• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.7
• /
• pp.1214-1221
• /
• 2006

Header compression scheme is suggested as a solution to reduce the inefficient overhead of general packet stream data. Especially, it is shown that there are more overhead rate for real-time media stream links such as voice because of its short payload size, and it is possible to get higher bandwidth efficiency using the header compression scheme. There are two kinds of error recovery in header compression such as Periodic Header Refresh(PHR) and Header Request(HR) schemes. In this paper, we analyze the performance of these two compression recovery schemes, and some results such as the overhead rate, bandwidth gain and bandwidth efficiency(BE) are presented.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.18 no.1
• /
• pp.55-65
• /
• 2006

The air and water flow distribution are experimentally studied for a round header - flat tube geometry simulating a parallel flow heat exchanger. The number of branch flat tube is thirty. The effects of tube outlet direction, tube protrusion depth as well as mass flux, and quality are investigated. The flow at the header inlet is identified as annular. For the downward flow configuration, the water flow distribution is significantly affected by the tube protrusion depth. For flush-mounted configuration, most of the water flows through frontal part of the header. As the protrusion depth increases, more water is forced to the rear part of the header. The effect of mass flux or quality is qualitatively the same as that of the protrusion depth. Increase of the mass flux or quality forces the water to rear part of the header. For the upward flow configuration, however, most of the water flows through rear part of the header. The protrusion depth, mass flux, or quality does not significantly alter the flow pattern. Possible explanations are provided based on the flow visualization results. Negligible difference on the water flow distribution was observed between the parallel and the reverse flow configuration.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.18 no.6
• /
• pp.39-44
• /
• 2019

The evaporator is a key driver of an air conditioning system's efficiency. In this study, we study methods of maximizing the efficiency of a Massey Ferguson (MF) evaporator by measuring how the cooling performance of different shapes vary with temperature. We varied the tube insertion depth as well as the shape of the evaporator's header and tube. When we compare header shapes of "D", "Ellipse", and "Quadrangle" types, we find that the elliptical header creates the smallest pressure loss and the highest temperature difference. Between tube shapes of "Rectangular", "Projection", and "Circular" types, the "Projection" type tube creates the most temperature difference. We also investigated the depth of tube insertion in the header and find that tube insertion of 5 - 10 mm is feasible; we selected the depths of 5, 7, and 10 mm since they corresponded to approximately 30%, 50%, and 70% of the total width of the header. The tube insertion test demonstrated that a tube insertion depth of 7 mm creates the least pressure loss and the highest temperature difference. In conclusion, the optimal evaporator design uses an "Ellipse" type header, "Projection" type tube, and a tube insertion depth between 30 and 50% of the header width.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.6
• /
• pp.1076-1085
• /
• 2004

Recently, the demands for real-time service and multimedia data are rapidly increasing. There are significant redundancies between header fields both within the same packet header and in consecutive packets belonging to the same packet stream. And there are many overheads in using the current UDP/IP protocol. Header compression is considered to enhance the transmission efficiency for the payload of small size. By sending the static field information only once initially and by utilizing dependencies and predictability for other fields, the header size can be significantly reduced for most packets. This work describes an implementation for header compression of the headers of IP/UDP protocols to reduce the overhead on Ethernet network. Typical UDP/IP Header packets can be compressed down to 7 bytes and the header compression system is designed and implemented in Linux environment. Using the Header compression system designed between a server and clients provides have the advantage of effective data throughput in network. Since the minimum packet size in Ethernet is 64 bytes, the amount of reduction by header compression in practical chatting environment was 6.6 bytes.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.20 no.3
• /
• pp.175-180
• /
• 2008

Flow quantity to supply to a coil in floor heating system is important to achieve comfortable indoor air condition in the winter season. The hot water header is used to distribute the water into the coil. Experimental study has been performed using the water header that have 5 branches consisted of flow control valves and automatic shut-off valves. Each branch line connected it with X-L pipe. Experimental tests accomplished it to investigate the flow distribution characteristics of the hot water header. Experimental results show that the selection of the pump head and differential pressure are very important to save running energy of the system, and high differential pressure needs more friction loss in the case of suitable differential pressure for balancing of the header.

• Journal of the Optical Society of Korea
• /
• v.20 no.3
• /
• pp.335-342
• /
• 2016

We demonstrate an optical asynchronous transfer mode/wavelength division multiplexing (OATM/WDM) optical access network, using a router based on an optical header decoder to conduct next-generation communications. The router consists of a decoder or hardware analysis processing of the header bit and switches. The router in the OATM/WDM optical access network is a key technology by which to satisfy subscribers’ requests, including reliability, cost efficiency, high speed, large-capacity transmission, and elevated information security. In this study, we carry out experiments in which a header decoder delivers to 16 and 32 subscribers with a single wavelength in the router. These experiments confirm the decoder’s successful operation via hardware using 4 and 5 header bits. We propose that this system may significantly contribute toward the realization of an optical access network that provides high-quality service to subscribers of next-generation communications.

• Journal of Sensor Science and Technology
• /
• v.19 no.5
• /
• pp.369-374
• /
• 2010

It is important to efficiently elect the cluster header in Hierarchical Sensor Network, because it largely affects on the lifetime of the network. Therefore, recent research is focused on the lifetime extension of the whole network for efficient cluster header election. In this paper, we propose the new Cluster Header Election Scheme in which the cluster is divided into Group considering Distance from Upper Node, and a cluster header will be elected by node density of the Group. Also, we evaluate the performance of this scheme, and show that this proposed scheme improves network lifetime in Zigbee environment.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.05a
• /
• pp.704-711
• /
• 2003

Recently, the demands for real-time service and multimedia data are rapidly increasing. There are significant redundancies between header fields both within the same packet header and in consecutive packets belonging to the same packet stream. But there are many overheads in using the current UDP/IP protocol. Header compression is considered to enhance the transmission efficiency for small size of payload. By sending the static field information only once initially and by utilizing dependencies and predictability for other fields, the header size can be significantly reduced for most packets. This work describes an implementation for header compression of the headers of U/UDP protocols to reduce overhead on Ethernet network. Typical UDP/IP Header packets can be compressed down to 7 bytes and the header compression system is designed and implemented on the Linux environment. Using the designed Header compression system between a server and a client have the advantage of effective data throughput in network.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.6
• /
• pp.1173-1178
• /
• 2012

In the Cluster-Based Routing Protocol (CBRP) a cluster header in each cluster should be elected. The cluster headers consume energy much more than other nodes because they manage and operate all of mobile nodes in their cluster. The traditional CBRP elects a cluster header without considering the remaining electric energy of each node. So, there exists problems that the cluster header has short average lifetime, and another cluster header should be elected again frequently. In this paper, we propose the improved protocol which prolongs the lifetime of the cluster header and enhances the stability of the path. In order to achieve this, when a cluster header is elected in a cluster, the remaining electric energies of all the nodes are compared with one another, and the node with the highest energy is elected as the cluster header.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.1
• /
• pp.69-76
• /
• 2010

We describe an all-optical circuit which recognizes the header information of packet-by-packet in the access networks based on FTTH. The circuit's operation is confirmed by an experiment in the recognition of 3 and 4 header bits. The output from the header recognition circuit appears in a signal assigned in the time axis according to the header information. The recognition circuit of header for self-routing has a very simple structure using only delay lines and switches. The circuit is expected that it can be constructed of the high reliability and the low cost. Also, the circuit can solve the problems of the power loss and private security which is the weak point of the TDM-PON method by being established a unique transmission line to each subscriber.