• 상하수도학회지
• /
• 제22권4호
• /
• pp.461-466
• /
• 2008

Because of their simplicity, efficiency, and economy, slow sand filters are appropriate means of water treatment for small water systems. In this study, the effect of filtration velocity and dirty skin (Schmutzdecke) was evaluated on the performance of turbidity removal. Also, removal characteristics of particulate were investigated in the case of the usage of non-woven fabric on the surface of sand and the application of PCF as pretreatment process. Comparative column tests were carried out for the various operation condition. From the result of column tests, filtration velocity had little effect on the turbidity removal rate. The formation of algal biofilm on the surface of media is helpful in turbidity removal, while non-woven fabric is not as effective as expected. The relative contribution of biomass and accumulated particulates to head loss development in slow sand filters requires further study.

• 한국자동차공학회논문집
• /
• 제4권3호
• /
• pp.22-30
• /
• 1996

In-cylinder flow of a purpose-built small HSDI Hydra Diesel engine was investigated by laser Doppler velocimetry(LDV) during induction and compression processes. The flow was quantified in terms of ensemble-averaged axial and swirl velocities, normalized by the mean piston speed, at a plane located 12mm from the cylinder head and corresponding to the mid-plane of the diametrically-opposed quartz windows at an enigne speed of 1000rpm. The formation of toroidal vortices during the intake process and the evolution and decay of swirl motion during the compression process were observed. Turbulence at around TDC of compression became homogeneous and isotropic.

• 천문학회지
• /
• 제34권4호
• /
• pp.341-343
• /
• 2001

Here were continue the MHD study started by Santillan et al (1999) for the interaction of high-velocity clouds (HVCs) with the magnetized thick gaseous disk of our Galaxy. We use the MHD code ZEUS-3D and perform 3D-numerical simulations of this interaction, and study the formation of head-tail structures in HVCs. Our results show that clouds located above 2 kpc from mindplane present velocity and column density gradients with a cometary structure that is similar to those observed in 21 cm emission

• 아동학회지
• /
• 제13권1호
• /
• pp.125-138
• /
• 1992

The purpose of the present study was to examine the development of embedding through relative clause formation in the first language acquisition of Korean. Results are reported from the study of the spantaneous natural speech of 36 young Korean children ranging from 16 months to 45 months in age acquiring Korean as their first language in Chinju, Korea. The results revealed a developmental order in the first language acquisition of Korean relative clause structures. Namely, a free or headless relative clause appears to be acquired first, before lexically headed restrictive relative construction. This order is consistent with one evidenced in English (and also Chinese) first language acquisition, 'free' relatives appear to provide a developmentally early stage in the acquisition of restrictive relative clauses. The Korean data provided additional evidence for an intermediary stage with an overt complementizer as well as an overt lexical head. Implications for the results are disscused with regard to a continuous theory of universal grammar in the first language acquisition.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2009년도 춘계학술발표대회
• /
• pp.13.2-13.2
• /
• 2009

Electrostatic printing either it is drop-on-demand or continuous has immense applications in non-contact printing systems such as solar cells, flexible printed circuits, RFIDs and bio applications. In this paper a laboratory manufactured nozzle has been designed for the experimental investigation of electrostatic dripping and atomization of liquid. Dripping and atomization conditions such as voltage, nozzle tip diameter, distance between counter electrode and flowrate has been indentified for the designed nozzle. Furthermore it is also demonstrated that the diameter of a generated droplet could be reduced from a significantly large size to a narrow size distribution which can be controlled by volumetric flow rate and applied voltage. This study will help in classify the conditions between different electrostatic dripping mode such as drop-on-demand formation, jet mode and finally the atomization mode based on the laboratory fabricated nozzle head.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2002년도 봄 학술발표회 논문집
• /
• pp.165-172
• /
• 2002

We presents an hazard zonation mapping technique in karst terrain and its assessment. From the detailed engineering geological mapping. Controlling factors of sink hole and limestone cave formation were discussed and 4 main hazard factors affecting hazard potential are identified as follows: prerequisite hazard factor(distributions of pre-existing sink holes and cavities), geomorphological hazard factors(slope gradient, vegetation, and drainage pattern etc.) geological hazard factors(lithology, fracture patterns and geological structures etc.) and hydraulic conditions(hydraulic head, annual fluctuation of ground water table and composition of g/w water). From the construction of hazard zonation map along the Jecheon-Maepo area, and vertical cross-sectional hazard zonations specific tunnel site we suggest hazard zonation rating systems.

