• Biomedical Science Letters
• /
• v.11 no.4
• /
• pp.539-543
• /
• 2005

Elevated level of serum cholesterol in humans is a risk factor correlated with the development of coronary heart disease. We have screened lactic acid bacteria from pig and human feces for the development of probiotics which have an anti-cholesterol effect. We have used special media to isolate only lactic acid bacteria and they were subjected to the experiments such as oxgal test, carbohydrate fermentation test. Results from the acid tolerance test and growth test in the presence of oxgal demonstrated that some strains would likely survive in thuman stomach, where acidity is high, and in small intestine, where bile fluid is present. In conclusion, we were able to screen lactic acid bacteria which were tolerant against bile acid and supposed to be prominent to lower the cholesterol level in human serum.

• Journal of radiological science and technology
• /
• v.5 no.1
• /
• pp.45-47
• /
• 1982

Authors carried out the research on the actual condition of intensifying screens in a certain hospital and obtained the results as follows: 1. High speed intensifying screens were 63.9% and medium typed screen had 36.1%. 2. Half the number of using screens(51.5%) were not clear in a period of used time. 3. 47.4% of same typed screens showed a remarkable difference(two times) in sensitivity.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.7
• /
• pp.558-562
• /
• 2012

As an alternative energy, Dye-sensitized solar cells (DSSCs) have received much attention due to low cost manufacturing procedure and high energy consumption rate. Incorporating scattering centers in the nanocrystalline photoanode or additional scattering layers on the nanocrystalline photoanode is an effective way to enhance the light harvest efficiency of the photoanode and the performance of dye-sensitized solar cells (DSSCs). The light scattering abilities of these scattering layers also depend on the relative sizes and phase of the particles in the layers. A higher surface area is normally obtained using large particle sizes. Therefore, transparent high surface area $TiO_2$ layers and an additional scattering layer consisting of $TiO_2$-Rutile 500 nm paste with relatively larger particles are attractive. In this work, we investigates the applicability of a hybrid $TiO_2$ electrode (or a working electrode with a light scattering layer) in a DSSCs. We fabrication various thin film using $TiO_2$ paste 20 nm and $TiO_2$ paste 500 nm. As a result, the efficiency of the a single structure thin film was 3.35% and the efficiency as scattering layer of hybrid structure thin film was 4.36%, 4.73%.

• Science of Emotion and Sensibility
• /
• v.11 no.4
• /
• pp.575-588
• /
• 2008

This study is to inquire respective patterns of mental models caused by wrongful usages which can be experienced when a user who is used to a keypad-based mobile phone starts using a touch screen mobile phone and to find out the features of the user's logical process of correcting such wrongful usages to a new mental model. In addition, design improvement to be considered for easy generation of the mental model regarding touch screen mobile phones was reviewed in this study. We set up test subjects for the most frequently used seven high priority functions among touch screen phone functions and carried out the subject assessment together with interview surveys after the video observation experiment. Our test results show that test subjects who were used to keypad-based mobile phones tend to use operation knowledge related to the computer operational system(Window) or the web browse, navigation including Tap or Double Tap in order to correct the mental model when a wrongful usage is made. In addition, the result of comparison and analysis of the subject assessment and the video observation experiment data shows that wrongful usages of touch screen mobile phones mostly occurred in the field of 'information feedback' and 'navigation' among mobile phone components.

