• Journal of the Korean Geotechnical Society
• /
• v.22 no.8
• /
• pp.77-88
• /
• 2006

In this study, the lateral behavior of Pile-Bent structures subjected to lateral loading was evaluated by a load-transfer approach. An analytical method based on the Beam-Column model and nonlinear load transfer curve method was proposed to consider material non-linearity (elastic and yielding) and $P-{\Delta}$ effect. Special attention was given to the lateral deflection of Pile-Bent structures depending on different soil properties, lateral load, slenderness ratio based on pier length and reinforcing effect of casing. From the results of the parametric study, it is shown that the increase of lateral displacement in a pile is much less favorable for an inelastic analysis than for an elastic analysis. It is found that for inelastic analysis, the maximum bending moment is located within a depth approximately 3.5D(D: pile diameter) below ground surface, but within 1.5D when $P-{\Delta}$ effect is considered. It is also found that the magnitude and distribution of the lateral deflections and bending moments on a pile are highly influenced by the inelastic analysis and $P-{\Delta}$ effect, let alone soil properties around an embedded pile.

• Journal of Plant Biotechnology
• /
• v.34 no.4
• /
• pp.331-338
• /
• 2007

One-node stem pieces ca. 1 cm in length containing a axillary bud and a fully expanded leaf were obtained from it in vitro plants of potato (Solanum tuberosum L.). Leaves were removed and the nodes were cultured on the MS medium to investigate the effects of temperature, day length, sucrose, and CCC in microtuber formation and development. The fresh weight of microtubers after 80 days increased significantly at 8% sucrose and $20^{\circ}C$ compared with $28^{\circ}C$. The tuberization and development were reduced at $28^{\circ}C$ except short-day treatment of 8 hours at 8% sucrose. The fresh weight and diameter were increased on the culture medium added CCC 500 mg/L. The potato tuberization was promoted under short daylength, and it showed great effect by treatment with the CCC. Though the tuberization was promoted at low temperature of $20^{\circ}C$ in a histologic change of an axillary bud part cell of a potato, the cells were able to observe the swelling growth. Swelling growth of tissue was stimulated in the darkness and was more remarkable by addition of CCC. In particular, in the visual ratio of cell division for each position in the tissue, the cortex part showed larger ratio of cell expansion than that of the pith part. The effect of CCC was identified at 8% sucrose in the darkness. The effect of CCC was not showed in sucrose 3% under long daylength of 16 hours. As a result, the fact of a substance with AGPase important for starch composition was certified by the result with the inclose of AGPase activity on high concentration of sucrose, CCC, and dark treatment by which tuber formation and development are promoted.

• Horticultural Science & Technology
• /
• v.30 no.1
• /
• pp.34-41
• /
• 2012

The study was conducted in a glasshouse to examine the possibility of producing paprika plug seedlings in a newly developed inert phenolic foam growing medium. Plug seedlings of 'Fascinato' paprika were grown in five media, Grodan rockwool (Grodan Co. Ltd., Denmark), UR rockwool (UR Co. Ltd., Korea), phenolic foam LC (Smithers Oasis Korea Co. Ltd., Korea), phenolic foam RC, and phenolic foam 3813-4 all in a pellet type. Seeds were germinated in a growth chamber ($25^{\circ}C$, 90% RH, dark) for 4-5 days and then seedlings were grown in a glasshouse with nutrient solution supplied by an overhead irrigation system. Seedling growths were measured 20 days after sowing. The medium pH was the highest in the Grodan rockwool, and medium EC was the highest in phenolic foam 3813-4, although no nutritional excess disorders were observed. Germination rates of paprika were higher than 90% in all the media. Plant height, stem diameter, T/R ratio, leaf area, and chlorophyll showed a similar to those in the rockwool medium. Number of leaves, length of the longest root and dry weights of shoot were not significantly different among treatments. Overall, phenolic foam LC and RC produced seedlings with a similar growth as the rockwool medium. The results obtained suggest that rockwool can be replaced with a new material such as phenolic foam in the commercial scale production of plug seedlings of 'Fascinato' paprika.

