• 한국태양에너지학회 논문집
• /
• 제31권4호
• /
• pp.80-86
• /
• 2011

Investigation of the effective soil thermal conductivity(k) is the first step in designing the ground loop heat exchanger(borehole) of a geothermal heat pump system. Another important factor is the borehole thermal resistance($R_b$). Thermal response tests offer a good method to determine the ground thermal properties for the total heat transport in the ground. This is done by supplying a constant heat power into a borehole heat exchanger. There are two methods to supply a constant heat power. One is to employ the electricity provided by Korea Electric Power Corporation(KEPCO). The other is to use electricity generated by a generator. In this study, the power supply regulation was found to reduce when the electricity generated by the generator was used. This is because the generator evaluated with the power supply characteristically reduces the power supply regulation between an overload and a complex using. But it sometimes occurs a power supply regulation in In-situ thermal response test. In this case getting of k,$R_b$ requires delay times and restored normal state. However, the effect of the delay times and restored normal state on the soil thermal conductivity and borehole thermal resistance is very small. Therefore it is possible to use a generally accepted delay times and restored normal state in the analysis. In this work, it is also shown that an acceptable range of ${\Delta}k$, ${\Delta}R_b$ for normal state and regulation state might be approximately 0.01-0.16W/m k, and -0.004-0.007m K/W, respectively. Thus, restored normal state of power supply regulation is valuable to recommend.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2008년도 동계학술발표대회 논문집
• /
• pp.33-38
• /
• 2008

A ground-loop heat exchanger in a ground source heat pump system is an important unit that determines the thermal performance of a system and its initial cost. The Size and performance of this heat exchanger is highly dependent on ground thermal properties. A proper design requires certain site-specific parameters, most importantly the ground effective thermal conductivity, the borehole thermal resistance and the undisturbed ground temperature. This study was performed to investigate the effect of some parameters such as borehole lengths, various grouting materials and U-tube configurations on ground effective thermal conductivity. In this study, thermal response tests were conducted using a testing device with 9-different ground-loop heat exchangers. From the experimental results, the length of ground-loop heat exchanger affects to the effective thermal conductivity. Among the various grouting materials, the bentonite-based grout with silica sand shows the largest thermal conductivity value.

• 한국태양에너지학회 논문집
• /
• 제30권4호
• /
• pp.71-78
• /
• 2010

Investigation of the effective soil thermal conductivity(k) is the first step in designing the ground loop heat exchanger(borehole) of a geothermal heat pump system. The line source method is required by New and Renewable Energy Center of Korea Energy Management Corporation in analyzing data obtained from thermal response tests. Another important factor in designing the ground loop heat exchanger is the borehole thermal resistance($R_b$). There are two methods to evaluate $R_b$ : one is to use a line source method, and the other is to use a shape factor of the borehole. In this study, we demonstrated that the line source method produces better results than the shape factor method in evaluating $R_b$. This is because the borehole thermal resistance evaluated with the line source method characteristically reduces the temperature differences between an actual and a theoretical thermal behaviors of the borehole. Evaluation of $R_b$ requires soil volumetric heat capacity. However, the effect of the soil volumetric heat capacity on the borehole thermal resistance is very small. Therefore, it is possible to use a generally accepted average value of soil volumetric heat capacity($=2MJ/m^3{\cdot}K$) in the analysis. In this work, it is also shown that an acceptable range of the initial ignoring time should be in the range of 8~16hrs. Thus, a mean value of 12 hrs is recommended.

• 화약ㆍ발파
• /
• 제28권2호
• /
• pp.37-49
• /
• 2010

도심지 특성상 주변구조물에 근접한 발파로 발생되는 지반진동은 인체에 간접피해와 구조물에 물적피해를 줄 수 있다. 설계단계 또는 시공 전 민원발생 시 구조물의 피해정도를 평가하는 방법으로는 단순 진동파형을 정량적으로 표현하는데 가장 접근성이 좋은 시추공 발파시험이 주로 이용되고 있다. 본 연구는 소량의 폭약으로 인위적인 진동에너지를 발생시키는 발파시험에 전자뇌관 기폭시스템을 처음 적용하였다. 전기뇌관 시추공 발파와 전자뇌관 시추공발파의 뇌관 지연시차 상관관계, 시험장소의 터널본선과 유사 암층에 시설된 구조물에서 측정한 PPV와 서로 다른 매개 층을 포함한 터널상부 지상도로에서 측정한 PPV의 상관관계, 기존 연구결과 얻어진 시추공발파 및 터널발파 PPV와의 상관관계를 비교 분석하여 시추공 발파의 유용성과 뇌관 지연시차의 중요성을 언급하고자 한다.

