• Journal of Korean Society of Environmental Engineers
• /
• v.29 no.2
• /
• pp.229-234
• /
• 2007

In the present work, the sequencing batch reactor process of two-sludge type was optimized. The effects of solid retention time, hydraulic retention time, length of biosorption phase and temperature variation were investigated, respectively. In the T-N removal, the long solid retention time was favored. It was speculated that SCOD biosorption efficiency was higher in long solid retention time than in short solid retention time. In the comparison of hydraulic retention time, the removal efficiency of $NH_4^+-N$ and T-N were almost same in all applied hydraulic retention times which were 8 hr, 10 hr and 15 hr. It was observed that there was no need to have the hydraulic retention time more than 20 min in biosorption phase for enhancement of T-N removal efficiency. An experimental comparison of removal efficiencies with different temperature conditions was carried out. Decrease of temperature didn't affect the performance of the process, however, phosphorus removal efficiency was a little higher at low temperature than high temperature. Consequently, the process developed in this study was much amenable to wastewater treatment which was conducted in the low temperature and high loading rate.

• Wind and Structures
• /
• v.11 no.4
• /
• pp.275-289
• /
• 2008

Large eddy simulations have been performed within and over different types of urban building arrays. This paper adopted three dimensionless parameters, building frontal area density (${\lambda}_f$) the variation degree of building height (${\sigma}_h$), and the staggered degree of building range ($r_s$), to study the systematic influence of building spacing, height and layout on wind and turbulent characteristics. The following results have been achieved: (1) As ${\lambda}_f$ decrease from 0.25 to 0.18, the mean flow patterns transfer from "skimming" flow to "wake interference" flow, and as ${\lambda}_f$ decrease from 0.06 to 0.04, the mean flow patterns transfer from "wake interference" flow to "isolated roughness" flow. With increasing ${\lambda}_f$, wind velocity within arrays increases, and the vortexes in front of low buildings would break, even disappear, whereas the vortexes in front of tall buildings would strengthen and expand. Tall buildings have greater disturbance on wind than low buildings do. (2) All the wind velocity profiles and the upstream profile converge at the height of 2.5H approximately. The decay of wind velocity within the building canopy was in positive correlation with ${\lambda}_f$ and $r_s$. If the height of building arrays is variable, Macdonald's wind velocity model should be modified through introducing ${\sigma}_h$, because wind velocity decreases at the upper layers of the canopy and increases at the lower layers of the canopy. (3) The maximum of turbulence kinetic energy (TKE) always locates at 1.2 times as high as the buildings. TKE within the canopy decreases with increasing ${\lambda}_f$ and $r_s$ but the maximum of TKE are very close though ${\sigma}_h$ varies. (4) Wind velocity profile follows the logarithmic law approximately above the building canopy. The Zero-plane displacement $z_d$ heighten with increasing ${\lambda}_f$, whereas the maximum of and Roughness length $z_0$ occurs when ${\lambda}_f$ is about 0.14. $z_d$ and $z_0$ heighten linearly with ${\sigma}_h$ and $r_s$, If ${\sigma}_h$ is large enough, $z_d$ may become higher than the average height of buildings.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.18 no.2
• /
• pp.155-164
• /
• 2016

The changes in earth pressure and ground settlement due to the underground excavation nearby the existing retaining wall according to the separation distance between underground excavation and retaining wall, were studied experimentally. A soil tank having 160 cm in length and 120 cm in height, was manufactured to simulate the underground excavation like tunnel by using 5 separated bottom walls. The variation of earth pressure was measured according to the excavation stages by using 10 separated right walls simulating the retaining wall. The results showed that the earth pressure was changed by the lowering of first bottom wall(B1), however the earth pressure was not changed significantly by the lowering of third bottom wall(B3) since B3 had sufficient separation distance from retaining wall. Lowering of first bottom wall(B1) induced the decrease of earth pressure in lower part of retaining wall, on the contrary, lowering of first bottom wall(B1) induced the increase of earth pressure in middle part of retaining wall proving the arching effect.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.46 no.4
• /
• pp.413-423
• /
• 2013

