• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.184-185
• /
• 2006

The flux-lock type superconducting fault current limiter (SFCL) has the attractive characteristics that can adjust the current limiting level by the turns ratio between two coils. Since the recovery characteristics of a superconducting element m the flux-lock type SFCL were dependent on the turns ratio between two coils, the analysis for the recovery characteristics of this type SFCL together with the current limiting characteristic is necessary to apply it to power system. When the applied voltage and load impedance were same, the recovery time of the superconducting element was 0.32sec in case that the turn's ratio between the primary and secondary windings was 63:21. In the meantime, when the turn's ratio of secondary winding increased to 3 times, the recovery time became longer to 0.58sec.

• Journal of Magnetics
• /
• 제15권2호
• /
• pp.91-98
• /
• 2010

The paper presents results of a study on the selective separation technology of ferrous and non-ferrous metals from broken light bulbs. The proposed method is to use magnetic fluids to obtain a magnetic fluid based- separation. [1] The study was conducted using three types of waste materials: regular light bulbs, auto light bulbs and neon tubes. In order to process the waste materials, a six stages technologic flow was developed: a) separation of light bulbs components; b) Physical and chemical analysis of raw materials; c) grain conditioning of the raw material; d) dry magnetic separation of ferrous components; e) magnetic fluid separation of non-magnetic material; f) recovery of the magnetic fluid adhered to the surface of the separated material grains. [2] This study shows that magnetic fluid separation is only profitable for regular and auto light bulbs and is not profitable in the case of neon tubes.

• 한국전기전자재료학회논문지
• /
• 제16권11호
• /
• pp.1001-1007
• /
• 2003

The silicone fluids have been generally used as processing agent in silicone rubber(SIR) compounding. The addition of hydroxy silicone (HS) fluids to SIR for insulator housing material is required to meet the good electrical performance and the good processability. In this study, SIR with HS fluids was evaluated to investigate how the kinds of them affect insulation properties. The contact angle of the virgin sample of 40-HS SIR was low and its recovery rate was also slow. The recovery rate of 50-HS SIR was the highest being decreased with the viscosity increase of HS fluids. The tracking resistances and the corona aging resistance of 70-HS SIR and 1,040-HS SIR were excellent Tracking resistance depended largely on heat resistance of silicone fluids. But arc resistance didn't depend merely on the kind of silicone fluids.

• 자원리싸이클링
• /
• 제30권3호
• /
• pp.63-69
• /
• 2021

폐기물에서의 납 회수 및 재활용을 통해 원료공급 안정화와 환경오염 예방을 동시에 도모할 수 있고 실제로도 최근 폐납축전지 위주의 재활용을 통해 납 원자재 공급 측면에서 긍정적인 효과를 보고 있다. 다만 향후 납 회수 및 재활용의 효과를 극대화하기 위해서 납의 물질 흐름의 현황을 효과적으로 파악할 필요가 있는데, 배출원 등의 복잡성과 다양성으로 인해 관련 조사가 번거로울 수 있다. 이 경우 편의상 인터넷 공개자료를 통한 예비 조사의 선수행이 효과적일 수 있다. 따라서, 본 연구에서는 공공기관 공개자료를 통해 국내 납의 흐름을 파악하여 향후 납 회수/재활용에 효율성을 기여하고자 한다. 이에 본 연구에서는 UN Comtrade와 국내 화학물질배출×이동량 사이트 자료를 이용하여 납의 수입량 및 배출×이동량을 파악하고 이를 국가통합자원관리시스템에서 제시된 납의 흐름과 비교하였다. 그 결과 폐납축전지 등 주요 항목별 관련 납의 흐름이 각 사이트 간에 대략적인 일치를 보였다.

• 한국자원리싸이클링학회:학술대회논문집
• /
• 한국자원리싸이클링학회 2004년도 춘계임시총회 및 제23회 학술대회
• /
• pp.92-97
• /
• 2004

• 자원리싸이클링
• /
• 제16권5호
• /
• pp.51-56
• /
• 2007

플라스틱은 아주 유용한 물질로서 우리 일상생활에 폭넓게 이용되고 있다. 국내에서는 약 400 만톤의 폐플라스틱이 발생되고 있지만 재활용율은 30% 이하로 대부분 소각이나 매립에 의해 처리되고 있다. 따라서 폐플라스틱을 재활용할 수 있는 재질분리 기술개발 필요한 실정이다. 본 연구에서는 폐플라스틱 종말품으로부터 PET 회수를 위한 마찰하전 정전선별이 수행되었다. 하전특성 연구결과에 의하면, PET와 PVC의 하전극성과 하전량은 HDPE와 PP의 하전물질 그리고 상대습도가 낮을수록 효과적이었다. HDPE 싸이클론 하전장치를 이용한 재질분리 실험결과, PET의 품위와 회수율은 전극전압 30 kV 이상, 분리대위치 -2cm의 조건에서 각각 96.8%와 85.0%로 얻어졌으며, 분리대의 위치(-6cm)에 따라 PET 회수율이 24% 감소하지만 품위를 98.5%까지 분리할 수 있는 기술을 개발하였다.

