• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.9
• /
• pp.903-913
• /
• 2011

A numerical study is carried out to analyze the steady three-dimensional turbulent flow through cylindrical and fan-shaped holes and the film cooling of these holes at low and high blowing ratios. Compressible Reynoldsaveraged Navier-Stokes equations and the energy equation are solved using a finite-volume-based solver, and a shearstress transport model is used as the turbulence closure. The effects of the compound angle, pitch to diameter ratio, and lateral expansion angle of the hole on the film-cooling effectiveness are evaluated by the film-cooling effectiveness. It is observed that the compound angle of the hole enhances the film performance for the cylindrical hole, and a small hole pitch induces interactions between the coolants from the adjacent holes, thus reducing the film-cooling performance.

• Asian Journal of Atmospheric Environment
• /
• v.12 no.1
• /
• pp.47-58
• /
• 2018

The aim of this work is to investigate the effect of atmospheric stability on near-field pollutant dispersion from rooftop emissions of a single cubic building using computational fluid dynamics (CFD). This paper used the shear stress transport (here after SST) k-${\omega}$ model for predicting the flow and pollutant dispersion around an isolated cubic building. CFD simulations were performed with two emission rates and six atmospheric stability conditions. The results of the simulations were compared with the data from wind tunnel experiments and the result of simulations obtained by previous studies in neutral atmospheric condition. The results indicate that the reattachment length on the roof ($X_R$) obtained by computations show good agreement with the experimental results. However, the reattachment length of the rooftop of the building ($X_F$) is greatly overestimated compared to the findings of wind tunnel test. The result also shows that the general distribution of dimensionless concentration given by SST k-${\omega}$ at the side and leeward wall surfaces is similar to that of the experiment. In unstable conditions, the length of the rooftop cavity was decreased. In stable conditions, the horizontal velocity in the lower part around the building was increased and the vertical velocity around the building was decreased. Stratification increased the horizontal cavity length and width near surface and unstable stratification decreased the horizontal cavity length and width near surface. Maintained stability increases the lateral spread of the plume on the leeward surface. The concentration levels close to the ground's surface under stable conditions were higher than under unstable and neutral conditions.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.34 no.9
• /
• pp.1227-1233
• /
• 2010

In the hot section of a gas turbine, the turbine blades were protected from high temperature by providing a thermal barrier coating (TBC) as well as by cooling air flowing through internal passages within the blades. The cooling air then passed through discrete holes on the blade surface, creating a film of cooling air that further protects the surface from the hot mainstream flow. The holes are subjected to stresses resulting from the lateral growth of thermally grown oxide, the thermal expansion misfit between the constituent layers, and the centrifugal force due to high-speed revolution; these stresses often result in cracking. In this study, the deformation and cracks occurring near a hole on a heat-resistant alloy subjected to thermo-mechanical cycling were investigated. The experiment showed that cracks formed around the hole depending on the applied stress level and the number of cycles. These results could be explained by our analytic solution.

• Korean Journal of Head & Neck Oncology
• /
• v.33 no.1
• /
• pp.73-77
• /
• 2017

An 81 year-old male patient presented with rapid enlargement of left lateral neck mass, diagnosed two months earlier as cervical nontuberculous mycobacterial lymphadenitis. Abscess formation and impending rupture related to aggravation of nontuberculous mycobacterial lymphadenitis was highly suspected. Unexpectedly, blood flow was detected by Doppler ultrasonography, which indicated possible vascular mass. Computed tomography demonstrated a $6.0cm{\times}4.0cm$ sized enhancing mass consistent with pseudoaneurysm of internal carotid artery. The patient underwent pseudoaneurysmectomy. Surgical drainage without adequate evaluation might have led to potentially life-threatening condition. We describe this rare case with importance of imaging screening in a neck mass.

• Journal of Korea Water Resources Association
• /
• v.33 no.3
• /
• pp.341-350
• /
• 2000

The objectives of this study are to develop a state-space form of stochastic dynamic storage function routing model and to test the model performance for real-time flow forecast. The selected study area is the main Han River starting from Paldang Dam site to Indogyo station and the 13 flood events occurred from 1987 to 1998 are selected for computing model parameters and testing the model performance. It was shown that the optimal model parameters are quite different depending on Hood events, but the values used on field work also give reasonable results in this study area. It is also obvious that the model performance from the stochastic-dynamic model developed in this study gives more accurate and reliable results than that from the existing deterministic model. Analysis for allowable forecast lead time leads that under the current time step the reasonable predicted downstream flows in 5 hours time advance are obtained from the stochastic dynamic model on relatively less lateral inflow event in the study area.