• 전기학회논문지
• /
• 제58권10호
• /
• pp.1881-1887
• /
• 2009

This paper discusses the effects of ECC (Earth Continuity Conductor) for reducing the level of induced sheath overvoltages at the single point bonded section of combined transmission lines which are mixed underground power cable with overhead line in one T/L. In previous papers, the characteristics of ECC on only underground power cable systems were sufficiently analyzed. However, the result of only underground power cable systems are totally different from that of combined transmission lines because ECC is commonly grounded with overhead grounding wire at mesh of cable head. Therefore, in this paper, the installation effects of ECC have been variously analyzed considering the three kinds of fault positions, cable formation of duct and trefoil, spacing between phase conductor and ECC, and the change of overhead transmission line section length on 154kV combined transmission line. Finally, simulation results show that ECC can effectively reduce the induced sheath voltage.

• Hip & pelvis
• /
• 제30권4호
• /
• pp.276-281
• /
• 2018

Pseudotumors are not uncommon complications after total hip arthroplasty (THA) and may occur due to differences in bearing surfaces of the head and the liner ranging from soft to hard articulation. The most common causes of pseudotumors are foreign-body reaction, hypersensitivity and wear debris. The spectrum of pseudotumor presentation following THA varies greatly-from completely asymptomatic to clear implant failure. We report a case of pseudo-tumor formation with acetabular cup aseptic loosening after revision ceramic-on-metal hip arthroplasty. The patient described herein underwent pseudotumor excision and re-revision complex arthroplasty using a trabecular metal shell and buttress with ceramic-on-polyethylene THA. Surgeons should be aware of the possibility of a pseudotumor when dealing with revisions to help prevent rapid progression of cup loosening and implant failure, and should intervene early to avoid complex arthroplasty procedures.

• 전자통신동향분석
• /
• 제34권3호
• /
• pp.55-64
• /
• 2019

In drone-assisted wireless sensor networks, drones collect data from sensors in an energy-efficient manner and quickly distribute urgent information to sensor nodes. This article introduces recent communication and security schemes for drone-assisted wireless sensor networks. For the communication schemes, we introduce data collection optimization schemes, drone position and movement optimization schemes, and drone flight path optimization schemes. For the security schemes, we introduce authentication and key management schemes, cluster formation schemes, and cluster head election schemes. Then, we present some enhancement methodologies for these communication and security schemes. As a conclusion, we present some interesting future work items.

• 한국미생물생명공학회:학술대회논문집
• /
• 한국미생물생명공학회 1986년도 추계학술대회
• /
• pp.509.2-509
• /
• 1986

Owing to the growing interest in the production of fuels and chemicals from biomass the well-know butanol-acetone fermentation as carried out by Clostridium acetobutylicum has been intensely studied again in recent years. Several solvent-yielding fermentation processes were established which are operated by using batch cultures or continuous cultures. 1 could be shown that under conditions of phosphate limitation an asporogenous mutant of C. acetobutylicum establishes itself in a chemostat which produces the solvents continuously. Attempts have been made to change the butanol/acetone ratio in favor of butanol production. A corresponding shift of the product spectrum can be achieved by carbon monoxide addition to the head space of the fermentation (B.H. Kim et al., App. Envioron. Microbiol. 48, 764-770 1984) or by iron limitation. Progress has been made in understanding the mechanism underlying the shift from acid to solvent prodcction. Experimental results are in agreement with the view that intracellular accumulation of acetic and butyric acid results in a shortage of phosphate and coenzyme A. This shortage may serve then as signal for the synthesis of the enzymes involved in the formation of acetone and butanol.