• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.10C
• /
• pp.635-640
• /
• 2011

This paper proposes a frequency offset estimation scheme with low-complexity for orthogonal frequency division multiplexing (OFDM)-based cognitive radio (CR) systems. The proposed scheme is applicable to any type of training symbol and has a lower complexity than the scheme in [9] by using the partial periodogram. Simulation results show that the estimation performance of the proposed scheme is almost the same as that of the scheme in [9].

• Journal of the Korean Society for Precision Engineering
• /
• v.25 no.5
• /
• pp.96-102
• /
• 2008

Manufacturing of printed electronics using printing technology has begun to get into the hot issue in many ways due to the low cost effectiveness to existing semi-conductor process. This technology, with low cost and high productivity, can make it possible to produce printed electronics such as TFT, solar cell, RFID Tag, printed battery, and so on. In this study, apparatus of gravure-offset printing are developed for fine line-width/gap printing and the results obtained from the apparatus shows that it is possible to make around 20 micro-meter line-width/gap printing patterns. The roll-to-roll printing system for fine line-width printing based on primary experiment is presented. The printing results obtained from the system shows around 30 micro-meter line-width/gap printing patterns.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.12C
• /
• pp.1197-1206
• /
• 2002

Recently, the research on the construction of optical Internet backbone networks using WDM has been actively progressed. In this paper, we propose the offset based service-differentiation scheme in optical burst switching (OBS) networks. We classify the services into two classes; high class and low class. The proposed scheme decides the offset time of high class so as to satisfy the required burst loss rate (BLR) of services according to the service-differentiation ratio (SDR). The SDR may be set depending on the environment of OBS network and user's requirements, our scheme decides the BLR of high class by using the required SDR and conservation law. Finally, we use the offset time decision (OTD) algorithm to determine the offset time of high class. The proposed scheme is evaluated through simulation. The result of simulation is compared with that of analysis to verify the proposed scheme.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.47 no.1
• /
• pp.30-40
• /
• 2010

The hard disk is one of the most frequently used storage in IPTV sep-top box. It has large storage capacity and provides fast I/O speed compared to its price whereas it causes high power consumption due to mechanical characteristics of spindle motor. In order to play streaming data in the set-top box, spindle motor of hard disk keeps active mode and it causes high power consumption. In this paper, We propose an offset-buffering and multi-mode spin-down method to reduce power consumption for streaming data playback. The offset-buffering inspects the user's viewing pattern and performs buffering based on the analysis of viewing pattern. So, it can maintain the status of spindle motor as idle mode for long time. Besides, it can reduce power consumption by spinning down according to offset-buffer size. The experimental result shows that proposed offset-buffering and multi mode spin-down method is about 28.3% and 12.5% lower than the full-Buffering method in terms of the power consumption and spin-down frequency, respectively.

• ETRI Journal
• /
• v.27 no.5
• /
• pp.473-483
• /
• 2005

In this paper, we propose two LC voltage-controlled oscillators (VCOs) that improve both phase noise and tuning range. With both 1/f induced low-frequency noise and low-frequency thermal noise around DC or around harmonics suppressed significantly by the employment of a current-current negative feedback (CCNF) loop, the phase noise in the CCNF LC VCO has been improved by about 10 dB at 6 MHz offset compared to the conventional LC VCO. The phase noise of the CCNF VCO was measured as -112 dBc/Hz at 6 MHz offset from 5.5 GHz carrier frequency. Also, we present a bandwidth-enhanced LC VCO whose tuning range has been increased about 250 % by connecting the varactor to the bases of the cross-coupled pair. The phase noise of the bandwidth-enhanced LC-tank VCO has been improved by about 6 dB at 6 MHz offset compared to the conventional LC VCO. The phase noise reduction has been achieved because the DC-decoupling capacitor Cc prevents the output common-mode level from modulating the varactor bias point, and the signal power increases in the LC-tank resonator. The bandwidth-enhanced LC VCO represents a 12 % bandwidth and phase noise of -108 dBc/Hz at 6 MHz offset.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.11
• /
• pp.1074-1080
• /
• 2013

