• Korean Journal of Crystallography
• /
• v.1 no.2
• /
• pp.99-104
• /
• 1990

The hetero-epitaxial growth of AmB v type onto-electronic material is attempted by means of the laser-induced chemical vapour deposition technique. The bimolecular gas phase reaction of trimethylgallium with ammonia on (001) alumina substrate for the epitaxy of gallium nitride is chosen as a model system. In this study, ArF exciter laser (193nm) is employed as a photon source. Marked difference is found in nucleation and in subsequent crystal incorporation between the doposits formed with and without the laser-irradiation. The surface coverage with isomorphically grown drystallites is pronounced upon "volume-excited" irradiation in comparison with the conventional thermal process. As to the crystal structure of the grown layers, the laser-induced deposits of GaN may be represented by either of the following two models: (001) plane of sapphire //y (001) plane of wurtzite-type GaN, OR (001) plane of sapphire//(001) plane of wurtzite-type-GaN (111) plane of twinned zinc blende-type GaN.

• Korean Journal of Crystallography
• /
• v.8 no.1
• /
• pp.33-37
• /
• 1997

The optical properties of (1210) GaN epitaxy films grown on the (1012) $\alpha-A1_2O_3$ substrates have been studied. The hetero-epitaxy films were grown by the halide vapor phase epitaxy (HVPE) method using $Ga/HC1/NH_3/He$ system at $990^{\circ}C$. XRD, RHEED and SEM are used for the identification of the hetero-epitaxy films structure and surface morphology. The confirmed (1210) GaN epitaxy films were characterized by PL and Raman. By the Raman scattering, the active phonon modes of single-phase GaN films are varied with the arrangement of both polarization and propagation directions of laser beam with reference to the axis in single-phase crystal films. The Y(Z, Y & Z) X geometry allows scattering pat-terns of $A_1(TO)=533\;cm^{-1},\;E_1(TO)=559\;cm^{-1}\;and\;E_2=568 cm^{-1}$ modes, whereas in the Z(Y, Y & Z) X geometry the only $E_2$ mode are observed.

• Korean Journal of Materials Research
• /
• v.33 no.12
• /
• pp.525-529
• /
• 2023

β-Ga₂O₃ has become the focus of considerable attention as an ultra-wide bandgap semiconductor following the successful development of bulk single crystals using the melt growth method. Accordingly, homoepitaxy studies, where the interface between the substrate and the epilayer is not problematic, have become mainstream and many results have been published. However, because the cost of homo-substrates is high, research is still mainly at the laboratory level and has not yet been scaled up to commercialization. To overcome this problem, many researchers are trying to grow high quality Ga₂O₃ epilayers on hetero-substrates. We used diluted SiH4 gas to control the doping concentration during the heteroepitaxial growth of β-Ga₂O₃ on c-plane sapphire using metal organic chemical vapor deposition (MOCVD). Despite the high level of defect density inside the grown β-Ga₂O₃ epilayer due to the aggregation of random rotated domains, the carrier concentration could be controlled from 1 × 10¹⁹ to 1 × 10¹⁶ cm^-3 by diluting the SiH4 gas concentration. This study indicates that β-Ga₂O₃ hetero-epitaxy has similar potential to homo-epitaxy and is expected to accelerate the commercialization of β-Ga₂O₃ applications with the advantage of low substrate cost.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.21 no.5
• /
• pp.11-16
• /
• 1984

In this paper, the construction of the Liquid Phase Epitaxy system for fabricating III-V compound semiconductor devices and the method of growing AIGaAs/GaAs Double-Hetero-structure are discussed. The possibility of this Double-Heterostructure for the Light Emitting Diode is confirmed also.

• Journal of Sensor Science and Technology
• /
• v.15 no.3
• /
• pp.216-221
• /
• 2006

ZnO thin films prepared by PLD method exhibit an excellent optical property, but may have some problems such as incomplete surface roughness and crystallinity. In this study, undoped ZnO buffer layers were deposited on (0001) sapphire substrates by ultra high vacuum pulse laser deposition (UHV-PLD) and molecular beam epitaxy (MBE) methods, respectively. After post annealing of ZnO buffer layer, undoped ZnO thin films were deposited under different oxygen pressure ($35{\sim}350$ mtorr) conditions. The Arsenic-doped (1, 3 wt%) ZnO thin layers were deposited on the buffer layer of undoped ZnO by UHV-PLD method. The optical property of the ZnO thin films was analyzed by photoluminescence (PL) measurement. The ${\theta}-2{\theta}$ XRD analysis exhibited a strong (002)-peak, which indicates c-axis preferred orientation. Field emission-scanning electron microscope (FE-SEM) revealed that microstructures of the ZnO thin films were varied by oxygen partial pressure, Arsenic doping concentration, and deposition method of the undoped ZnO buffer layer. The denser and smoother films were obtained when employing MBE-buffer layer under lower oxygen partial pressure. It was also found that higher Arsenic concentration gave the enhanced growing of columnar structure of the ZnO thin films.

