• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2004.10a
• /
• pp.1207-1210
• /
• 2004

As many humans age, degenerative lumbar spinal stenosis (DLSS) becomes a major cause of lower limb discomfort and disability. By surgical treatment method of DLSS, the existing surgical treatment methods using internal fixation have showed degeneration changes of an adjacent vertebrae and loss of lumbar spine lordosis-kyphosis due to eliminating a motion. For solving the problems of internal fixation, a novel interspinous spacer has been developed to treat DLSS by surgical treatment method. In this study, we evaluated the biomechanical effects of the interspinous spacer on the kinematics of the porcine lumbar spine before and after insertion of the implant. For this purpose, a device that is capable of measuring 3-D motions were built based on direct linear transformation (DLT) algorithm written with MATLAB program. Results showed that in extension, a change of the mean angle between the intact and the implanted specimens at L4-L5 was 1.87 degree difference and the implant reduced the extension range of motion of the L4-L5 (p＆lt;0.05). But the range of motion in flexion, axial rotation and lateral bending at the adjacent segments was not statistically affected by the implant. In conclusion, we thought that interspinous spacer may have remedical value for DLSS by flexing human lumbar spine.

• Journal of Korean Physical Therapy Science
• /
• v.10 no.2
• /
• pp.112-122
• /
• 2003

The purpose of this study is to search effect that GCM joint treatment gets to right and left range of motion of neck, lumbar, trunk and anke joint. Estimated body deformity using GCM body type assesment chart then measured range of motion of each region. After control group did as act freely after do experiment premeasurement control group did postmeasurement. Each region was measured by measurer who each subject person differs. Experimental group did GCM joint treatment and all measurements each region by measurer who each subject person differs three times measured. When measure with each measurement, measured after leave and walk time interval for 10 minutes. For the analysis of the resulr of experiment the results is change amount comparison increased to keep in mind except ankle joint's dorsiflexion before experiment of experimental group and control group(P<.05). Before an experiment and after an experiment of experimental group, differed to keep in mind in right and left comparison of neck rotation, dorsiflexion, plantaflexin of ankle joint in change amount comparison(P<.05). Neck lateral flexion appears and displayed significantly level right and left difference than rotation after experiment of experimental group(P<.05). Because dorsiflexion, plantefleaion of ankle joint became similar right and left significantly difference did not appear(P<.05).

• Physical Therapy Korea
• /
• v.22 no.3
• /
• pp.50-60
• /
• 2015

The purpose of this study was to apply the joint mobilization technique to the level of segments with pain and to the level of segments with hypomobility respectively and compare the immediate effects of the joint mobilization technique on the pain, the active cervical range of motion (ROM), and treatment satisfaction of patients with acute mechanical neck pain. After the baseline assessment, forty-two patients were randomized into two groups: a painful group ($n_1=21$) that received joint mobilization at the most painful cervical spine level and a hypomobile group ($n_2=21$) that received joint mobilization at the most hypomobile cervical level. The patients received an intervention that applied unilateral posterior-anterior gliding for 5 minutes and two repetitions of 10 times of active extension motion with distraction. In the Wilcoxon signed-rank test, the painful group and the hypomobile group were improved significantly in all pain variables (p<.001), while the painful group was improved significantly in the active cervical flexion (p<.001), extension (p<.001), left side-bending (p<.01), right side-bending (p=.001), left rotation (p<.001), and right rotation (p<.001). The hypomobile group was significantly improved in active cervical flexion (p=.001), extension (p<.001), left side-bending (p<.05), right side-bending (p=.001), left rotation (p=.001), and right rotation (p<.01) after intervention. In the Mann-Whitney U test, there was no significant difference in any of the dependent variables after the intervention between the two groups, but the painful group was slightly superior to the hypomobile group in all variables except for the right lateral flexion ROM and treatment satisfaction. These outcomes suggest that the cervical joint mobilization may be applied to either the level of painful segments or the hypomobile segments for the treatment of patients with acute mechanical neck pain.

