• 한국군사과학기술학회지
• /
• 제23권4호
• /
• pp.346-354
• /
• 2020

Nowadays, it is required to apply low observable technology to weapon systems in operation or under development. Radar Cross Section(RCS) is a measure of the scattered power in an given direction when a target is illuminated by an incident wave and used as a parameter to estimate the low observable performance of weapon system. RCS of a target can be calculated by various numerical methods. However, measurement is also needed to estimate RCS of a complex target because it is difficult to estimate theoretically. To acquire reliable measurement results, an analysis of measurement uncertainty is essential. In this paper, error components and uncertainties of near-field RCS measurement system which was constructed in ASTEC(Aerospace System Test & Evaluation Center) were analyzed based on the IEEE recommended practice for radar cross-section test procedures(IEEE Std. 1502-2007) which describes the uncertainty of RCS measurement and unique error components of this near-field measurement system were also identified.

• 한국전자파학회논문지
• /
• 제18권5호
• /
• pp.553-562
• /
• 2007

본 논문에서는 극저주파 자계 세기를 원격으로 측정하기 위한 장치를 설계하고 제작하였다. 자계 측정기는 자계를 등방적으로 측정하기 위하여 3축 자계 센서를 사용하였으며, 측정 대역내 주파수에서 주파수 특성을 보상하기 위하여 등화기를 사용하였다. 3축 자계 센서의 출력 신호를 시간적으로 다중화 시켜, 3축간 균일한 이득 및 주파수 특성을 얻었다. 자계 측정 레벨 범위는 $0.01{\sim}10.0\;uT$이며, 측정 주파수 대역은 $40{\sim}180\;Hz$이 되도록 설계하였다. 제어 시스템은 무선으로 자계 측정기에 접근하며, 최대 접근 거리는 1.0 km이다. 제작된 장치의 측정 레벨 오차는 5% 이내이다. 제작된 장치는 고전압 송전선이 지나는 골프 연습장에 설치되었다.

• Wind and Structures
• /
• 제4권3호
• /
• pp.247-260
• /
• 2001

In the last three decades several comprehensive field measurement programs have produced significant insight into the wind effects on low-rise structures. The most notable and well published of these efforts are measurements being collected at the Wind Engineering Field Laboratory (WERFL) at Texas Tech University, measurements on low-rise structures in Silsoe, England and measurements on groups of low-rise structures collected in Aylesbury, England. Complementary to these efforts, an additional full-scale field investigation program has recently collected meteorological, pressure, strain and displacement data on a low-rise structure in Southern Shores, North Carolina. To date over seventy-five hundred data sets have been collected at the Southern Shores site in a variety meteorological conditions up to and including hurricane-force winds. This paper provides details of the system, its development, and preliminary assessment of its performance. A description of the field site, the instrumented structure, and the instrumentation system is provided. In addition, an example of the data collected during three hurricanes is presented. The primary goal of this paper is to provide the reader with the necessary technical details to appropriately interpret data from this experiment, which will be presented in future publications currently under development.

• 한국콘텐츠학회:학술대회논문집
• /
• 한국콘텐츠학회 2004년도 추계 종합학술대회 논문집
• /
• pp.280-284
• /
• 2004

안테나의 특성 중 지향성(Directivity)과 관계있는 방사 패턴을 측정하기 위한 저가의 근역장 측정 시스템을 설계한다. 근역장 측정방법은 평면주사법에 기반을 둔 개선된 원통형 주사법 공식을 이용한다. 고가의 측정 장비인 네트워크 분석기를 대체하기 위한 방법을 제시하고 필요한 장치 규격을 제안한다.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2008년도 추계학술대회 논문집
• /
• pp.263-268
• /
• 2008

The measurement of magnetic field is performed AC magnetic field emission density in driver cab and saloon's compartment of rolling stock. In order to measure magnetic-field emission, a three-axial magnetic-field sensor is used and connected to data process system. The AC magnetic field is checked and analysis through BNC output, DAQ cad and notebook PC. The spectral analysis is performed by short time Fourier transform(STFT) for time-domain emission signal.

• Wind and Structures
• /
• 제20권6호
• /
• pp.739-749
• /
• 2015

Field measurement of wind characteristics is of great significance for the wind engineering community. High-frequency anemometers such as ultrasonic anemometers are widely used to obtain the high-frequency fluctuating wind speed time history. However, conventional instrumentation systems may suffer from low efficiency, non-real time transmission and higher maintenance cost, and thus are not very appropriate in the field measurement of strong winds in remote areas such as mountain valleys. In order to improve the field measurement performance in those remote areas, a wireless high-frequency anemometer instrumentation system for field measurement has been developed. In this paper, the architecture of the proposed instrumentation system, and measured data transmission and treatment will be presented firstly. Then a comparison among existing instrumentation systems and the proposed one is made. It shows that the newly-developed system has considerable advantages. Furthermore, the application of this system to the bridge site located in the mountain valley is discussed. Finally, typical samples of measured data from this area are presented. It can be expected that the proposed system has a great application potential in the wind field measurement for remote areas such as the mountainous or island or coastal area, and hazardous structures such as ultra-voltage transmission tower, due to its real-time transmission, low cost and no manual collection of data and convenience.

