• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.26 no.2
• /
• pp.84-88
• /
• 2016

AlN single crystals were grown by the PT (Physical vapor transport) method with position-changable induction coil. And the graphite crucible dimensioned ${\Phi}90{\times}H120$ was used on processing. The temperature was $1950{\sim}2050^{\circ}C$ and ambient pressure was 150~1 Torr. And the hot-zone was changed according to times on growing for result comparison. When hot-zone by coil is located below far enough (> 40 mm) from AlN crystal concentration position, the as-grown crystals physical size is better ($300{\mu}m/hr$) than another condition, but the condition-reproducibility was very poor. However the closer the distance between hot-zone and AlN growing posion, the smaller the size of as-grown crystal and the rarer the generation of the crystal nuclear, but the crystal growing condition is stable for quality. The best condition for both growth rate and quality is gained when the starting position of hot-zone coil is about 20 mm distance from growing position. For the best growth condition, the position of hot-zone is very sensitive factor and the further more the condition of speed of coil shift also must control.

• Journal of the Korean Magnetics Society
• /
• v.14 no.1
• /
• pp.7-12
• /
• 2004

The annealing-temperature dependence of magnetic properties in compressed powder cores being composed of ball-milled F $e_{73.5}$C $u_1$N $b_3$S $i_{15.5}$ $B_{7}$ alloy powders (size 250∼850${\mu}{\textrm}{m}$) and 5 wt% of ceramic insulators has been investigated. When annealed at 5$50^{\circ}C$ for 1 h and so transformed to $\alpha$-Fe phase nanocrystalline structure with the grain size of 11 nm (electrical resistivity : 110 $\mu$Ω$.$cm), the highest effective permeability of 125 and quality factor of 53 were obtained, and the permeability persisted up to about 500 KHz. Further the core loss measured at the frequency of 50 KHz and the induction amplitude of 0.1 T was very low (230 mW/㎤). However the dc bias characteristics was not satisfactory as compared to that of conventional powder core materials(MPP, Sendust etc.). The inferior dc bias property of F $e_{73.5}$C $u_1$N $b_3$S $i_{15.5}$ $B_{7}$ alloy powder cores was attributed to the fact that the size of powder was too large for obtaining the same permeability with that of conventional materials.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.19 no.1
• /
• pp.109-114
• /
• 1997

Malignant hyperthermia is a hypermetabolic, fatal syndrome triggered by anesthetic drugs that occurs frequently in genetically susceptible persons. It is characterized by tachycardia, rapidly increasing temperature, skeletal muscle rigidity, respiratory and metabolic acidosis, cyanosis etc. It has been noted that the majority of cases of malignant hyperthermia are fatal unless early diagnosis and treatment are performed. Thus, the accurate prediction of preanesthetic susceptibility and early diagnosis of malignant hyperthermia is necessary to appropriate treatment. Dantrolene sodium has been shown to be effective in the prevention and treatment of malignant hyperthermia. We experienced a case of malignant hyperthermia, which is presented of a 32-year-old healthy male patient in whom a orthognatic surgery was performed under $O_2-N_2O$-enfl-rane anesthesia with induction by pentobarbital and succinylcholine. We discuss this case with reviewing the history, incidence, etiology, pathophysiology, clinical signs & biochemical changes, prevention & treatment.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.45 no.5
• /
• pp.438-444
• /
• 2012

This study was investigated the effect of gamma irradiation (GI) on the shelf-life and quality improvement of squid sundae (a traditional Korean sausage) stored at room temperature after 0 (control), 10 and 20 kGy doses of irradiation. The total viable cells decreased with increasing irradiation dose, and no viable cells were detected with the doses of 20 kGy. There were no significant changes in pH compared to the control. The volatile basic nitrogen (VBN) and thiobarbituric acid reactive substance (TBARS) values of GI (20 kGy) squid sundae were significantly lower than those of the control. In addition, the induction period for the GI (20 kGy) squid sundae measured by the Rancimat method was higher level than that of the control. In a sensory evaluation, there were no significant differences between the control and GI samples during storage.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.55 no.4
• /
• pp.284-291
• /
• 2010

