returning from the energy piles were $23.80^{\circ}C$ and $7.90^{\circ}C$, which were in a range of design target temperatures. In addition, after 20 years' operation, these returning temperatures decreased slowly to $23.05^{\circ}C$ and $6.98^{\circ}C$, and finally reached to stable state. The results also showed that the energy piles injected heat of 65.6 MWh to the ground and extracted heat of 96.0 MWh from the ground, respectively. Also, it is expected this GHP system with energy piles can operate with average SPF of more than 4.15 for long term.

• Steel and Composite Structures
• /
• v.35 no.2
• /
• pp.295-306
• /
• 2020

This paper deals with free vibration analysis of non-uniform column resting on elastic foundations and subjected to follower force at its free end. The internal pores and graphene platelets (GPLs) are distributed in the matrix according to different patterns. The model is proposed with material parameters varying in the thickness of column to achieve graded distributions in both porosity and nanofillers. The elastic modulus of the nanocomposite is obtained by using Halpin-Tsai micromechanics model. The differential quadrature method as an efficient and accurate numerical approach is used to discretize the governing equations and to implement the boundary conditions. It is observed that the maximum vibration frequency obtained in the case of symmetric porosity and GPL distribution, while the minimum vibration frequency is obtained using uniform porosity distribution. Results show that for better understanding of mechanical behavior of nanocomposite column, it is crucial to consider porosities inside the material structure.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.39 no.5
• /
• pp.297-311
• /
• 2021

Around the world, there is an increasing interest in Digital Twin cities. Although geospatial data is critical for building a digital twin city, currently-established spatial data cannot be used directly for its implementation. Integration of geospatial data is vital in order to construct and simulate the virtual space. Existing studies for data integration have focused on data transformation. The conversion method is fundamental and convenient, but the information loss during this process remains a limitation. With this, standardization of the data model is an approach to solve the integration problem while hurdling conversion limitations. However, the standardization within indoor space data models is still insufficient compared to 3D building and city models. Therefore, in this study, we present a comparative analysis of data models commonly used in indoor space modeling as a basis for establishing a generic indoor space feature model. By comparing five models of IFC (Industry Foundation Classes), CityGML (City Geographic Markup Language), AIIM (ArcGIS Indoors Information Model), IMDF (Indoor Mapping Data Format), and OmniClass, we identify essential elements for modeling indoor space and the feature classes commonly included in the models. The proposed generic model can serve as a basis for developing further indoor feature models through specifying minimum required structure and feature classes.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.46 no.spc
• /
• pp.54-60
• /
• 2023

The government focuses on promoting start-ups, fostering ventures, and creating an ecosystem of start-ups through the formation of a strong growth environment for small businesses. This study provides academic and practical implications about ways of improving our business incubator's support service across stages of growth through IPA. To this end, an Importance-Performance Analysis (IPA) was conducted to analyze relationship and differences in importance and satisfaction of business incubator's support service support at business incubation center. These results present to provide the following academic and practical implications. The academic implications are the need for differences in support services for each phase of start-up growth. As factors that could increase the likelihood of successful start-up were identified in each phase of the start-up growth, important information needed for policy and strategy was provided. As a practical suggestion, the managers and expert groups are presented with sections to be opened for each start-up growth stage, minimum effort input, and areas to be maintained continuously. A systematic support plan is established and a foundation is provided for improvement measures in efficient start-up business incubator's support service.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.11
• /
• pp.144-150
• /
• 2019

In this study, resistance spot welding was performed using a high tensile steel plate SGAFC 780. The shear tensile strength, fracture profile, nugget diameter, and simulation were compared according to the conditions. After the nugget diameter calibration, the minimum diameter of welding was more than 4.3mm when the welding current was 8kVA or more. At 9kVA and above 10kVA, the minimum nugget diameter of 4.3mm was satisfied. On the other hand, due to the high current and time, the fly phenomenon occurred and the deep indentation remained. An evaluation of the weldability confirmed that there was an interval that was evaluated as weld failure due to the creep phenomenon, which satisfied the tensile shear strength and minimum nugget diameter. On the other hand, areas that have sufficient load bearing capacity even when drift has occurred were also identified. The simulation results show that the error rate was less than 4.2% when comparing the nugget diameter in the simulation and the experimental results in the appropriate weld zone, and confirmed the reliability of the simulation.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.46 no.3
• /
• pp.327-334
• /
• 2017

