• 한국지하수토양환경학회지:지하수토양환경
• /
• 제21권6호
• /
• pp.114-127
• /
• 2016

An increase of groundwater flux in BHE system creates that ground temperature (locT) becomes lower in summer and higher in winter time. In other words, it improves significantly the performance of BHE system. The size of thermal plume made up by advection driven-flow under the balanced energy load is relatively small in contrast to the unbalanced energy load where groundwater flow causes considerable change in the size of thermal plume as well ground temperature. The ground temperatures of the up gradient and down gradient BHEs under conduction only heat transport are same due to no groundwater flow. But a significant difference of the ground temperature is observed between the down gradient and up gradient BHE as a result of groundwater flow-driven thermal interference took placed in BHE field. As many BHEs are designed under the obscure assumption of negligible groundwater flow, failure to account for advection can cause inefficiencies in system design and operation. Therefore including groundwater flow in the design procedure is considered to be essential for thermal and economic sustain ability of the BHE system.

• 설비공학논문집
• /
• 제26권9호
• /
• pp.409-415
• /
• 2014

Ground-source heat pump (GSHP) systems have become an efficient alternative to conventional cooling and heating methods due to their higher energy efficiency. These systems use the ground as a heat source and the heat sink for cooling mode operation. The purpose of this simulation study is to evaluate the performance of a hypothetical GSHP system in an office building and to assess the energy saving effect against the existing HVAC systems (boiler and turbo chiller). We collected monthly energy consumption data from an actual office building ($32,488m^2$) in Seoul, and created a model to calculate the hourly building loads with EnergyPlus. In addition, we used GLD (Ground Loop Design) V8.0, a GSHP system design and simulation software tool, to evaluate hourly and monthly performance of the GSHP system. The energy consumption for the GSHP system based on the hourly simulation results were estimated to be 582.6 MWh/year for cooling and 593.2 MWh/year for heating, while those for the existing HVAC systems were found to be 674.5 MWh/year and 2,496.4 MWh/year, respectively. The seasonal performance factor (SPF) of the GSHP system was also calculated to be in the range of 3.37~4.28.

• 한국전자파학회논문지
• /
• 제17권8호
• /
• pp.725-731
• /
• 2006

Feedforward와 defected ground structure(DGS)를 이용한 새로운 주파수 체배기를 제안하였다. 제한된 주파수 체배기는 feedforward 구조에 의해 기본 주파수$(f_0)$가 제거되고, 아령 또는 나선형 모양의 DGS 구조에 의해 2차, 3차 또는 4차의 원하지 않는 고조파 성분들을 제거할 수 있었다. 결국 feedforward와 DGS 구조에 의해서 체배하고자 하는 성분을 제외한 나머지 고조파들이 제거되었다. 기본 주파수를 1 GHz로 하여 주파수 체배기를 설계하고, 측정하였다. 입력 전력을 0dBm으로 하였을 때 2체배기, 3체배기와 4체배기의 출력 전력은 각각 -2.59 dBm, -5.36 dBm과 -4.57 dBm이었다.

• 한국항공우주학회지
• /
• 제49권6호
• /
• pp.497-504
• /
• 2021

본 논문에서는 항공기가 편대 비행 중에 발생되는 수신잡음에 대한 개선 방안을 연구하였다. 항공기의 통신 장비는 내/외부통신의 기능을 담당하기에 비행 임무 수행과 안전에 있어서 매우 중요하기 때문에 잡음이 없고 깨끗한 통신 품질과 송/수신 기능이 구현이 요구된다. 따라서 수신잡음 현상에 대해서 FTA 분석 및 고장탐구를 수행하였고, 수신잡음에 영향을 주는 인터컴의 내부 잡음 및 송신 끊김 현상이 식별되었다. 인터컴의 다중 접지를 단일 접지로 변경하고 DC Offset 전압을 필터링하는 개선된 방안을 적용하였다. 이를 통해 편대 비행 시 수신잡음 저감을 통하여 항공기 통신 시스템의 품질을 향상시켰으며, 지상 및 비행 시험의 결과로도 확인하였다.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제12권4호
• /
• pp.1458-1470
• /
• 2018

In this letter, a new dual-port Multiple-Input Multiple-Output (MIMO) antenna is introduced which has two independent signal feeding ports in a single antenna element to achieve smaller antenna volumes for the 5G mobile applications. The dual-port structure is implemented by adding a cross coupled semi-loop (CCSL) antenna as the secondary radiator to the ground short of inverted-F antenna (IFA). It is found that the port to port isolation is not deteriorated when an IFA and CCSL is combined to form a dual-port structure. The isolation property of the proposed antenna is compared with a polarization diversity based dual-port antenna proposed in the literature [9]. The operating frequency range is 3.3-4.0 GHz which is suitable for places where $4{\times}4$ MIMO systems are supposed to be deployed such as in China, EU, Korea and Japan at the band ${\times}$ (3.3 - 3.8GHz. The measured 6-dB impedance bandwidths of the proposed antennas are larger than 700 MHz with isolation between the feeding ports higher than 18 dB [1-2]. The simulation and measurement results show that the proposed antenna concept is a very promising alternative for 5G mobile applications.

