• Geomechanics and Engineering
• /
• v.18 no.6
• /
• pp.567-574
• /
• 2019

In order to study the effect of stress and water pressure on the permeability of fractured rock mass under three-dimensional stress conditions, a single fracture triaxial stress-seepage coupling model was established; By using the stress-seepage coupling true triaxial test system, large-scale rock specimens were taken as the research object to carry out the coupling test of stress and seepage, the fitting formula of permeability coefficient was obtained. The influence of three-dimensional stress and water pressure on the permeability coefficient of fractured rock mass was discussed. The results show that the three-dimensional stress and water pressure have a significant effect on the fracture permeability coefficient, showing a negative exponential relationship. Under certain water pressure conditions, the permeability coefficient decreases with the increase of the three-dimensional stress, and the normal principal stress plays a dominant role in the permeability. Under certain stress conditions, the permeability coefficient increases when the water pressure increases. Further analysis shows that when the gob floor rock mass is changed from high stress to unloading state, the seepage characteristics of the cracked channels will be evidently strengthened.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.19 no.1
• /
• pp.3-14
• /
• 1982

In this paper, the sway added mass of a rectangular cylinder in a restricted water is considered by applying Hamilton's principle as the frequency tends to zero. The present method is an extension of Isshiki's method proposed in 1978. In the present method, it is assumed that the fluid velocity distribution in each subdomain of the fluid can be represented by higher order polynomials while Isshiki assumed linear velocity distribution. The fluid flow is assumed as a rotational motion in the present analysis. However, the results obtained from the present method show good agreement with Bai's numerical results for the case of large clearances between a canal wall and a cylinder. From Kelvin's minimum energy theorem, we can see that the value of sway added mass obtained from the present method approaches the upper bound. The approximate formula obtained in the present study takes a simple form which consists of the dimensions of the canal and the cylinder. The present formulae are derived for the cases of a rectangular cylinder swaying at the center of a narrow or wide canal relative to a cylinder, at off-center location in a canal, and in the restricted water with a single wall. From the results of numerical calculation, it is concluded that the sway added mass in restricted waters is more affected by water depth than clearance between a wall and a cylinder.

• Tunnel and Underground Space
• /
• v.31 no.6
• /
• pp.480-493
• /
• 2021

Since the generalized Hoek-Brown criterion (GHB) provides an efficient way of identifying its strength parameter values with the consideration of in-situ rock mass condition via Geological Strength Index (GSI), this criterion is recognized as one of the standard rock mass failure criteria in rock mechanics community. However, the nonlinear form of the GHB criterion makes its mathematical treatment inconvenient and limits the scope of its application. As an effort to overcome this disadvantage of the GHB criterion, the explicit approximate analytical equations for the minimum principal stress, which is associated with the maximum principal stress at failure, are formulated based on the Taylor polynomial approximation of the original GHB criterion. The accuracy of the derived approximate formula for the minimum principal stress is verified by comparing the resulting approximate minimum principal stress with the numerically calculated exact values. To provide an application example of the approximate formulation, the equivalent friction angle and cohesion for the expected plastic zone around a circular tunnel in a GHB rock mass are calculated by incorporating the formula for the approximate minimum principal stress. It is found that the simultaneous consideration of the values of mi, GSI and far-field stress is important for the accurate calculation of equivalent Mohr-Coulomb parameter values of the plastic zone.

• Herbal Formula Science
• /
• v.22 no.2
• /
• pp.105-120
• /
• 2014

Objectives : This study was investigated the improvement effects of Gangjihwan (DF) and combination of Gangjihwan and Gamisochehwan (GSH) on obesity in a high fat diet-fed obese mouse model. Methods : Eight-week-old C57BL/6N mice were divided into four groups: a normal lean group given a standard diet, an obese control group given a high fat diet, and DF and DF+GSH groups given a high fat diet with DF (40 mg/kg), and DF+GSH (80 mg/kg), respectively. After 8 weeks of treatment, body weight gain, feeding efficiency ratio, blood lipid markers, fat weight and histology were examined. Results : 1. Body weight gain and fat mass were significantly decreased in DF and DF+GSH groups compared with control. The extent of decreases was eminent in DF+GSH group. 2. Feeding efficiency ratio and circulating concentration of leptin were decreased in DF and DF+GSH groups compared with control. These decreases were significant in DF+GSH group. 3. Consistent with their effects on body weight gain and fat mass, circulating concentrations of triglyceride, glucose and insulin were decreased in DF and DF+GSH groups compared with control. 4. The size of adipocytes was decreased by DF and DF+GSH compared with control, whereas the adipocyte number per unit area was increased by them, suggesting that DF and DF+GSH decreased the number of large adipocytes. 5. Consistent with their effects on body weight gain, liver fibrosis was also improved in DF and DF+GSH groups compared with control. Conclusions : In conclusion, these results suggest that DF and DF+GSH groups decrease feeding efficiency ratio, plasma leptin concentration, blood anti-obesity biomarkers and fat mass, improves body weight gain contributing to the inhibition of liver fibrosis. In addition, these effects were more effective in DF+GSH combination group than in DF-only group.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 1993.10a
• /
• pp.443-452
• /
• 1993