To elucidate the variation of species composition, biomass and length distribution of flatfishes by the period and region in the Uljin marine ranching area, bottom trawl survey was investigated at the six stations from Feb. 2008 to Dec. 2010. During the survey period, a total 4 families 17 species in the Pleuronectiformes, average 69,158 $ind./km^2$ and 5,625 $kg/km^2$ were identified, in 2008 appeared in 14 species, average 25,798 $ind./km^2$ and 2,333 $kg/km^2$ and in 2009 appeared in 13 species, average 102,360 $ind./km^2$ and 5,634 $kg/km^2$ and in 2010 appeared in 14 species, average 75,704 $ind./km^2$ and 8,632 $kg/km^2$. The individual dominant species, occupying over 10% of total individuals, was Pleuronectes herzensteini (20,811 ind., 30.0%), Hippoglossoides pinetorum (18,666 ind., 26.9%) and Glyptocephalus stelleri (13,499 ind., 19.4%) also the biomass dominant species, occuping over 10% of total biomass, was P. herzensteini (2,207 kg, 39.3%), Pleuronectes yokohamae (857 kg, 15.3%), H. pinetorum (761 kg, 13.5%), Kareius bicoloratus (677 kg, 12.1%). From the cluster and MDS analysis based on Bray-Curtis similarity matrix of fourth root transformed data of species number and individuals in the Uljin marine ranching area from Feb. 2008 to Dec. 2010 was divided into two different groups of the flatfishes community in 2008 and from Jan. to Apr. in 2009 and 2010 (Group A) and the pleuronectiform community in from May to Dec. in 2009 and 2010 (Group B). From the cluster and MDS analysis using the similarity of demersal organisms community among six stations, the Uljin marine ranching area was divided into two different groups of Group 1 (St. 1 and St. 3) and Group 2 (St. 2, St. 4, St. 5 and St. 6).

• Korean Chemical Engineering Research
• /
• v.47 no.6
• /
• pp.720-726
• /
• 2009

Hydrodynamic similarity was investigated in pressurized three-phase slurry bubble columns by selecting the bubble holdup and pressure drop as objective functions, for the effective design and scale-up of it. In addition, effects of operating variables on the bubble holdup with variation of column diameter were also analyzed. Gas velocity($U_G$), viscosity(${\mu}_{SL,eff}$) and surface tension(${\rho}_{SL}$) of slurry phase, density difference between the slurry and gas phases(${\rho}_{SL}-{\rho}_G$) depending on the operating pressure, pressure drop per unit length(${\Delta}P/L$), column diameter(D) and gravitational acceleration(g) were chosen as governing parameters in determining the bubble holdup and pressure drop in the column. From the dimensional analysis, four kinds of dimensionless groups were derived from the 7 parameters and 4 fundamental dimensions. Effects of dimensionless groups such as Reynolds, Froude and Weber numbers on the bubble holdup in the column were discussed. The pressure drop and bubble holdup could be predicted from the correlation of dimensionless groups effectively, which could be used as useful information for the design and scale-up of pressurized slurry bubble columns.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.11
• /
• pp.635-639
• /
• 2016

In the devices used in the microwave frequency band, the gain decreases as the frequency increases due to the parasitic component. To compensate for these characteristics, a linear gain equalizer with an opposite slope is needed in wideband systems, such as those used for electronic warfare. In this study, a linear gain equalizer that can be used in the 18 ~ 40GHz band is designed and fabricated. Circuit design and momentum design (optimizations) were carried out to reduce the errors between design and manufacturing. A thin film process is used to minimize the parasitic components within the implementation frequency band. A sheet resistance of 100 ohm/square was employed to minimize the wavelength variation due to the length of the thin film resistor. This linear gain equalizer is a structure that combines a quarter wavelength-resonator on a series microstrip line with a resistor. All three 1/4 wavelength short resonators were used. The fabricated linear gain equalizer has a loss of more than -5dB at 40GHz and a 6dB slope in the 18 ~ 40GHz band. By using the manufactured gain equalizer in a multi-stage connected device such as an electronic warfare receiver, the gain flatness degradation with increasing frequency can be reduced.

