• Journal of Astronomy and Space Sciences
• /
• v.40 no.4
• /
• pp.237-245
• /
• 2023

Laser communication has been considered as a novel method for earth observation satellites with generation of high data volume. It offers faster data transmission speeds compared to conventional radio frequency (RF) communication due to the short wavelength and narrow beam divergence. However, laser beams are refracted due to atmospheric turbulence between the ground and the satellite. Refracted laser beams, upon reaching the receiver, result in angle-of-arrival (AoA) fluctuation, inducing image dancing and wavefront distortion. These phenomena hinder signal acquisition and lead to signal loss in the course of laser communication. So, precise alignment between the transmitter and receiver is essential to guarantee effective and reliable laser communication, which is achieved by pointing, acquisition, and tracking (PAT) system. In this study, we simulate the effectiveness of tip/tilt compensation for more efficient laser communication in the satellite-ground downlink. By compensating for low-order terms using tip/tilt mirror, we verify the alleviation of AoA fluctuations under both weak and strong atmospheric turbulence conditions. And the performance of tip/tilt correction is analyzed in terms of the AoA fluctuation and collected power on the detector.

• Journal of Satellite, Information and Communications
• /
• v.12 no.4
• /
• pp.166-169
• /
• 2017

This paper describes atmospheric phenomena and effects for satellite-to-ground laser communication channel. Satellite laser communication has advantages such as very high bandwidth, inherent security, robustness to electromagnetic interference, unlicensed frequency band. However, satellite laser communication is affected by various factors. Transmission quality is degraded by factors as system loss, geometric loss, misalignment loss, atmospheric loss. Atmospheric loss is major factor of performance degradation. In this paper, the atmospheric phenomena such as absorption, scattering and turbulence are discussed and analyzed for developing satellite laser channel model and laser transmission scheme robust to atmospheric phenomena.

• Korean Journal of Optics and Photonics
• /
• v.25 no.3
• /
• pp.146-149
• /
• 2014

The homogeneous line broadening in EDF leads to unstable lasing and strong mode competition. In this paper a multiwavelength fiber ring laser that overcomes these effects by using variable attenuators between the DWDM and $1{\times}N$ coupler, has been proposed. Fiber ring lasers with four and eight wavelength outputs are implemented, and we show that the output powers can be adjusted with stable operation. The EDF ring laser has one four-wavelength output and four of single wavelengths, with OSNR of 50 and 60 dB respectively.

• Current Optics and Photonics
• /
• v.1 no.2
• /
• pp.113-117
• /
• 2017

With the increasing use of high-power laser diode bars (LDBs) and stacked LDBs, the issue of thermal control has become critical, as temperature is related to device efficiency and lifetime, as well as to beam quality. To improve the thermal resistance of an LDB set, we propose and analyze a bypass heat sink with a top canopy structure for an LDB set, instead of adopting a thick submount. The thermal bypassing in the top-canopy structure is efficient, as it avoids the cross-sectional thermal saturation that may exist in a thick submount. The efficient thickness range of the submount in a typical LDB set is guided by the thermal resistance as a function of thickness, and the simulated bypassing efficiency of a canopy is higher than a simple analytical prediction, especially for thinner canopies.

• Journal of Sensor Science and Technology
• /
• v.22 no.1
• /
• pp.49-53
• /
• 2013

In this paper, we proposed a laser-based non-contact temperature measuring method for high speed rotating polycarbonate (PC) disk using transparency change of thermocolor. The thermocolor has abilities to change color and transparency due to a change in temperature. The thermocolor is applied on one side of polyvinylidene fluoride (PVDF) membrane. The thermocolor applied membrane is attached to inside of reaction chamber in disk. An optical system consisted of a laser beam radiator and a laser photometer is installed. Laser is irradiated at the bottom side of disk and the transmitted laser beam is detected by the laser photometer at the opposite side of disk. During the disk is rotating, laser is irradiated and detected simultaneously. The laser photometer senses the transmitted laser power and generates voltage as output. The temperature of disk can be detected during the disk is rotating up to 3000 RPM.

• ETRI Journal
• /
• v.24 no.3
• /
• pp.255-258
• /
• 2002

We created a new design for an Nd-doped clad-pumped silica fiber laser to enhance the pump absorption and lasing efficiency for a butt-coupled, end-pumped scheme. Two concatenated adiabatic tapers formed within the laser cavity simultaneously removed higher order modes and were spliced to conventional single mode fibers. We theoretically analyzed mode propagation along the composite cavity and experimentally achieved continuous wave oscillation in the $LP_{01}$ mode at $1.06\;{\mu}m$ and a laser output power of over 820 mW with a slope efficiency of 27%.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.4
• /
• pp.605-610
• /
• 2021

Wireless charging method using a laser is considered as the most efficient method at a long distance of the wireless charging method. Combining long-range laser wireless charging technology with wireless communication technology will make it possible to use it for a variety of applications. Accordingly, this paper shows the results of research and experiments on wireless charging and wireless communication simultaneously based on a laser. This technique uses a laser as a light source for E/O(: Electric-to-Optical) conversion at the transmitter for optical wireless power transmission. In the experimental results, the optical power transmission using a 100 mW laser transmitter and a solar cells receiver showed a DC-to-DC efficiency of 1.9 %, wireless optical communication showed a transmission speed of up to 90 kbps when the transmission distance is 15 m.

• Proceedings of the KIEE Conference
• /
• 2007.10a
• /
• pp.283-284
• /
• 2007

In this paper we introduce a compensation of nonlinearity Heterodyne laser interferometer. The Laser Interferometer is used for length measurement in various industries. However, it has nonlinearity error caused by the imperfect optical equipment. This acts as an obstacle in the measurement improvement. We propose an adaptive error compensation using least mean square(LMS) to improve precision.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.11
• /
• pp.1-8
• /
• 1990

We made a 12-Laser Diode Array consisting of 12 Graded Index Separate Confinement (GRINSCH) InGaAs/Inp Buried Heterostructure 4 Quantum Well Laser Diodes and examined the potential of controlling lasing operation of each laser diode by the voltage to its electroabsorption region. Using Si V-Groove with 12 V-grooves, a 12-Laser Diode Array, and 12 optical fibers, we investigated the various characteristics of each laser diode by changing the voltage to its electro-absorption region. Finally, we thought over the promising way of implementing optical local area communication between electric circuit boards or between subscribers and a central office using a 12-Laser Diode Array, Si V-groove, and optical fibers.

• Journal of Communications and Networks
• /
• v.10 no.1
• /
• pp.1-4
• /
• 2008

This paper reports the design of a multiwavelength fiber laser source that utilizes a linear cavity of hybrid Brillouin/Erbium fiber laser (BEFL). The output power, threshold power and free running cavity modes were investigated against the pump powers. The structure exhibited low threshold operation of 4 mW at 2.3 mW injected Brillouin pump power. The optimization of Brillouin pump wavelength, power and Erbium gain led to a maximum possible number of channels generated. Simultaneous and stable operation of 21 channels with 10.88 GHz channels spacing were obtained from this architecture at 1 mW injected Brillouin pump power and 90 m W Erbium doped fiber pump power in the 1555 nm region.