• 국제초고층학회논문집
• /
• 제8권4호
• /
• pp.313-324
• /
• 2019

This paper presents the analysis of wind speeds data measured on top of three neighboring high-rise buildings close to a beach in Xiamen city, China, during Typhoon "Usagi" 2013. Wind tunnel simulation was carried out to validate the field measurement results. Turbulence intensity, turbulence integral scale, power spectrum and cross correlation of recorded wind speed were studied in details. The low frequency trend component of the typhoon speed was also discussed. The field measurement results show turbulence intensity has strong dependence to the wind speed, upwind terrain and even the relative location to the Typhoon center. The low frequency fluctuation could severely affect the characteristics of wind. Cross correlation of the measured wind speeds on different buildings also showed some dependence on the upwind terrain roughness. After typhoon made landfall, the spatial correlation of wind speeds became weak with the coherence attenuating quickly in frequency domain.

• 한국위성정보통신학회논문지
• /
• 제10권3호
• /
• pp.84-88
• /
• 2015

본 논문은 극저주파 자계 세기를 무선 모니터링하기 위한 디지털 자계측정기의 설계 및 구현에 대해 기술한다. 우리 실생활에 극 저주파대역의 자기장이 노출되어 있어 인체에 자기장이 얼마나 영향을 미치는가에 대한 연구의 필요성이 있으며 그에 따른 측정 장비의 수요가 증가하고 있다. 본 논문에서는 3-축 코일형 자계센서를 사용하였으며, 자계의 측정 범위는 0.03~10uT, 주파수 범위는 40~180Hz이다. 자계 세기의 측정과 주파수 특성을 보상하는 등화기능은 DSP 기반의 디지털 방식으로 설계하였으며, 측정 값은 와이파이 통신을 이용하여 PC 모니터링 할 수 있도록 설계 및 구현하였고 측정오차는 6% 이내로 실용성을 확인하였다.

• 한국전자파학회논문지
• /
• 제22권12호
• /
• pp.1155-1164
• /
• 2011

본 논문에서는 국내 최초로 개발되는 함상용 중거리 레이더에 사용되는 능동 위상 배열 안테나의 송신 빔 특성을 근접 전계 시험으로 측정하는 방안에 대하여 제시하였다. 측정하고자 하는 능동 위상 배열 안테나는 고출력 송신 빔을 펄스 형태로 방사하기 때문에 저출력의 연속적인 파형을 사용하는 일반적인 근접 전계 시험 시설에서는 측정하기 어렵다. 그래서 본 논문에서는 고출력 송신 시에도 견딜 수 있도록 설계된 근접 전계 시험 시설과 펄스 모드 측정을 지원하는 Agilent사의 PNA-X 네트웍 분석기를 이용한 근접 전계 시험으로 펄스 형태의 고출력 송신 빔을 방사하는 능동 위상 배열 안테나를 측정하는 방안에 대하여 제시하였고, 실제 개발된 능동 위상 배열 안테나의 고출력 송신 빔 패턴을 근접 전계 시험으로 측정하였다. 또한, 능동 위상 배열 안테나의 송신 특성인 EIRP(Effective Isotropic Radiated Power)를 측정하였고, 수학적인 계산을 통해 예측한 EIRP 값과 비교한 결과 0.1 dB의 오차 내에서 동일함을 확인하였다.

• 조명전기설비학회논문지
• /
• 제30권2호
• /
• pp.78-84
• /
• 2016

This paper is focused on the measurement and analysis of an atmospheric electric field which is caused by thunderclouds. The electric field due to thunderclouds changes very slowly. For this reason, the extremely low frequency E-field sensor needs to be used for measuring the atmospheric electric field strength. The balloon-carried E-field sensor system with the time constant of 1sec was designed and fabricated. The electric field sensor consists of $100mm{\times}100mm$ copper plate, active integrator, high pass and low pass filters and batteries. The measurements of atmospheric electric fields were made by the balloon-carried E-field sensor and radiosonde, which sends the data back to ground in real time. From the calibration experiments, the response sensitivity of the E-field sensor was 0.154mV/kV/m in the frequency range of less than 1kHz. As a result from the actual experiment of the atmospheric electric field, the electric field signals were observed from the altitude of about 2.5km. Also, as the altitude was increased, the detected electric field wave oscillated with the fluctuation of sensing plate. The proposed method seems suitable for measurements of atmospheric electric fields, because it is inexpensive, simple to use and launch.