• 한국인터넷방송통신학회논문지
• /
• 제14권3호
• /
• pp.43-49
• /
• 2014

마크-젠더 변조기와 저역 통과 필터를 사용하여 광 듀오바이너리 신호를 생성하는 광 듀오바이너리 송신기의 전송 특성을 40Gbps에서 이론적으로 분석하였다. 광 듀오바이너리 시스템의 전송 성능은 송신기를 구성하는 저역 통과 필터와 광 필터 그리고 수신기내 필터의 대역폭에 따라 차이를 보였으며 각 필터들은 광 파워 스펙트럼에 각기 다른 영향을 주었다. 필터들의 최적화된 대역폭을 선택함으로써 광 듀오바이너리 신호 전송 시 부엽 발생과 리플을 억제시키고 분산 내성을 개선 할 수 있었다.

• 전기학회논문지
• /
• 제65권6호
• /
• pp.1108-1114
• /
• 2016

The cause of failure in the AT feeding system is divided into grounding, short-circuit of feeding circuit and internal faults of the railway substation. Since the fault current is very high, real-time current is detected and the failure must be immediately removed. In this paper, a new DC offset elimination filter that can remove component to decrease in the form of exponential function using low-pass filter was proposed in order to extract the fundamental wave from distorted fault current. In order to confirm the performance of the proposed filter method, AT feeder system was modelled by simulation tool and simulations were performed under various conditions such as fault location, fault resistance and fault voltage phase angle in case of trolley-rail short-circuit fault. When applying the proposed DC-offset removal method, it can be seen that the phase delay and gain error did not appear.

• 융복합기술연구소 논문집
• /
• 제7권2호
• /
• pp.25-30
• /
• 2017

This paper presents the effects of a virtual mass with a low-pass filter on the stability boundary of a virtual spring in the haptic system. In general, a haptic system consists of a haptic device, a sampler, a virtual impedance model and zero-order-hold. The virtual impedance is modeled as a virtual spring and a virtual mass. However the high-frequency noise due to the sampling time and the quantization error of sampled data may be generated when an acceleration is measured to compute the inertia force of the virtual mass. So a low-pass filter is needed to prevent the unstable behavior due to the high-frequency noise. A finite impulse response (FIR) filter is added to the measurement process of the acceleration and the effects on the haptic stability are simulated. According to the virtual mass with the FIR filter and the sampling time, the stability boundary of the virtual spring is analyzed through the simulation. The maximum available stiffness to guarantee the stable behavior is reduced, but simulation results still show that the stability boundary of the haptic system with the virtual mass is larger than that of the haptic system without the virtual mass.

• Journal of Advanced Marine Engineering and Technology
• /
• 제22권4호
• /
• pp.538-550
• /
• 1998

The variable frequency and variable voltage AC source made by a conventional inverter which is composed of power semi-conductors includes much noises in sine wave due to high frequency switching of DC source. In this paper the 3rd low pass LC filter for a variable speed 3 phase induction motor driven by a full bridge inverter is introduced to solve the EMI problem by serious noise current. The utility of a modified 3rd order Butterworth LC filter is confirmed through FFT analysis of sine waves and noiseless ACsource can be obtained by the proposed LC filter. The speed of a 3 phase induction motor driven by a full bridge inverter with a LC filter is satisfactorily controlled by a digital PID controller under the condition of stepwise load and setpoint changes.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 하계종합학술대회 논문집
• /
• pp.357-360
• /
• 1999

A 20 MHz CMOS continuous low-pass filter using simulated floating inductor consisted of two fully-differential transconductors and a capacitor is presented. The theory of operation is described and simulation results show close agreement between predicted behaviour and experimential performance. Simulation results show that the filter has ripple bandwidth of 22 MHz, pass-band ripple of 0.36 ㏈. and cutoff frequency of 26 MHz at supplay voltage of $\pm$3 V. The power dissipation is 19.2 ㎽.