• Archives of Plastic Surgery
• /
• v.36 no.1
• /
• pp.33-37
• /
• 2009

Purpose: Liver transplantation is considered as the treatment of choice in many acute and chronic liver diseases, and it is becoming more common. Since successful microscopic anastomosis of hepatic artery is a crucial requirement of successful liver transplantation, we studied and analyzed the result of hepatic artery anastomosis of liver transplantation in our liver transplantation center. Methods: 145 liver transplantations were performed between February 2005 and May 2008. Male to female ratio of the liver transplantation recipients was 3.4 : 1. Anastomosis of portal vein, hepatic vein and biliary tract was performed by the general surgeon, and anastomosis of hepatic artery was performed by the plastic surgeon under the loupe or microscopic vision. After the hepatic artery was reconstructed, anastomosed site status and flow were checked with Doppler ultrasonography intraoperatively and with contrast enhanced CT or angiography postoperatively if necessary. Results: Out of 145 liver transplantations, cadaveric liver donor was used 37 cases and living donor liver transplantation was performed 108 cases including the 2 dual donor liver transplantations. As for the baseline diseases that resulted in the liver transplantation, there were 57 cases of liver cirrhosis and hepatocellular carcinoma due to hepatitis B, taking up the greatest proportion. Single donor hepatic artery was used in 114 cases, and mean artery diameter was 2.92 mm and mean artery length was 24.25 mm. Hepatic artery was used as the recipient artery in every case except the 8 cases in which gastroepiploic artery was used as alternative. Out of 145 cases of hepatic artery anastomosis, 3 cases resulted in the thrombosis of the hepatic artery, requiring thrombectomy and re - anastomosis. In all 3 cases, thrombosis was found in left hepatic artery and there was no past history of hepatic artery chemoembolization. Conclusion: Incidence of hepatic artery thrombosis after the anastomosis of hepatic artery during liver transplantation was 2.1%, which is considered sufficiently low.

• Korean Journal of Medicinal Crop Science
• /
• v.22 no.5
• /
• pp.363-368
• /
• 2014

This study was conducted to find out the optimum composition of nursery soil for raising seedling of ginseng (Panax ginseng C. A. Meyer). Total 9 kinds of raw materials were used such as peat-moss, perlite, leaf mould, rice bran, gull's guano, castor-oil plant bark, palm bark, cow manure and chicken manure for optimum composition of nursery soil in ginseng. Occurrence of damping-off in ginseng was lowered about 50% in nursery soil type 1, 2 and 4 than in other types nursery soil in June, and occurrence rate of rusty root also lowest in nursery soil type 1. As the salinity of nursery soil increased, so did the occurrence of physiological disorder in ginseng seedling. The cause of salinity increasing in nursery soil has closely relation to $NO_3-N$, $P_2O_5$ and $Na^+$ content. Plant height, root length, diameter and weight were longer and heavier in nursery soil type 1 (mixing ratio of peat-moss, perlite and leaf mould was 50 : 20 : 30 based in volume) than in other types of nursery soil. So nursery soil type 1 was selected for raising seedling of ginseng. pH and electric conductivity (EC) of selected nursery soil type 1 was 5.55 and 0.13 dS/m. Contents of $NO_3-N$ and $P_2O_5$ were 21.0 and 40.0 mg/L, and $K^+$ 0.36, $Ca^{2+}$ 3.38, $Mg^{2+}$ 2.01 and $Na^+$ $0.09cmol^+/L$, respectively.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.53 no.3
• /
• pp.292-296
• /
• 2008

Clay-coated rice seeds (clay-coated seeds A and B) were directly sown on dry paddy and their growth and yield were compared with the normal drill-sown seeds on dry flat paddy. In clay-coated seeds, germination was 1 day earlier and the emergence rate was higher up to 5% than that of normal drill-sown seeds. But the apparent number of seedling stand per $m^2$ was lower than that of normal drill-sown seeds, which is due to the smaller amount of seeding in clay-coated seeds. At the early growth stage, the plant height of clay-coated seeds A was taller than that of drill-sown seeds, while the plant height of clay-coated seeds B was 0.7 cm shorter than that of drill-sown seeds. At the late growth stage, however, the difference was insignificant in both cases. The maximum tillering stage was 10 days earlier in drill-sown seeds. Lodging index was the lowest in clay-coated seeds B and there was no difference between clay-coated seeds A and drill-sown seeds. The ratio of stem base weight, culm diameter and culm wall thickness were higher in clay-coated seeds, while the lower internodes (4th, 5th and 6th) length was shorter in claycoated seeds than in drill-sown seeds. In clay-coated seeds, the number of panicle per $m^2$ was smaller, while the number of spikelet per panicle was a little larger than in drill-sown seeds. The rate of ripened grain and brown rice 1,000 grain weight were lower in the clay-coated seeds, thus the yield was $98{\sim}99%$ level of drill-sown seeds. Considering that the amount of seeding in clay-coated seeds was two-thirds of that in drill-sown seeds, it is expected that clay coating method could become an additional technique for direct seeding cultivation.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.14 no.2
• /
• pp.132-141
• /
• 1994

