• Tunnel and Underground Space
• /
• v.7 no.3
• /
• pp.221-229
• /
• 1997

Disc-type and ring-type specimens of four different materials were tested to investigate the tensile characteristics and their brief results are presented. Materials tested were marble, granite, cement mortar and plaster. Unizxial tensile strengths are compared with Brazilian and ring test strengths. It was found that Brazilian strengths were usually greater than uniaxial tensile strengths and affected by loading rates. In the ring tests, tensile strengths were generally found to be decreased as relative hole radius being increased. Ring test strengths, however, converged to some value in r$\geq$0.45 of marble, r$\geqq$0.29 of cement mortar and r$\leq$0.5 of plaster specimens. In such range of r, furthermore, transverse cracking of specimens were observed.

• Tunnel and Underground Space
• /
• v.10 no.2
• /
• pp.227-236
• /
• 2000

The fracture toughness can be measured by the two testing methods using chevron-notched specimen according to the ISRM Working Group of Commission of Testing Methods. They are chevron bend (CB) test and short rod (SR) test. In this study, the suggested methods (Level I tests) were conducted on the CB and SR specimens of Chuncheon granite. In addition. the J-integral analysis was combined with an acoustic emission technique to determine the fracture toughness. The results from two telling methods were analyzed in terms of the anisotropy and the acoustic emission characteristics.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.42 no.6
• /
• pp.106-114
• /
• 2000

In order to evaluate the shear characteristics of undisturbed weathered granite soil which is a typical residual soil in Korea, the mechanical properties are first investigated and discussed by carrying out a series of direct shear test and then dilatancy correction is performed by using Taylor’s correction equation. In this study, specimens are sampled at Pungam(-3, -8, -13m below ground surface), Kwangju and Iksan(-5m below ground surface), Jeonbuk. The test results are summarized as follows: 1) Mohr-Coulomb failure criterion is not linear under the low confining pressure. 2) The value of cohesion is smaller than usually determined value in low pressure region. 3) The value of strength parameter c and ø which are corrected by Taylor’s correction equation is a little bit small.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2003.11a
• /
• pp.206-213
• /
• 2003

Laboratory testing of representative rock specimens is of fundamental necessity for the successful design and/or assessment of facilities associated with many kinds of underground exploitation, including the geological disposal of radioactive nuclear waste. As a fundamental and systematic study, a series of measurements of the physical, mechanical and hydraulic properties of Inada granite and Shirahama sandstone, two rock types that are widely available in Japan, have been performed. This paper presents the results of a study of the effective porosity, density, compressive and shear wave velocity, unconfined compressive strength and permeability of the two rocks. The anisotropy and the effects of confining pressure on the permeability of the rocks, as well as the relationships among the physical, mechanical and hydraulic properties, are also investigated and discussed.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2006.11a
• /
• pp.95-98
• /
• 2006

This study investigates spalling properties of high performance concrete, 60MPa clan, made with the various types of coarse aggregate and adding ratio of polypropylene(PP) fiber. As experimental parameters, totally sixteen specimens of ${\phi}100{\times}200mm$ in size are prepared: one specimen for control without fiber, ten specimens with different coarse aggregate types, along with 0.05, 0.1, 0.15 percent of PP fiber in each. 1 hour fire test is conducted and then spalling appearance, spalling degree and residual compressive strength are examined. In addition, sit specimens made with two types of coarse aggregate site, along with same adding ratio of fiber are supplementally done, and only spalling properties is examined. Test results showed that control concrete and most specimens containing 0.05% of PP fiber exhibited 4 to 3 level of spalling degree, resulting severe explosive spalling, except for the specimen using basalt aggregate(Bc) showing 2 to 3 level of that. Especially, the Bc specimen containing 0.1% of the fiber exhibited that residual compressive strength value was 32%, which is 10% higher than other specimens using limestone or granite. Spalling resistance performance was also effective as aggregate size increase.