• Korean Journal of Materials Research
• /
• v.11 no.7
• /
• pp.615-621
• /
• 2001

We carried out the kinetic model calculations in order to estimate the nucleation rates for two kinds of half-loop dislocations in highly strained hetero-epitaxial growths; $60^{\circ}$dislocations and twinning dislocations. The surface defects and the stress concentration effects were considered in this model, and the remaining elastic strain of the epilayers with increasing film thickness was taken into account by using the modified Matthews' relation. The calculations showed that the stress concentration effect at surface imperfections is very important for describing the defect generation in highly mismatched epitaxial growth. This work also showed that the stress concentration effect determined the type of dislocation nucleating dominantly at early growth stages in accordance with our XTEM (cross-section transmission electron microscopy) defect observation.

• Applied Science and Convergence Technology
• /
• v.26 no.3
• /
• pp.52-54
• /
• 2017

An InGaN/GaN multiple quantum well (MQW) structure is grown on a GaN/sapphire template using a plasma-assisted molecular beam epitaxy (PA-MBE). The fluctuation of the quantum well thickness formed from roughly-grown InGaN layer results in a disordered photoluminescence (PL) spectrum. The surface morphologies of the InGaN layers with various In compositions are investigated by reflection high energy electron diffraction (RHEED) and atomic force microscopy (AFM). A blurred InGaN/GaN hetero-interface and the non-uniform QW size is confirmed by high resolution transmission electron microscopy (HR-TEM). Inhomogeneity of the quantum confinement results in a degradation of the quantum efficiency even though the InGaN layer has a uniform In composition.

• Journal of the Korean Chemical Society
• /
• v.40 no.3
• /
• pp.167-172
• /
• 1996

For the preparation of single-crystalline GaN film, heteroepitaxial growth on a sapphire substrate was carried out by halide vapor phase epitaxy(HVPE) method. The resulting GaN films showed n-type conductivity. The insulator type GaN film was made by doping with Zn(acceptor dopant), which showed emission peaks around 2.64 and 2.43 eV. The result of this study indicates that GaN can be obtained in an epitaxial structure of MIS(metal-insulator-semiconductor) junction. The observed data are regarded as fundamental in developing GaN epitaxial films for light emitting devices of hetero-structure type.

• Journal of the Korean Chemical Society
• /
• v.39 no.1
• /
• pp.1-6
• /
• 1995

The surface of a sapphire substrate used for hetero-epitaxy was chemically polished in a mixture of $H_3PO_4\;and\;H_2SO_4$ solution. The extent of etching for various crystal orientations was found to be dependent on the etching time at $315{\pm}2^{\circ}C$ and at the composition of $H_2SO_4 : H_3PO_4$=3 : 1. In addition, the etching rates of the substrates were investigated in the mixture of $H_2SO_4 : H_3PO_4$=3 : 1 by volume and in the temperature range of 280~320$^{\circ}C$. From the plot of log R against 1/T, the activation penergy ($(E_a)$) was found to be in the order of $({\bar1}012) > (10{\bar1}0) > (11{\bar2}0) > (0001)$ plane. After removing the surface layers of the sapphire with (0001), $({\bar1}012),\;(10{\bar1}0)\;and\;(11{\bar2}0)$ plane by a thickness of 64.6, 46.5, 16.2 and 5.1 ${\mu}m$, respectively, the morphology of the resulting surface was observed by SEM.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1994.11a
• /
• pp.50-53
• /
• 1994

In this study. we report the properties of optically pumped stimulated emission at room temperature (RT) from column-III nitride semiconductors of GaN, GaInN, AlGaN/GaN double hetero-structure (DH) and AlGaN/GaInN DH which grown by low pressure metal-organic vapor phase epitaxy on sapphire substrate using an AIN buffer-layer. The peak wavelength of the stimulated emission at RT from AlGaN/GaN DH is 370nm and the threshold of excitation pumping power density (P$\_$th/) is about 89㎾/$\textrm{cm}^2$, and they from AlGaN/GaInN DH are 403nm and 130㎾/$\textrm{cm}^2$, respectively. The P$\_$th/ of AlGaN/GaN and AlGaN/GaInN DHs are lower than the bulk materials due to optical confinement within the active layers of GaN and GaInN. The optical gain and the polarization of stimulated emission characteristics are presented in this article.