• 한국컴퓨터정보학회논문지
• /
• 제22권6호
• /
• pp.87-93
• /
• 2017

In this paper, we design a small low power single channel ECG(Electrocardiogram) system of Chest Belt type with fiber-type electrodes to measure emotional state change of game addict. HRV(Heart Rate Variability) is analyzed through heart rate signal measurement and the psychological stress state is judged by using it. And it verifies its effectiveness through prototype. First, we design HR measurement module through low power MCU(Micro Controller Unit) and implement prototype level measurement system. The results showed that the difference between the addiction group and the general group was confirmed and that the system was effective. The result of this study can be used for health management such as reduction of stress of the user through music and breathing that lowers the stress by detecting the stress state of the general person or the chronic ill person.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2004년도 추계학술대회논문집
• /
• pp.269-274
• /
• 2004

The aims of this study were to Investigate the floor impact noise isolation performance of floating floor with isolation materials and propose the improvement direction of floor impact noise measurement method and evaluation classes using impact ball. Reduction of light-weight impact sound pressure level can be achieved by the finishing materials, such as vinyl finishing material and wooden flooring with isolation materials. Floor impact noise Isolation material which satisfy the properties of the floor impact noise isolation materials cause resonance in the low frequency band and worsen heavy-weight impact sound pressure level. Heavy-weight impact sound level can be reduced by using noise reduction flooring, ceiling and increase of slab thickness. Strong impact force in low frequency bang below 63Hz of bang machine is not similar to human impact source and causes some problem in evaluating heavy-weight impact noise but heavy-weight impact noise measurement and evolution using impact ball which is very similar to human impact is more reliable than bang machine. Correction value on the background noise and sensitivity of residents should be considered on the floor impact noise evaluation classes.

• 한국초전도ㆍ저온공학회논문지
• /
• 제23권4호
• /
• pp.56-60
• /
• 2021

The microwave Radar used for special purposes in the past is being applied in various areas due to the technological advancement and cost reduction, and is particularly applied to autonomous driving in the automobile field. The FMCW (Frequency Modulated Continuous Wave) Radar can acquire level information of liquid in vessel based on the beat frequency obtained by continuously transmitting and receiving signals by modulating the frequency over time. However, for cryogenic fluids with small impedance differences between liquid medium and gas medium, such as liquid nitrogen and liquid hydrogen, it is difficult to apply a typical Radar-based level meter. In this study, we develop an 80 GHz FMCW Radar for level measurement of cryogenic fluids with small impedance differences between media and analyze its characteristics. Here, because of the low intrinsic impedance difference, most of the transmitted signal passes through the liquid nitrogen interface and is reflected at the bottom of the vessel. To solve this problem, a radar measurement algorithm was designed to detect multiple targets and separate the distance signal to the bottom of the vessel in order to estimate the precise position on the liquid nitrogen interface. Thereafter, performance verification experiments were performed according to the liquid nitrogen level using the developed radar level meter.

• 한국지리정보학회지
• /
• 제24권2호
• /
• pp.78-90
• /
• 2021

정밀지오이드를 구축하기 위하여 육상, 해상, 항공, 위성 중력측정 방법으로 다양화되고 측정 기술이 발전되어 고해상도 고정밀도의 중력자료 확보가 가능해졌다. 정밀지오이드의 구축은 별도의 수준측량 없이 GNSS 측량을 통해 표고를 빠르고 편리하게 결정할 수 있으며 우리나라는 2014년부터 국토지리정보원에서 GNSS를 기반으로 한 높이측량 정확도를 향상시키기 위해 합성지오이드 모델을 개발하고 있다. 본 연구에서는 공공측량의 GNSS높이측량을 검증하기 위하여 기존의 고시된 공공기준점을 선점하여 GNSS높이측량 결과와 비교 분석하였다. 실험은 연구보고서 등에서 정밀도가 낮은 지역으로 제시되거나 정밀도가 낮을 것으로 예상되는 연안, 접경, 산악지형의 공공기준점에 대하여 GNSS높이측량을 수행하고 정밀도를 분석하였다. GNSS높이측량 검증을 위해 공공기준점 GNSS높이측량 기지점으로 사용될 주변 통합기준점의 GNSS 타원체고를 점검하였다. 점검된 통합기준점을 기준으로 공공기준점의 GNSS 타원체고를 산출하고 KNGeoid18 모델을 이용하여 표고를 계산하여 직접수준측량 표고결과와 비교하였다. 분석 결과 연안, 접경, 산악 지역 공공기준점의 GNSS 높이측량 결과가 3·4급 공공수준측량 정확도에 만족하는 것으로 나타났다. 이를 통하여 사용자가 요구하는 높이 정확도에 따라 기존의 직접수준측량보다 GNSS 높이측량이 효율적으로 이용될 수 있으며, KNGeoid18도 자율주행자동차, 무인항공기 등 다양한 분야에서 활용될 수 있을 것으로 판단된다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 추계학술대회 논문집 Vol.18
• /
• pp.321-322
• /
• 2005

