• Journal of Korean Society of Forest Science
• /
• v.84 no.4
• /
• pp.517-524
• /
• 1995

This study was conducted to investigate the characteristics of the road alignment, correlations among evaluation factors of the alingment, and the relationships between the evaluation factors and terrain factors for the forest road of five National Forest Offices. The results were as follows : 1. The elongation coefficients(${\eta}$) of forest road in Kangnung and Wonju National Forest Office were ranged 0.3~0.5, and those of Andong, Namwon, and Kongju National Forest Offices were ranged 0.2~0.3 in straight line of 100m, 200m, and 300m. 2. Three different types of plane alignment were identified for Kangnung and Wonju National Forest Offices, Namwon and Kongju National Forest Offices, Andong National Forest Office. However, longitudinal alignment for five National Forest Offices tended to be similar conditions. 3. Low correlation coefficients were calculated in the relation between elongation coefficients(${\eta}$) and evaluation factors of plane alignment(curve length ratio(%), sum of inverse number of each curve radius(m/km), and sum of each intersection angle($^{\circ}/km$)) for three straight lines. On the contrary, high correlation coefficients were obtained among the relations of curve length ratio(%), sum of inverse number of each curve radius(m/km), and sum of each intersection angle($^{\circ}/km$). 4. Slope(%) were closely correlated with plane alignment, and so were the relationships between frequency of valleys and streams(No./km) and elongation coefficients(${\eta}$) of forest road.

• The Journal of Engineering Geology
• /
• v.19 no.2
• /
• pp.119-129
• /
• 2009

In relation to slope stability analysis, geologic characteristics and engineering properties of the discontinuities in three slopes selected are compared and analyzed by both square-inventory method and scanline survey. The aim of the study is in evaluating which method is applied better in slope stability analysis by comparing results of the two methods with those of direct observation on outcrop of slope failures generated. In each slope, results of comparative analysis among geologic and engineering properties are analyzed similarly one another. However, results of orientation analysis in slope 2 are different each other, which indicates orientation of joints in slope 2 depends on persistency and frequency of each joint and also indicates appearance of new joint set with different orientation. Probability density distribution and spacing in slope 3 are high in comparison to those in slope 2 and 3. The reasons are that distribution of psammitic rocks and development of minor folds in slope 3 unlike slope 2 and 3 are closely associated with development of joints. The research data indicate that the square-inventory method predicts more precise failure aspects and is more effective way than scanline survey in analyzing slope stability of the study area.

• Journal of Sensor Science and Technology
• /
• v.8 no.1
• /
• pp.10-15
• /
• 1999

White emission thin film electroluminescent device was fabricated using ZnS for phosphor layer and BST ferroelectric thin film for insulating layer. For fabrication conditions of BST thin film, stoichiometry of target was $Ba_{0.5}Sr_{0.5}TiO_3$, substrate temperature was $400^{\circ}C$, working pressure was 30 mTorr, and A:$O_2$ ratio was 9:1. At this time, dielectric constant was 209 at 1kHz frequency. For phosphor layer ZnS:Mn, ZnS:Tb, and ZnS:Ag were used. Mixing rates of activators were respectively 0.8, 0.8, and 1 wt%. Total thickness of phosphor tapers was 500 nm, thickness of lower insulating layer was 200 nm, and thickness of upper insulating layer was 400 nm. In this conditions, luminescence threshold voltage of thin film electroluminescent device was $95\;V_{rms}$, maximum brightness was $3,000\;cd/m^2$ at $150\;V_{rms}$. Luminescence spectrum peak was observed at region of blue(450 nm), green(550 nm), and red(600 nm).