• 한국의류산업학회지
• /
• 제9권4호
• /
• pp.445-449
• /
• 2007

The results of warmth retaining, heat transfer and compressive elastic recovery of the five kinds of bedspread fabrics, which were produced from packing weft of 2700 denier and 3600 denier batt yarn treated with raw material of Polyester $150^D$/48 DTY, are as follows: 1) 3600 denier packing weft showed lover count in compressive elastic recovery than 2700d packing weft, so it took longer time to recover. 2) When packing weft of the same count is used, a sample of packing weft with higher density showed lower recovery. 3) It took 2700d packing weft 30min to get approximately 98% recovery in temperature $30^{\circ}C$. But, 3600d packing weft stayed under 98% recovery in the same temperature. Considering only the result of compressive elastic recovery, we should use 2700d packing weft. 4) The higher the density of packing weft is, the higher warmth retaining becomes. Although sharp increase appeared until 5min, equilibrium was kept without any increase after that time. 5) When 2700d packing weft was used, the maximum warmth retaining was approximately 60% and 64% in the conditions of density 12(thread/in) and 22(thread/in) respectively.

• 식품보건융합연구
• /
• 제7권3호
• /
• pp.25-32
• /
• 2021

This study examined the effects of kinesio taping on recovery from fatigue induced by an exercise of concentric contraction using an isokinetic machine. The fatigue was introduced by a mode of exercise at 60°/sec, 50 repetitions for three sessions. The changes of blood ammonia, lactate, LDH, and CK as a marker of fatigue were monitored. Eight healthy collegiate students participated in two experiments; 1) kinesio taping application condition and 2) no kinesio taping application condition. Before experiments, their physical characteristics were measured. For the experiment, blood samples were taken before and immediately after exercise, and 24hr as well as 72hr of recovery period. Window SPSS package 12.0 version was used and one-way ANOVA with repeated measures were employed. The results were as follows. 1) Blood ammonia tended to reduce along the recovery, but no differences between conditions were noticed. 2) Blood lactate tended to reduce during the recovery period, but differences between conditions were not noticed. 3) The LDH was not different between conditions and CK tended to reduce during the recovery period, but differences between conditions were not noticed. Based on the results, kinesio taping did not influence on recovery phase of blood ammonia, lactate concentration, LDH, and CK.

• 품질경영학회지
• /
• 제47권3호
• /
• pp.615-630
• /
• 2019

Purpose: Based on the theory of "Stimulus-Organism-Response" (S-O-R), this thesis takes customer forgiveness as a medium variable to explore the impact of merchant service remedy on customer behavior intention in the context of online shopping service failure. This thesis divides the merchant service remedy into two dimensions: spiritual recovery and material recovery, and reveals the influence difference of different merchant service remedy methods on customer behavior intention and the mediating role of customer forgiveness. Methods : 325 questionnaires were distributed and 307 valid questionnaires were collected for data analysis. The relationship between potential variables is proposed by using Structural Equations Modeling. Results : The two dimensions of service recovery have significant positive impact on customer forgiveness, and physical recovery has greater impact on customer forgiveness. In the influence of physical recovery on customer behavior intention, customer forgiveness is a partial mediating effect. However, in the influence of spiritual recovery on customer behavior intention, customer forgiveness is a complete mediating effect. Conclusion : In case of service faults, merchants should take the initiative to provide appropriate physical recovery and provide spiritual recovery sincerely and patiently. Only in this way can they regain good impression in the hearts of consumers and promote them to improve the quality of service recovery, so as to increase their willingness to repurchase Intention and positive word of mouth.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2009년도 하계학술발표대회 논문집
• /
• pp.1272-1276
• /
• 2009

The purpose of this study is to introduce wasted heat recovery heat exchanger for different kind of material in HVAC systems in field. For the purpose of estimating the large volume rotary heat exchanger and cross flow plate heat exchanger in heat recovery ventilator.