• Journal of Environmental Health Sciences
• /
• v.44 no.1
• /
• pp.63-75
• /
• 2018

Objectives: The aim of this research is to explore the total heavy metals from a coal-fired power plant burning bituminous coal with wood pellets due to the implementation of the Renewable Portfolio Standard policy (RPS, 10% of electricity from renewable energy resources by 2023). Methods: The research was carried out by collecting archival data and using the USEPA's AP-42 & EMEP/EEA compilation of emission factors for use in calculating emissions. The Monte Carlo method was also applied for carrying out the calculations of measurement uncertainty. Results: In this paper, the results are listed as follows. Sb was measured at 110 kg (2015) and calculated as 165 kg (2019) and 201 kg (2023). Cr was measured at 1,597 kg (2015) and calculated as 1,687 kg (2019) and 1,728 kg (2023). Cu was measured at 2,888 kg (2015) and calculated as 3,133 kg (2019) and 3,264 kg (2023). Pb was measured at 2,580 kg (2015) and calculated as 2,831 kg (2019) and 2,969 kg (2023). Mn was measured at 3,011 kg (2015) and calculated as 15,034 kg (2019) and 23,014 kg (2023). Hg was measured at 510 kg (2015) and calculated as 513 kg (2019) and 537 kg (2023). Ni was measured at 1,720 kg (2015) and calculated as 1,895 kg (2019) and 1,991 kg (2023). Zn was measured at 7,054 kg (2015) and calculated as 9,938 kg (2019) and 11,778 kg (2023). Se was measured at 7,988 kg (2015) and calculated as 7,663 kg (2019) and 7,351 kg (2023). Conclusion: This shows that most heavy metals would increase steadily from 2015 to 2023. However, Se would decrease by 7.9%. This analysis was conducted with EMEP/EEA's emission factors due to the limited emission factors in South Korea. Co-firewood pellets in coal-fired power plants cause the emission of heavy metals. For this reason, emission factors at air pollution control facilities would be presented and the replacement of wood pellets would be needed.

• Korean Journal of Food Science and Technology
• /
• v.32 no.6
• /
• pp.1442-1445
• /
• 2000

This study was carried out to investigate the contents of minerals and heavy metals in the sea salts of Korean products and imported products. NaCl was major component, which ranged from $80.31{\sim}89.84%$ for Korean products and from $91.59{\sim}97.66%$ for imported products. Minerals and heavy metals of Korean products and imported products were analyzed with ICP-AES and AAS, respectively. Mineral contents of K and Mg in Korean products were relatively higher than those in imported ones, but no significant differences were found for heavy metals between them.

• Journal of Environmental Health Sciences
• /
• v.42 no.6
• /
• pp.450-464
• /
• 2016

Objectives: This study developed and validated reference materials (RMs) to analyze metal compounds in blood. Methods: We referred to KoNEHS (Korea National Environmental Health Survey) to estimate concentrations of blood metals (cadmium, Cd; lead, Pb; mercury, Hg) and applied analytical methods (inductively coupled plasma - mass spectroscopy, ICP-MS, for Cd and Pb; graphite furnace - atomic absorption spectrometry, GF-AAS, for Cd and Pb; and direct mercury analyzer, DMA, for Hg). Homogeneity and stability tests were carried out. In addition, certified values and uncertainties of RMs were calculated through internal and external experiments. All RMs were developed and assessed in various forms according to element, analytical method, and two types of concentration levels high concentration for occupational exposure and low concentration for environmental exposure. Results: All samples showed acceptable homogeneity, except for low concentration of Cd in the GF-AAS method. Short- and long-term stabilities were satisfied by ANOVA testing. In the inter-laboratory comparison, robust medians were lower than the certified values of all RMs (robust median/reference value; $1.301/1.327{\mu}g/L$ for Cd, ICP-MS, low concentration; $3.152/3.388{\mu}g/L$ for Cd, ICP-MS, high concentration; $1.219/1.301{\mu}g/L$ for Cd, GF-AAS, low concentration; $3.074/3.321{\mu}g/L$ for Cd, GF-AAS, high concentration; $14.473/14.516{\mu}g/L$ for Pb, ICP-MS, low concentration; $50.069/50.114{\mu}g/L$ for Pb, ICP-MS, high concentration; $12.881/14.147{\mu}g/L$ for Pb, GF-AAS, low concentration; $47.015/47.591{\mu}g/L$ for Pb, GF-AAS, high concentration; $4.059/4.218{\mu}g/L$ for Hg, DMA, low concentration; $11.474/11.181{\mu}g/L$ for Hg, DMA, high concentration). Conclusion: This study demonstrates procedures for developing and validating RMs for biomonitoring in the field of the environmental health.