• 한국항행학회논문지
• /
• 제13권1호
• /
• pp.41-47
• /
• 2009

이 논문에서는 마이크로스트립을 이용하여 차단주파수가 10.2 GHz인 계단형 임피던스 구조의 저역 통과 여파기를 설계하고, 차단주파수 3.2 GHz인 병렬 스터브를 이용한 고역 통과 여파기를 설계하여 서로 결합하고 삽입하여 소형화하는 방식으로 UWB 대역을 포함하는 대역통과여파기를 설계, 제작하였다. 설계에 사용된 기판의 유전율은 2.2, 높이 0.508mm, loss tangent 0.0009이고, 대역통과 여파기의 넓이는 약 3 cm의 소형으로 제작되었다. 통과 대역에서의 측정 결과 -10 dB 대역폭은 7.5 GHz, -3dB 이하의 삽입손실의 특성을 보였다. 이 연구의 결과 UWB 통신 시스템과 MIC/MMIC, RFIC 시스템에 충분히 이용될 수 있을 것이다.

• 한국산업융합학회 논문집
• /
• 제24권4_2호
• /
• pp.443-451
• /
• 2021

It is essential to examine and analyze the power output and load responses together using real-world turbulent wind speeds. In this paper, the power controller and the drive train damper are simultaneously considered using the NREL 5MW wind turbine model, and the damage equivalent load(DEL) of the low speed shaft torque and power output responses according to the natural frequency of the second order low pass filter are simultaneously investigated. Numerical testing is carried out above rated wind speed using commercially available Bladed software. From the viewpoints of DEL reduction of the drive train shaft torque and power output responses, it is shown that the natural frequency of the low pass filter is appropriately about 6 to 10rad/s. And the reduction ratio of the DEL of the low-speed shaft torque decreases as the wind speed becomes higher, and it is confirmed that the reduction ratio is limited to about 20% at high wind speeds.

• 한국통신학회:학술대회논문집
• /
• 한국통신학회 1987년도 춘계학술발표회 논문집
• /
• pp.219-222
• /
• 1987

A Semi-cusion VLSI Digital Filter Design for TDM/FDM tran-smultiplexer is decribed. Using the polyphase network approach a filter bank composed of only all-pasdigital filter sections was designed. The use of all-pass filters as basic building blocks is shown to provide a Transmultiplexer structure that has low computational requirements low quanization noise and hign modularity. A design of 1st order 2nd All pass filter is done using COMS 2um double metal.

• 한국컴퓨터정보학회논문지
• /
• 제3권2호
• /
• pp.77-84
• /
• 1998

요즈음 CMOS 기술의 발전에 의해서 연속시간 신호시스템이 매우 각광을 받고 있다. 따라서 이 논문에서는 음성신호 처리영역에서 동작하는 CMOS floating 저항을 이용한저역통과 필터를 설계하였다. 특히 이 논문에서는 포화영역에서 동작하는 all CMOS floating 저항을 설계하였으며, $\pm$1V 영역에서 $\pm$0.04%의 선형성이 얻어졌다. 주파수 응답은10MHz를 초과하였으며 능동 RC회로의 집적화에 매우 유용할것으로 생각한다. 이 방법에 의해 설계도니 저역통과필터는 SC 필터보다 그 구조가 간단하므로 IC의 형태로 만들 때 칩 면적을 많이 줄일 수 있다. 설계된 필터의 특성은 pspice에 의해 시뮬레이션 하였으며, 그 특성이 우수함이 입증되었다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 A
• /
• pp.249-251
• /
• 2001

This paper presents performance analysis on a low pass filter of a CT saturation detecting algorithm using difference. At the instants of beginning/end of saturation, the shapes of the secondary current are changed significantly though secondary currents are continuous. At the instants, the second-order or third-order difference of the secondary current has big values because of discontinuity of the first order difference. Thus, the third difference of the current is used to detect the beginning/end of CT saturation. An antialiasing low pass filter removes high frequency components and causes phase lag. A CT saturation detecting algorithm using difference of CT secondary currents is affected by the low pass filter. The algorithm is tested with cutoff frequencies of the filter for the two sampling rates of 64[S/C] and 32 [S/C]. The results of various test cases indicate satisfactory performance of the algorithm.