A simulation modeling for predicting the harvesting date with high potato solids consists of development of mathematical models. The mathematical model on potato growth and its development should be obtained by using agricultural elements which analyze relations of solar radiation quantity, temperature, photon quantity, carbon dioxide exchange rate, water stress and loss, relative humidity, light intensity, and wind etc. But more reliable way to predict harvesting date against climatic change employs in vivo energy consumption for growth and induction shape in a slight environmental adaptation. Therefore, to calculate in vivo energy loss, we take a concept of estimate of the amount of basal metabolism in each tuber on the basis of $Wm={\int}^m_tf(x)dt$ and $Tp=\frac{Tm{\cdot}Wm^{Tp}}{Wm^{Tm}}$. In the validation experiments, results of measuring solid accumulation of potato harvested at simulated date agreed fairly well with the actual measured values in each regional field during the growth period of 2005-2009. The calculation method could be used to predict an appropriate harvesting date for a production of high potato solids according to weather conditions.

• Journal of the Society of Disaster Information
• /
• v.16 no.1
• /
• pp.96-110
• /
• 2020

Recently, due to global warming, it is easily exposed to various disasters such as fire, flood, and earthquake. In particular, large-scale disasters have continuously been occurring in crowded areas such as traditional markets, facilities for the elderly and children, and public facilities where various people stay. Purpose: This study aims to detect a fire occurred in crowded facilities early in the event to analyze and provide an optimal evacuation route using big data and advanced technology. Method: The researchers propose a new algorithm through context-aware 3D object model technology and A* algorithm optimization and propose a scenario-based optimal evacuation route selection technique. Result: Using the HPA* E algorithm, the evacuation simulation in the event of a fire was reproduced as a 3D model and the optimal evacuation route and evacuation time were calculated for each scenario. Conclusion: It is expected to reduce fatalities and injuries through the evacuation induction technique that enables evacuation of the building in the shortest path by analyzing in real-time via fire detection sensors that detects the temperature, flame, and smoke.

• Journal of Veterinary Clinics
• /
• v.28 no.2
• /
• pp.211-218
• /
• 2011

The aims of this study were to investigate the anesthetic effects of medetomidine-midazolam-ketamine (MMK) combination and to compare antagonistic effects of atipamezole and yohimbine in dogs anesthetized with MMK. Eighteen adult male healthy beagles were used in this study. All dogs were anesthetized with intramuscular (IM) administration of medetomidine (0.04 mg/kg), midazolam (0.2 mg/kg) and ketamine (5 mg/kg) in one syringe. Intravenous (IV) administration of atipamezole (0.24 mg/kg, MMKA), yohimbine (0.2 mg/kg, MMKY) or saline solution (0.1 ml/kg, MMK) was administered 20 minutes after MMK combination anesthesia. Induction and recovery times, scores of sedation and analgesia, heart rate, blood pressure, rectal temperature, respiratory rate and blood gases were determined and recorded for each dog. Mean anesthesia times, sternal recumbency times, standing times and walking times in the MMKA and MMKY groups were significantly shorter than those in the MMK group. But there were not significantly different between MMKA and MMKY groups. In all groups, MMK administration produced a satisfactory sedation and analgesia for all dogs. However, after administration of atipamezole or yohimbine the scores for posture and response to noxious stimuli were significantly lower in the MMKA or MMKY group than those in the MMK group. MMK produced good sedation and anesthesia effects, and atipamezole or yohimbine can be used as a safe and effective agent for antagonizing the MMK anesthesia in dogs.