Water and 75% ethanol extracts were prepared from defatted green tea seeds and evaluated for their anti-yeast activities. The antimicrobial activities of defatted green tea seed extracts (DGTSEs) were tested against food-spoilage bacteria, yeasts, and molds. DGTSEs exhibited antimicrobial activities with minimum inhibitory concentrations of $39{\sim}1,250{\mu}g/mL$ against three bacteria, two molds, and all tested yeast strains. Ethanol extract showed higher antimicrobial activity than water extract. The stability of anti-yeast activities of DGTSEs was examined under different conditions of temperature, pH, and NaCl concentrations. The anti-yeast activities of DGTSEs were stable at pH 3~9, 0~20% NaCl, and $100^{\circ}C$ for 30 min. However, anti-yeast activities of DGTSEs decreased upon heating at $70^{\circ}C$ for 24 h or $121^{\circ}C$ for 15 min. DGTSEs were applied to food models to determine their inhibitory effects on yeast film formation. Water and 75% ethanol extracts were effective in preventing yeast film formation at concentrations more than 156 and $39{\mu}g/mL$ in soy sauce, 156 and $78{\mu}g/mL$ in pickle sauce, and 78 and $39{\mu}g/mL$ in kimchi, respectively.

• Korean Journal of Environment and Ecology
• /
• v.18 no.4
• /
• pp.446-455
• /
• 2004

This study has been conducted as a basic research for developing efficient ways of managing Korean National Parks by finding differences via the comparison of present management systems of national parks in Korea and Japan. The survey was conducted through telephone interviews and direct interviews with staffs of related organizations as well as related literature study. In result, it is found that Japanese national parks have a numerical standard of minimum area, with less staff than Korea, and larger designated areas are being managed. Management organizations of both countries are divided as main and commission. In Korea, 6 staff in Natural Resources Division under Ministry of Environment are managing main organization, and in Japan, 53 staff of 3 divisions(National Park Division, Natural Environment Management Division, General Affairs Division) are taking charge of it. Moreover, General Affairs Division, dividing whole country into 11 blocks, manages 11 units of natural preservation offices, 12 branch offices, and 67 units of nature preservation management offices. In case of commission, Foundation of Natural Park Beautification & Management in Japan has a headquarter and 20 branch offices with 54 staff who are only doing site management, while in Korea, the National Parks Management Corporation has a headquarter and 25 offices with 748 staff carrying out main office jobs and site management side by side. From the differences in both countries, we could suggest efficient measures for our national park management as follows: \circled1 introduction of numerical value as criteria for national park designation, \circled2 review of use zone, \circled3 division of the national park management office into site office and regional office, with dividing works and re-posting staff, \circled4 enlargement of park management division in Department of Environment, \circled5 National Park authority becomes a national public servant

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.13 no.4
• /
• pp.183-196
• /
• 2018

In this study, we conducted in - depth interviews of young entrepreneurs who are currently in the process of establishing new entrepreneurs management diagnosis and consulting for young entrepreneurs, and found the common difficulties experienced in young entrepreneurs' perception of entrepreneurship, In addition, through a case study, we verified product suitability through customer issue / solution suitability, idea marketability verification and MVP (Minimum Viable Product) using Lean Canvas according to the structure of Lean Start-up It is aimed at voluntary management diagnosis and consulting of small business owners, activation of young entrepreneurs' entrepreneurship, and reduction of startup failure rate. The purpose of this study is to examine the items of five young entrepreneurs from the perspective of the customer for about 10 months, focusing on the case of small entrepreneurs in the small entrepreneurs support project. Or we could provide the customer's problem or solution based on Lean Start-up. This study was conducted as a case - based qualitative study due to the limited sample and it is hoped that this study will be used as a basic research to verify the effectiveness of the lean start-up methodology for small business owners through quantitative research.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.3
• /
• pp.481-487
• /
• 2020

This study examined the behavior change of river levees during an earthquake by numerical analysis. Unlike conventional research using artificial earthquake waves, earthquake analysis was performed using real earthquake waves. The behavior of a river levee before and after an earthquake was compared and analyzed quantitatively. Studies show that the river levee has a safety factor of approximately 28.5% due to an earthquake. On the other hand, the minimum standard safety factor is satisfied. Vertical effective stress has decreased by 81.8% due to excess pore-water pressure generated by the earthquake. In addition, liquefaction occurs in most of the foundation soil. An examination of the stress-displacement behavior due to the earthquake revealed a large amount of settlement in the backfill layer. Most of the foundation soil yielded. Therefore, the target river levee is quite vulnerable to earthquakes. Through the results of this study, the necessity of refreshing the seismic design standards for river levees is required. This study can be used as basic data for estimating the approximate damage level and vulnerable areas.