• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1700-1702
• /
• 1996

Solid oxide fuel cell(SOFC) is an electrochemical energy device which converts the free energy of fuel gas directly to electric energy. SOFC has several diratinct advantages over other types of fuel cells: no use of noble metals, no requirement of a reformer, no problem of liquid electrolyte management, and no problem of corrosion by liquid electrolyte. In this study, we have investigated the cell components and the single cell of the planar SOFC fabricated by composite plate process, in which green films of electrolyte, anode and cathode were co-fired. The planar SOFCs were tested and the cell performance characteristics wag evaluated by using electrochemical methods.

• The Korean Journal of Food And Nutrition
• /
• v.1 no.2
• /
• pp.76-85
• /
• 1988

In order to obtain the basic data for the preparation of yogurt containing ginseng component, the effect of ginseng component on cell growth of Lactobacillus casei YIT 9018 and on lactic acid production were investigated. Initial cell growth and acid production were markedly inhibited by the addition of ethanol extracts in the level of 8% into 15% skim milk. Crude saponin did not show any inhibitory effect on cell growth and acid production, but ether layer fraction showed inhibitory effect. It was thought to be more advantageous to add ginseng extracts after the fermentation of milk than before. The addition of ginseng extract at 8% level into liquid yogurt was most suitable in organoleptic test. Cell viability was not affected by the addition of ethanol extracts up to 8% level during storage of liquid yogurt.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.4
• /
• pp.332-336
• /
• 2000

We have developed a novel vertical-alignment(VA) -$\pi$ cell mode that provides a wide viewing angle and fast response times for nematic liquid crystal(NLC) with negative dielectric anisotropy on a homeotropic polymide(PI) surfaces. Good voltage-transmittance curves and low driving voltages were achieved with the new VA-$\pi$ cell mode without a negative compensation film. Iso-viewing angle characteristics using the new VA-$\pi$ cell mode without a negative compensation film was also successfully observed. As well a fast response time of 31.7 ms for a new VA-$\pi$ mode was measured. Consequently the iso-viewing angel fast response time and low driving voltage characteristics using a VA-$\pi$ cell can be achieved.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.10
• /
• pp.883-886
• /
• 2000

We have developed a novel vertical-alignment(VA) - 1/6$\pi$ mode that provides a wide viewing angle for nematic liquid crystal (NLC) with negative dielectric anisotropy on a homeotropic polyimide (PI) surfaces. Good voltage-transmittance curves were achieved with the new VA - 1/6$\pi$ cell model without a negative compensation film. The viewing angle of a new VA -1/6$\pi$ cell without a negative compensation film was wider than that of a conventional VA cell. Finally, the wide viewing angle using the new VA-1/6$\pi$ cell mode can be achieved.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.6
• /
• pp.633-640
• /
• 2004

We have studied color tracking of a fringe-field driven homogenously aligned nematic liquid crystal (LC) cell with negative dielectric anisotropy and compared it with other devices such as the twisted nematic(TN) and in-plane switching(IPS) modes. According to studies, the TN device shows bluish color at grey scale and even at a low retardation cell it cannot avoid color tracking. The authentic IPS device having cell retardation value of 0.23 ${\mu}{\textrm}{m}$ also shows bluish white color. However, the FFS device shows excellent color tracking characteristics even at high retardation value of the cell while keeping high transmittance and greenish white.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.20 no.3
• /
• pp.1114-1122
• /
• 1996

Variation of temperature field in a Hele-Shaw convection cell was measured by using a HSI true color image processing system and TLC(Thermochromic Liquid Crystal) solution. The relationship between the hue value of TLC color image and real temperature was obtained and this calibration result was used to measure the true temperature. The temperature field in the Hele-Shaw convection cell shows periodic characteristics of 45 sec at Ra = 9.3 * 10$\^$6/. The temperature field measurement technique developed in this study was proved to be a useful and powerful tool for analyzing the unsteady thermal fluid flows.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.18 no.1
• /
• pp.148-156
• /
• 2004

In order to searched for the ways of use for distilled liquid of Cervus Elaphus Xanthopgus, the study examined the difference of immunological efficiency generally raised in the existing extracted liquid and distilled liquid of Cervus Elaphus Xanthopgus. As seen from the above results, both the extracted liquid of Cervus Elaphus Xanthopgus and distilled liquid have remarkable efficiency in the increase of cells, the efficient condition of immunity activation degree, the effect of anti-cancer possibly formed by these two and activation of cells and organism, in which distilled liquid in the beginning and the extracted liquid later tend to show its efficiency.

• Macromolecular Research
• /
• v.17 no.11
• /
• pp.856-862
• /
• 2009

This study examined the effects of liquid and solid additives on the morphological, mechanical and thermal insulating properties of rigid polyurethane foams (PUFs). The PUFs synthesized with tetramethylsilane (TEMS) as a liquid-type additive showed a smaller average cell size and lower thermal conductivity than those with the aerosil 200 and clay 30B as solid-type additives. When TEMS was added, the average cell size of the PUF became more uniform and finer due to the reduced surface tension of the polymer solution, which increased the nucleation rate and number of bubbles produced and reduced cell size. The PUFs with TEMS showed the highest closed cell contents among the PUFs prepared using TEMS, aerosil 200 and clay 30B. This suggests that the insulation properties of PUF can be determined by both the size of the cell structure and the amount of closed cell contents in the system. The compression and flexural strengths of the PUF increased slightly when the aerosil 200, clay 30B and TEMS were added compared those of the neat PUF. The reaction profiles of the PUFs showed a similar gel and tack tree time with the reaction time among the PUFs synthesized with three different additives and neat PUF. This suggests that the nucleating additives used in this study do not affect the bubble growth of the chemical reaction, and the additives may act as nucleating agents during the formation of PUF. From the above results of the cell size, thermal conductivity, closed cell contents and reaction profile of the PUFs, liquid-type nucleating agent, such as TEMS, is more effective in decreasing the thermal conductivity of the PUF than solid-type nucleating agent, such as aerosil 200 and clay 30B.

• Korean Journal of Optics and Photonics
• /
• v.8 no.3
• /
• pp.223-229
• /
• 1997

A source code is developed on the basis of Berreman's 4$\times$4 matrix formalism for the analysis of polarization transmission characteristics of twisted nematic liquid crystal display. By using the program, the polarization transmission characteristics of liquid crystal cells and polarizers are analyzed. For a normally white twisted nematic liquid crystal cell, we obtained a family of iso-contrast contours which helps to understand the viewing angle characteristics of the liquid crystal display device by using the cell. The program also help us to understand the variation of the degree of polarization as well as the deviation of the state of polarization of the light transmitted through the polarizer commonly used in the LCD according to the change in incidence angle. This result suggests the contrast of the images appearing on the LCD can be limited by the characteristics of the polarizer in addition to the liquid crystal cell.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.340-343
• /
• 2008

This work reports the simple fabrication of the single cell gap transflective liquid crystal display (LCD) using wire grid polarizer. The nano sized wire grid polarizer was patterned on common electrode itself, on the reflective part of FFS (Fringe field switching) mode whereas the common electrode was unpatterned at transmissive part. However, this structure didn't show single gamma curve, so we further improved the device by patterning the common electrode at transmissive part. As a result, V-T curve of proposed structure shows single gamma curve. Such a device structure is free from in-cell retarder, compensation film and reflector and furthermore it is very thin and easy to fabricate.