In order to study the effects of silage additive on the quality and in preventing aerobic deterioration, reed canarygrass silages were made with various levels of formic acid, caproic acid and a mixture of the two acids. Preparation of silages cutted into about 1.5 cm length with the forage cutter and packed in vinyl bags(50 kg of capacity, 0.1 mrn of thickness), and it also divided nine types of experimental treatments. Aerobic deterioration in the silages were investigated for 7 days of aerobic exposure periods, and the plastic vessel of diameter 25 cm, a height 30 cm used as a tool. The results obtained from this experiment are summarized as fellow. 1. Crude protein and NFE contents at the time if opening were increased in the silage with mixture of formic and caproic acids(P<0.01). Crude fiber and ADF contents during the 7 days of aerobic exposure periods were the decreased in the sslages with mixture of two acods treatment(P<0.01). 2. Temperature of the silage treated with fromic acid alone during the 2 days of aerobic exposure period reached$34.4^{\circ}C$, while that of the silage with caproic acid and mixture formic and caproic acids were not rapidly increased resulting by reduced aerobic deteriorarion. 3. The pH of silages treated with formic acid alone during 7 days of aerobic exposure was not effectively changed, while solages treated with caproic acid were effectively stabilized. 4. The ratio of amminia nitrogen to total nitrogen was significantly decreased in silages with formic acid>caproic acid>mixture of both in the order(P<0.01). 5. Microbiological population of the silage were positively changed during the 7 days of aerobic exposure period. Solages with formic acid were deteriorated at ensiling observed, while applicarion of 1.2% caproic acid was partially reduced deteriorarion by precenting of the growth moulds.

• Korean Journal of Medicinal Crop Science
• /
• v.4 no.4
• /
• pp.271-276
• /
• 1996

This studies were conducted to basic information on growth characteristics and root yield in progeny the derived from different bolting years and to establish optimum seed production time in Angelica gigas. Plant height of early and mid-growing stages had decreased with each year increase in bolting year, but showed no significance in late growing stage at different bolting years. Root charac­teristics including root length, root diameter and dry root weight was slightly good and it had high root/ shoot ratio in third year seed production. respectively. Bolting rate showed that first year seed 38.1%, second year seed 10.4% and third year seed 1.2%, respectively. Therefore, optimum seed production time revealed third year seed for reduce bolting rate. Root yield at different bolting years showed average 1,690kg per hectare as fresh root weight on first year seed, 2,860kg on second year and 2,940kg on third year seed, respectively. A significant positive correlation was appeared between bolting rate and plant height in mid-growing stage. On the other hard, there was highly significant negative correlation between bolting rate and root yield.

• Journal of Ginseng Research
• /
• v.27 no.4
• /
• pp.202-206
• /
• 2003

This study was conducted to compare the growth status of aerial parts, photosynthesis and microclimate between fixing light transmittance (Control) and changing light transmittance (C.L.T.) during ginseng growing seasons. Control showed 8％ light transmittance rate during growing seasons. But C.L.T. showed 18％ light transmittance rate during early (April-June) and late growth stage (September-October) and 6％ light transmittance rate middle growth stage(July-August). Air temperature, leaking water rate and soil water content of C.L.T. was higher than those of control during early and late growth stage. But Air temperature, leaking water rate and soil water content of C.L.T was lower than those of control during middle growth stage C.L.T. exhibited superiority in survival ratio, stem diameter, stem length, L.A.I. and stem angle compared to control. Chlorophyll content of C.L.T. was lower than that of control but S.L.W., stomatal opening and photosynthetic rates of C.L.T. was higher than those of control. Also Alternaria blight disease and defoliation of C.L.T. was lower than those of control.

• Korean Journal of Food Science and Technology
• /
• v.16 no.2
• /
• pp.206-210
• /
• 1984

Heat penetration pattern of canned oyster mushroom(Pleurotus astreatus) was monitored for processing variables-can size, heating temperature and solid fill fraction, and its effects on sterilization condition was reviewed. The $f_h$ value decreased sharply with decrease of solid fill fraction and then became stable from certain solid fill fraction unique to can size. Heat penetration was a little faster at higher heating temperature with lower $f_h$ value. As viewed from $f_h$ value, convection started at higher solid fill fraction with higher length/diameter ratio, and $f_h$ values decreased to about 1.0 with decrease of solid fill fraction. From standpoint of overall cost, retorting time and energy consumption, solid fill fraction of 3/5 was optimum for all can sizes considered.