• Journal of the Korean GEO-environmental Society
• /
• v.15 no.3
• /
• pp.5-13
• /
• 2014

This paper presents the results of a numerical investigation on applicability of Light-weighted Foam Soils (LWFS) consisted of dredged soils for soft ground improvement. The engineering properties of LWFS were comprehensively investigated based on the previous experimental tests. And three dimensional numerical models which reflect soft ground conditions were adopted to evaluate the applicability of LWFS compared to SCP and DCM. A number of cases were analyzed using a stress-pore pressure coupled model. The results indicated that LWFS method enables to reduce more settlement, lateral flow and heaving than SCP method and enable to reduce more residual settlement than DCM method. Also it was revealed that such effect depends on the properties of LWFS such as unit weight, unconfined compressive strength, deformation modulus and Poisson's ratio.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.18 no.3
• /
• pp.8-16
• /
• 2014

This paper analyzes the effects of sideslip angle(SA) on the buzz margin of supersonic intake. The buzz margin is assumed to be stabilized by a controller which generates command depending only on the longitudinal sensor measurements. The analysis is performed based on three dimensional CFD results with which the sensor measurements can be simulated. In such a control system based on the longitudinal measurements, unexpected lateral flow perturbation results in the increase in the total angle of attack(TAoA), that causes the degradation of the engine intake performance. As a consequence, it is shown that the control stability is reduced such that additional control margin needs to be secured.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.17 no.2
• /
• pp.183-192
• /
• 2004

New dynamic analysis procedures lot the vertically drilled sea water pile are suggested and demonstrated by the typical design Problem. Pile structure submerged in the sea water as well as forces by the ocean waves and tidal currents are modeled and formulated by finite element method. To obtain wave forces for the finite element equation, Airy's wave theory is tested and selected among others. Lateral lifting forces induced by the vortex shedding of current flow is simply based on the harmonic function with the Strouhal frequency and lifting coefficient. Natural frequencies and frequency responses for the pile are calculated by NASTRAN using the results of the formulation. Dynamic displacement and stress results obtained by these procedures are shown to be applicable to predict the dynamic behaviors of the ocean pile by the wave and lifting forces as a preliminary design analysis.

• Nuclear Engineering and Technology
• /
• v.20 no.4
• /
• pp.253-264
• /
• 1988

Our experience of neutron noise analysis in French-type 900 MWe pressurized water reactor (PWR) is presented. Neutron noise analysis is based on the technique of interpreting the signal fluctuations of ex-core detectors caused by core reactivity changes and neutron attenuation due to lateral core motion. It also provides advantages over deterministic dynamic-testing techniques because existing plant instrumentation can be utilized and normal operation of the plant is not disturbed. The data of this paper were obtained in the ULJIN unit 1 reactor during the start-up test period and the statistical descriptors, useful for our purpose, are power spectral density (PSD), coherence function (CF), and phase difference between detectors. It is found that core support barrel (CSB) motions induced by coolant flow forces and pressure pulsations in a reactor vessel were indentified around 8 Hz of frequency.

• Journal of Korean Society on Water Environment
• /
• v.24 no.4
• /
• pp.442-451
• /
• 2008

We analyzed characteristics of rainfall-runoff for the channel of Yongwon area made by a new port construction. And we conducted inundation analysis on the region of lower elevation near the coast. SWMM5 was calibrated with the storm produced by the typhoon Megi from August 19 to August 20 in 2004, and was verified with the storm from August 22 to August 22 in 2004. We performed hydraulic channel routing of Yongwon channel about typhoon Megi from August 19 to August 20 in 2004 by UNET model which is a hydraulic channel routing. The simulated runoff hydrographs were added to the new stream as lateral inflow hydrographs and a watershed runoff hydrograph was the upstream boundary condition. The downstream boundary condition data were estimated by the measured stage hydrographs. The maximum stage that was calculated by hydraulic channel routing was higher than the levee of inundated region in typhoon Megi. Thus we can suppose an inundation to have been occurred. We performed inundation analysis about typhoon Megi from August 19 to August 20 in 2004 and flood discharge of return period 10~150 years. And we estimated each inundation area. The inundation areas by return periods of storms were estimated by 3.4~5.7 ha. The causes of inundation are low heights of levee crests (D.L. 2.033~2.583 m), storm surges induced by typhoons and reverse flow through the coastal sewers (D.L. -0.217~0.783 m). A result of this study can apply to establish countermeasure of a flood disaster in Yongwon.