In this paper, we dealt with a partial discharge(PD) measurement system that has been accepted as an effective and non-destructive technique for estimating reliabilities of low-voltage electrical and electronic components. Calibration tests on laboratory set-up have shown that the PD measurement system has a stable sensitivity of 37.6 mv/pC. In an application test on photo coupler, we could detect 0.1 pC level of partial discharge at the applied voltage of AC 520 $V_{peak}$.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2010년도 춘계학술대회 논문집
• /
• pp.1039-1040
• /
• 2010

• 한국물환경학회지
• /
• 제34권5호
• /
• pp.462-469
• /
• 2018

There are differences in method and cycle of flow rate survey depending on purpose of the operating department. To verify and use results of flow data according to the purpose, flow data of the directly measured and tele monitoring system were compared to verify validity. Flow measurement in the Ministry of Environment is aimed at setting up a standard flow of target water quality for water quality management and securing flow data of low and normal water level seasons for water quality evaluation. In this study, correlation analysis result ($R^2$) of same time zone data by direct measurement and tele monitoring system (TMS) at Seombon D point, a unit watershed of Seomjin river, for six years ('10 ~ '15) according to implementation of Total Daily Maximum Load (TDML) was wading 0.716, boating 0.962 and on bridge 0.943, and effectiveness of measurement method was verified by characteristics of flow duration as a season of dry and low-water; normal and high water are appropriate for wading, boating, and on bridge respectively. Results revealed it is reasonable to use directly measured results using the wading and boating method for low water level and dry seasons, and TMS data for rainy seasons. It can be used important data for future policy decisions.

• 한국전자파학회논문지
• /
• 제18권5호
• /
• pp.553-562
• /
• 2007

본 논문에서는 극저주파 자계 세기를 원격으로 측정하기 위한 장치를 설계하고 제작하였다. 자계 측정기는 자계를 등방적으로 측정하기 위하여 3축 자계 센서를 사용하였으며, 측정 대역내 주파수에서 주파수 특성을 보상하기 위하여 등화기를 사용하였다. 3축 자계 센서의 출력 신호를 시간적으로 다중화 시켜, 3축간 균일한 이득 및 주파수 특성을 얻었다. 자계 측정 레벨 범위는 $0.01{\sim}10.0\;uT$이며, 측정 주파수 대역은 $40{\sim}180\;Hz$이 되도록 설계하였다. 제어 시스템은 무선으로 자계 측정기에 접근하며, 최대 접근 거리는 1.0 km이다. 제작된 장치의 측정 레벨 오차는 5% 이내이다. 제작된 장치는 고전압 송전선이 지나는 골프 연습장에 설치되었다.

• 한국산업융합학회 논문집
• /
• 제13권4호
• /
• pp.205-209
• /
• 2010

Even the domestically small-and medium-sized companies progressed development in the monitoring equipment of inspecting run out in steel wheel aiming to supply and generalize through developing the monitoring equipment for securing quality technology and enhancing quality-test level. Run-Out value in vehicle wheel was measured with Computer & Servo system by using Low-Point marking machine control system, which is this development product. Low-Point value was operated and calculated. It marked by revolving wheel as much as the demanded measurement value based on 1ST harmony curve. Thus, the shipment of inferior product, which occurs in the measurement by the existing worker, could be blocked in advance. In the existing case, 60 sec. was required for inspecting 1 product. However, it came to bring about a rise in production volume through shortening inspection time to 8 seconds and improving workers' operating environment.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2004년도 추계학술대회 논문집
• /
• pp.729-732
• /
• 2004

An experimental and numerical approach has been carried out for to see the noise characteristics of a circular diamond saw. The noise level measurement result for the several kinds of shanks shows us that the noise level reduction in high frequency range could be an effective way to control the noise problem. Sandwich type shank whose center part is laminated with a low Young‘s modulus material greatly reduces the noise level. The noise level for the shank where several curve shaped slits are provided in the circumferential direction is reduced considerably too. The response spectrum analysis by the FEM shows us to be an alternative for predicting the noise characteristics of the shank.