• The Journal of Engineering Geology
• /
• v.14 no.2
• /
• pp.147-168
• /
• 2004

Purpose of this study is to quantitatively characterize the fracture roughness which was measured with a confocal laser scanning microscope. The roughness discrete data measured by confocal laser microscope were analyzed by spectral analysis and fast Fourier transform (FFT).The roughness data by used noise reduction filter were applied for fractal analysis to describe roughness features quantitatively. Artificial fractures created by Brazilian test on granites were used to measure fracture roughness under the confocal laser scanning microscope. Measurements were performed along three scan lines on each fracture surface. 36 scan lines were determined on 12 specimens in total. Features of roughness showed that coarse and medium grained granites tend to more rough features than those of fine grained granites. Continuous analog data of roughness is possible to described as discrete data of measure roughness with a fixed interval under the confocal laser microscope. Results of FFT with the measured data showed the highest values on the second harmonics. Distribution of average amplitude of second harmonics was observed 0.9853 in coarse grained granite, 1.0792 in medium grained granite and 0.6794 in fine grained granite. This indicates that the larger roughness has the higher energy of harmonics as the result of fractal analysis in low frequency zone.

• Journal of the Korean Geosynthetics Society
• /
• v.11 no.1
• /
• pp.35-45
• /
• 2012

Dynamic characteristics of decomposed granite soil mixed with stone sludge and bentonite were investigated to figure out adequate applications of stone sludge, A total of 16 specimens with different stone sludge contents of 0%, 5%, 10%, 15% and bentonite with 0%, 5%, 10%, 15% were prepared. Resonant column tests were carried out on each specimen at different confining pressure. The results showed that the optimum mixing ratio which can satisfy the maximum shear modulus and the minimum damping ratio of the decomposed granite soils ranges from 5% to 10% respectively.

• Journal of the Korean Geotechnical Society
• /
• v.21 no.7
• /
• pp.5-12
• /
• 2005

In order to investigate the strength and deformation anisotropy of compacted decomposed granite soils, a series of unsaturated-drained triaxial compression tests were performed. The sample used in the study was decomposed granite soil from Shimonoseki in Yamaguchi prefecture. The sample had three different angles of the axial (major principal) direction to the sedimentation plane (compaction plane), 0, 45 and 90 degrees. The compression strain of specimens subjected to isotropic compression was strongly influenced by the sedimentation angle. In addition, the time dependence was independent of the sedimentation angle in relation to the deformation behavior during the secondary compression process. The effect of the sedimentation angle on the triaxial compression strength and deformation was clear with low confining stress. Moreover, it was recognized that although the sedimentation angle and preparation methods were different, the dilatancy rate was relative to the increment of strength due to dilatancy. Therefore, it may be concluded that the compacted specimen has anisotropic mechanical properties similar to those of sand with initial fabric anisotropy.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2003.11a
• /
• pp.198-205
• /
• 2003

We considered the variation of elastic wave velocity due to the anisotropy of rock materials and stress level for acoustic emission (AE) source location in cylindrical rock specimens. Elastic wave velocity and AE were measured for Keochang granite and Yeosan marble under various axial stresses and confining pressures. Partition approximation method was suggested and it was compared with the difference approximation method and the least square method.

• Economic and Environmental Geology
• /
• v.23 no.2
• /
• pp.127-133
• /
• 1990

Relation between fluid inclusions and mineralization has been studied for 30 granitoid specimens from 19 localities in South Korea. Polyphase inclusions are found in granitoid specimens of 9 localities. In the vicinities of 6 localities among them occurs any of W, Cu or Fe deposits of the vein-, stockwork-, skarn-or pegmatite-type. On the contrary, no ore deposit is reported near the granitoids characterized by no polyphase inclusion except only one locality. This fact implies that the occurrence of polyphase inclusions is a good indicator for such kinds of mineralization. Ores and country rocks of some of the deposits contain polyphase inclusions in their quartz crystals. The fact that many polyphase inclusions occur in granitoids and ore constituents suggests that highly saline hydrothermal solution played an important role for the formation of such kinds of deposits. On the contrary, the granite and the ore of the Mugug gold deposit have many fluid inclusions, but are free from the polyphase type.