• 한국우주과학회:학술대회논문집(한국우주과학회보)
• /
• 한국우주과학회 2008년도 한국우주과학회보 제17권2호
• /
• pp.35.3-36
• /
• 2008

The ground-based spacecraft simulator is a useful tool to realize various space missions and satellite formation flying in the future. Also, the spacecraft simulator can be used to develop and verify new control laws required by modern spacecraft applications. In this research, therefore, Hardware-in-the-loop (HIL) simulator which can be demonstrated the experimental validation of the theoretical results is designed and developed. The main components of the HIL simulator which we focused on are the thruster system to attitude control and automatic mass-balancing for elimination of gravity torques. To control the attitude of the spacecraft simulator, 8 thrusters which using the cold gas (N2) are aligned with roll, pitch and yaw axis. Also Linear actuators are applied to the HIL simulator for automatic mass balancing system to compensate for the center of mass offset from the center of rotation. Addition to the thruster control system and Linear actuators, the HIL simulator for spacecraft attitude control includes an embedded computer (Onboard PC) for simulator system control, Host PC for simulator health monitoring, command and post analysis, wireless adapter for wireless network, rate gyro sensor to measure 3-axis attitude of the simulator, inclinometer to measure horizontality and battery sets to independently supply power only for the simulator. Finally, we present some experimental results from the application of the controller on the spacecraft simulator.

• Journal of Astronomy and Space Sciences
• /
• 제27권4호
• /
• pp.377-382
• /
• 2010

In lunar explorer development program, computer simulator is necessary to provide virtual environments that vehicle confronts in lunar transfer, orbit, and landing missions, and to analyze dynamic behavior of the spacecraft under these environments. Objective of simulation differs depending on its application in spacecraft development cycle. Scope of use cases considered in this paper includes simulation of software based, processor and/or hardware in the loop, and support of ground-based flight test of developed vehicle. These use cases represent early phase in development cycle but reusability of modeling results in the next design phase is considered in defining requirements. A simulator architecture in which simulator platform is located in the middle and modules for modeling, analyzing, and three dimensional visualizing are connected to that platform is suggested. Baseline concepts and requirements for simulator development are described. Result of trade study for selecting simulation platform and approaches of defining other simulator components are summarized. Finally, characters of lunar elevation map data which is necessary for lunar terrain generation is described.

• 설비공학논문집
• /
• 제30권4호
• /
• pp.186-194
• /
• 2018

A ground-source heat pump system (GSHP) is more energy efficient than other heat-source systems because it uses annual constant underground and water temperatures. Especially, two-well geothermal systems using groundwater as the heat source can achieve higher performance than closed-loop geothermal systems. However, performance of two-well geothermal systems is decreased by occurring overflow according to scale during long-term operations. Therefore, this study presents a two-well pairing geothermal system that controls the groundwater level of a diffusion well. In addition, a two-well pairing geothermal system and an SCW geothermal system were installed, and a comparative analysis of cooling performance depending on system operation under the same load conditions was conducted. The result was that the average heat pump coefficient of performance (COP) of the two-well pairing system was 6.5, and the entire system COP was 4.3.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2007년도 Proceedings of ISRS 2007
• /
• pp.442-444
• /
• 2007

How to observe the atmosphere is a subject of atmospheric research. The meteorological satellites and the ground states are used to do observation. However, both ways do not satisfy the requirement of scientists, especially the profiles of atmosphere on the ocean and the data for global atmosphere. Radio occultation (RO) technique, which has been used in planet science, is a method to solve the problem. In RO technique, the low Earth orbit (LEO) satellite receives the two frequency signal of Global Positioning System (GPS) satellite. The excess phase of the signal is calculated to retrieve the profiles of atmosphere parameters. In moist troposphere, the fluctuations appear in the phase of the signal and open loop (OL) is used to resolve it. The quality of the GPS signal generally deteriorates as the altitude decreases. In the procedure, the SNR of the GPS signal is used as the criterion. However, the SNR decreases with fluctuation which makes it difficult to locate the data of poor quality. In this paper, the phase of the signal will be used as part of the criterion.

• 전력전자학회논문지
• /
• 제26권2호
• /
• pp.150-157
• /
• 2021

Nowadays, a DC microgrid that can link various distributed power sources is gaining much attention. Accordingly, research on fault situations, such as line-to-line and line-to-ground faults of the DC microgrid, has been conducted to improve grid reliability. However, the blackout of an AC system and the oscillation of a DC bus voltage have not been reported or have not been sufficiently verified by previous research. In this study, a 20 kW DC microgrid testbed using a power HIL simulation technique is proposed. This testbed can simulate various fault conditions without any additional grid facilities and dangerous experiments. It includes the blackout of the DC microgrid caused by the AC utility grid's blackout, a drastic load increment, and the DC bus voltage oscillation caused by the LCL filter of the voltage source converter. The effectiveness of the proposed testbed is verified by using Opal-RT's OP5707 real-time simulator with a 3 kW prototype three-port dual-active-bridge converter.