• Journal of Biosystems Engineering
• /
• v.1 no.1
• /
• pp.15-15
• /
• 1976

In analyzing the operational characteristics of a rice whitening machine, the internal radial pressure of the machine was measured using strain gage equipment. Changes in cylinder and feed screw configurations, screen type, cylinder speed and counter-pressure levels were examined to determine their impact on the quality and quantity of milled rice and the performance of the machine. The results are summarized as follows: 1. The internal radial pressure in the whitening chamber varied with the surface condition of the grain being processed. During the first or second pass through the machine, pressure was relatively low, reached a maximum after two to three passes with combinations I and II, three to six with combination III and then began to fall. 2. The pitch of the feed screw and the size of the feed gate opening which determine the rate of entry of grain into the whitening chamber, appeared to be the most important factor aff-::cting the degree of radial pressure, quality and quantity of milled rice and the efficiency of the machine. Using a feed screw with a wide pitch (4.8cm), radial pressure was relatively high and head rice recovery ratio \vere quite low. In this case capacity and machine effic?iency were much higher than obtained when using a feed screw with a narrow pitch (2.3cm). Very significant responses in radial pressure, head rice recovery rates and machine capacity were observed with changes in cylinder speed and counter-pressure levels when using the wide pitch feed screw. 3. The characteristics of the screen which surrounds the whitening chamber had an important effect on whitening efficiency. The existence of small protuberances on the original screen resulted in significant increases in both machine capacity and efficiency but without a significant decrease in head rice recovery or development of excessive radial pressure. Further work is required to determine the effects of screen surface conditions and the shape of the cylinderical steel roller on the rate of bran removal, machine efficiency and recovery rates. The size of the slotted perforations 0:1 the screen affects total milled rice recovery. The opening size on the original screen was fabricated to accommodate the round shape of Japonica rice varieties but was not suitable for the more slender Indica type. Milling Indica varieties with this screen resulted in a reduction in total milled rice recovery. 4. An increase in cylinder speed from 380 to 820 rpm produced a positive effect on head rice recovery for all machine combinations at every level of counter-pressure used in the tests. Head rice recovery was considerably lower at 380rpm using a wide screw pitch when compared to the results obtained at speeds from 600 to 820 r.p.m. The effects of cylinder speed On radial pressure, capacity and machine efficiency showed contrasting results, depending on the width of the feed screw pitch. With a narrow feed screw pitch (2.3cm), a direct proportional relationship was observed bet?ween cylinder speed and both radial pressure and machine efficiency. In contrast, using a 4.8 centimeter pitch feed roller produced a series of inverse relationships between the above variables. Based on the results of this study it is recommended when milling Indica type long grain rice varieties that the cylinder speed of the original machine be increased from 500-600 rmp up to a minimum of 800 rpm to obtain a greater abrasive effect between the grain and the screen. The pitch of the feed screw should be also reduced to decr?ease the level of internal radial pressure and to obtain higher machine efficiency and increased quality of milled rice with increased cylinder speeds. Further study on the interaction between cylinder speed and feed screw pitch is recommended. 5. An increase in the counter pressure level produced a negative effect On the head rice recovery with an increase in radial pressure, capacity, and machine efficiency over all combinations and at every level of cylinder speed. 6. Head rice recovery rates were conditioned primarily by the pressure inside the whitening chamber. According to the empirical cha racteristics curve developed in this study, the relationships of head rice recovery ($Y_h$) and machine capacity ($Y_c$/TEX>) to internal radial pressure ($X_p$) followed an inverse quadratic function and a linear function respectively: $$Y_h^\Delta=\frac{1}{{1.4383-0.2951X_p^\ast+0.1425X_p^{\ast\ast}}^2} , (R^2=0.98)$$$$Y_c^\Delta=-305.83+374.37X_p^{\ast\ast}, (R^2=0.88)$$The correlation between capacity and power consumption per unit of brown rice expressed in the following exponential function: $$Y_c^\Delta=1.63Y_c^{-0.7786^\{\ast\ast}, (R^2=0.94)$$These relationships indicate that when radial pressure increases above a certain range (1. 6 to 2.0 kg/$cm^2$ based On the results of the experiment) head ricerecovery decrea?ses in a quadratic relation with a inear increase in capacity but without any decrease in power consump tion per unit of brown rice. On the other hand, if radial pressure is below the range shown above, power consumption increases dramatically with a lin?ear decrease in capacity but without significant increases in head rice recovery. During the operation of a given whitening machine, the optimum radial pressure range or the correct capacity range should be selected by controlling the feed rate and/or counter-pressure keeping in mind the condition of the grain, particulary the hardness. It was observed that the total number of passes is related to radial pessure level, feed rate and counter-pressure level. The higher theradial pressure the fewer num?ber of pass required but with decreased head rice recovery. In particular, when using high feed rates, the total number of passes should be increased to more than three by reducing the counter-pressure level to avoid decreaseases in head rice recovery (less than 65 percent head rice recovery on the basis of brown rice) at every cylinder speed. 7. A rapid rise in grain temperature seemed to have a close relationship with the pressure generated inside the whitening chamber and, subsequently with head rice reco?very rates. The higher the rate of increase, the lower were the resulting head rice recoveries.