• Korean Journal of Environmental Agriculture
• /
• v.34 no.4
• /
• pp.282-287
• /
• 2015

BACKGROUND: The current study was carried out to investigate Cd, Hg, Pb and As contaminations in 222 commercial medicinal plants and to estimate the potential health risk through dietary intake of commercial medicinal plants in Korea.METHODS AND RESULTS: The Cd, Hg, Pb, and As in medicinal plants were analyzed by ICP/MS and mercury analyzer.The potential health risk was estimated using risk assessment tools. Total amount of Cd in medicinal plants with 29% samples exceeded the standard limit legislated in 'Pharmaceutical Affairs Act' while all plant samples were lower than the standard limit value for As, Hg, and Pb. However, when applying the standard limit for root vegetable (fresh weight) in the Food Sanitation Act, four samples exceeded the standard limit of Pb. For health risk assessment, the values of cancer risk probability were 0.3~5.9×10^-7which were less than the acceptable cancer risk of 10^-6~10^-4for regulatory purpose. Also, Hazard quotientvalues were lower than 1.0.CONCLUSION: Therefore, these results demonstrated that human exposure to Cd, Hg, Pb, and As through dietary intake of commercial medicinal plants might notcause adverse health effects although some medicinal plants were higher than the standard limit values for Cd and Pb.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.20 no.6
• /
• pp.1983-1993
• /
• 1996

For selected (pure and compound) metallic species effects of saturation ratio, temperature, particle size and number density on condensation mechanisms are first reviewed. The tendencies for vaporization and condensation differ between metallic species because of the significant differences in their saturation pressures. Then particle pressure of a metal vapor species at incineration temperature is calculated by simplifying waste as a compound of methane, chlorine and small amounts of metals and assuming a thermodynamic equilibrium state. Next the condition is assessed for which supersaturation of combustion gases by the species above the critical level for homogeneous condensation may occur, when the gases contain a large number of pre-existing particles such as entrained ashes. Regardless of the presence of chlorine in the waste, the homogeneous condensation of PbO vapors may occur, depending on number density of the pre-existing particles. However, when chlorine exists in the waste, the homogeneous condensation of PbCl$_2$vapors does not occur, which is similar to the case of Cd and Hg vapors. Thus these highly volatile species, PbCl$_2$, Cd, and Hg, may emit to atmosphere as vapor phase. In general, for reducing the emission of hazardous metallic species into the atmosphere, the number density of pre-existing particles has to be increased. For fixed particle number density, the temperature drop rate must be kept in low if the temperature at which a condensable vapor species emits from a incineration system is fixed, while the temperature drop rate must be kept in high if the residence time for which a condensable species stays in the system is fixed.

• Journal of Food Hygiene and Safety
• /
• v.35 no.2
• /
• pp.162-169
• /
• 2020

This study was conducted to survey levels of heavy metals, benzopyrene and mycotoxins in teas purchased from online markets, supermarkets, and traditional markets in Gwangju, Korea. We examined the arsenic, cadmium and lead content in heavy metals. We also tested for benzo(a)pyrene, which is classified as a carcinogen. In addition, we tested for the mycotoxins aflatoxin (AFB₁, AFB₂, AFG₁, AFG₂), ochratoxin A (OTA), fumonisin (FUB₁, FUB₂), and zearalenone (ZON). According to our results, heavy metals were detected within the allowable range (below 5.0 mg/kg for lead) and all samples met with the standards for tea as presented in the Korean Food Code. The Benzo(a)pyrene showed a detection rate of 12.8% in 16 of 125 samples and mycotoxins showed 23.2% in 29 of 125 samples. However, safe levels regarding benzo(a)pyrene and mycotoxin in tea were not ascertainable since the standards are not set in the Korean Food Code.