• Journal of Science Education
• /
• v.36 no.2
• /
• pp.167-185
• /
• 2012

This study aimed at finding points of improvement in teaching expertise by analyzing the question patterns that appeared during teaching demonstrations which applied science teaching models prepared by a pre-service biology teacher. The question analysis frame for analyzing question types were categorized largely into the question types of Category 1 (questions in cognitive domain, questions with research function, questions in affective domain), Category 2 (repeated questions, questions for narrowing the range, practice questions), and Category 3 (questions on student activity progress, memory questions, and thinking questions). The results of analyzing question patterns from five different science teaching models revealed a high frequency of questions in the fields of cognition and memory. For the circular learning model, questions from the cognitive field appeared the most often, while, student activity progressive questions in particular were used mostly in the 'preliminary concept introduction stage' of the circular learning model and the 'secondary exploratory stage', in which experiments were conducted, and displayed the characteristics of these stages. The discovery learning model combined the courses of observation, measurement, classification and generalization, but, during teaching demonstrations, memory questions turned up the most, while the portion of inquisitive function questions was low. There were many questions from the inquisitive learning model, and, compared to other learning models, many exploratory function questions turned up during the 'experiment planning stage' and 'experiment stage'. Definitional questions and thought questions for the STS learning model turned up more than other learning models. During the change of concept learning model, the five concepts of students were stimulated and the modification of scientific concepts was very much aided by using many memory questions.

• Fire Science and Engineering
• /
• v.28 no.4
• /
• pp.104-111
• /
• 2014

The purpose of this study is to investigate the CPR within ambulance. The Subjects were 890 emergency medical technicians in fire department in Gyeonggido. After continuing education program, the emergency medical technicians completed the questionnaires from January to February, 2012. Questionnaire consisted of demographic characteristics, method of chest compression (one handed or two handed), chest compression - ventilation ratio, and hands only CPR. Data were analyzed by frequency analysis and Chi-square test, t-test. One-way analysis of variance (ANOVA) was followed by Scheffe post-hoc test to analyze changes in all parameters between all groups. One handed chest compression accounted for 14.0% and two handed chest compression accounted for 86.0%. Hands only CPR accounted for 71.7% and standard CPR (30:2) accounted for 28.3%. In order to perform the high quality CPR, as least three persons must be dispatched in the ambulance. The flexible management of manpower may improve the survival from the cardiac arrest. A systemic approach for educating and training EMT's in CPR is needed.

• Journal of Korea Water Resources Association
• /
• v.49 no.12
• /
• pp.995-1006
• /
• 2016

According to 5th IPCC Climate Change Report, there is a very high likelihood that the frequency and intensity of extreme rainfall events will increase. In reality, flood damage has increased, and it is necessary to estimate the future probabilistic design rainfall amount that climate change is reflected. In this study, the future probabilistic design precipitation amount is estimated by analyzing trends of future annual maximum daily rainfall derived by RCP 8.5 scenarios and using the scale-invariance technique. In the first step, after reviewing the time-scale characteristics of annual maximum rainfall amounts for each duration observed from 60 sites operating in Korea Meterological Administration, the feasibility of the scale-invariance technique are examined using annual daily maximum rainfall time series simulated under the present climate condition. Then future probabilistic design rainfall amounts for several durations reflecting the effects of climate change are estimated by applying future annual maximum daily rainfall time series in the IDF curve equation derived by scale-invariance properties. It is shown that the increasing trend on the probabilistic design rainfall amount has resulted on most sites, but the decreasing trend in some regions has been projected.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.12
• /
• pp.1219-1227
• /
• 2014

For development of the surface acoustic wave bandpass filter(SAW-BPF), we fabricated the high quality ZnO thin films through the step-by-step(double) deposition using two different deposition methods which are pulsed laser deposition(PLD) and RF sputtering techniques. The second growth of ZnO thin films was completed by RF sputtering method on the first ZnO thin films pre-deposited by PLD method. The characteristics of ZnO thin films were analyzed by XRD, SEM and AFM systems. The FWHM of ${\omega}$-scan analysis and the minimum RMS value of surface roughness of step-by-step grown ZnO thin films were $0.79^{\circ}$ and 1.108 nm respectively. As a result, the crystallinity and the preferred orientation of the grown ZnO thin films were kept good quality and the surface roughnesses of those were improved by post-annealing process as comparison with ZnO thin film fabricated by the conventional PLD technique only. Using these proposed ZnO thin films, we demonstrated the RF device such as SAW-BPF, built by the proposed ZnO thin films, shows that it has the bandwidth of 2.98 MHz and the insertion loss of 36.5 dB at the center frequency of 260.8 MHz, respectively.

