• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.161-162
• /
• 2008

In this paper we design an irregular low-density parity-check (LDPC) code for a multi-input multi-output (MIMO) system. The considered MIMO system is minimum mean square error soft-interference cancellation (MMSE-SIC) detector. The MMSE-SIC detector and the LDPC decoder exchange soft information and consist a turbo iterative detection and decoding receiver. Extrinsic information transfer (EXIT) charts are used to obtain the edge degree distribution of the irregular LDPC code which is optimized for the input-output transfer chart of the MMSE-SIC detector. It is shown that the performance of the designed LDPC code is much better than that of conventional LDPC code optimized for the AWGN channel.

• Journal of Sensor Science and Technology
• /
• v.20 no.6
• /
• pp.393-399
• /
• 2011

In this paper, we designed and fabricated the novel air flow sensor using air drag force, which can be applied to the low air flow detection. To measure the low air flow, we should enlarge the air drag force and the output signal at the given air flow. The paddle structure is applied to the device, and the device is vertically located against the air flow to magnify the air drag force. We also adapt the corrugation structure to improve the output signals on the given air velocity. The device structure is made up of the silicon nitride layer and the output signal is measured with the piezoresistive layer. The output signals from the corrugated device show the better measurement sensitivity and the response time than that of flat one. The repeated measurement also shows the stabilized signals.

• Proceedings of the KIPE Conference
• /
• 2007.07a
• /
• pp.101-103
• /
• 2007

Since they use the low switching frequency in multilevel inverter systems, they generate the high low frequency harmonic components. Generally, LC filter is used at the output terminal of inverter systems to solve this problem. But it causes a voltage drop at the output terminal by use of damping resistors, and causes the problem in which system efficiency decreases due to power loss of the damping resistor. In this paper, we proposed an output filter design method for NPC three-level inverter systems with low switching frequency. And we analyzed the efficiency of the proposed filter system, and the effectiveness of the proposed system is verified by simulation and experimental results.

• STI Policy Review
• /
• v.1 no.2
• /
• pp.51-68
• /
• 2010

This paper compares OECD nations by developing a comprehensive evaluation index that examines the efforts and achievements of countries toward Low-Carbon Green Growth. The input-process-output of a Low-Carbon Society system is in dynamic competition with that of a High-Carbon Society system. The model used in this study of the comprehensive evaluation index for Low-Carbon Green Growth was comprised of Large indices such as Input, Process, and Output. The Input and Output consisted of 'Social-economic' and 'Physical-ecological' Middle indices while the Process was made up of 'Stimulation mechanisms' and 'Participation of stakeholders and Knowledge flow' Middle indices. In order to calculate the comprehensive evaluation index, our model gave a weight to each indicator/index and applied a weighted arithmetic mean. Korea ranked $15^{th}$ out of 30 OECD nations in the comprehensive evaluation that analyzed Input ($14^{th}$), Process ($18^{th}$), and Output ($17^{th}$). The top five nations were Switzerland, Sweden, Denmark, Germany, and France; while Japan was $8^{th}$ and the USA $26^{th}$.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.685-688
• /
• 2008

Mini-LVDS has been widely used for high speed data transmission because it provides low EMI and high bandwidth for display driver. In this paper, a Mini-LVDS output buffer with LTPS TFT process is presented which provides sufficient performance in the presence of large variation in the threshold voltage and mobility and kink effect.

• Proceedings of the KIPE Conference
• /
• 2004.07b
• /
• pp.542-546
• /
• 2004

This paper presents a technique to reduce the low frequency ripple voltage of the dc output in a BIFRED converter with a small-sized energy storage capacitor. The proposed pulse width control method can be effectively used to suppress the low frequency ripple appeared in the dc output and still shows generally good performance such as low THD of input line current and high power factor. Using the small-sized energy storage capacitor, it has better merits of low cost and small size than a conventional BIFRED converter. The proposed technique is illustrated its validity and effectiveness through simulations.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2002.05a
• /
• pp.283-287
• /
• 2002

To remedy both the degradation and saturation of the output voltages in the modified Dickson pump. a new multi-stage charge pump circuit is presented in this paper. Here using PMOS charge-transfer switches instead of NMOS ones eliminates the necessity of diode-configured output stage in the modified-Dickson pump, achieving the improved voltage pumping gain and its output voltages proportional to the stage numbers. Measurement indicates that VOUT/3VDD of this new pump circuit with two stages reaches to a value as high as 0.94 even with low VDD=1.0 V, strongly addressing that this scheme is very favorable at low-voltage memory applications.

• Proceedings of the KIEE Conference
• /
• 2001.07d
• /
• pp.2531-2533
• /
• 2001

This paper describes a low noise and high efficiency analog-digital switching mixed mode battery charger for production facilities of Li-Ion batteries. The requirements for battery chargers for production facilities are very strict. The accuracy of output voltage and output current should be below 0.1% with very low ripple current. Therefore analog type linear regulators are widely used for battery charger in spite of their inefficiency and bulkiness. We combined linear regulator as a voltage source with digital switching converter as a dependent current source. Low current ripple and high accuracy are obtained by linear regulator while high efficiency is achieved by digital switching converter. Experimental results show that proposed method has 0.1% ripple and 90% efficiency at an output current of 1A for a battery voltage of 4V.

• Journal of Power Electronics
• /
• v.5 no.3
• /
• pp.190-197
• /
• 2005

This paper presents a technique to reduce the low frequency ripple voltage of the dc output in a BIFRED converter with a small-sized energy storage capacitor. The proposed pulse width control method can be effectively used to suppress the low frequency ripple appeared in the dc output and still maintains generally good performance such as low THD of input line current and a high power factor. Using the small-sized energy storage capacitor, it has better merits of low cost and smaller size than a conventional BIFRED converter. The proposed technique is illustrated its validity and effectiveness through simulations.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.6 no.4
• /
• pp.255-261
• /
• 2013

In this paper, we compare two methods that improve the reliability of soft output at the receiver of MIMO communications. The receiver complexity of spatially mutiplexed MIMO system is in proportion to the number of candidate vectors. Low complexity receiver techniques involving a small number of candidate vectors, provide soft output values of low reliability. In order to improve the low reliability of soft output, two previous methods can be used; the first method involves a clipping threshold, the second method uses Euclidian distance instead of squared Euclidian distance. In the paper, we address the theoretical similarity of the two methods, then we compare the two methods from the perspective of hardware implementation.