Direct freezing tests of soybean seed by liquid nitrogen were carried out at various moisture contents and the following important conclusions were drawn from the results of temperature measurements of soybean seed and photographs of bubbles generated on its surface : 1) Assuming that the temperature gradient in a soybean seed is negligible because of its small seed size and the freezing ratio is followed the Heiss's formula, and a differential equation based on the heat energy balance was introduced . The equation was easily solved by the Runge-Kutta-Gill method and the predicted values of the temperature were in good agreement with the observed data. 2) The photographs of bubble generation during freezing showed the boiling mode was nucleate, and then the most suitable formula on the nucleate boiling heat transfer was introduced from many formulate proposed up to now by fitting the calculated values based on the formula to the observed data. The formula used for the predict on of the seed temperature was as follows: $\frac{{\partial}T_s}{\partial\theta}\;=\;-\frac{{\alpha}(T_s\;-\;T_L)^{3.3}}{W(C_s\;-\;\frac{{\delta}m(CT_s\;+\;{\sigma})}{T_s^2})}$ where C = difference of the specific heat between pure ice and water m=moisture content of soybean seed $T_s$ = seed temperature $T_L$ = Temperature of liquid nitrogen W = mass of soybean seed $\alpha$ = proportional constant $\delta$ = constant depends on variety or the type of seed $\theta$ = time $\sigma$ = latent heat of melting of pure ice This study will give important information in the hydro-freezing technique by liquid nitrogen, available as a new technique of processing agricultural products in the near future.

• The Journal of Advanced Prosthodontics
• /
• v.6 no.5
• /
• pp.333-345
• /
• 2014

PURPOSE. Bonding agents (BA) are the crucial weak link of composite restorations. Since the commercial materials' compositions are not disclosed, studies to formulize the optimum ratios of different components are of value. The aim of this study was to find a proper formula of BAs. MATERIALS AND METHODS. This explorative experimental in vitro study was composed of 4 different sets of extensive experiments. A commercial BA and 7 experimental formulas were compared in terms of degree of conversion (5 experimental formulas), shear bond strength, mode of failure, and microleakage (3 experimental formulas). Statistical analyses were performed (${\alpha}$=.05). The DC of selected formula was tested one year later. RESULTS. The two-way ANOVA indicated a significant difference between the shear bond strength (SBS) of two tissues (dentin vs. enamel, P=.0001) in a way that dentinal bonds were weaker. However, there was no difference between the four materials (P=.283). The adhesive mode of failure was predominant in all groups. No differences between the microleakage of the four materials at occlusal (P=.788) or gingival (P=.508) sites were detected (Kruskal-Wallis). The Mann-Whitney U test showed a significant difference between the microleakage of all materials (3 experimental formulas and a commercial material) together at the occlusal site versus the gingival site (P=.041). CONCLUSION. A formula with 62% bisphenol A-glycidyl methacrylate (Bis-GMA), 37% hydroxy ethyl methacrylate (HEMA), 0.3% camphorquinone (CQ), and 0.7% dimethyl-para-toluidine (DMPT) seems a proper formula for mass production. The microleakage and SBS might be respectively higher and lower on dentin compared to enamel.

• Korean Journal of Community Nutrition
• /
• v.18 no.1
• /
• pp.45-54
• /
• 2013

This study was conducted to investigate the physical activity pattern, activity coefficient, basal metabolic rate and energy expenditure of female university students. One-day activity diaries were collected from 95 female university students in Seoul. Body composition was measured by Inbody 720. Subjects spent 7 hr 8min on sleeping, 6 hr 31min on studying, 2 hr 50min on physiological activity, 2 hr 3min on leisure, 2 hr 2min on walking and jogging, 1 hr 58 min on commuting and 22min on house chores. The activity coefficient of these subjects was 1.58. The comparison of body composition of subjects according to PAL showed that body weight, body fat mass, arm circumference and arm muscle circumference of physically active group were significantly higher than those of the sedentary group. BMR calculated by Harris-Benedict (H-B) formula and DRI formula and BMR measured by Inbody 720 was 1375 kcal, 1306 kcal and 1209 kcal, respectively. Total energy expenditure (TEE) examined by one-day activity diaries and calculated by H-B formula and estimated energy requirement (EER) formula in DRI was 2102.1 kcal, 2184.4 kcal, and 2164.5 kcal, respectively. The Pearson correlation coefficient between TEE examined by one-day activity diaries and H-B TEE was 0.795 (p < 0.001) while that between TEE examined and DRI EER was 0.604 (p < 0.001). Overall data indicated that female university students seemed to be less active. Therefore it is recommended that universities develop good exercise programs for their students. Further studies are needed to generate more meaningful results with a larger sample size and using machine attached to the body, which are able to detect physical activity more accurately.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.5 no.3
• /
• pp.238-243
• /
• 1981

An empirical formula for the mass flow rate in natural convection flume above a spherical heated body which is submerged in a finite fluid contained in a tank was determined. The ratio of depth of submergence to diameter of the sphere for which the sphere sensed as infinite medium was found to be bigger than 7. A dimensionless heat transfer correlation for the natural convection from a sphere was determined for Gr.Prq etween 7x10$\^$7/ and 2x10$\^$8/ also.

• Bulletin of the Korean Mathematical Society
• /
• v.55 no.5
• /
• pp.1371-1387
• /
• 2018

The classification of the self-dual codes over Galois rings GR(p, 2) and $GR(p^2,2)$ of length 4 is completed for all primes p up to equivalence in terms of automorphism group. We obtain all inequivalent classes and the number of each classes of self-dual codes for all primes.

• Proceedings of the PSK Conference
• /
• 2003.10b
• /
• pp.237.1-237.1
• /
• 2003

Cefuroxime axetil, a broad spectrum antibiotic, has been known to form a gelatinous mass in contact with aqueous media, which could lead to poor dissolution. Therefore, this study was conducted for removing the gelling phenomenon and thereby obtaining a favorable dissolution profile. We have found that the addition of poly (methacrylic acid, methyl methacrylate) could not only inhibit the tendency of cefuroxime axetil to form a gel but also showed the good dissolution profile compared to the formula without poly (methacrylic acid, methyl methacrylate). (omitted)