• 한국지구과학회지
• /
• 제34권3호
• /
• pp.195-208
• /
• 2013

지하 폐광도에 의한 지반침하 지역에서 전기비저항탐사와 시추공영상촬영을 통하여 지하공동의 분포 파악 및 지반 침하의 시간에 따른 변화량 측정을 수행하였다. 전기비저항탐사가 가능했던 연구지역 1에서는 100-150 ohm-meter 정도 낮은 비저항을 가지는 이상대가 관찰되었으며 시추조사와 시추공영상촬영 결과에서 폐갱도를 확인하였다. 연구지역 2는 도로로 피복되어 전기비저항탐사 수행이 불가능하였으나 광맥분포를 고려한 시추조사에서 채굴적 및 폐갱도를 확인하였다. 또한 시추공영상촬영을 43일간 총 6차례에 걸쳐 수행하여 시간에 따른 지하매질의 수직 이동 변위를 측정하였다. 지반침하로 인한 지하매질의 수직이동양상은 하부에서 상부보다 3배 이상 큰 규모로 발생하며 그 지속기간 역시 4배 이상 오랫동안 발생했음을 확인하였다. 효과적인 지하공동 탐지 및 지반침하 작용 모니터링을 위해서는 전기비저항탐사와 시추공영상촬영기법을 활용하는 것이 유용함을 알 수 있었다.

• 지질공학
• /
• 제19권2호
• /
• pp.217-225
• /
• 2009

케이싱 구간에서 얻어진 밀도검층 자료에 대한 보정연구의 일환으로 모형공에서 PVC 케이싱의 인위적 이격을 이용한 이격보정 연구를 실시하였다. 케이싱의 유형과 공벽으로부터의 이격의 정도, 공내 유체의 존재에 따른 검출기의 반응양상의 변회를 추적하였으며 특히 동일한 이격환경에서 시추공 내에 물이 있을 때와 물이 없는 상태에서 얻어진 이격반응에 대한 비교 분석이 집중적으로 수행되었다. 이로부터 PVC 케이싱에서 수행되는 밀도검층에서 공벽과 검출기 사이의 이격 거리에 따른 감마선 반응 특성을 정량화할 수 있었으며 이격보정 차트가 작성되고 지하수면 하부구간과 상부구간에서의 각 이격오차보정의 효과와 한계가 밝혀졌다.

• 한국지열·수열에너지학회논문집
• /
• 제8권4호
• /
• pp.8-16
• /
• 2012

The use of energy pile foundation has been increased for economic utilization of geothermal energy. This paper describes an experimental and numerical study on thermal response tests (TRTs) using W and 3U-shaped ground heat exchangers (GHEs) in precast-high strength concrete (PHC) energy piles. Ground thermal conductivity and borehole thermal resistance were measured and compared with those numerical analysis. W-shpaed GHE showed higher heat transfer behavior than 3U-shaped one because of different conditions such as pile size and volume of grout. That is, ground thermal conductivity using W-shaped GHE was higher than that of 3U shaped GHE, and borehole thermal resistance vice versa. The relative error of borehole resistance values between numerical and analytical solution was less than 5%.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2005년도 제17회 워크샵 및 추계학술대회
• /
• pp.587-590
• /
• 2005

A detailed geothermal characteristics survey with numerical simulations of the heat transfer in a site for ground source heat pump system is necessary for deploying a shallow geothermal utilization system. Density, specific heat, thermal diffusivity, and thermal conductivity are measured on 91 core samples from a 300 m deep borehole in KIGAM(Korea Institute of Geoscience and Mineral Resources). The heat flow is estimated from the thermal gradient and average thermal conductivity and the correlation between fracture system and hydraulic conductivity is analyzed. From the obtained ground information of the study site the performance of the ground heat pump system can be analyzed with some detailed numerical simulations for seasonal heat pump operation skill and optimal system design techniques.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2009년도 세계 도시지반공학 심포지엄
• /
• pp.1346-1353
• /
• 2009

In this study, a numerical study was carried out to simulate the expansion of ground borehole by pulse discharge technology using finite element analysis. Considering the mortar in the borehole as an acoustic medium and the surrounding soil as an elasto-plastic material, the strong shock wave developed by the pulse discharge was modeled using the underwater explosion model. The ground expansion was simulated based on a coupled acoustic-structural analysis with varying properties of mortar and soil, and the behavior between acoustic-structural interface.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2006년도 춘계학술대회
• /
• pp.442-444
• /
• 2006

On long time scale and over large areas ground surface temperatures (GSTs) track surface air temperatures (SATs). Additionally, GST changes penetrate into the subsurface and are recorded as transient temperature perturbation to the background thermal filed. Therefore, climate change can be reconstructed from borehole temperature measurements We present GST hi story reconstructed from temperature measurements in a borehole at Pocheon The result shows that GST cold period in the late 19th century and then increased by about 2K to 1990. GST history matches well with surface air temperatures measured from 1907 to 2001 at the Seoul Meteorological Station and GST history reconstructed from temperature measurements in three boreholes at Ulsan.