• Journal of The Korean Society of Integrative Medicine
• /
• v.8 no.1
• /
• pp.113-124
• /
• 2020

Purpose : The purpose of this study was to investigate the effects of exercise intervention combined with 3D visual feedback and motion observation on postural alignment and cerebral cortical activity in subjects with forward head posture (FHP). Methods : The study included 28 participants with FHP, randomly divided into a 3D visual feedback plus motion observation group (n=14) or control group (n=14). The experimental group received corrective exercise combined with 3D visual feedback and motion observation for FHP, three times a week for four weeks. We examined cervical spine radiographs in the lateral standing position with both arms crossed to measure the craniovertebral angle (CVA) and cervical lordosis (CL). Relative alpha (RA) and beta waves (RB) were measured by wireless dry EEG. Results : The CVA value was significantly different between the groups, and the CL value was significantly different only in the experimental group. RA and RB values were not significantly different before and after intervention in the control group. RB values were significantly decreased before and after intervention in the experimental group. Conclusion : Based on the results of this study, we suggest that interventions combined with motion observation and 3D visual feedback may be effective as exercise methods to improve postural alignment and cerebral activity in subjects with FHP. Further research is required to generalize our results on technical supplementation complemented with 3D visual feedback devices.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.4
• /
• pp.369-376
• /
• 2013

The purposes of this study were to assess dynamic stability toward pelvis-spine column distortion during running and to compare the typical three-dimensional angular kinematics of the trunk motion; cervical, thoracic, lumbar segment spine and the pelvis from the multi-segmental spine model between exercise group and non-exercise group. Subjects were recruited as exercise healthy women on regular basis (group A, n=10) and non-exercise idiopathic scoliosis women (group B, n=10). Data was collected by using a vicon motion capture system (MX-T40, UK). The pelvis, spine segments column and lower limbs analysiaed through the 3D kinematic angular ROM pattern. There were significant differences in the time-space variables, the rotation motion of knee joint in lower limbs and the pelvis variables; obliquity in side bending, inter/outer rotation in twisting during running leg movement. There were significant differences in the spinal column that is lower-lumbar, upper-lumbar, upper-thoracic, mid-upper thoracic, mid-lower thoracic, lower thoracic and cervical spine at inclination, lateral bending and twist rotation between group A and group B (<.05, <.01 and <.001). As a results, group B had more restrictive motion than group A in the spinal column and leg movement behaved like a 'shock absorber". And the number of asymmetry index (AI) showed that group B was much lager unbalance than group A. In conclusion, non-exercise group was known to much more influence the dynamic stability of equilibrium for bilateral balance. These finding suggested that dynamic stability aimed at increasing balance of the trunk ROM must involve methods and strategies intended to reduce left/right asymmetry and the exercise injury.

• Korean Journal of Applied Biomechanics
• /
• v.24 no.3
• /
• pp.189-199
• /
• 2014

The purpose of this study was to compare pflugbogen's biomechanical characteristics between on the ski simulator and snowed ski slope to develop interactive ski simulator. Nine ski instructors(sex: male, age: $29.6{\pm}5.4yrs$, height: $176.0{\pm}5.6cm$, body mass: $76.0{\pm}14.0kg$) belong to Korean Ski Instructors Association participated in this research. 24 Infrared cameras for snowed ski slope experiment and 13 infrared camera for ski simulator experiment were installed near by path of pflugbogen. The participants did pflugbogen on the snowed ski slope and the ski simulator both. During the experiment, the participants weared motion capture suit with infrared reflective makers on it, and plantar pressure sensors in ski boots, so that ski motion and plantar pressure data were collected together. Displacement of COG(center of gravity) movements, trunk flexion/extension angle, adduction/abduction angle, and plantar pressure data were significantly different between on the simulator and ski slope. However, percentage of time of COG movement in the phases during medial/lateral and anterior/posterior movement were not significantly different. Findings indicate that the difference between two groups occurred because the ski simulator's drive mechanism is different from ski motion on the slope. In order to develop the ski simulator more interactively for pflugbogen, the ski simulator's drive mechanism need to be reflected 3D motion data of pflugbogen on the slope that were purposed in this research.