• Journal of the Mineralogical Society of Korea
• /
• v.19 no.4 s.50
• /
• pp.259-264
• /
• 2006

This work carried out to analyze the physicochemical properties and investigate the assessment of heavy metal contamination of stream sediments of the Yudeung and the Gab streams in the Daejeon area. The pH of stream sediments of the Yudeung stream shows the range of weak acid and weak alkaline. Most of stream sediments contain about 80% sand grain and have low water and cation retention capacity. Hence the stream sediments are not suitable fur various plans to grow up. The analysis of heavy metals in the stream sediments shows that the concentration of Pb, Cr and Cd increases from upstream to down stream. It is likely that the trend has a relationship with the water. Contamination of stream water. The authors recommend that clay materials be replenished in the stream sediments to increase the self-purification capacity and to make the suitable condition for growing up of various plants, and that water quality of the stream which can Influence into the contamination of stream sediments be monitored.

• Economic and Environmental Geology
• /
• v.40 no.5
• /
• pp.575-585
• /
• 2007

Microbial control of the geochemical behavior of heavy metals (Cd, Cu, Pb, and Zn) and As in contaminated subsurface soil and sediment was investigated through activation of indigenous bacteria with lactate under anaerobic condition for 25 days. The results indicated that dissolved Cd, Pb and Zn were microbially removed from solutions, which was likely due to the formation of metal sulfides after reduction of sulfate by indigenous sulfate-reducing bacteria. Soils from the Dukeum mine containing a large amount of sulfate resulted in complete removal of dissolved As after 25 days by microbial activities, while there were gradual increases in dissolved As concentration in soils from the Hwabuk mine and sediments from the Dongducheon industrial area which showed low $SO_4{^2-}$ concentrations. Addition of appropriate carbon sources and sulfate to contaminated geological media may lead to activation of indigenous bacteria and thus in situ stabilization of the heavy metals; however, potential of As release into solution after the amendment should be preferentially investigated.

• Polymer(Korea)
• /
• v.30 no.6
• /
• pp.525-531
• /
• 2006

In this study, Sulfonated PONF-g-styrene ion exchange fibers were synthesized by radiation induced graft copolymerization. And also, hybride ion exchange fibers, which was combined sulfonated PONF-g-styrene fibers and cationic ion exchange resin, were fabricated by hot melt adhesion method and then their adsorption properties were investigated. ion exchange capacity and water content of hybrid ion exchange fibers increased as compared with those of bead and ion exchange fiber. Their maximum values were 4.76 meq/g and 23.5%, respectively. Adsorption breakthrough time for mercury of hybrid ion exchange fiber was slower than those of bead resin and fibrous ion exchanger. It's value was 130 minutes. Their breakthrough time become short as increasing of pH, and concentration. The initial breakthrough time was observed before and after 10 minutes as increasing of concentration. The adsorption of hybrid ion exchange fibers for $Hg^{2+}\;Pb^{2+},\;Cd^{2+}$ among heavy metals in the mixed solution was observed before 20 min. And also, The adsorption for $Hg^{2+}$ among the heavy metals by hybride ion exchange fibers was observed.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.21 no.2
• /
• pp.201-206
• /
• 1992

Pinus pollen is used as the chief ingredient for Song-wha-dashik (Korea's traditional pattern-pressed candy). It has been the food stuff indispensable especially on the occasion of performing ancestral rites and holding a banquet since Shilla and Koryo Dynasty. In this paper, therefore, a new examination is made of the nutritive ingredients of the very Pinus pollen. Analysis has been made of the proximate composition, minerals, heavy metals, vitamins and free sugars of the Pollen of both Pinus densinora Siebol et Zuccarini and Pinus rigida Miller. In the proximate composition, Pinus rigida Miller is high except in free sugar ; crude ash (4.0%), crude protein (15.0%), crude fat (2.5%), crude fiber (17.5%). A lot of minerals have been found in both the samples. They contain Mg, Cl, Ca, Fe, Mn, Na, Zn, etc. In heavy metals, both the samples contain the same quantity of Cd(0.3 ppm) and the contents of Pb, Cu, and As are lower than the maximal limit permitted for food stuff. The contents of vitamin B$_1$, B$_2$, vitamin C are a little higher in Pinus rigida Miller : in vitamin E, on the contrary, Pinus densiflora Siebol et Zucarini (1.6 mg) doubles Pinus rigida Miller (0.8 mg). In free sugars, the results is as follows : 6.6%/6.9% in sucrose : 0.2% in fructose : 2.1% /2.9% in glucose respectively.