• Journal of the Korean Society of Tobacco Science
• /
• v.3 no.2
• /
• pp.129-130
• /
• 1981

The potato tuberworm, Phthorimaea operculella, is an occasional pest to tobacco plants in southern regions of Korea. In order to screen effective pesticides against the worm in tobacco leaves, pot and field experiments were carried out in 1981. In the pot experiment with a tobacco variety, Hicks, several effective organic phosphates (Dimecron- LQ 50, Dursban-WP 25, Ekalux-EC 25. Elsan-EC 47.5, and EPN-EC 45), out of 9 Pesticides tested, were solecte4 from their high mortality of more than 90%. Among these Pesticides Ekalux- EC 25 and Elsan- EC 47.5 were recommended to tobacco growers from their excellent efficacy in the field experiment with a tobacco variety, Burley 21.

• Journal of Power Electronics
• /
• v.7 no.4
• /
• pp.278-285
• /
• 2007

Recently, plasma display panels (PDP) have become the most promising candidate in the market for large screen size flat panel displays. PDPs have many merits such as a fast display response time and wide viewing angle. However, there are still concerns about high cost because they require complex driving circuits composed of high power switching devices to generate various voltage waveforms for three operational modes of reset, scan, and sustain. Conventional PDP driving circuits use path switches for voltage separation and a scan switch to offer a scan voltage for reset and scan operations, respectively. In addition, there exist reset switches to initialize PDPs by regulating the wall charge conditions with ramp shaped pulses, which means the necessity of specific power devices for the reset operation. Because power for the plasma discharge accompanied by a large current is transferred to a panel via path switches, high power rating switches are used for path switches. Therefore, this paper proposes a novel low-cost PDP driving scheme achieved by not only eliminating path switches but also merging the function of reset switches into other switches used for sustain or scan operations. The simulated voltage waveforms of the proposed topology and experimental results implemented in a 42-inch panel to demonstrate the validity of using a new gate driver that merges the functions of power switches are presented.

• Biomedical Science Letters
• /
• v.12 no.4
• /
• pp.405-411
• /
• 2006

Heterotrimeric GTP binding proteins (G proteins) mediate signal transduction generated by neurotransmitter and hormones. Among G-proteins, Go is classified as a member of the Go/Gi family and the most abundant heterotrimeric G protein in brain. Most of the mechanistic analyses on the activation of Go indicated its action to be mediated by the $G{\beta}{\gamma}$ dimer because downstream effectors for its ${\alpha}$ subunit have not been clearly defined. To determine the downstream effectors of alpha subunits of Go ($Go{\alpha}$), we used yeast two-hybrid system to screen $Go{\alpha}$ interacting partners in cDNA library from the human brain. A brain specific high mobility group box containing protein (BHX), A possible transcription factor, was identified as a $Go{\alpha}$ interacting protein. We confirmed interaction between $Go{\alpha}$ and BHX employing in vitro affinity binding assay. Moreover, active form of $Go{\alpha}$ preferentially interacts with BHX than inactive farm. Our findings indicate that $Go{\alpha}$ could modulate gene expression via interaction with BHX during neuronal or brain development.

• Journal of Pharmaceutical Investigation
• /
• v.25 no.4
• /
• pp.307-311
• /
• 1995

Three herbal medicine recipes were tried on the animal model of diet induced hypercholesterolemia to screen for the lipid-lowering effect. The recipes adopted were based on the prescription for atherosclerosis-related symptoms by folk-medicine practioners. Hyperlipidemia was induced in rats by giving the high lipid/cholesterol diet for 7 days. Then, the recipes started with the normal diet. Blood was sampled at 1,2,3 and 5 week-points of the treatment, and levels of total cholesterol, triglyceride, high density lipoprotein and lower density lipoprotein were measured. Dae-shiho-tang decreased total cholesterol level significantly. Hwangryun-haedok-tang and Samhwang-sasim-tang slightly decreased total cholesterol level, although it was not statistically significant.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.8 no.4
• /
• pp.550-554
• /
• 1998

We suggested the new method of thermal screen in Bridgman-Stockbarger method to control the polygrain, the internal cavities and solid-liquid (SL) interface. $CaF_2$ single crystal of 6 inch was grown perfectly when we adopted to use a graphite pipe and a ceramic warmer in the conditions of growth rate 2 mm/hr, vertical temperature of $14^{\circ}C$ for freezing and temperature of $1324^{\circ}C$ at conical tip of crucible. The light scattering phenomena occurred by internal cavities were controlled as decreasing the freezing rate to 2 mm/hr and/or as adopting the rotation of melt (7 rpm).