• Food Science of Animal Resources
• /
• v.28 no.2
• /
• pp.154-159
• /
• 2008

To investigate the rheological properties of protein mixed gels mediated by microbial transglutaminase (MTGase), pork myofibrillar protein (MFP), sodium caseinate (SC) and their mixture (MS), the various gels were incubated at different temperatures for various times. Extracted MFP, SC and their mixture (MS, 1:1) were incubated at different temperatures ($4^{\circ}C$ vs $37^{\circ}C$) for various times (0, 0.5, 2, 4 hr), and assessed for viscosity, gel strength and other characteristics using differential scanning calorimeter (DSC) and sodium dodecyl sulfate polyacrylamide gel electrophoresis (SDS-PAGE). DSC measurements showed that incubation at $37^{\circ}C$ rather than $4^{\circ}C$ caused marked changes in thermal transition, and MS displayed similar thermal curves (three endothermic transitions) to MFP and SC alone. After incubation at $37^{\circ}C$ for 2 hrs, the viscosity (cP) of MS increased (p<0.05) due to induction by MTGase, whereas no differences were observed at $4^{\circ}C$. However, gel strength values were no different, regardless of incubation temperatures and times. Future research will address how longer incubation times affect the functionality of protein mixed gels mediated by MTGase.

• Korean Journal of Microbiology
• /
• v.52 no.3
• /
• pp.313-318
• /
• 2016

Bacteria in the viable but nonculturable (VBNC) state fail to produce colonies on routine bacteriological media, but are still alive in the state of very low metabolic activity. The aim of the present study was to induce the VBNC state of the Edwardsiella tarda using sea water microcosm under starvation conditions at $10^{\circ}C$ and to investigate resuscitation of the VBNC cells in temperatures changed from 10 to $25^{\circ}C$, with and without additives. E. tarda entered into the VBNC state within about 42-84 days of incubation in the microcosm. Throughout this period, the total cell counts as determined using acridine orange direct counting remained near the original inoculum level of ${\sim}10^8cells/ml$. The live cell counts measured with direct viable counting, on the other hands, declined to ${\sim}10^4cells/ml$. When the VBNC cells were incubated with addition of yeast extract, fish muscle extract or serum at $25^{\circ}C$, the ratios of resuscitated samples were 37%, 23%, and 37%, respectively. The characteristics of resuscitated E. tarda were consistent with those of the original E. tarda. When the resuscitated E. tarda were intraperitoneally injected into olive flounders, all fishes died within 5 days, indicating that the VBNC E. tarda might retain its pathogenic potential. Therefore, E. tarda under starvation conditions in the winter enter into the VBNC state and the VBNC E. tarda cells resuscitated at summer and autumn seawater temperature are considered to be pathogen continuously to olive flounder on the southern coast of Korea.

• Korean Journal of Materials Research
• /
• v.10 no.6
• /
• pp.398-402
• /
• 2000

Three kinds of $Al_3Ti-Cr$ alloys, namely, $Al_{67}Ti_{25}Cr_8,\;Al_{66}Ti_{24}Cr_{10}\;and\;Al_{59}Ti_{26}Cr_{15}$, were prepared by induction melting followed by the thermomechanical treatment. The corrosion behavior in 3.5% NaCl solution and the high-temperature oxidation behavior at 1000, 1100 and $1200^{\circ}C$ for the prepared alloys were investigated. Electrochemical results indicated increased resistance to localized corrosion with increasing Cr content. Cr additions were found to prevent passive film from undergoing brittle fracture. XPS results revealed the passive films of $Al_3Ti-Cr$ alloys were composed mainly of $Al_2O_3$ that coexisted with $TiO_2$ and $Cr_2O_3$. The overall oxidation resistance of the prepared alloys were excellent. Specifically, the oxidation resistance increased in the order of $Al_{59}Ti_{26}Cr_{15},\;Al_{66}Ti_{24}Cr_{10}\;and\;Al_{67}Ti_{25}Cr_8$. As the Al content in the base alloys increased, the $Al_2O_3$ formation was facilitated leading to the increased oxidation resistance.