• 한국전기전자재료학회논문지
• /
• 제26권6호
• /
• pp.488-492
• /
• 2013

Current limiting diode (CLD) was fabricated using junction field effect transistor (JFET) structured two small cells and eight large cells. Two small cells and eight large cells were connected in parallel and the obtained constant current was 110 mA. The application of CLD in each of the parallel circuits on chip on board (COB) type LED lighting source, could significantly reduce the current deviation within the parallel circuits. The applications of CLD on AC power small lighting source, battery power low voltage parallel lighting source and AC flat lighting source were investigated.

• 조명전기설비학회논문지
• /
• 제25권4호
• /
• pp.16-23
• /
• 2011

Since the first lighting light source was invented, lighting has turned into superior-quality lighting considering the amenity of occupants, and the characteristics of a light source has developed rapidly. So this research confirmed the lighting performance of a dimmer control system and an ON-OFF control system via the existing light source, and analyzed the basic lighting environment of Permanent Supplementary Artificial Lighting of Interiors(PSALI) through the physical comparison and evaluation of a LED lamp substituted for a fluorescent lamp used in a dimmer control system, showing that the lighting physical quantity characteristics of an ON-OFF control system and a dimmer control system are similar to each other and that they are effective in terms of energy saving. Besides, it was shown that introducing a LED light source to a dimmer control system improves lighting environments and largely reduces energy consumption.

• 한국전기전자재료학회논문지
• /
• 제35권5호
• /
• pp.466-470
• /
• 2022

In order to widely disseminate LED lighting, LED lighting technology that directly uses AC commercial power has been recently introduced. AC powered LED lighting technology has a problem in that the light brightness of the LED changes because the voltage applied to the LED and the current flowing through the LED continuously change. In this study, when the LED current is greater than the design current, the current control signal generated by the controller is supplied to the current source to supply only the design current to the LED by increasing the voltage drop at the current source. If it is smaller than the design current, the controller is adjusted so that the current is supplied only to the LED without a voltage drop in the current source. It can be seen that the higher the maximum rectified voltage, the faster the lighting time of the LED light emitting block is, so that the power factor of the LED lighting is improved. The LED lighting technology proposed in this study enables LED lighting with constant light brightness, reduced power consumption, and long lifetime.

• 대한조선학회 특별논문집
• /
• 대한조선학회 2017년도 특별논문집
• /
• pp.63-66
• /
• 2017

All passenger ships aboard more than 36 passengers are to be able to easily find escape routes when the escape way by fire with flame spread were onboard vessel (incl. Ferry, Passenger, Ro-pax, Inland Ferry) It should be impossible by ordinary emergency lights. The international Maritime Organization (IMO) gives special requirement for luminescent evaluation onboard test procedure and applicable location of low location lighting. In order to maintain the residual light source for a certain time in the low location lighting with a strip-shaped light source, the light source material must be sufficiently exposed to the light due to the proper placement of the escape route. The lighting arrangement influence how maintain low location lighting strip luminescent which measured onboard in connection with what elements are mainly sustain luminescent.

• 조명전기설비학회논문지
• /
• 제25권3호
• /
• pp.7-14
• /
• 2011

Many countries and researchers in the lighting field have focused on the LED light source as a solution to energy savings and environmental pollution. The LED light source consumes less power, has a long life and is highly economical. It is vibration and shock-resistant, and environment friendly as well. But LED lighting has some problems. In particular, the photobiological safety of LED light sources is emerging as an issue. Ultraviolet radiation from the LED light source emitted directly to the human body over a long period of time is harmful. In this paper, UV radiation from white LED was measured. Finally, the LED light source emits UV radiation, but it is relatively small when compared to others.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2005년도 학술대회 논문집
• /
• pp.161-165
• /
• 2005

In this paper, we observed degradation characteristics of luminous flux for new light source. Because degradation tests can be a useful tool for assessing the reliability when few or even no failures are expected in a life tests. And we use a simple random coefficient degradation model to induce most suitable equation of degradation. As a result, exponential distribution and equation is best suitable model for new light source.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 광주전남지부
• /
• pp.71-74
• /
• 2006

Discharge of the flat lamp lighting source research arc requested very much. For improving brightness, life time, efficiency of flat lamp, plasma diagnosis of the flat lamp lighting source to understand property of lighting source is very important. distance of discharge electrode is 5.5mm and width is 16.5mm, we measured electron temperature and electron density measured with single langmuir probe in flat lamp. we tested the discharge from 100 Torr to 300 Torr pressure. the Pulse is rectangular pulse with frequency 20kHz and Duty ratio 20%. Resultly, electron temperature decreases and electron density increase as increase the gas pressure and electron temperature decreases and electron density increase as increase the voltage.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 C
• /
• pp.2190-2192
• /
• 2005

Discharge of the flat lamp lighting source research are requested very much. For improving brightness, life time, efficiency of flat lamp, plasma diagnosis of the flat lamp lighting source to understand property of lighting source is very important. distance of discharge electrode is 5.5mm and width is 16.5mm, we measured electron temperature and electron density measured with single langmuir probe in flat lamp. we tested the discharge from 100 Torr to 300 Torr pressure. the Pulse is rectangular pulse with frequency 20kHz and Duty ratio 20%. Resultly, electron temperature decreases and electron density increase as increase the gas pressure and electron temperature decreases and electron density increase as increase the voltage.

• 감성과학
• /
• 제15권3호
• /
• pp.381-388
• /
• 2012

The purpose of this study is to check if LED lighting can be used as general lighting and examine the color rendering property of full color RGB LED lighting. CRI is one of the important properties of evaluating lighting. However the present CRI does not fully evaluate LED lightings. Firstly, the performance of a simple task was compared other than comparing CRI values for different lighting. For experimental preparation three types of lightings were used; standard D65 fluorescent tube, general household fluorescent tube, and RGB LED lighting. All three lightings show high error for Purple-Red. All three lightings show similar error for all hues and prove that color discrimination is not affected by the lighting. This proves that LED could be used as general lighting. Secondly, problems of the conventional CIE CRI method are considered and new models are suggested for the new lighting source. Each of the models was evaluated with visual experiment results obtained by the white light matching experiment. The suggested model is based on the CIE CRI method but replaces the color space model by CIELAB, color difference model by CIEDE2000, and chromatic adaptation model by CAT02.

• 조명전기설비학회논문지
• /
• 제18권3호
• /
• pp.1-6
• /
• 2004

고체기반 조명인 LED를 적용시킨 건축조명 설계사례는 최근 수적으로 증가하고 있으나, 조명기구의 개발 및 설계적용기법은 새로운 광원에 적합하지 못한 경우가 많다. 본 논문에서는 디지털 기술로 제어되는 조명설계기법 관련 요소를 살펴보고, 디지털 광원 모듈을 개발하여 건축조명설계에 적용해봄으로써 센서와 연동되는 인터랙티브 라이팅 기법의 효용성을 검토하였다. 자연의 아날로그적 변화를 센서로 검출하여 연출하는 인터랙티브 라이팅은 디지털 기술이 조명대상공간을 획일화시킬 수 있다는 부정적 측면을 극복할 수 있는 하나의 새로운 대안이 된다 하겠다.