• Journal of Biomedical Engineering Research
• /
• v.9 no.1
• /
• pp.135-138
• /
• 1988

In this paper, computerized BEAM was implemented for the space domain analysis of EEG. Trans-formation from temporal summation to two-dimensional mappings is formed by 4 nearest point inter-polaton method. Methods of representation of BEAM are two. One is dot density method which classify brain electrical potential 9 levels by dot density of gray levels and the other is colour method which classify brain electrical 12 levels by red-green colours. In this BEAM, instantaneous change and average energy distribution over any arbitrary time interval of brain electrical activity could be observed and analyzed easily. In the frequency domain, the distribution of energy spectrum of a special band can easily be distinguished normality and abnormality.

• 한국신재생에너지학회:학술대회논문집
• /
• 2008.10a
• /
• pp.208-212
• /
• 2008

Gas hydrate has been paid attention to study for because: 1) it can be considered as a new energy resources; 2) one of reasons causing the instability of sea floor slope and 3) a factor to the climate change. Bottom simulating reflector (BSR) defined as seismic boundary between the gas hydrate and free gas zone has been considered as the most common evidence in the seismic reflection data for the gas hydrate exploration. BSR has several characteristics such as parallel to the sea bottom, high amplitude, reducing interval velocity between above and below BSR and reversing phase to the sea bottom. Moreover, instantaneous attribute properties such as amplitude envelop, instantaneous frequency, phase and first derivative of amplitude of seismic data from the complex analysis could be used to analyze properties of BSR those would be added to the certain properties of BSR in order to effectively find out the existence of BSR of the gas hydrate stability zone. The output of conventional seismic data processing for gas hydrate data set in Ulleung basin in the East sea of Korea will be used for complex analyses to indicate better BSR in the seismic reflection data. This result of this analysis implies that the BSR of the analyzed seismic profile is clearly located at the two ways time (TWT) of around 3.1 seconds.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.3
• /
• pp.6-11
• /
• 2006

This paper describes the novel control techniques design of VSC(Voltage Sag Corrector) for the purpose of power line quality enhancement. A fast detecting technique of voltage sag is implemented through the detection of instantaneous value on synchronous rotating dq-reference frame. The first order digital filter is added in the detection algorithm to protect the insensitive characteristics against the noise. The relationship between the total detection time and cut-off frequency of the filter is described. The size of the capacitor bank used as the energy storage element is designed from the point of view of input/output energy with circuit analysis. Finally, the validity of the proposed scheme is proven through the simulated results.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.4
• /
• pp.1210-1216
• /
• 2014

This paper deals with an application of Teager Energy Operator (TEO) and Energy Separation Algorithm(ESA) to detect and determine various voltage waveform distortions like harmonics, inter-harmonics and frequency variation. Because the TEO and DESA algorithm was initially proposed for speech or communication analysis, its applications are limited to some types of waveform in the power quality analysis area. For example, an undistorted voltage signal is similar with a pure sinusoid. A voltage fluctuation is very similar with an amplitude-modulated signal, from the viewpoint of signal theory. And a continuous frequency variation is similar with a frequency-modulated signal, which is also known as a chirp signal. This paper is written to show that the TEO and DESA algorithm can be used for detecting occurrences of the representative waveform distortions and determining their instantaneous information of amplitude and frequency.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.5
• /
• pp.666-669
• /
• 2020

Energy harvesting sensor networks have the ability to collect energy from the environment to overcome the power limitations of traditional sensor networks. The sensor network, which has a limited transmission range, delivers data to the destination node through a multi-hop method. The routing protocol should consider the power situation of nodes, which is determined by the residual power and energy harvesting rate. At this time, if only considering the magnitude of the power, power imbalance can occur among nodes and it can induce instantaneous power shortages and reduction of network lifetime. In this paper, we designed a routing protocol that considers the balance of power as well as the residual power and energy harvesting rate.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.23 no.5
• /
• pp.822-826
• /
• 1994

Effects of concentration(6-9%, db) , heating temperature (80-95$^{\circ}C$), cooking time (10-50min) and heating method (continuous and instantaneous) on the apparent viscosity of cowpea sediment dispersions at 6$0^{\circ}C$ were investigated. The instantaneous heating resulted in higher apparent viscosity than continuous heating regardless concentrations and heating temperatures. The activation energy of the increase rate constant of the apparent viscosity was about 8 kcal/mole. The apparent viscosity of the cowpea sediment dispersion heated to 95$^{\circ}C$ and held for 20 min showed a linear relation with the 20 min height at 92.5$^{\circ}C$ by viscoamylograph.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.18 no.3
• /
• pp.26-36
• /
• 2010

This paper provides a description of the combustion model to obtain an accurate dynamic engine phenomena that satisfies real-time simulation for model-based engine control. The combustion chamber is modeled as a storage device for mass and energy. The combustion process is modeled in terms of a two-zone model for the burned and unburned gas fractions. The mass fraction burnt is modeled in terms of a Wiebe function. The instantaneous net engine torque is calculated from the engine speed and the instantaneous piston work. The modeling accuracy has been tested with a cylinder pressure data on a test bench and also the ability of real-time simulation has been checked. The results show that combustion model yields sufficiently good performance for the model-based control logic design. However the influence factors effected on model accuracy are some room for improvement.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.48 no.6
• /
• pp.678-682
• /
• 1999

In this paper, we propose the algorithm which can control active power and reactive power independently in Battery Energy Storage System. The proposed algorithm is based on the instantaneous power theory that the inner product of the voltage vector and current vector represents the active power and the cross product of those represents the reactive power, and it can control active power and reactive power independently. To verify the validity of the proposed algorithm, we make model of the real power system in th KERI and simulate this algorithm. As a result of this simulation, we verified that the proposed algorithm can control active power and reactive power independently.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.1 no.4
• /
• pp.171-181
• /
• 1977

This paper is aiming at calculating NOx concentration, which is one of the harmhul components of emission from the gasoline engine, formed in the combustor through the presess of combustion. Instantaneous temperature and concentration of each components for each division can be determined by the solution of simulatneous equation of reaction equation and equation of energy conservation, inputting the estimated temperature with a considerably wide rage of temperature. After determining instantaneous temperature and instantanous concentration of each components, the nonequilibrium calculation is performed based on the reaction kinetics in order to determine NOx concentration. To summarize the result abtained from the above method ;through the passage of NO concentration, NO concentration is the highest in the first division and it is gradually decreasing through the following divisions In the final division, NO concentation is the lowest.

• Current Optics and Photonics
• /
• v.1 no.5
• /
• pp.491-499
• /
• 2017

Ghost imaging offers great potential, with respect to standard imaging, for imaging objects in optically harsh or noisy environments. It can solve the problems that are difficult to solve by conventional imaging techniques. Recently, it has become a hot topic in quantum optics. In this paper, we propose a scheme for ghost imaging based on rosette scanning, named rosette ghost imaging. Sampling a small area sampling instead of the whole object, the instantaneous field of view of rosette scanning is used as the modulation light field in ghost imaging. This scheme reduces energy loss, the number of samples, and the sampling time, while improving the quality of the reconstructed image.