• Korean Journal of Plant Taxonomy
• /
• v.37 no.4
• /
• pp.477-502
• /
• 2007

The Aconitum alboviolaceum Kom. complex includes four controversial species described from Korea; A. albouiolaceum, A. pseudolaeue, A. longecassidatum, and A. quelpaertense. The main objective of this study was to determine the taxonomic identities and systematic relationships among the species in the A. albouiolaceum complex based on morphology, numerical analyses and DNA sequence analysis. In the present study, variations in the principal morphological characters and chloroplast DNA noncoding region sequences (psbA-trnH IGS, trnL intron, and trnL-trnF IGS) were examined for 95 individuals from 20 populations. Also, neighbor-joining analysis was adopted to infer their relationships. Morphological variation appeared to be considerably high but not to be related to geographic distribution. These morphological results suggest that reevaluation of key morphological characters are needed for the proper taxonomic treatment of the complex. The length of psbA-trnH IGS region ranged from 241 to 250 bp, that of the trnL intron from 526 to 532 bp, and that of the trnL-trnF IGS region from 466 to 472 by in all taxa. Nine haplotypes were recognized from the analysis. Seven populations shared more than two haplotypes, while other thirteen populations shared only one haplotype. In the phylogenetic analysis, the nine haplotypes formed four groups, separated A. sibiricum, one of the sister groups of the complex. There also was no distinct grouping pattern supporting the species and populations observed. These results suggest that introgression or speciation might have been involved in the formation of taxa of A. alboviolaceum complex.

• Journal of Korean Society of Steel Construction
• /
• v.29 no.1
• /
• pp.81-88
• /
• 2017

Residual stress is defined as stress that already exists on a structural member from the effects of welding and plastic deformation before the application of loading. Due to such residual stress, welded H-section compression members under centroidal compression load can undergo buckling and failure for strength values smaller than the predicted buckling load and specified compressive strength. Therefore, this study was carried out to evaluate the effect of residual stress from welding on the determination of the buckling load and specified compressive strength of the H-section compression member according to the column length variation. A three-dimensional nonlinear finite element analysis was performed for the H-section compression member where the welded joint was fillet welded by applying heat inputs of 3.1kJ/mm and 3.6kJ/mm using the SAW welding method.

• Korean Journal of Medicinal Crop Science
• /
• v.15 no.5
• /
• pp.339-345
• /
• 2007

Field performance and morphological characterization was conducted on seven transgenic lines of Codonopsis lanceolata expressing ${\gamma}-TMT$ gene. The shoots were obtained from leaf explants after co-cultivation with Agrobacterium tume-faciens strain LBA 4404 harboring a binary vector pYBI 121 that carried genes encoding ${\gamma}-Tocopherol$ methyltransferase gene (${\gamma}-TMT$) and a neomycin phosphotransferase II gene (npt II) for kanamycin resistance. The transgenic plants were transferred to a green house for acclimation. Integration of T-DNA into the $T_0\;and\;T_1$ generation of transgenic Codonopsis lanceolata genome was confirmed by the polymerase chain reaction and southern blot analysis. The progenies of transgenic plants showed phenotypic differences within the different lines and with relative to control plants. When grown in field, the transgenic plants in general exhibited increased fertility, significant improvement in the shoot weight, root weight, shoot height and rachis length with relation to the control plants. However, all seven independently derived transgenic lines produced normal flower with respect to its shape, size, color and seeds number at its maturity. Indicating that the addition of a selectable marker gene in the plant genome does not effect on seed germination and agronomic performance of transgenic Codonopsis lanceolata. $T_1$ progenies of these plants were obtained and evaluated together with control plant in a field experiment. Overall, the agronomic performance of $T_1$ progenies of transgenic Codonopsis lanceolata showed superior to that of the seed derived non-transgenic plant. In this study, we report on the morphological variation and agronomic performance of transgenic Codonopsis lanceolata developed by Agrobacterium transformation.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.6 no.3
• /
• pp.57-66
• /
• 2007

Weaving is defined as the crossing of two or more traffic streams traveling in the same general direction along a significant length of highway without the aid of traffic control devices. Compared with other freeway sections, perturbation is easy to happen at weaving section. Because there are a lot of lane-changing maneuvers at the weaving section, traffic is subject to turbulence in excess of that normally presents on freeway basic section. This turbulence causes operational problems and its impact must be considered. The purpose of this paper is to perform a basic study on flow characteristics by lane, which can be achieved through analyzing breakdown phenomenon in the microscopic approach. The study made use of data derived from the aerial photography for the microscopic analysis. This research produced the 30-second interval data such as flows, speeds, and densities for the macroscopic analysis and derived the vehicular data to draw time-space diagram for the microscopic analysis. The paper analyzed the traffic characteristics using flows, speeds and densities variation and investigated the conditions of breakdown occurrence with the time-space diagrams. The breakdown phenomenon was identified at weaving section and the propagation from free flow to synchronized flow was observed in this study. In the future, the findings help develop the traffic operational algorithm to manage the traffic congestion under ubiquitous circumstance since the conditions of breakdown Phenomenon can be understood more.