• Korean Journal of Applied Biomechanics
• /
• v.14 no.3
• /
• pp.119-134
• /
• 2004

The purpose of this study was to analyze the angular momentum characteristics of the Fosbury Flop high jump and the role of the body segments for the production of 3 angular momentum components. The subjects were three male jumpers who were former Korean national team players. Their jumping motions were analyzed using the DLT method of three-dimensional cinematography. The conclusions were as follows. 1. All the forward angular momentum needed to clear the bar was created in the take-off phase. Take-off leg was the great contributor of the forward angular momentum. On the other hand, free leg produced large opposite angular momentum. 2. All subject had some lateral angular momentum before the take-off phase. Head and free leg had major contribution to the lateral angular momentum production. Take-off leg produced opposite angular momentum. 3. All subject had some twisting angular momentum, which make the back of the athlete him to the bar, before the take-off phase. Free leg was the major contributor of the twisting angular momentum. Head and trunk was the second contributor of the twisting angular momentum. 4. Total angular momentum needed to clear the bar had no significant correlation to the jumping height. 5. Subject who made excessive angular momentum showed different pattern of angular momentum production and had a poor record compared to other subject.

• Structural Engineering and Mechanics
• /
• v.73 no.3
• /
• pp.287-302
• /
• 2020

This investigation deals with a size-dependent coupled thermoelasticity analysis based on Green-Naghdi (GN) theory in nano scale using a new modified nonlocal model of heat conduction, which is based on the GN theory and nonlocal Eringen theory of elasticity. In the analysis based on the proposed model, the nonlocality is taken into account in both heat conduction and elasticity. The governing equations including the equations of motion and the energy balance equation are derived using the proposed model in a nano beam resonator. An analytical solution is proposed for the problem using the Laplace transform technique and Talbot technique for inversion to time domain. It is assumed that the nano beam is subjected to sinusoidal thermal shock loading, which is applied on the one of beam ends. The transient behaviors of fields' quantities such as lateral deflection and temperature are studied in detail. Also, the effects of small scale parameter on the dynamic behaviors of lateral deflection and temperature are obtained and assessed for the problem. The proposed GN-based model, analytical solution and data are verified and also compared with reported data obtained from GN coupled thermoelasticity analysis without considering the nonlocality in heat conduction in a nano beam.

• Proceedings of the Society of Korea Industrial and System Engineering Conference
• /
• 2002.05a
• /
• pp.291-296
• /
• 2002

The midsole hardness of athletic footwear affects capability of absorbing impact shock and controls rearfoot movement during running and walking. The prior studies were focused on examining the proper hardness of footwear for rearfoot movement or to finding effective hardness for absorbing impact shock. The displacements of maximal Achilles tendon angle described a amount of pronation motion is decreased when medial hardness of midsole is large more than lateral. Increasing hardness of footwear midsole are effected to reduce maximum and intial pronation angle, but declined the ability of impact shock during heelstrike. For determination of effectiveness hardness of midsole, therefore, the study that makes a compromise between rearfoot movement and absorbing impact during footstrike must be performed. The purpose of this study is to examine quantitative values of rearfoot control and absorbing impact shock with different hardness of medial and lateral midsole on heel portion. The results are useful to define biomechanical hardness of midsole for developing running shoes. As variable for impact shock, accelerations onto shank and knee are measured during 4 running speeds (5, 7, 9, 11km/h). Also, maximum and $10\%$ pronation angle (Achilles tendon angle) were measured using high-speed camera.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.8 no.4
• /
• pp.169-176
• /
• 2000

Longitudinal and lateral forces acting on tires are known to be closely related to the tract-ability braking characteristics handling stability and maneuverability of ground vehicles. In thie paper in order to develop tire force monitoring systems a monitoring model is proposed utilizing not only the vehicle dynamics but also the roll motion. Based on the monitoring model three monitoring systems are developed to estimate the tire force acting on each tire. Two monitoring systems are designed utilizing the conventional estimation techniques such as SMO(Sliding Mode Observer) and EKF(Extended Kalman Filter). An additional monitoring system is designed based on a new SKFMEC(Scaled Kalman Filter with Model Error Compensator) technique which is developed to improve the performance of EKF method. Tire force estimation performance of the three monitoring systems is compared in the Matlab simulations where true tire force data is generated from a 14 DOF vehicle model with the combined-slip Magic Formula tire model. The built in our Lab. simulation results show that the SKFMEC method gives the best performance when the driving and road conditions are perturbed.