• Journal of the Korean Society of Safety
• /
• v.35 no.2
• /
• pp.28-33
• /
• 2020

Recently, the overseas construction market has been actively promoted for about 10 years, and overseas dam construction has been continuously performed. For the economic and safe construction of the dam, it is important to prepare the main dam construction plan considering the design frequency of the diversion tunnel and the cofferdam. In this respect, the prediction of river level during the rainy season is significant. Since most of the overseas dam construction sites are located in areas with poor infrastructure, the most efficient and economic method to predict the water level in dam construction is to use the upstream water level. In this study, a linear regression model, which is one of the simplest statistical methods, was proposed and examined to predict the downstream level from the upstream level. The Pyeongchang River basin, which has the characteristics of the upper stream (mountain stream), was selected as the target site and the observed water level in Pyeongchang and Panwoon gaging station were used. A regression equation was developed using the water level data set from August 22th to 27th, 2017, and its applicability was tested using the water level data set from August 28th to September 1st, 2018. The dependent variable was selected as the "level difference between two stations," and the independent variable was selected as "the level of water level in Pyeongchang station two hours ago" and the "water level change rate in Pyeongchang station (m/hr)". In addition, the accuracy of the developed equation was checked by using the regression statistics of Root Mean Square Error (RMSE), Adjusted Coefficient of Determination (ACD), and Nach Sutcliffe efficiency Coefficient (NSEC). As a result, the statistical value of the linear regression model was very high, so the downstream water level prediction using the upstream water level was examined in a highly reliable way. In addition, the results of the application of the water level change rate (m/hr) to the regression equation show that although the increase of the statistical value is not large, it is effective to reduce the water level error in the rapid level rise section. Accordingly, this is a significant advantage in estimating the evacuation water level during main dam construction to secure safety in construction site.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.6
• /
• pp.494-502
• /
• 2017

This study examined the change in the students' perception of infection after school education. A self-reported questionnaire was filled out by 300 dental hygiene students in Kangwon from December 3 to December 4, 2016. The contents of the questionnaire included the general characteristics (5 items), infection-related selection (2 items), infection control recognition (5 items), and infection control behavior (10 items). The data were analyzed by frequency analysis, t-test, one way ANOVA, Chi-square test, and hierarchical multiple regression analysis using SPSS 24.0. The Cronbach's Alpha was 0.941 and 0.658, respectively. The school year and hospital practice experience had some influence on the change in infection recognition. A total of 127 students (62.6%) who had experience in practicing in hospitals knew more about antibodies. Hand washing was the highest in personal protection, followed by masks. The selection of the infectious control education method showed that the practical training class was high irrespective of the hospital practice experience, and the perceptions of patient-related infections were the greatest explanatory factor in perception after education.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.26 no.6
• /
• pp.587-593
• /
• 2020

The securing safety of ferry ships on the domestic coast is evaluated by comparing the external force applied and the securing device based on the cargo weight and hull acceleration that can exist at the loaded position. The hull acceleration based on the domestic standard, which is the basis for securing safety evaluation, is applied without reflecting the characteristics of the ship and the sailing conditions. In this study, a total of 12 acceleration measurements were performed at four points of the hull of a ship with a DWT 6,800 ton class 15.5 knots passing through Busan-Jeju to analyze the hull acceleration of the domestic coastal ferry ship. Data were collected for the buoy. For a theoretical comparative analysis of the limited measurement results, the response amplitude operator (RAO) was analyzed through frequency-response analysis by numerical simulation, and acceleration analysis for the four points was performed using the RAO results. Based on the acceleration comparison, differences in the degree of each position were observed, but in the case of the Y-axis acceleration, the analysis was 1.81 m/s², and the measurement was 1.47 m/s². The analyzed simulation result was as high as 0.34 m/s². Moreover, analysis was performed at 22 % level, and measurement at 18 % level.