The low phase noise and wideband frequency synthesizer has been designed by using YTO. Offset PLL structure is used for reducing a division ratio of feedback loop. The phase noise modeling is applied to optimize loop filter of PLL and YTO module. And DDS is used as reference signal of frequency synthesizer for fine resolution. The fabricated wideband frequency synthesizer has the output frequency of 3.2 GHz to 6.8 GHz, phase noise of -107 dBc/Hz at 10 kHz offset from the carrier and frequency resolution of 1 Hz. The measured phase noise is well agreed with the simulated one.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.1 s.104
• /
• pp.17-23
• /
• 2006

This paper has presented a low phase noise oscillator using a square open loop with microstrip structure. A square open loop resonator has a large coupling coefficient value, which makes a high Q value, and has reduced phase noise. This oscillator has presented the oscillation frequency of 5.84 GHz, harmonics of -15.83 dBc and the phase noise of -111.17 dBc/Hz at the offset frequency of 100 kHz. In conclusion, the proposal structure has improved phase noise of 15 dB at the offset frequency of 100 kHz compared with the conventional structure of oscillator.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.2
• /
• pp.145-151
• /
• 2004

This paper presents a fully integrated 5 GHz band low phase noise LC tank VCO. The implemented VCO is tuned by integrated PN diodes and tuning rage is 5.01∼5.30 GHz with 0∼3 V control voltage. For improved phase noise performance, a LC filtering technique is adapted. The measured phase noise is -87.8 dBc/Hz at 100 kHz offset frequency and -111.4 dBc/Hz at 1 MHz offset frequency which is excellent performance. Moreover phase noise is improved by 5 dB after employing the LC filter. It is the first experimental result in field of InGaP/GaAs HBT VCOs. The figure of merit of the fabricated VCO with LC filter is -172.1 dBc/Hz. It is the best result among 5 GHz InGaP HBT VCOs. Moreover this work shows lower DC power consumption, higher output power and more fixed output power compared with previous 4, 5 GHz band InGaP HBT VCOs.

• Korean Journal of Optics and Photonics
• /
• v.9 no.6
• /
• pp.408-412
• /
• 1998

As the radius of curvature of curved optical waveguide gets smaller, the loss increases at the junction of linear-curved waveguide by the cross sectional mode mismatch. The concept of lateral offset has been used widely to minimize it, and simple method of maximum matching has been efficient for most cases of silica waveguide with low optical confinement and large radius of curvature. Here, we analyzed that the propagation mode characteristics of the lateral offset and propagation mode characteristics of general case with effective index method and Airy function solution. As the normalized frequency varies, mode characteristics changes near the boundary of 1/V=0.7 and the simple matching of gaussian profile might give -35% of error at most. We proposed improved method with a new correction factor to improve the mode mismatch problem of conventional methods for general cases, and showed the convenience and feasibility of this method for the calculation of the lateral offset.

• Journal of Positioning, Navigation, and Timing
• /
• v.9 no.2
• /
• pp.43-50
• /
• 2020

In this paper a low power Spreading Code Authentication (SCA) sequence with a BPSK(1) modulation at a frequency offset of +7.161 MHz is tested for authentication purposes, the Galileo E1OS is used as base signal. The tested signals comprise a Galileo constellation with 5 satellites including the Galileo OS Navigation Message Authentication (OSNMA) and a low power offset BPSK (OBPSK(7,1)) as SCA component. The signals are generated with the software based MuSNAT-Signal-Generator. The generated signals were transmitted Over-The-Air (OTA) using a Software-Defined-Radio (SDR) as pseudolite. With a real-environment-testbed the performance of the SCA in real channel conditions (fading and multipath) was tested. A new SCA evaluation scheme is proposed and was implemented. Under real channel conditions we derive experimental threshold values for the new SCA evaluation scheme which allow a robust authentication. A Security Code Estimation and Replay (SCER) spoofing attack was mimicked on the real-environment-testbed and analyzed with the SCA evaluation scheme. It was shown that the usage of an OBPSK is feasible as an authentication method and can be used in combination with the OSNMA to improve the authentication robustness against Security SCER attacks.